Camel grazing affects species diversity and community structure in the deserts of the UAE

Camel grazing plays a crucial role in the desert ecosystems of the UAE. In this study, we compare areas grazed by small antelope (Al Maha Resort – the AMR) with areas grazed by both camels and small antelope (Dubai Desert Conservation Reserve – the DDCR). A total of 126 plots were selected during the growing season 2006/07 on three soil substrates: gravel plains, sand flats and sand dunes. In each plot, several vegetation parameters were assessed: density, frequency, percent cover and diversity indices. The replacement of camels with wild antelope has significantly increased the number of species on gravel plains, vegetation density on sand dunes and diversity indices on both sand flats and sand dunes, but significantly decreased plant cover on sand flats and sand dunes. The increase in species diversity in the AMR was attributed to moderate grazing by antelope. Replacement of camels by antelope in the AMR has resulted in change in plant community composition of the three substrate types. Species recovered after protection from camel grazing are palatable, especially for camels, except Heliotropium kotschyi and Aerva javanica. The absence of most of the palatable species from the DDCR was attributed to both selective foraging and overgrazing by camels.     

Design and commissioning of a laminar soil container for use on small shaking tables

This paper describes the design, fabrication and commissioning of a single axis laminar shear box for use in seismic soil–structure interaction studies. A laminar shear box is a flexible container that can be placed on a shaking table to simulate vertical shear-wave propagation during earthquakes through a soil layer of finite thickness. The laminar shear box described in this paper was designed to overcome the base shear limitations of a small shaking table at The University of Western Ontario. The design details of the box are provided in addition to results of dynamic tests performed to commission the box. A synthetic clay comprising sodium bentonite mixed with diluted glycerin was used as the model soil and 1-G similitude theory was employed to maintain model to prototype similarity. The model soil was compacted into the container in lifts to achieve soil stiffness that increased with depth. A series of shaking table tests and numerical analyses that were performed to study the performance of the laminar box and non-linear seismic behavior of the model clay are described. The results of this study show that the laminar box does not impose significant boundary effects and is able to maintain 1-D soil column behavior. In addition, the dynamic behavior of the model clay during scaled model tests was found to be consistent with the behavior measured during cyclic laboratory tests.     

Efficient 3D nonlinear Winkler model for shallow foundations

This paper presents a new practical modeling approach, based on the beam-on-a-nonlinear Winkler foundation (BNWF) model, to simulate the 3D rocking, vertical and horizontal responses of shallow foundations using structural elements that are readily available in the element library of commercially available structural analysis programs. An assemblage of a moment-rotation hinge, shear hinge connected in series with an elastic frame member attached to the bottom end of ground story columns was proposed to model the response of the footing under combined action of vertical, horizontal and moment loading. To couple the responses of these hinges, two bounding surfaces equations were introduced and derived mathematically: a surface that defines the interaction between the rocking and vertical capacities of the footing along its width and length; and a surface that defines the interaction between the horizontal capacities of the footing along its width and length. Simple calculation steps to evaluate the geometric and mechanical properties of the proposed assemblage of structural elements are provided. The proposed modeling approach was verified using experimental results from large scale model foundations subjected to cyclic loading. Based on this study, it was found that the proposed assemblage can be reliably used in modeling the rocking and horizontal responses of shallow foundations under cyclic loading.     

Flow dynamics at the origin of thin clayey sand lacustrine turbidites: Examples from Lake Hazar,Turkey

Turbidity currents and their deposits can be investigated using several methods, i.e. direct monitoring, physical and numerical modelling, sediment cores and outcrops. The present study focused on thin clayey sand turbidites found in Lake Hazar (Turkey) occurring in eleven clusters of closely spaced thin beds. Depositional processes and sources for three of those eleven clusters are studied at three coring sites. Bathymetrical data and seismic reflection profiles are used to understand the specific geomorphology of each site. X‐ray, thin sections and CT scan imagery combined with grain‐size, geochemical and mineralogical measurements on the cores allow characterization of the turbidites. Turbidites included in each cluster were produced by remobilization of surficial slope sediment, a process identified in very few studies worldwide. Three types of turbidites are distinguished and compared with deposits obtained in flume studies published in the literature. Type 1 is made of an ungraded clayey silt layer issued from a cohesive flow. Type 2 is composed of a partially graded clayey sand layer overlain by a mud cap, attributed to a transitional flow. Type 3 corresponds to a graded clayey sand layer overlain by a mud cap issued from a turbulence‐dominated flow. While the published experimental studies show that turbulence is damped by cohesion for low clay content, type 3 deposits of this study show evidence for a turbulence‐dominated mechanism despite their high clay content. This divergence may in part relate to input variables, such as water chemistry and clay mineralogy, that are not routinely considered in experimental studies. Furthermore, the large sedimentological variety observed in the turbidites from one coring site to another is related to the evolution of a sediment flow within a field‐scale basin made of a complex physiography that cannot be tackled by flume experiments.     

Phosphorus removal efficiency from wastewater under different loading conditions using sand biofilters augmented with biochar

Treated wastewater is a valuable resource, particularly in countries facing water shortage such as Jordan. Nevertheless, excess nutrients, especially phosphorus, may have detrimental impacts on receiving waterbodies. Treated wastewater in Jordan often exceeds the recommended levels set by the Jordanian Standards for wastewater reuse and discharge. Therefore, it is important to reduce phosphorus loads to acceptable levels before discharge. Biofiltration is a low-cost technology that has shown good potential for wastewater treatment. The performance of biofilters largely depends on the media used. In this study, local sand and sand augmented with biochar prepared from the olive oil processing waste (SBC) were used as filter media for phosphorus removal from clarified secondary treated wastewater. The two media types were tested under different hydraulic and phosphorus loading conditions to simulate shock, flooding, and inundation conditions. The results showed that sand media was more effective in removing phosphorus (90.8 ± 2.6%) than sand amended with biochar (83.3 ± 3.2%). Both media showed resilience under extreme loading conditions. Although phosphorus removal efficiency was negatively affected following the extreme loading events, the observed effects were temporary. The simulated inundation event further showed that the media was able to retain the adsorbed phosphorus. Furthermore, the phosphorus concentration in the effluent remained within the prescribed discharge guidelines at all times.     

Ionic conductivity in gem-quality single-crystal alkali feldspar from the Eifel: temperature,orientation and composition dependence

We measured the ion conductivity of single-crystal alkali feldspar originating from two different locations in the Eifel/Germany, named Volkesfeld and Rockeskyller sanidine and having potassium site fractions \(C_\mathrm{K}\) of 0.83 and 0.71, respectively. The dc conductivities resulting from electrochemical impedance spectroscopy over the temperature range of 300–900 \(^{\circ }\hbox {C}\) show a weak composition dependence but pronounced differences between the b-direction [\(\perp (010)\)] and \(c^{*}\)-direction [\(\perp (001)\)] of the monoclinic feldspar structure. Conductivity activation energies obtained from the observed linear Arrhenius plots are close to 1.2 eV in all cases, which is closely similar to the activation energies of the \(^{22}\mathrm{Na}\) tracer diffusivity in the same crystals. Taking into account literature data on K tracer diffusion and diffusion correlation effects, the present results point to a predominance of the interstitialcy mechanism over the vacancy mechanism in mass and charge transport on the alkali sublattice in potassium-rich alkali feldspar.     

Late Proterozoic older granitoids from the North Eastern desert of Egypt: petrogenesis and geodynamic implications

Major, trace, and REE data for three localities of calc?Calkaline older granitoid rocks exposed in the north Eastern Desert of Egypt are presented. These rocks were selected to cover wide compositional spectrum of the Egyptian older granitoid varieties. They are petrographically represented by granodiorite, tonalite, quartz?Cdiorite, and quartz?Cmonzodiorite. The rocks are comparable with the peraluminous, unfractionated calc?Calkaline suites and fall within the volcanic arc and I-type granite fields. So, they can be regarded as belonging to the volcanic arc collision stage (665?C614?Ma). The granitoids are geochemically similar to other rocks recorded from continental margin arc-systems being exhibit light-REE enriched patterns with variable but chiefly positive Eu anomaly. The latter has reverse relationship with the ??REE, which was attributed to the fractionation of hornblende during partial melting. These patterns are comparable with models involving partial melting of amphibolitic source. This source must represent basalts, gabbros, or volcanics of an island arc system that were transformed to the level of the island arc crust during continental growth where the P?CT conditions are suitable for partial melting. Thus, it is plausible that the studied rocks were derived by partial melting of LREE-enriched, garnet-free, and amphibole-bearing (i.e., hydrated) mafic source. Wadi Milaha granitoids are consistent with the derivation by a high degree of partial melting (30?C40%) of amphibolite protolith in the deep crust. However, the two other localities (Wadi Umm Anab and West Gharib) are matching with 20?C30% partial melting. Within each locality, variation in rock types from granodiorite to tonalite is said to be dominated by variable degree of restite separation during magma ascent. The high water and volatile contents in Wadi Milaha granitoids allowed higher degree of partial melting (30?C40%). Moreover, the lower volatile contents in the other two localities (Wadi Umm Anab and West Gharib) gave lower degrees of partial melting (20?C30%). These processes may resemble important geodynamic features of the Arabo-Nubian Shield evolution in the north Eastern Desert of Egypt.     

Iron isotope fractionation in subduction-related high-pressure metabasites (Ile de Groix,France)

Characterisation of mass transfer during subduction is fundamental to understand the origin of compositional heterogeneities in the upper mantle. Fe isotopes were measured in high-pressure/low-temperature metabasites (blueschists, eclogites and retrograde greenschists) from the Ile de Groix (France), a Variscan high-pressure terrane, to determine if the subducted oceanic crust contributes to mantle Fe isotope heterogeneities. The metabasites have δ⁵⁶Fe values of +0.16 to +0.33‰, which are heavier than typical values of MORB and OIB, indicating that their basaltic protolith derives from a heavy-Fe mantle source. The δ⁵⁶Fe correlates well with Y/Nb and (La/Sm)_PM ratios, which commonly fractionate during magmatic processes, highlighting variations in the magmatic protolith composition. In addition, the shift of δ⁵⁶Fe by +0.06 to 0.10‰ compared to basalts may reflect hydrothermal alteration prior to subduction. The δ⁵⁶Fe decrease from blueschists (+0.19 ± 0.03 to +0.33 ± 0.01‰) to eclogites (+0.16 ± 0.02 to +0.18 ± 0.03‰) reflects small variations in the protolith composition, rather than Fe fractionation during metamorphism: newly-formed Fe-rich minerals allowed preserving bulk rock Fe compositions during metamorphic reactions and hampered any Fe isotope fractionation. Greenschists have δ⁵⁶Fe values (+0.17 ± 0.01 to +0.27 ± 0.02‰) similar to high-pressure rocks. Hence, metasomatism related to fluids derived from the subducted hydrothermally altered metabasites might only have a limited effect on mantle Fe isotope composition under subsolidus conditions, owing to the large stability of Fe-rich minerals and low mobility of Fe. Subsequent melting of the heavy-Fe metabasites at deeper levels is expected to generate mantle Fe isotope heterogeneities.