Steady critical discharge rates from vertical and horizontal wells in fresh–saline aquifers with sharp interfaces

In this study, the critical (or maximum) discharge rates before saline water enters a well were determined for vertical and horizontal wells in a freshwater aquifer which is separated from a static saline aquifer by a sharp interface. Flow around the well was solved by integration of a point sink solution along the well axis, and both the critical discharge rate and critical interface rise were determined through a comparison of the heads and vertical gradients at the saline–fresh water interface. The rates were determined for vertical and horizontal wells with various lengths and depths for different aquifer salinities. Results were generalized by drawing dimensionless type curves. The results showed that the dimensionless total critical discharge rates are higher for the longer horizontal wells and longer vertical wells with a certain bottom depth, and they almost linearly decrease with well depth at rates of 0.7–0.9. For the dimensionless well length of 0.2, the dimensionless total discharge rate of a horizontal well is about 0.1 more than that of a vertical well with the same length and well-top depth. Also, the critical discharge rates per unit length of well are inversely proportional to well length and remarkably higher for shallower wells. Additionally, the critical pumping rate is proportional to the salinity difference of the aquifers. These results were confirmed by comparison to existing solutions for vertical wells with dimensionless lengths of 0.2, 0.5 and 0.6, and for critical interface rises in the range of 0.75–0.9.     

Improved regional groundwater flow modeling using drainage features: a case study of the central northern karst aquifer system of Puerto Rico (USA)

In northern Puerto Rico (USA), subsurface conduit networks with unknown characteristics, and surface features such as springs, rivers, lagoons and wetlands, drain the coastal karst aquifers. In this study, drain lines connecting sinkholes and springs are used to improve the developed regional model by simulating the drainage effects of conduit networks. Implemented in an equivalent porous media (EPM) approach, the model with drains is able to roughly reproduce the spring discharge hydrographs in response to rainfall. Hydraulic conductivities are found to be scale dependent and significantly increase with higher test radius, indicating scale dependency of the EPM approach. Similar to other karst regions in the world, hydraulic gradients are steeper where the transmissivity is lower approaching the coastline. This study enhances current understanding of the complex flow patterns in karst aquifers and suggests that using a drainage feature improves modeling results where available data on conduit characteristics are minimal.     

Spatial multi-criteria analysis for selecting potential sites for aquifer recharge via harvesting and infiltration of surface runoff in north Jordan

In (semi-)arid regions, available water resources are scarce and groundwater resources are often overused. Therefore, the option to increase available water resources by managed aquifer recharge (MAR) via infiltration of captured surface runoff was investigated for two basins in northern Jordan. This study evaluated the general suitability of catchments to generate sufficient runoff and tried to identify promising sites to harvest and infiltrate the runoff into the aquifer for later recovery. Large sets of available data were used to create regional thematic maps, which were then combined to constraint maps using Boolean logic and to create suitability maps using weighted linear combination. This approach might serve as a blueprint which could be adapted and applied to similar regions. The evaluation showed that non-committed source water availability is the most restricting factor for successful water harvesting in regions with <200 mm/a rainfall. Experiences with existing structures showed that sediment loads of runoff are high. Therefore, the effectiveness of any existing MAR scheme will decrease rapidly to the point where it results in an overall negative impact due to increased evaporation if maintenance is not undertaken. It is recommended to improve system operation and maintenance, as well as monitoring, in order to achieve a better and constant effectiveness of the infiltration activities.     

Applying disk-based discontinuous deformation analysis (DDA) to simulate Donghekou landslide triggered by the Wenchuan earthquake

In this paper, for the first time, disk-based discontinuous deformation analysis (DDA) is applied to simulate a real landslide triggered by an earthquake. For this purpose, the kinematic behaviour of the Donghekou landslide triggered by the Wenchuan earthquake is simulated and the results obtained using disk-based DDA are compared with actual data. The comparisons show that there is a good agreement between the results obtained using disk-based DDA and observed data. The simulation results provided an understanding of the failure behaviour and temporal evolution of the landslide. This study shows that disk-based DDA is a practical numerical tool that can be used to simulate the post-failure behaviour of landslides triggered by an earthquake.     

The effect of specimen diameter size on uniaxial compressive strength,P-wave velocity and the correlation between them

Estimation of uniaxial compressive strength (UCS) by P-wave velocity (V_P) is of great interest to geotechnical engineers in various design projects. The specimen diameter size is one of the main factors that influence rock parameters such as UCS and V_P. In this study, the diameter size of specimens that effect UCS and V_P is investigated. Moreover, the correlation between UCS and V_P are examined via empirical analysis. For this purpose, 15 travertine samples were collected and core specimens with a diameters size of 38, 44, 54, 64 and 74 mm were prepared. Then, uniaxial compressive strength and P-wave velocity tests were conducted according to the procedure suggested by ISRM (1981). It is concluded that the diameter size of the specimen has a significant effect on UCS and V_P. Moreover, it was found that the best correlation between relevant parameters obtained for the specimen diameter of 38 mm.