巴丹吉林沙漠北缘拐子湖流沙下垫面近地层湍流强度和陆面过程特征

利用巴丹吉林沙漠北缘拐子湖流沙下垫面2013年7、10月和2014年1、4月的湍流通量资料,计算并分析了研究区近地层湍流强度,同时针对风速分量、温度、水汽和CO₂归一化标准差随稳定度的变化关系和总体输送系数等陆面过程特征进行分析。结果表明：（1）风速各分量的湍流强度均随风速的增加逐渐减小,风速处于2 m·s^-1以下时湍流发展最为旺盛。湍流强度主要由水平方向风速分量决定,垂直方向风速的作用较小,且近中性和不稳定层结利于湍流的发展。与其他地区相比,平坦且没有建筑物的沙漠地区,机械湍流较弱,湍流强度相应较小。（2）风速各分量的归一化标准差与稳定度（z/L）均满足1/3次方函数规律,其中垂直方向风速分量的拟合曲线方程较好。（3）动量输送系数C_d具有明显的夏季高、冬季低的变化状态且各月的日变化形态均呈夜间低、日间高的循环形态。热量输送系数C_h的不同月份日变化间并没有明显的排列次序,且日出日落前后具有明显的波动。不稳定层结时,C_d和C_h均随风速的增加逐渐减小;稳定层结时,C_d和C_h均随着风速的增加逐渐上升。     

塔克拉玛干荒漠-绿洲过渡带尘卷风活动特征——以肖塘为例

利用1992—2011年塔克拉玛干沙漠北缘荒漠-绿洲过渡带肖塘气象站的观测资料,分析了该地区尘卷风的年、月变化规律及其与气象因子的关系。结果表明:(1) 1992—2011年尘卷风发生日数总体呈波动递减趋势;尘卷风主要发生在3—9月,占全年总日数的90.9%,其中4—7月占全年总日数的70%左右。(2)尘卷风月发生日数随月平均地表与1.5 m高处温差的增大而线性增加(r=0.875,P<0.01)。(3)尘卷风月发生日数随着月平均风速的增大而幂函数增加(r=0.89,P<0.01)。(4)尘卷风月发生日数随月平均相对湿度的增大而线性减少(r=-0.869,P<0.01)。     

Experimental Evaluation of A New Developed Algorithm for An Autonomous Surface Vehicle and Comparison with Simulink Results

China Ocean Engineering - Performing repeatable duties automatically was the dreams of human being for centuries. Although full autonomy has long been dreamed of by visionaries, many researches...     

Use of genetic algorithm in new approach to modeling of flood routing

Journal of Oceanology and Limnology - The hydrological models and simplified methods of Saint-venant equations are used extensively in hydrological modeling, in particular for the simulation of the...     

Estimation of crowd density from UAVs images based on corner detection procedures and clustering analysis

With rapid developments in platforms and sensors technology in terms of digital cameras and video recordings, crowd monitoring has taken a considerable attentions in many disciplines such as psychology, sociology, engineering, and computer vision. This is due to the fact that, monitoring of the crowd is necessary to enhance safety and controllable movements to minimize the risk particularly in highly crowded incidents (e.g. sports). One of the platforms that have been extensively employed in crowd monitoring is unmanned aerial vehicles (UAVs), because UAVs have the capability to acquiring fast, low costs, high-resolution and real-time images over crowd areas. In addition, geo-referenced images can also be provided through integration of on-board positioning sensors (e.g. GPS/IMU) with vision sensors (digital cameras and laser scanner). In this paper, a new testing procedure based on feature from accelerated segment test (FAST) algorithms is introduced to detect the crowd features from UAV images taken from different camera orientations and positions. The proposed test started with converting a circle of 16 pixels surrounding the center pixel into a vector and sorting it in ascending/descending order. A single pixel which takes the ranking number 9 (for FAST-9) or 12 (for FAST-12) was then compared with the center pixel. Accuracy assessment in terms of completeness and correctness was used to assess the performance of the new testing procedure before and after filtering the crowd features. The results show that the proposed algorithms are able to extract crowd features from different UAV images. Overall, the values of Completeness range from 55 to 70 % whereas the range of correctness values was 91 to 94 %.     

Implementation of baroclinic terms in a three-dimensional hydrodynamic model and its application to Anzali Port, Iran

Baroclinic terms have been implemented in a three-dimensional fully hydrodynamic model developed by Badiei et al. [2008. A three-dimensional non-hydrostatic boundary fitted model for free surface flows. International Journal for Numerical Methods in Fluids, 56(6), 607-627] modifying its momentum equations to account for density gradients and utilizing the scalar (salinity, temperature, etc.) conservation equation (SCE) and a state equation for the calculation of density. In the solution of advection-diffusion terms of the governing Navier-Stokes equations (NSE) and SCE, a symmetric splitting method was applied to ensure the long-term stability of simulations. Correction terms proposed by Ruddic et al. (1995) were applied to SCE to ensure the conservation of the scalar quantity. In the presence of baroclinic terms, the zero gradient pressure in the vertical direction in the vicinity of surface and bottom boundaries assumed by Badiei et al. [2008. A three-dimensional non-hydrostatic boundary fitted model for free surface flows. International Journal for Numerical Methods in Fluids, 56(6), 607-627] created spurious currents. This problem was solved by assuming a hydrostatic pressure variation at those boundaries. The ability of extended model was validated by comparing its results with an experimental test case. The simulation of hydrodynamic and salt intrusion at Anzali Port located at the southern coasts of Caspian Sea in Iran was carried out by the model with both barotropic and baroclinic modes. The simulated results with baroclinic mode show a better agreement with measured data as compared to the results of barotropic mode that clearly demonstrate the significance of baroclinic terms in the simulation of cyclic intrusion of salt wedge into the Port Basin.     

Late quaternary seismic stratigraphy and active faults of the Gulf of İzmit (NE Marmara Sea)

The Upper Quaternary seismic stratigraphy and active faults of the Gulf of İzmit were investigated by means of high-resolution shallow seismic profiling data in the source region of 1999 İzmit earthquake. High-resolution seismic reflection data correlated with borehole data indicate that the stratigraphy of İzmit Bay consists of three distinct depositional sequences formed in response to middle Pleistocene-Holocene sea-level changes. Reflector R, separating the pre-Holocene sequences (1 and 2) from the Holocene sequence (3), represents an erosional unconformity produced by the subaerial fluvial erosion of the continental shelves at the time of the last glacial maximum. Occasional, anomalous reflections (acoustic turbidity) observed within the Holocene sequence are interpreted as gas accumulations. The maximum thickness of the Holocene sediments is found to be about 25 m. The isopach map of Holocene sediment implies that the thickness of the Holocene decreases from the east towards the central and western basins of İzmit Bay. Two distinct fault systems are interpreted in İzmit Bay. The main fault system extending roughly in an E-W direction along the Gulf of İzmit is an active right lateral strike slip fault with a normal component. The secondary faults are normal faults striking in different directions and these are identified as being both active and inactive. In addition, prominent compressive features are identified in the seismic cross-sections of some profiles acquired to the east of Hersek Peninsula where the focal mechanisms of the aftershocks of the 1999 İzmit earthquake also reveal predominantly reverse faulting mechanisms, as identified by a local dense seismic network.     

Distribution of diagenetic alterations within depositional facies and sequence stratigraphic framework of fluvial sandstones: Evidence from the Petrohan Terrigenous Group,Lower Triassic,NW Bulgaria

Sequence stratigraphy of fluvial deposits is a controversial topic because changes in relative sea level will eventually have indirect impact on the spatial and temporal distribution of depositional facies. Changes in the relative sea level may influence the accommodation space in fluvial plains, and hence have impact on types of fluvial system, frequency of avulsion, and style of vertical and lateral accretion. This study aims to investigate whether depositional facies and changes in the fluvial system of the Lower Triassic Petrohan Terrigenous Group sandstones (NW Bulgaria) in response to changes in the relative sea level have an impact on the spatial and temporal distribution of diagenetic alterations.     

A traversing system to measure bottom boundary layer hydraulic properties

This study describes a new convenient and robust system developed to measure benthic boundary layer properties, with emphasis placed on the determination of bed shear stress and roughness height distribution within estuarine systems by using velocity measurements. This system consisted of a remotely operated motorised traverser that allowed a single ADV to collect data between 0 and 1 m above the bed. As a case study, we applied the proposed traversing system to investigate bottom boundary layer (BBL) hydraulic properties within Coombabah Creek, Queensland, Australia. Four commonly-employed techniques: (1) Log-Profile (LP); (2) Reynolds stress (RS); (3) Turbulent Kinetic Energy (TKE); and (4) Inertial Dissipation (ID) used to estimate bed shear stresses from velocity measurements were compared. Bed shear stresses estimated with these four methods agreed reasonably well; of these, the LP method was found to be most useful and reliable. Additionally, the LP method permits the calculation of roughness height, which the other three methods do not. An average value of bed shear stress of 0.46 N/m², roughness height of 4.3 mm, and drag coefficient of 0.0054 were observed within Coombabah Creek. Results are consistent with that reported for several other silty bed estuaries.     

Compressive and rarefactive double layers in non-uniform plasma with $$-nonextensive distributed electrons

Electrostatic solitary waves and double layers (DLs) formed by the coupled ion acoustic (IA) and drift waves have been investigated in non-uniform plasma using \(q\)-nonextensive distribution function for the electrons and assuming ions to be cold \(T_{i}< T_{e}\). It is found that both compressive and rarefactive nonlinear structures (solitary waves and DLs) are possible in such a system. The steeper gradients are supportive for compressive solitary (and double layers) and destructive for rarefactive ones. The \(q\)-nonextensivity parameter \(q\) and the magnitudes of gradient scale lengths of density and temperature have significant effects on the amplitude of the double layers (and double layers) as well as on the speed of these structures. This theoretical model is general which has been applied here to the \(F\)-region ionosphere for illustration.