The influence of oxidation state on the electrical conductivity of olivine

The electrical conductivity of a single crystal of San Carlos olivine (Fo₉₂, 0.16 wt.% Fe₂O₃) has been measured as a function of temperature and oxygen fugacity (fO₂). After heating to 1338°C at fO₂ = 10^?12 atm., the conductivity at 950°C was 10^?5 (ohm-m)^?1, almost 3 orders of magnitude less than that measured in air. This decrease is due to the reduction of Fe³⁺ to Fe²⁺. Further heating to 1500°C at fO₂ = 10^?14 atm., decreased the electrical conductivity at 950°C to 10^?6 (ohm-m)^?1. When recovered at room temperature, the speciment had Fo₉₆ composition and contained small, opaque blebs distributed throughout the crystal. Derivations of temperature profiles for the earth's mantle from conductivity-depth models must take account of the important role played by iron oxidation state in the electrical conductivity of olivine.     

An Estimate of Microwave low-Brightness-Temperature Regions' Heights Obtained Measuring Their Rotation Velocity

Daily full-disk solar maps obtained at 37 GHz in the years 1979, 1980, 1981, 1982, 1987, 1988, 1989, 1990, and 1991 are analysed and compared with full-disk solar maps in H. A search for a difference in the measured angular rotation velocity for two classes of microwave low-brightness-temperature regions (LTRs), associated and not associated with H filaments, is performed. Procedures with and without statistical weights, assigned to angular rotation velocities according to the tracing time, are applied and the statistical significance of the results is discussed. A higher angular rotation velocity is measured for LTRs associated with H filaments than for the not-associated ones. This angular velocity difference is interpreted as a consequence of a height difference between these two types of LTR tracers. Changes of the solar differential rotation velocity during the activity cycle measured using LTRs as tracers are explained by the measured cycle-dependence of the association rate between LTRs and H filaments. Similarly, the north–south asymmetry in the solar rotation velocity measured tracing LTRs is explained by the measured north–south asymmetry in the association rate between LTRs and H filaments. The rotation velocity of LTRs and H filaments is on the average more rigid in comparison with sunspots.     

The Dar al Gani meteorite field (Libyan Sahara): Geological setting,pairing of meteorites,and recovery density

Abstract— As of July 2001, 1238 Libyan meteorites have been reported. Most were found in two areas called Dar al Gani and Hamadah al Hamra. Dar al Gani is located on a plateau of marine carbonate rocks with marly components. Eight‐hundred and sixty‐nine meteorites between 6 g and 95 kg totalling 687 kg have been found here but the calculated mean recovery density is comparatively low with one meteorite on 6.5 km². Dar al Gani is a perfect site for the recognition and preservation of meteorites. The existence of meteorites is the result of a combination of specific geological and geomorphological conditions: there is a bright‐colored, old limestone plateau (<2 Ma), under arid weather conditions over long periods of time, with rapid elimination of surface water if present and low erosion rates. The preservation of meteorites is guaranteed through the absence of quartz sand on the plateau, strongly reducing wind erosion and a basic environment emerging from the carbonate ground retards rusting of metallic meteorite components. A supposed soil cover during pluvial times has probably protected older meteorites and led to a concentration of meteorites of different periods. An evaluation of Dar al Gani meteorites suggests the existence of at least 26 strewnfields and 26 meteorite pairs reducing the number of falls to, at most, 534. Shock and weathering grades as a tool for the recognition of pairings turned out to be problematic, as several strewnfields showed paired meteorites which had been classified to different shock and weathering grades.     

Plain strain soil–structure interaction model for a building supported by a circular foundation embedded in a poroelastic half-space

A simple theoretical model for soil–structure interaction in water saturated poroelastic soils is presented, developed to explore if the apparent building–foundation–soil system frequency changes due to water saturation. The model consists of a shear wall supported by a rigid circular foundation embedded in a homogenous, isotropic poroelastic half-space, fully saturated by a compressible and inviscid fluid, and excited by in-plane wave motion. The motion in the soil is governed by Biot's theory of wave propagation in fluid saturated porous media. Helmholtz decomposition and wave function expansion of the two P-wave and the S-wave potentials is used to represent the motion in the soil. The boundary conditions along the contact surface between the soil and the foundation are perfect bond (i.e. welded contact) for the skeleton, and either drained or undrained hydraulic condition for the fluid (i.e. pervious or impervious foundation). For the purpose of this exploratory analysis, the zero stress condition at the free surface is relaxed in the derivation of the foundation stiffness matrix, which enables a closed form solution. The implications of this assumption are discussed, based on published comparisons for the elastic case. Also, a closed form representation is derived for the foundation driving forces for incident plane (fast) P-wave or SV wave. Numerical results and comparison with the full-scale measurements are presented in the companion paper, published in this issue.     

Effects of rainfall on soil–structure system frequency: Examples based on poroelasticity and a comparison with full-scale measurements

In this paper, a simple two-dimensional soil–structure interaction model, based on Biot's theory of wave propagation in fluid saturated porous media, is used to explain the observed increase of the apparent frequencies of Millikan library in Pasadena, California, during heavy rainfall and recovery within days after the rain. These variations have been measured for small amplitude response (to microtremors and wind excitation), for which Biot's linear theory is valid. The postulated hypothesis is that the observed increases in frequency are due to the water saturation of the soil. The theoretical model used to explore this hypothesis consists of a shear wall supported by a circular foundation embedded in a poroelastic half-space. This rigid foundation model may be appropriate only for the NS response of Millikan library. This paper presents results for the foundation stiffness, and for the system response for model parameters similar to those for Millikan library (located on alluvium with shear wave velocity of about 300 m/s). The foundation impedance matrix, foundation input motion and system response are compared for dry and fully saturated half-space, with permeable and impermeable foundation. The results show that for embedded foundations, the effects of saturation on the horizontal foundation stiffness are as significant as for the vertical stiffness, contrary to what has been known for surface foundations investigated by other authors. Further, the results suggest a 1–2% increase in system frequency of the first two modes of vibration, depending on the drainage condition along the foundation–soil interface. Such increases agree qualitatively with the observations.     

Comparison of three mathematical models for the estimation of 10-day drain discharge

Summary This paper presents an the evaluation of three mathematical models for the estimation of 10-day drain discharge using weather, pedological and phenological parameters. One model uses modified Palmer’s procedure for the calculation of water balance components and the second two use empirical multiple linear regression. The models have been applied to data of an amelioration experimental field in central Croatia (south-western part of the Pannonian Lowland), where a set of average 10-day air temperature and relative humidity data, average wind speed, cumulative precipitation and drain discharge amounts, insolation and soil moisture data and vegetation indices have been collected. The experiment has been performed during the period 1990–1992. The models have been tested by comparing estimated and observed 10-day drain discharge amounts. All models mainly give acceptable cumulative results although their accuracy depends on the season.     

Everyday effects, practices and causal mechanisms of ‘cultural embeddedness’: Learning from Utah’s high tech regional economy

In recent years, economic geographers have drawn extensively upon notions of ‘cultural embeddedness’ to explore how spatially variable sets of cultural conventions, norms, values and beliefs shape firms’ innovative performance in dynamic regional economies. However, our understanding of these causal links remains partial, reinforced by an ‘over-territorialised’ conception of cultural embeddedness which sidelines the role of institutional actors operating outside and across the boundaries of ‘the local’. So motivated, this paper offers a theoretically-informed - and theoretically informing - empirical analysis of the high tech regional economy in Salt Lake City, Utah to explore the everyday causal mechanisms, practices and processes - both local and extra-local - through which firms’ cultural embedding within the region is manifested, performed and (un)intentionally (re)produced. In so doing, this paper aims to further our understanding of the constitutive entanglement and complex interweaving of cultural/economic practices, and to contribute to the development of an in-depth empirical corpus of work which compliments the exciting conceptual developments that have largely dominated cultural economic geography over the last decade.     

Using Remote Sensing Data to Delineate the Lineaments for Hydrothermal Mineral Prediction in Heqing Area, Northwest Yunnan Province, China

Lineament extraction and analysis is one of the routine work in mapping medium and large areas using remote sensing data, most of which are satellite images. Landsat Enhanced Thematic Mapper （ETM） of 945×1 232 pixels subscene acquired on 21 March 2000 covering the northwestern part of Yunnan Province has been digitally processed using ER Mapper software. This article aims to produce lineament density map that predicts favorable zones for hydrothermal mineral occurrences and quantify spatial associations between the known hydrothermal mineral deposits. In the process of lineament extraction a number of image processing techniques were applied. The extracted lineaments were imported into MapGIS software and a suitable grid of 100 m×100 m was chosen. The Kriging method was used to create the lineament density map of the area. The results show that remote sensing data could be useful to extract the lineaments in the area. These lineaments are closely correlated with the faults obtained through other geological investigation methods. On comparing with field data the lineament-density map identifies two important high prospective zones, where large-scale deposits are already existing. In addition the map highlights unrecognized target areas that require follow up investigation.     

Utilisation of the image analysis method for the detection of the morphological anisotropy of calcite grains in marble

This paper presents the development and utilisation of an automated image processing algorithm for detection and analysis of grains. Using optical polarising microscopy, a set of colored images are collected from an area on a thin section. A filtering operation, using rotation of a morphological alternating sequence filter (based on a structuring element), is used to remove twinning features within individual grains. Filtering is followed by the watershed segmentation technique to determine grain boundaries. The method is used for the identification of calcite grains in marble and the subsequent analysis of morphological anisotropy.     

A Method to Determine the Solar Synodic Rotation Rate and the Height of Tracers

The dependence of the measured apparent synodic solar rotation rate on the height of the chosen tracer is studied. A significant error occurs if the rotation rate is determined by tracing the apparent position of an object above the photospheric level projected on the solar disc. The centre-to-limb variation of this error can be used to determine simultaneously the height of the object and the true synodic rotation rate. The apparent (projected) heliographic coordinates are presented as a function of the height of the traced object and the coordinates of its footpoint. The relations obtained provide an explicit expression for the apparent rotation rate as a function of the observed heliographic coordinates of the tracer, enabling an analytic least-squares fit expression to determine simultaneously the real synodic rotation rate and the height of the tracer.