An experimental pressure compensated wet suit

Personal thermal insulation by means of neoprene from wet suits provides adequate temporary control of body heat loss only at the shallow end of the air diving depth range, but it constitutes by far the most popular approach to diver thermal support. Howewer, compression of the trapped gas phase in neoprene foam seriously reduces its insulation performance on exposure to high ambient pressure. With conventional wet suits equipped with heating, the necessary level of power required at depths greater than about 30 m is too high, and also unsafe without the back up that increased insulation would provide. One approach to the goal of depth-insensitive insulation is to use a wet suit with a continuous internal gas space pressurized nominally to ambient pressure, so that its thickness remains substantially constant at all depths. The composite material properties required are: outer skins that are tough, flexible and free of pin holes; an open foam internal structure capable of resisting, without significant dimensional change, the relatively small pressure changes that occur over the height of a man; and a high bond strength.Samples of a composite material that meets these requirements have been developed, and a prototype suit has been successfully fabricated by conventional techniques.     

Sedimentology of a subtidal,tide-dominated sand body in the Yellow Sea,southwest Korea

Odanam Satoe, a subtidal, tide-dominated sand body in the Yellow Sea, Korea, is linear in plan and asymmetrical in cross-section. It consists of fine- to medium-grained, well-sorted subangular sand. Bedforms consist of high-amplitude (1–2 m) sandwaves on the lower flanks of the gentler-sloping bar surface, and medium-amplitude (0.5-1 m) sandwaves on the sand body trough adjoining the steeper face, the bar crest and shallower parts of the gently sloping bar surface. Bedforms are absent on the relatively steeper bar surface, which is characterized by 2° slopes. Bedform orientation on the gentler slope is oblique by 30° to the bar crest, parallel to the sand-body crest on the crest itself, and opposite to the steeper sand-body face in the trough below the steeper slope of the bar.Bottom current velocity data show that tidal currents are semi-rotary with a flood time—velocity asymmetry over the gentler slope, and ebb time—velocity asymmetry over the steeper slope during most of the tidal cycle. Tidal-current flow parallels bar elongation over the steeper slope, whereas over the gentler slope, tidal-current flow is directed at 30° to the bar crest and changes to normal to the crest one hour prior to low tide. Bedform orientation mapped with side-scan sonar shows agreement with these flow directions.Sand dispersal around the sand body is controlled by time—velocity asymmetry and partial rotary flow directions of tidal currents. This circulation causes not only a trapezoidal mode of grain dispersal, but also westerly migration of the sand body documented from comparative bathymetric surveys in 1964 and 1980.     

Breaking wave impact on vertical and sloping coastal structures

The results of laboratory experiments on the maximum and bottom impact pressures from waves breaking directly on vertical and sloping faced coastal structures are presented. Direct wave breaking on a wall is classified as early, late, and perfect breaking. Although the present study is aimed at dealing with the type of impact resulting from the perfect breaking, to some extent the occurrence of early and late breaking are unavoidable. The wave impact pressures, therefore, have a random nature of variation from impact-to-impact under the same conditions. The maximum and bottom impact pressures on walls are treated statistically. The effects of the wall angle and foreshore slope on these two quantities are examined. The results show that for practical applications, the still-water level can be taken as the acting place for the maximum impact pressure on the wall. Simultaneous impact pressure distribution below and above still-water level may be approximated as parabolic and linear, respectively. Finally, using a wall deflection criterion, a water depth region in front of the wall is defined, where the breaking wave forces may reach a critical level.     

Harpacticoida taxocen diversity in the silty-sandy littoral zone of Kandalaksha Bay of the White Sea

The fauna composition, ecological groups, and life forms of Harpacticoids of soft littoral grounds from 15 sites off the Karelian coast in Kandalaksha Bay of the White Sea were studied. Six types of harpacticoid taxocens with different sets of dominating species are described. On silty sands with clear signs of desalination, the Stenchelia palustris taxocen is common; medium-grained sands are characterized by the Heterolaophonte minuta, Paraleptastacus kliei — Huntemannia jadensis, and Amphiascoides nanus — Scottopsyllus minor taxocens; while on coarse sands, the Ameira parvula and Ameira scotti — Mesochra lilljeborgi taxocens have developed. The diversity of the taxocens is partly explained by the differences in the grain-size composition and salinity at different sites. In addition, groups of various taxocens dwelling on the same type of the sediments were found in different minor bights of the coastline.     

Chemical leaching and specific surface area measurements of marine sediments in the evaluation of mercury contamination near cinnabar deposits

This paper investigates mercury contamination in recent marine sediment of the Tyrrhenian continental shelf near the mouths of three rivers draining an area with cinnabar deposits (M. Amiata, Italy). By means of chemical leaching, two fractions of the total mercury were distinguished: a ‘non-leachable’ fraction, consisting of mercury held in relatively stable forms and a ‘leachable’ fraction, composed of forms that are more weakly bound to the sediments. The two Hg fractions are correlated to the organic matter content, the distribution of which is strictly dependent on the sediment surface area.In order to eliminate the effects of grain size variations among the samples, the Hg concentrations were normalized to the unit of surface area (ng/m²). Following this procedure, the ‘non-leachable’ Hg was found to be concentrated mostly in a belt along the coast, while the ‘leachable’ Hg fraction was shown to accumulate largely in the zones with high depositional dynamics near the mouths of the rivers.Hypotheses to account for the discrepancy between the low concentrations of ‘leachable’ Hg in the sediment of the outer continental shelf and the high concentrations in the fauna of the same area, reported in previous papers, are presented.     

Power from the people: a documentation of non-governmental organizations' experience in community-based coastal resource management in the Philippines

Community-based coastal resource management projects facilitated by non-governmental organizations (NGOs) in the Philippines have explored approaches to decrease poverty-driven over-exploitation of coastal resources. There has been little reporting and analysis of such activities until recently. Nine case studies have recently been published and this paper presents a brief summary of these, along with an analysis of the trends and themes identified. Though diverse and covering the Philippines from Mindanao to Luzon, the case studies highlight the value of community commitment and participation in decisions regarding, and in the implementation of, resource management in ways that consider not only the bio-physical aspects of resource management but the social, economic and legal implications. Experience in working with local government has been both successful and limited. Successful projects raise hopes for further progress through education and organization of communities to improve livelihoods and protect coastal resources.     

The impact of mesoscale eddies on plankton dynamics in the upper ocean

A coupled QuasiGeostrophic mixed-layer ECOsystem model (QGECO) is used to investigate the impact of the underlying mesoscale eddy field on the spatial and temporal scales of biological production and on overall rates of primary productivity. The model exhibits temporal trends in the biological and physical fields similar to those observed in the North Atlantic; i.e. the mixed layer shallows in spring causing a rapid increase in phytoplankton concentrations and a corresponding decline in nutrient levels. Heterogeneity is produced in the mixed layer through Ekman pumping velocities resulting from the interaction of windstress and surface currents. This variability impacts on biological production in two ways. Firstly, spatial variations in the depth of the mixed layer affect the photosynthetically active radiation (PAR) availability and hence production rates, and secondly, eddy enhanced exchange between the surface water and those at depth bring additional nutrients into the euphotic zone. These processes result in significant spatial and temporal heterogeneity in the ecosystem distributions.Investigation of the spatial heterogeneity of the biological system finds variability to be significantly greater than that of the mixed layer. The relationship between the eddy field and the ecosystem is investigated. The structure and correlation of the biogeochernical fields change with time. The biological fields are found to have a shorter horizontal scale, but whiter spectrum than the underlying eddy field.Overwinter conditions are found to have a profound effect on the variability, size and timing of the following spring bloom event. Variations in the nitrate levels are primarily responsible for the variability in the biological system in the first year. In subsequent years the variation in the overwintering population is found to be dominant.     

Quality control in mud coring

Consideration of factors influencing the interaction between a corer and sediment suggest the likelihood of significant and anisotropic straining of the particle framework during coring. Direct observations allow the coring process to be discretised, the relative motion of corer, core and sediment to be visualized and confirm that the development of differences between corer penetration and core length is not a continuous process. Records suggest the possibility of dislocation of the relative positions of porewater and particle framework, which may lead to the disequilibration of sorbed species.     

An inexpensive instrument for measuring benthic current velocity and direction at sea

An instrument which measures the velocity and direction of benthic water currents at depths of up to 80 m is described. Characteristics of this meter include: (i) readings are not affected by water flow during sinking or retrieval; (ii) it is portable; (iii) it operates unattended; (iv) it is inexpensive; and (v) it requires only simple maintenance. A timing circuit which operates two time periods in succession is used to activate and de-activate a revolution counter and a fluidfilled compass which are mounted on a special frame and vane system. In the field, the instrument accurately measured average current velocities of up to 6 m s⁻¹. Data are presented which illustrate the usefulness of this instrument in describing the velocity and direction of benthic currents along the east coast of Australia and demonstrate a positive correlation between benthic current velocity and catch rates of the commercially-exploited spanner crab Ranina ranina.     

Hydrography and phytoplankton of waters off south-west Ireland

Distributions of physical, chemical and biological characteristics were recorded for coastal waters off south-west Ireland during the summers of 1985–1987. A number of thermal fronts were identified from both shipboard measurements and satellite imagery. Upwelling was shown to be an important process in the area and enhanced phytoplankton biomass and productivity were associated with areas of upwelling and the fronts. Phytoplankton species composition, although varying between cruises, was associated with differences in hydrographic features.