A deep-sea in-situ suspended sediment sampling system: Comment

A recent article by Beer et al. (1974) in Marine Geology describes an in-situ suspended sediment sampling system which utilizes a pump/motor unit, filter holders, and a lead-acid battery power source. Two aspects of their article may be misleading: the use of certain filter material as X-ray diffraction mounts, and the technique by which an oil-filled battery case may be operated.     

Rare earth elements in the clay fraction of coaliferous sediments of the Arkagalinskoe (Magadan district) and Dolinskoe (Sakhalin Island) coalfields

The study of REE distribution in the clay fraction of sedimentary rocks from two coalfields made it possible to distinguish several types of REE distribution, which correlate with their mineral composition. It is shown that the REE fractionation was related to the mineral reconstruction of the primary clay fraction and some detrital minerals in the course of postsedimentary transformations of rocks during diagenesis, early catagenesis, and beginning of late catagenesis. These transformations were governed by several factors, such as the composition of sediments; hydrochemical features of accumulation environment; the chemical composition, dynamics, and feeding sources of pore solutions; the porosity and permeability of sediments and rocks; and the content of organic matter and its reaction ability.     

Snow measurement techniques for land-surface-atmosphere exchange studies in boreal landscapes

Summary  Snow has been studied widely in hydrology for many decades whereas recent meteorological interest in snow is caused by increased emphasis on high latitudes and wintertime in climate-change research as well as by the need to improve weather-forecast models during these conditions. Ground-based measurements of snow properties are needed both to improve understanding of surface-atmosphere exchange processes and to provide ground truth to new remote-sensing algorithms. This justifies a review of techniques to measure snow in combination with establishment of criteria for the suitability of the methods for process studies. This review assesses the state-of-art in ground-based snow-measurement techniques in the end of the 1990s in view of their accuracy, time resolution, possibility to automate, practicality and suitability in different terrain. Methods for snow-pack water equivalent, depth, density, growth, quality, liquid-water content and water leaving the snow pack are reviewed. Synoptic snow measurements in Fennoscandian countries are widely varying and there is no single standard on which process-related studies can build. A long-term, continuous monitoring of mass and energy properties of a snow cover requires a combination of point-measurement techniques. Areally representative values of snow properties can be achieved through a combination of automatically collected point data with repeated manual, areally covering measurements, remote-sensing data and digital elevation models, preferably in a GIS framework. Received August 27, 1999     

Improved Petrological Modal Analyses from X-ray Powder Diffraction Data by use of the Rietveld Method I. Selected Igneous, Volcanic, and Metamorphic Rocks

Mineral modes have been determined for specimens of eight rocktypes from CuK X-ray powder diffraction data using the Rietveldmethod. The samples include two granites, a granodiorite, adamellite,gabbro, basalt, trachyte, and two granulite-facies metamorphicrocks. Up to eight individual mineral components have been measuredin each sample (no glassy phases were observed), with a detectionlimit of {small tilde}1 wt.%, depending on the mineral assemblage.Marked variations in grain size (i.e., granite vs. trachyte)provide no difficulties for the X-ray method. The X-ray resultscompare very favourably with (1) optical modes determined forthe medium–coarse-grained samples by point counting, (2)normative calculations obtained using locally enhanced catanormand mesonorm software, and (3) corresponding Rietveld modesdetermined, for two samples, from neutron powder data. Wheredifferences occur, these are discussed in relation to the limitationsof each of the methods. The improved accuracy of the X-ray method is due primarily tothe incorporation of the full diffraction profile in the Rietveldanalysis calculations, and the elimination of preferred orientationby collecting the data from samples packed in glass capillaries(i.e., Debye–Scherrer mode). The good agreement of theX-ray and neutron modes shows that the usual problems encounteredwith microabsorption, extinction, and sampling are of littleconcern in these rocks. The results highlight one of the majoradvantages provided by Rietveld modal analysis over the moretraditional ‘reference intensity’ X-ray methods,namely, that the crystal chemistry (and thus the calibrationconstants) of the individual phases can be adjusted dynamicallyduring each individual analysis. This not only provides moreaccurate phase abundances, but also gives important supplementaryinformation about the mineralogy of the major components.     

A case study of warm air advection over a melting snow surface

When relatively warm, moist air moves over a snow surface, sensible heat and moisture are extracted from its lower layers and used to melt the snow. The depth of the cooled layer depends on horizontal wind speeds and the presence of high vertical wind shear. The mechanism for air mass modification appears to be turbulent mixing.     

Desert vegetation and timing of solar radiation

Timing and amount of solar radiation were examined as factors influencing the distribution of seven perennial plants on a small mountain located in the Chihuahuan Desert. Average direct beam solar radiation fluxes at differing times throughout the day and year were estimated with computer calculations. Principal components analysis was used to reduce the number of solar radiation parameters and include the maximum available information with a manageable number of variables. The remaining solar radiation parameters were compared to plant distributions using redundancy analysis and generalized additive models. Unimodal, bimodal, and monotonic responses were all found depending upon the species and solar radiation parameter. Niche separation at this location depends upon the timing as well as the amount of solar radiation.     

Investigation of submicron volcanic aerosol-particles by photoelectron emission

Volcanic aerosol emissions have been studied for the first time by in situ photoelectric charging. Explorative studies on Mt Etna reveal large concentrations of particles below 1000 nm with the spectrum peaking in the size range of 100–1000 nm diameter. Although a large fraction of the particles is already charged upon emission, the net electrical charge carried by the aerosol turned out to be close to zero.Particles with high photoelectric yield vary greatly in their relative abundance and seem to occur mainly at active points of the volcano.     

Use of Rhodamine water tracer in the marshland upwelling system

Rhodamine water tracer (RWT) was used to characterize the migration of waste water within the saline subsurface of a marshland upwelling system (MUS), which is an alternative on-site waste water treatment system for coastal areas. Field tracer studies were performed to investigate the fresh waste water plume movement within the saline ground water. Pore velocities were calculated using first detection times and ranged from 0.68 to 10.7 x 10(-4) cm/sec for the loamy sandy soil matrix present at the site. Use of RWT in the field also allowed determination of main and preferential flowpaths. One- and two-dimensional laboratory experiments were performed using silica sand to investigate the interactions of the organically rich waste water with RWT within the zone surrounding the point of injection (one-dimensional) and the impact of background salinity on plume movement (two-dimensional). The results from these studies were used to help explain the field data. One-dimensional breakthrough curves revealed retardation factors for the RWT in the waste water mixture of 1.73 to 1.90. These results were similar to other researchers, indicating little interaction between the waste water and RWT. Variations in pore water salinity (5, 15, 25, and 35 ppt) were found to have a significant effect on pore water velocities of the fresh water plume (two-dimensional), indicating the need to incorporate background salinities into the design process for MUS.