Numerical simulation of the genesis of typhoon Durian (2001) over the South China Sea: The effect of sea surface temperature

Typhoon Durian (2001),which formed over the South China Sea (SCS),was simulated by using the Weather Research and Forecasting (WRF) model. The genesis of typhoon Durian which formed in the monsoon trough was reproduced by numerical simulations. The simulated results agree reasonably well with observations. Two numerical experiments in which the sea surface temperature (SST) was either decreased or increased were performed to investigate the impact of the SST on the genesis of the ty-phoon. When the SST was decreased by 5℃ uniformly for all grids in the model,the winds calculated became divergent in the lower troposphere and convergent in the upper troposphere,creating conditions in which the amount of total latent heat release (TLHR) was low and the tropical cyclone (TC) could not be formed. This simulation shows the importance of the convergence in the lower tropo-sphere and the divergence in the upper troposphere for the genesis of the initial vortex. When the SST was increased by 1℃ uni-formly for all grids,a stronger typhoon was generated in the results with an increase of about 10 m s-1 in the maximum surface wind speed. Only minor differences in intensity were noted during the first 54 h in the simulation with the warmer SST,but apparent dif-ferences in intensity occurred after 54 h when the vortex began to strengthen to typhoon strength. This experiment shows that warmer SST will speed the strengthening from tropical storm strength to typhoon strength and increase the maximum intensity reached,while only minor impact can be seen during the earlier stage of genesis before the TC reaches the tropical storm strength. The results sug-gest that the amount of TLHR may be the dominant factor in determining the formation and the intensification of the TC.     

Assessment on agricultural drought risk based on variable fuzzy sets model

Drought is one of the major natural disasters causing huge agricultural losses annually. Regional agricultural drought risk assessment has great significance for reducing regional disaster and agricultural drought losses. Based on the fuzzy characteristics of agricultural drought risk, variable fuzzy sets model was used for comprehensively assessing agricultural drought risk of Liaoning Province in China. A multi-layers and multi-indices assessment model was established according to variable fuzzy sets theory, and agricultural drought risk of all 14 prefecture-level cities was respectively estimated in terms of dangerousness, vulnerability, exposure and drought-resistibility. By calculating the combination weights of four drought risk factors, agricultural drought risk grade of each city was obtained. Based on the assessment results, the spatial distribution maps of agricultural drought risk were drawn. The results shows that eastern cities have lower drought dangerousness than western cities in Liaoning Province totally. Most cities are located in low drought vulnerability region and high drought exposure region. Because of frequent and severe drought since 2000, most cities are located in lower drought-resistibility region. Comprehensive agricultural drought risk presents apparent spatial characteristics, escalating from the east to the west. Drought dangerousness is the most important factor influencing comprehensive agricultural drought risk. Through the spatial distribution maps of drought risk, decision makers could find out drought situation and make decisions on drought resistance conveniently.     

Application of stable isotope techniques in studies of carbon and nitrogen biogeochemical cycles of ecosystem

Stable isotope techniques have been proved useful as tools for studying the carbon (C) and nitrogen (N) biogeochemical cycles of ecosystem. This paper firstly introduced the basic principles and the distribution characteristics of stable isotope, then reviewed the recent advances and applications of stable isotope in the C and N biogeochemical cycles of ecosystem. By applying the 13 C natural abundance technique, ecologists are able to understand the photosynthetic path and CO 2 fixation of plants, the CO 2 exchange and C balance status of ecosystem, the composition, distribution and turnover of soil organic C and the sources of organic matter in food webs, while by using the 13 C labeled technique, the effects of elevated CO 2 on the C processes of ecosystem and the sources and fate of organic matter in ecosystem can be revealed in detail. Differently, by applying the 15 N natural abundance technique, ecologists are able to analyze the biological N 2 -fixation, the N sources of ecosystem, the N transformation processes of ecosystem and the N trophic status in food webs, while by using the 15 N labeled technique, the sources, transformation and fate of N in ecosystem and the effects of N input on the ecosystem can be investigated in depth. The applications of both C and N isotope natural abundance and labeled techniques, combined with the elemental, other isotope ( 34 S) and molecular biomarker information, will be more propitious to the investigation of C and N cycle mechanisms. Finally, this paper concluded the problems existed in current researches, and put forward the perspective of stable isotope techniques in the studies on C and N biogeochemical cycles of ecosystem in the future.     

Concentrations and sources of polycyclic aromatic hydrocarbons in topsoil of Benxi City,Northeast China

Polycyclic aromatic hydrocarbons (PAHs) contamination of topsoil in Benxi City, Northeast China was investigated in this study, and sampling sites were located in industrial area and residential area. Results demonstrate that there is high variability in the total PAHs concentrations, ranging from 783.00 ng/g to 729 076.29 ng/g dry weight in the topsoil of Benxi City and the pollution in industrial area is the most serious. The results also present that higher molecular weight PAHs (4–6 rings) contribute substantially (79.03%) to the overall content of PAHs. The PAHs sources were determined with factor analysis by nonnegative constraints, and the results show that PAHs originating from traffic tunnel, power plant, coke oven and residential emission sources, account for 27.10%, 40.81%, 20.11% and 11.98%, respectively, of the total. The PAHs pollution is the most serious around Benxi Iron and Steel Group Corporation, and the PAHs mainly originate from coke oven and traffic tunnel, with the average contribution rate of 57.40% and 42.60%, respectively. The source apportionment results are basically consistent with the industry distribution, and the geographical and climatic characteristics of the study area.     

Corrosion behavior of anodic oxidized TiO<Subscript>2</Subscript> film in seawater

TiO₂ films were formed on metallic titanium substrates by the anodic oxidation method in H₂SO₄ solution under the 80V D.C.. Phase component and microstructure were characterized by X-ray diffraction (XRD) and scanning electron microscopy (SEM). Water contact angles on titanium oxide film surface were measured under both dark and sunlight illumination conditions. Corrosion tests were carried out in seawater under different illumination conditions by electrochemistry impedance spectrum (EIS) and polarization curves. The result showed that the TiO₂ film prepared by the anodic oxidation method was anatase with a uniform structure and without obvious pores or cracks on its surface. The average water contact angle of the film was 116.4° in dark, in contrast to an angle of 42.7° under the UV illumination for 2 hours, which demonstrates good hydrophobic property. The anti-corrosion behavior of the TiO₂ film was declining with the extended immersion time. Under dark conditions, however, the hydrophobic TiO₂ film retarded the water infiltrating into the substrate. The impedance changed slowly and the corrosion current density was 2 orders of magnitude lower than that with the film illuminated by sunlight. All of those mentioned above indicate that the TiO₂ film possesses much better performance under dark condition, and it can be applied as an engineering material under dark seawater environment.     

Effects of dietary β-glucan and glycyrrhizin on non-specific immunity and disease resistance of the sea cucumber (<Emphasis Type="Italic">Apostichopus japonicus</Emphasis> Selenka) challenged with <Emphasis Type="Italic">Vibrio splendidus</Emphasis>

Sea cucumbers, Apostichopus japonicus Selenka, were fed diets containing non-immunostimulant (basal diet), 0.2% β-glucan and 0.02% glycyrrhizin in a recirculatory water system for 45 days, and subsequently challenged with Vibrio splendidus by injection at 1.0×10⁸ cfu / sea cucumber for 15 days. Phagocytic capacity (PC), intracellular superoxide anion production (ISAP), lysozyme (LSZ) activity and superoxide dismutase (SOD) activity in the coelomic fluid were analyzed on the 0^th, 5^th, 10^th and 15^th days after injection. Results showed that after the 45-day feeding period, PC, ISAP, LSZ activity and SOD activity in sea cucumbers fed with dietary β-glucan or glycyrrhizin were significantly higher than in those fed with the basal diet. On the 5th day after infection, all the immune parameters examined in the sea cucumbers injected with V. splendidus decreased in value significantly. On the 15^th day, PC, ISAP and LSZ activity returned to levels similar to those on the 0^th day. For the sea cucumbers injected with saline, there were no significant differences in all the immune parameters examined and in the cumulative morbidity during the 15-day challenging trial. After injecting with V. splendidus, the cumulative morbidity of sea cucumbers fed with the basal diet was significantly higher than those fed with dietary β-glucan or glycyrrhizin when challenged with V. splendidus challenged sea cucumber fed with the basal diet was significantly higher than those fed with dietary β-glucan or glycyrrhizin. There was no significant difference in cumulative morbidity between the dietary β-glucan and glycyrrhizin treatments over time.     

Fault type analysis along the San Andreas Fault zone: A numerical approach

Finite Element (FE) modeling under plane stress condition is used to analyze the fault type variation with depth along and around the San Andreas Fault (SAF) zone. In this simulation elastic rheology was used and was thought justifiable as the variation in depth from 0.5 km to 20 km was considered. Series of calculations were performed with the variation in domain properties. Three types of models were created based on simple geological map of California, namely, 1) single domain model considering whole California as one homogeneous domain, 2) three domains model including the North American plate, Pacific plate, and SAF zone as separate domains, and 3) Four domains model including the three above plus the Garlock Fault zone. Mohr-Coulomb failure criterion and Byerlee's law were used for the calculation of failure state. All the models were driven by displacement boundary condition imposing the fixed North American plate and Pacific plate motion along N34°W vector up to the northern terminus of SAF and N50°E vector motion for the subducting the Gorda and Juan de Fuca plates. Our simulated results revealed that as the depth increased, the fault types were generally normal, and at shallow depth greater strike slip and some thrust faults were formed. It is concluded that SAF may be terminated as normal fault at depth although the surface expression is clearly strike slip.     

Micromorphological features of diagnostic horizons in several soils in southwest China: Implication for soil taxonomic classification

The comparative studies on micromorphological features in diagnostic horizons of Stagnic Anthrosols, Ustic Ferrosols and Ustic Vertosols in southwestern China were conducted to underpin the rationale for Chinese Soil Taxonomy. The following findings were explored: (1) Stagnic Anthrosols had the specific micromorphological features, e.g., the humic formation in anthrostagnic epipedon, the platy structures in plow subhorizon, the secondary formation of ferromanganese and the weakly optical-orientation clay do...     

Technique for Controlling Spread of Limnotic Oncomelania

Schistosomiasis is a parasitic disease mostly found in areas along the Changjiang River of China. The disease is spread solely through an intermediary named oncomelania, so its spread of schistosomiasis can be controlled by properly designing water intakes which prevent oncomelania from entering farming land or residential areas. This paper reports a successful design process and a new oncomelania-free intake device. The design of the new intake is based on a sound research program in which extensive experimental studies were carried out to gain knowledge of oncomelania eco-hydraulic behavior and detailed flow field information through CFD simulation.     

Is Precipitation the Dominant Controlling Factor of High Inorganic Nitrogen Content in the Changjiang River and Its Mouth？

The main reasons for the high content of inorganic N and its increase by several times in the Changjiang River and its mouth during the last 40 years were analysed in this work. The inorganic N in precipitation in the Changjiang River catchment mainly comes from gaseous loss of fertilizer N, N resulting from the increases of population and livestock, and from high temperature combustions of fossil fuels. N from precipitation is the first N source in the Changjiang River water and the only direct cause of high content of inorganic N in the Changjiang River and its mouth. The lost N in gaseous form and from agriculture non-point sources fertilizer comprised about 60% of annual consumption of fertilizer N in the Changjiang River catchment and were key factors controlling the high content of inorganic N in the Changjiang River mouth. The fate of the N in precipitation and other N sources in the Changjiang River catchment are also discussed in this paper.