Glacio-lacustrine stratigraphy,aquifer characterization and contaminant transport: a case study in South Lake Tahoe,California, USA

A hydrogeologic model that has been used by many researchers and consultants to describe an area of South Lake Tahoe, California, USA impacted by MTBE contamination describes a relatively homogeneous unconfined aquifer comprised of poorly sorted glacial outwash deposits, within which water-supply wells are able to exert significant alteration in natural groundwater flow. A re-examination of the area’s hydrogeology is presented, which supports a layered heterogeneous aquifer system constructed of alternating fine and coarser-grained glacio-lacustrine depositional units. This re-evaluation was accomplished through a review of lithologic logs across an area of approximately 1 km², combined with observations of significant hydraulic head differences and knowledge of the depositional environments controlled by Pleistocene Lake Tahoe high stands. Many of the fine-grained units observed at depths from 6 to 15 m, although relatively thin, are generally continuous and serve as significant barriers to groundwater flow. The vertical migration of contamination across these fine-grained units to deeper groundwaters was facilitated by cross-screened monitoring wells installed as part of site investigation activities. This conclusion highlights the importance of geologic characterization and proper monitoring well construction at contaminated site investigations.

---

Electronic supplementary material   The online version of this article (doi:) contains supplementary material, which is available to authorized users.

Bringing GPS into harsh environments for fully automated deformation monitoring

Engineering projects that require deformation monitoring frequently utilize geodetic sensors to measure displacements of target points located in the deformation zone. In situations where control stations and targets are separated by a kilometer or more, GPS can offer higher precision position updates at more frequent intervals than can normally be achieved using total station technology. For large-scale deformation projects requiring the highest precision, it is therefore advisable to use a combination of the two sensors. In response to the need for high precision, continuous GPS position updates in harsh deformation monitoring environments, a software has been developed that employs triple-differenced carrier-phase measurements in a delayed-state Kalman filter. Two data sets were analyzed to test the capabilities of the software. In the first test, a GPS antenna was displaced using a translation stage to mimic slow deformation. In the second test, data collected at a large open pit mine were processed. It was shown that the delayed-state Kalman filter developed could detect millimeter-level displacements of a GPS antenna. The actual precision attained depends upon the amount of process noise infused at each epoch to accommodate the antenna displacements. Higher process noise values result in quicker detection times, but at the same time increase the noise in the solutions. A slow, 25 mm displacement was detected within 30 min of the full displacement with sigma values in E, N and U of ±10 mm or better. The same displacement could also be detected in less than 5 h with sigma values in E, N and U of ±5 mm or better. The software works best for detecting long period deformations (e.g., 20 mm per day or less) for which sigma values of 1–2 mm are attained in all three solution components. It was also shown that the triple-differenced carrier-phase observation can be used to significantly reduce the effects of residual tropospheric delay that would normally plague double-differenced observations in harsh GPS environments.

模拟GPS精密测量系统误差的若干问题

讨论了模拟ＧＰＳ精密测量系统误差的一些主要问题．文中用了两个实例，一个是南美洲某油田地面沉陷监测网，另一个是美国超级超导对撞机ＧＰＳ地面控制网．     

When the Sun died over northern Europe: the unique geology of Denmark's inland islands

Most geologists asked to comment on the geology of Denmark would probably think of Cretaceous Chalk and Pleistocene glacial deposits. Today, many will perhaps be familiar with the Cretaceous–Tertiary boundary clay at Stevns Klint, which has played a prominent role in the discussions regarding the mass extinction event at this time (the ever popular 'end of the dinosaurs'). Few would perhaps think of volcanic or tectonic phenomena, although, in fact, outstanding localities for these processes are to be found here, documenting a time when dense volcanic ash clouds drifted over north-west Europe.     

Northwest Africa 1500: Plagioclase‐bearing monomict ureilite or ungrouped achondrite?

Abstract— Northwest Africa (NWA) 1500 is an ultramafic meteorite dominated by coarse (?100–500 μm) olivine (95–96%), augite (2–3%), and chromite (0.6–1.6%) in an equilibrated texture. Plagioclase (0.7–1.8%) occurs as poikilitic grains (up to ?3 mm) in vein‐like areas that have concentrations of augite and minor orthopyroxene. Other phases are Cl‐apatite, metal, sulfide, and graphite. Olivine ranges from Fo 65–73, with a strong peak at Fo 68–69. Most grains are reversezoned, and also have ?10–30 μm reduction rims. In terms of its dominant mineralogy and texture, NWA 1500 resembles the majority of monomict ureilites. However, it is more ferroan than known ureilites (Fo ≥75) and other mineral compositional parameters are out of the ureilite range as well. Furthermore, neither apatite nor plagioclase have ever been observed, and chromite is rare in monomict ureilites. Nevertheless, this meteorite may be petrologically related to the rare augite‐bearing ureilites and represent a previously unsampled part of the ureilite parent body (UPB). The Mn/Mg ratio of its olivine and textural features of its pyroxenes are consistent with this interpretation. However, its petrogenesis differs from that of known augite‐bearing ureilites in that: 1) it formed under more oxidized conditions; 2) plagioclase appeared before orthopyroxene in its crystallization sequence; and 3) it equilibrated to significantly lower temperatures (800–1000 °C, from two‐pyroxene and olivine‐chromite thermometry). Formation under more oxidized conditions and the appearance of plagioclase before orthopyroxene could be explained if it formed at a greater depth on the UPB than previously sampled. However, its significantly different thermal history (compared to ureilites) may more plausibly be explained if it formed on a different parent body. This conclusion is consistent with its oxygen isotopic composition, which suggests that it is an ungrouped achondrite. Nevertheless, the parent body of NWA 1500 may have been compositionally and petrologically similar to the UPB, and may have had a similar differentiation history.     

Contact Partial Melting of Granitic Country Rock, Melt Segregation, and Re-injection as Dikes into Ferrar Dolerite Sills, McMurdo Dry Valleys, Antarctica

Numerous, interconnected, granitic dikes (<30 cm in widthand hundeds of meters in length) cut Ferrar dolerite sills ofthe McMurdo Dry Valleys, Antarctica. The source of the graniticdikes is partial melting of granitic country rock, which tookplace in the crust at a depth of about 2–3 km adjacentto contacts with dolerite sills. Sustained flow of doleriticmagma through the sill generated a partial melting front thatpropagated into the granitic country rock. Granitic partialmelts segregated and collected at the contact in a melt-rich,nearly crystal-free reservoir adjacent to the initial doleritechilled margin. This dolerite chilled margin was subsequentlyfractured open in the fashion of a trapdoor by the graniticmelt, evacuating the reservoir to form an extensive complexof granitic dikes within the dolerite sills. At the time ofdike injection the dolerite was nearly solidified. Unusuallycomplete exposures allow the full physical and chemical processesof partial melting, segregation, and dike formation to be examinedin great detail. The compositions of the granitic dikes andthe textures of partially melted granitic wall rock suggestthat partial melting was characterized by disequilibrium mineraldissolution of dominantly quartz and alkali feldspar ratherthan by equilibrium melting. It is also unlikely that meltingoccurred under water-saturated conditions. The protolith granitecontains only 7 vol.% biotite and estimated contact temperaturesof 900–950°C suggest that melting was possible ina dry system. Granite partial melting, under closed conditions,extended tens of meters away from the dolerite sill, yet meltsegregation occurred only over less than one-half a meter fromthe dolerite chilled margin where the degree of partial meltingwas of the order of 50 vol.%. This segregation distance is consistentwith calculated length scales expected in a compaction-drivenprocess. We suggest that the driving force for compaction wasdifferential stress generated by a combination of volume expansionas a result of granite partial melting, contraction during doleritesolidification, and relaxation of the overpressure driving doleriteemplacement. On a purely chemical basis, the extent of meltsegregation necessary under fractional and batch melting tomatch the Rb concentrations between melt and parent rock isa maximum of 48 and 83 vol.% melt, respectively. KEY WORDS: Antarctica; dike injection; disequilibrium; granite partial melting; silicic melt segregation     

Unveiling the atmospheres of giant exoplanets with an EChO-class mission

More than a thousand exoplanets have been discovered over the last decade. Perhaps more excitingly, probing their atmospheres has become possible. With current data we have glimpsed the diversity of exoplanet atmospheres that will be revealed over the coming decade. However, numerous questions concerning their chemical composition, thermal structure, and atmospheric dynamics remain to be answered. More observations of higher quality are needed. In the next years, the selection of a space-based mission dedicated to the spectroscopic characterization of exoplanets would revolutionize our understanding of the physics of planetary atmospheres. Such a mission was proposed to the ESA cosmic vision program in 2014. Our paper is therefore based on the planned capabilities of the Exoplanet Characterization Observatory (EChO), but it should equally apply to any future mission with similar characteristics. With its large spectral coverage (0.4 ? 16 μm), high spectral resolution (λ/Δλ > 300 below 5 μm and λ/Δλ > 30 above 5 μm) and 1.5m mirror, a future mission such as EChO will provide spectrally resolved transit lightcurves, secondary eclipses lightcurves, and full phase curves of numerous exoplanets with an unprecedented signal-to-noise ratio. In this paper, we review some of today’s main scientific questions about gas giant exoplanets atmospheres, for which a future mission such as EChO will bring a decisive contribution.     

Real-time multi-model decadal climate predictions

We present the first climate prediction of the coming decade made with multiple models, initialized with prior observations. This prediction accrues from an international activity to exchange decadal predictions in near real-time, in order to assess differences and similarities, provide a consensus view to prevent over-confidence in forecasts from any single model, and establish current collective capability. We stress that the forecast is experimental, since the skill of the multi-model system is as yet unknown. Nevertheless, the forecast systems used here are based on models that have undergone rigorous evaluation and individually have been evaluated for forecast skill. Moreover, it is important to publish forecasts to enable open evaluation, and to provide a focus on climate change in the coming decade. Initialized forecasts of the year 2011 agree well with observations, with a pattern correlation of 0.62 compared to 0.31 for uninitialized projections. In particular, the forecast correctly predicted La Niña in the Pacific, and warm conditions in the north Atlantic and USA. A similar pattern is predicted for 2012 but with a weaker La Niña. Indices of Atlantic multi-decadal variability and Pacific decadal variability show no signal beyond climatology after 2015, while temperature in the Niño3 region is predicted to warm slightly by about 0.5 °C over the coming decade. However, uncertainties are large for individual years and initialization has little impact beyond the first 4 years in most regions. Relative to uninitialized forecasts, initialized forecasts are significantly warmer in the north Atlantic sub-polar gyre and cooler in the north Pacific throughout the decade. They are also significantly cooler in the global average and over most land and ocean regions out to several years ahead. However, in the absence of volcanic eruptions, global temperature is predicted to continue to rise, with each year from 2013 onwards having a 50 % chance of exceeding the current observed record. Verification of these forecasts will provide an important opportunity to test the performance of models and our understanding and knowledge of the drivers of climate change.     

Predicting June Mean Rainfall in the Middle/Lower Yangtze River Basin

We demonstrate that there is significant skill in the GloSea5 operational seasonal forecasting system for predicting June mean rainfall in the middle/lower Yangtze River basin up to four months in advance. Much of the rainfall in this region during June is contributed by the mei-yu rain band. We find that similar skill exists for predicting the East Asian summer monsoon index(EASMI) on monthly time scales, and that the latter could be used as a proxy to predict the regional rainfall. However, th...