Coal-measure source rock characteristics and burial evolution history in the Shisanjianfang Area,Tuha Basin

Shisanjianfang Area in the eastern margin of Taibei Sag, Tuha Basin, is an important region for oil and gas exploration. In this study, a large number of source rock geochemical data were used to analyze the geochemical characteristics of coal-measure source rocks in the Shisanjianfang Area, Tuha Basin, from three aspects, i.e., organic matter abundance, organic matter type, and organic maturity. The results show that the Jurassic Xishanyao Formation (J₂x) in the study area has great thickness, continuous distribution, and high source rock maturity, and is the major source rock horizon in the study area. The seismic data are used in combination with 1D and 2D basin simulation technology to study the distribution characteristics of the source rocks in Shisanjianfang Area. The results of the simulation research on the source rock maturity history in the study area indicate the following: (1) The source rocks in the Xishanyao Formation (J₂x) have a hydrocarbon generation threshold depth of 1800 m, threshold temperature of 95 °C, and hydrocarbon generation threshold time of about 162 Ma. (2) The Xishanyao Formation (J₂x) has a current formation temperature of 50~110 °C and Ro of 0.6~1.1 % in the peak oil generation stage. (3) The source rock maturity in the study area is shown as being higher in the west while lower in the east, and higher in the north while lower in the south, and the favorable exploration area mainly lies in the northwest of the study area. The results of this study could have important implications for the oil and gas exploration in the margins of Xiaocaohu Sag, Tuha Basin.     

Complexity measurement of regional groundwater resources system using improved Lempel-Ziv complexity algorithm

In this paper, the self-adaptive artificial fish swarm algorithm (SAAFSA) is used to optimize the coarse graining of segment numbers, which are used in the Lempel-Ziv complexity algorithm. This approach improves the Lempel-Ziv complexity (LZC) algorithm of equal probability coarse graining. As a case study, the complexities of monthly series of groundwater depth were analyzed at seven farms in the Hongxinglong Administration. GIS technology was used to create spatial distributions of monthly groundwater depths. A projection pursuit model based on the SAAFSA was established and used for complexity attribution analysis at selected farms with different degrees of complexity. The three selected farms, Hongqiling, 852, and Youyi, each represent a certain degree of complexity. Further analysis shows that precipitation, evaporation, temperature, and human activities are the primary factors that cause complexity variations in local groundwater depth. The results reveal the evolution of the complexity characteristics of local groundwater depth and provide scientific evidence for the need to effectively allocate regional water resources. Additionally, the proposed method can be applied in complexity analyses of other hydrologic features, as well as in research regarding nonlinear time series in economic, engineering, medical, and signal analyses.     

Facies analysis and sequence stratigraphy of Kometan Formation (Upper Cretaceous) in the imbricated zone,northeastern Iraq

Facies and sequence stratigraphic analysis of the Kometan Formation (Upper Cretaceous) were studied from Kometan village, Kurdistan region of northeastern Iraq. Lithologically, the formation consists of 44 m of white weathering, light grey, thin to medium-bedded highly fractured limestones with chert nodules. Petrographic study of the carbonates shows that both skeletal and non-skeletal grains were present. The skeletal grains include a variety of planktonic foraminifera (including Oligostegina), calcispheres, ostracods, pelecypods, larva ammonite, and echinoderms. Non-skeletal grains include peloids only. Three main microfacies types are distinguished in the studied formation. The results of stable carbon and oxygen isotopes of the studied carbonate samples show negative values of δ¹⁸O. These indicate that the seawater was warm with low salinity during precipitation of the carbonates in the Kometan Formation in northeastern Iraq. The positive δ¹³C values of carbonate samples, in the middle part of the formation, reflect the widespread deposition of organic-rich marine sediments during a transgression and deepening of the basin. Petrographic, facies and stable isotopic analyses revealed that the Kometan Formation was deposited in a warm, basinal, pelagic (open marine) environment with low salinity. The Kometan Formation consists of one complete third-order depositional sequence, separated by a sequence boundary (SB) of type 2. The third-order sequence is subdivided into a transgressive systems tract (TST) and highstand systems tract (HST). This reflects episodes of transgression and still stands of the relative sea level. The TSTs are topped by maximum flooding surface (MFS) characterized by deepening-/fining-upward parasequences implying a retrogradational stacking pattern. The HST is marked by shallowing-/coarsening-upward parasequences implying a progradational stacking pattern.     

Using cloud water path and cloud top temperature for estimating convective and stratiform rainfall from SEVIRI daytime data

A satellite rainfall retrieval technique is proposed here. The relationships of rain rate with each of cloud water path (CWP) and cloud top temperature (CTT) are investigated. The CWP and CTT are retrieved from SEVIRI data (spinning enhanced visible and infrared imager), and corresponding rain rates are measured by weather radar. The rain rates are compared to corresponding CWP and then to corresponding CTT. The investigation demonstrates an exponential functional dependency between rain rates and CWP for low and moderate rain rates (stratiform rainfall). Conversely, the rain rates are more closely related to CTT for high rain rates (convective rainfall). Therefore, two separate relationships are established for rain rate retrievals. The results show rain rates estimated by the developed scheme are in good correlation with those observed by weather radar.     

Regional debris flow susceptibility analysis based on principal component analysis and self-organizing map: a case study in Southwest China

A method was developed to analyze the susceptibilities of 541 regional basins affected by debris flows at the Wudongde Dam site in southwest China. Determining susceptibility requires information on source material quantity and occurrence frequency. However, the large number of debris flows can hinder the individual field investigation in a each small basin. Factors that may trigger debris flows can be identified using remotely sensed interpretation information. Susceptibility analysis can then be conducted based on these factors. In this study, SPOT5 satellite imagery, digital elevation models (DEM), a lithology distribution map, and rainfall monitoring data were used to identify 12 debris flow trigger factors: basin relief ratio, slope gradient in the initiation zone, drainage density, downslope curvature of the main channel, vegetation coverage, main channel aspect, topographic wetness index, Melton’s ruggedness number, lithology, annual rainfall, form factor, and cross-slope curvature of the transportation zone. Principal component analysis was used to obtain the eight principal components of these factors that contribute to susceptibility results. Then, a self-organizing map method was adopted to analyze the principal components, which resulted in a debris flow susceptibility classification. Field validation of 26 debris flow basins was used to evaluate the errors of the susceptibility classification, as well as assess the causes of such errors. The study found that principle component analysis and self-organizing map methodologies are good predictors of basin susceptibility to debris flows.     

Ground penetrating radar and 2D electric resistivity studies for tracing hydrocarbon leakage site,close to Abha City: a case study

This work presents the application of the ground-penetrating radar (GPR) method and electric resistivity tomography (ERT) technique in outlining a zone of contamination due to the light non-aqueous phase liquid (LNAPL) plume underground in the area of an impacted fuel station, close to Abha City. The GPR has been performed using SIR3000 unit with the 100 and 400 MHz antennas. The main objective of the GPR survey was to evaluate the lateral extension of contamination. The complex GPR signature of the plume was well characterized. Low reflectivity zone corresponds to hydrocarbon vapor phase in the vadose zone. Enhanced reflections are associated with free and residual products in the fractured saturated zone directly above the water table. An electric resistivity tomography (ERT) survey was performed on four profiles within the site to investigate the vertical and horizontal extent of the contamination plume and to define the bottom of the landfill. The 2D electric profiles show the presence of low-resistivity (4O to 37 Ω m) anomalies that refers to the presence of accumulated hydrocarbons. From the interpretation of the GPR and ERT profile, it was possible to locate the top and bottom of the contamination plume of the waste disposal site. The radar signal penetrated deep enough and enabled the identification of a second reflector at approximately 10-m deep, interpreted as the hard basement surface which causes the strong amplitude reflection in the GPR profile. The results of GPR and ERT showed good agreement.     

Sequence stratigraphic analysis of Eocene Rock Strata,Offshore Indus,southwest Pakistan

In this study, seismic data from two wells (Pak G2-1 and Indus Marine-1C) and age diagnostic larger benthic foraminifera (LBF) within drill cuttings has been used for the first time to identify depositional sequences within the carbonates in the Offshore Indus Basin, Pakistan. The Offshore Indus is tectonically categorized as a passive continental margin where carbonates occur as shelf carbonates in the near offshore and on volcanic seamounts in deeper waters. Seismic data analysis has indicated the presence of minor faults and carbonate buildups above the igneous basement in the south. Patterns of the seismic reflections enabled definition of three seismic facies units identified as: Unit 1 basement, represented by chaotic, moderate amplitude reflection configuration; while parallel bedding and the drape of overlying strata is typical character of Unit 2, carbonate mound facies. The younger Miocene channels represent Unit 3. The diagnosis of Alveolina vredenburgi/cucumiformis biozone confirmed the Ilerdian (55–52 Ma) stage constituting a second order cycle of deposition for the Eocene carbonates (identified as Unit 2). The carbonate succession has been mainly attributed to an early highstand system tract (HST). The environmental conditions remained favorable leading to the development of keep-up carbonates similar to pinnacle buildups as a result of aggradation during late transgressive system tract and an early HST. The carbonate sequence in the south (Pak G2-1) is thicker and fossiliferous representing inner to middle shelf depths based on fauna compared to the Indus Marine-1C in the north, which is devoid of fossils. Three biozones (SBZ 5, SBZ 6 and SBZ 8) were identified based on the occurrence of LBF. The base of the SBZ 5 zone marks the larger foraminifera turnover and the Paleocene–Eocene (P–E) boundary. The LBF encountered in this study coincides with earlier findings for the P–E boundary. Our findings indicate that the entire Ilerdian stage ranges from 55.5 to 52 Ma that was the episode of warmer water conditions on the carbonate shelves leading to the diversification of K-strategist larger foraminifera. The larger foraminiferal assemblage encountered in this study confirms the findings. The possible indication of stratigraphic-combination traps, revealed as reflection terminations, make carbonate mounds in the south a potential exploration target.     

Heat and mass transfer effects during displacement of deepwater methane hydrate to the surface of Lake Baikal

The present paper focuses on heat and mass exchange processes in methane hydrate fragments during in situ displacement from the gas hydrate stability zone (GHSZ) to the water surface of Lake Baikal. After being extracted from the methane hydrate deposit at the lakebed, hydrate fragments were placed into a container with transparent walls and a bottom grid. There were no changes in the hydrate fragments during ascent within the GHSZ. The water temperature in the container remained the same as that of the ambient water (~3.5 °С). However, as soon as the container crossed the upper border of the GHSZ, first signs of hydrate decomposition and transformation into free methane gas were observed. The gas filled the container and displaced water from it. At 300 m depth, the upper and lower thermometers in the container simultaneously recorded noticeable decreases of temperature. The temperature in the upper part of the container decreased to –0.25 °С at about 200 m depth, after which the temperature remained constant until the water surface was reached. The temperature at the bottom of the container reached –0.25 °С at about 100 m depth, after which it did not vary during further ascent. These observed effects could be explained by the formation of a gas phase in the container and an ice layer on the hydrate surface caused by heat consumption during hydrate decomposition (self-preservation effect). However, steady-state simulations suggest that the forming ice layer is too thin to sustain the hydrate internal pressure required to protect the hydrate from decomposition. Thus, the mechanism of self-preservation remains unclear.     

Modern modes of provenance and dispersal of terrigenous sediments in the North Pacific and Bering Sea: implications and perspectives for palaeoenvironmental reconstructions

During expedition 202 aboard the RV Sonne in 2009, 39 seafloor surface sediment sites were sampled over a wide sector of the North Pacific and adjoining Bering Sea. The data served to infer land–ocean linkages of terrigenous sediment supply in terms of major sources and modes of sediment transport within an over-regional context. This is based on an integrated approach dealing with grain-size analysis, bulk mineralogy and clay mineralogy in combination with statistical data evaluation (end-member modelling of grain-size data, fuzzy cluster analysis of mineralogical data). The findings on clay mineralogy served to update those of earlier work extracted from the literature. Today, two processes of terrigenous sediment supply prevail in the study area: far-distance aeolian sediment supply to the pelagic North Pacific, and hemipelagic sediment dispersal from nearby land sources via ocean currents along the continental margins and island arcs. Aeolian particles show the finest grain sizes (clay and fine silt), whereas hemipelagic sediments have high abundances of coarse silt. Exposed sites on seamounts and the continental slope are partly swept by strong currents, leading to residual enrichment of fine sand. Four sediment sources can be distinguished on the basis of distinct index minerals revealed by statistical data analysis: dust plumes from central Asia (quartz, illite), altered materials from the volcanic regions of Kamchatka and the Aleutian Arc (smectite), detritus from the Alaskan Cordillera (chlorite, hornblende), and fluvial detritus from far-eastern Siberia and the Alaska mainland (quartz, feldspar, illite). These findings confirm those of former studies but considerably expand the geographic range of this suite of proxies as far south as 39°N in the open North Pacific. The present integrated methodological approach proved useful in identifying the major modern processes of terrigenous sediment supply to the study region. This aspect deserves attention in the selection of sediment core sites for future palaeoenvironmental reconstructions related to aeolian and glacial dynamics, as well as the recognition of palaeo-ocean circulation patterns in general.