A comparison of bowen ratio and eddy correlation sensible and latent heat flux measurements above deciduous forest

Sensible and latent heat flux densities (H and E) were measured above a mature, 18 m deciduous forest during July and August, 1988, using the Bowen ratio-energy balance (BREB) and eddy correlation (EC) methods. EC estimates ofH and E underestimated day-time surface available energy by 11%. EC also partitioned available energy differently than BREB. for/L<0.0, EC favouredH and BREB favoured E. Practical and theoretical limitations of the BREB and EC methods above forests are discussed. The most plausible causes for the failure of EC to close the surface energy balance are a low frequency loss of flux and the failure of a single point measurement to account for the spatial dispersive flux. The most plausible causes of the EC-BREB energy partitioning anomaly are the invalidity of the BREB similarity assumption and the violation of flux-gradient diffusion assumptions in the near-field diffusion region.     

Early diagenetic processes during Mn-carbonate formation: evidence from the isotopic composition of authigenic Ca-rhodochrosites of the Baltic Sea

The formation of authigenic Ca-rich rhodochrosite (ACR) in sapropelic sediments of the Gotland Basin, Baltic Sea, is governed by deepwater renewal processes whereby saline water from the North Atlantic flushes the brackish anoxic Baltic Deeps. The carbon and oxygen isotopic compositions of these Mn-carbonates suggest that ACR formation takes place just below the sediment surface and that dissolved compounds from the deepwater column, such as water and bicarbonate molecules, were incorporated in ACR during authigenesis. Porewaters near the sediment surface display δ¹⁸O values of −5.4‰ (VSMOW) and are generally depleted in ¹⁸O, compared to the oxygen isotopic composition of water in equilibrium with Mn-carbonate solid solutions (ACR δ¹⁸O values are −4.6‰). This suggests that early burial diagenetic processes significantly modify the initial isotopic composition of water during Mn-carbonate formation. The reduction of sulfate having δ¹⁸O values of +8.4‰ accounts for a permanent enrichment of porewater ¹⁸O and observed δ¹⁸O values at depth equal to −4.6‰. However, this process does not explain the observed disequilibrium in the oxygen isotopic composition between water and ACR close to the sediment surface where Mn-carbonate formation takes place. Based on isotopic mass balance calculations, we suggest that MnO₂ with δ¹⁸O values of +8.9‰ released oxygen enriched in ¹⁸O into the anoxic porewaters close below the sediment surface. This process should occur after oxygenation events during deepwater renewal when MnO₂ accumulates at the surface of anoxic sediments. Manganese carbonates formed in these waters display δ¹⁸O values of ∼1.0‰ heavier than values expected solely from the initial deepwater composition. This quantitatively explains the discrepancy between paleosalinities calculated from ACR δ¹⁸O based on Mn-carbonate/water isotopic equilibrium fractionation and direct observations for the same period. Our results emphasize the important role of microbial MnO₂ reduction during rhodochrosite authigenesis and suggest that Mn(II) activity, rather than alkalinity, is the limiting component for sedimentary Mn-carbonate formation.     

Observations of urban and suburban environments with global satellite scatterometer data

A global and consistent characterization of land use and land change in urban and suburban environments is crucial for many fundamental social and natural science studies and applications. Presented here is a dense sampling method (DSM) that uses satellite scatterometer data to delineate urban and intraurban areas at a posting scale of about 1 km. DSM results are analyzed together with information on population and housing censuses, with Landsat Enhanced Thematic Mapper Plus (ETM+) imagery, and with Defense Meteorological Satellite Program (DMSP) night-light data. The analyses include Dallas-Fort Worth and Phoenix in the United States, Bogotá in Colombia, Dhaka in Bangladesh, Guangzhou in China, and Quito in Ecuador. Results show that scatterometer signatures correspond to buildings and infrastructures in urban and suburban environments. City extents detected by scatterometer data are significantly smaller than city light extents, but not all urban areas are detectable by the current SeaWinds scatterometer on the QuikSCAT satellite. Core commercial and industrial areas with high buildings and large factories are identified as high-backscatter centers. Data from DSM backscatter and DMSP nighttime lights have a good correlation with population density. However, the correlation relations from the two satellite datasets are different for different cities indicating that they contain complementary information. Together with night-light and census data, DSM and satellite scatterometer data provide new observations to study global urban and suburban environments and their changes. Furthermore, the capability of DSM to identify hydrological channels on the Greenland ice sheet and ecological biomes in central Africa demonstrates that DSM can be used to observe persistent structures in natural environments at a km scale, providing contemporaneous data to study human impacts beyond urban and suburban areas.     

Comparative assessment of CORINE2000 and GLC2000: Spatial analysis of land cover data for Europe

Given the current lack of interoperability between global and regional land cover products, efforts are underway to link the new European global land cover map (GLOBCOVER) with the existing global land cover 2000 map (GLC2000) and European CORINE mapping initiative. Since both datasets apply different mapping standards, key for a successful implementation is a thorough understanding of the heterogeneities among both datasets. Thus, this paper provides an assessment of compatibilities and differences between the CORINE2000 and GLC2000 datasets. The comparative assessment considers inconsistencies between the thematic legends (using the UN land cover classification system-LCCS), class specific accuracies, and the spatial resolution and heterogeneity of the datasets. The results are summarized with implications for the development of the new GLOBCOVER datasets.     

Application of Gibbs Energy Minimization to ModelEarly-Diagenetic Solid-Solution Aqueous-Solution EquilibriaInvolving Authigenic Rhodochrosites in Anoxic BalticSea Sediments

The natural early-diagenetic environment ``anoxicporewater – authigenic mineral phases' has beencharacterized in sediment of the Gotland Deep,Baltic Sea, by a closed-system model. Occurrence ofcarbonate precipitates as thin almost pure whitelaminae was considered as a natural experiment forlong-term equilibration between these phases andporewater. Plots of distribution coefficientsindicate that metastable equilibrium exists betweenporewater and the authigenic Ca-rich rhodochrositephases below 7 cm depth. A thermodynamic model ofporewater geochemistry at in situ P = 25 barand T = 5 °C was developed using the Gibbsenergy minimization (GEM) approach. The values of isobaric-isothermal potentials of Mn, Ca, Fe, Mg,Sr, Ba, C, and O, calculated from the porewatercomposition, were used in a new ``dual thermodynamic'calculation approach to estimate solid activitycoefficients of the end-members in the non-idealsolid solution (Mn, Ca, Mg, Sr, Ba, Fe)CO₃,i.e., at full major and minor multi-componentcomplexity. The regular Margules interactionparameters for the composing binaries estimated bythis model were _Mn-Ca = 1.9 ± 0.5,_Mn-Mg = 0.6,_Ca-Mg = 3.7,_Mn-Fe = 0.2,_Ca-Fe = 2.8,_Mn-Sr = 9.7,_Ca-Sr = 2.15,_Mn-Ba = 4.0,_Ca-Ba = 1.4,validating the theoretical predictions given byLippmann in his pioneering 1980's paper. Thestrictly thermodynamic equilibrium model is not onlyable to match both the measured porewater andcarbonate solid-solution composition, but also topredict that the porewater pH, pe, alkalinity, anddissolved Mn, Fe, and S concentrations arecontrolled by the authigenic mineral bufferingassemblage mackinawite-greigite-rhodochrosite. Ourmodel is only compatible with the idea of ACRformation with typical composition (X_Mnbetween 70–75%) in the topmost sediment layerwhich, however, needs a major source ofMn_aq ^II. This is provided by reduction ofparticulate Mn oxides precipitated in significantamounts in the water column upon major inflow eventsin the Baltic Sea. The model enables also to set upscenarios of changing environmental conditions, e.g.,to predict the non-linear response of the carbonatesolid-solution composition to changes in Mn loading,alkalinity and salinity of the sediment-watersystem. The results suggest that the major andespecially minor element contents (Sr, Mg, Ba) inauthigenic carbonates can be applied as anenvironmental paleoproxy.     

MIDI – the 10 μm instrument on the VLTI

After more than five years of preparation, the mid-infrared interferometric instrument MIDI has been transported to Paranal where it will undergo testing and commissioning on theVery Large Telescope Interferometer VLTI from the end of 2002through large part of this year 2003. Thereafter it will be available as a user instrument to perform interferometric observations over the8 μm–13 μm wavelength range, with a spatial resolution of typically 20 milliarcsec, a spectral resolution of up to 250, and an anticipated point source sensitivity of N = 3–4 mag or 1–2.5 Jy for self –fringe tracking, which will be the only observing mode during the first months of operation. We describe the layout of the instrument, laboratory tests, and expected performance, both for broadband and spectrally resolved observing modes. We also briefly outline the planned guaranteed time observations. This revised version was published online in July 2006 with corrections to the Cover Date.     

Using the adaptive simulated annealing algorithm to estimate ocean-bottom geoacoustic properties from measured and synthetic transmission loss data

This paper presents the results obtained using the adaptive simulated annealing (ASA) algorithm to invert the test cases from the Geoacoustic Inversion Techniques Workshop held in May 2001. The ASA algorithm was chosen for use in our inversion software for its speed and robustness when searching the geoacoustic parameter solution space to minimize the difference between the observed and the modeled transmission loss (TL). Earlier work has shown that the ASA algorithm is approximately 15 times faster than a modified Boltzmann annealing algorithm, used in prior versions of our TL inversion software, with comparable fits to the measured data. Results are shown for the synthetic test cases, 0 through 3, and for the measured data cases, 4 and 5. The inversion results from the synthetic test cases showed that subtle differences between range-dependent acoustic model version 1.5, used to generate the test cases, and parabolic equation (PE) 5.0, used as the propagation loss model for the inversion, were significant enough to result in the inversion algorithm finding a geoacoustic environment that produced a better match to the synthetic data than the true environment. The measured data cases resulted in better fits using ASTRAL automated signal excess prediction system TL 5.0 than using the more sophisticated PE 5.0 as a result of the inherent range averaging present in the ASTRAL 5.0 predictions.     

Modeling and simulation of two-phase two-component flow with disappearing nonwetting phase

Carbon capture and storage is a recently discussed new technology, aimed at allowing an ongoing use of fossil fuels while preventing the produced CO₂ to be released to the atmosphere. CCS can be modeled with two components (water and CO₂) in two phases (liquid and CO₂). To simulate the process, a multiphase flow equation with equilibrium phase exchange is used. One of the big problems arising in two-phase two-component flow simulations is the disappearance of the nonwetting phase, which leads to a degeneration of the equations satisfied by the saturation. A standard choice of primary variables, which is the pressure of one phase and the saturation of the other phase, cannot be applied here. We developed a new approach using the pressure of the nonwetting phase and the capillary pressure as primary variables. One important advantage of this approach is the fact that we have only one set of primary variables that can be used for the biphasic as well as the monophasic case. We implemented this new choice of primary variables in the DUNE simulation framework and present numerical results for some test cases.     

Submarine outcrop and acoustic expression of lithified sediment layers in northwest Providence Channel, Bahamas

 Visual observations of the wall of Great Bahama Canyon indicate that ledges produced by differential submarine erosion occur at depths like reflectors on high-resolution seismic profiles, suggesting lithologic changes produce acoustic impedance contrasts and therefore reflectors. Quaternary-aged sediments in a core from Little Bahama Bank exhibit changes in lithology (and presumably acoustic impedance) associated with glacial-to-interglacial transitions, which also correspond in depth to seismic reflectors. This supports the concept that reflectors on high-resolution seismic profiles of Bahamian periplatform ooze correspond directly to changes in lithology and may be associated with climate/sea level fluctuations. Received: 30 June 1998 / Revision received: 20 January 1999