CO<Subscript>2</Subscript> Flux Measurements over the Sea Surface by Eddy Correlation and Aerodynamic Techniques

The measurements of the vertical transport of CO₂ were carried out over the Sea of Japan using the specially designed pier of Kyoto University on September 20 to 22, 2000. CO₂ fluxes were measured by the eddy correlation and aerodynamic techniques. Both techniques showed comparable CO₂ fluxes during sea breeze conditions: −0.001 to −0.08 mg m⁻²s⁻¹ with the mean of −0.05 mg m⁻²s⁻¹. This means that the measuring site satisfies the fetch requirement for meteorological observations under sea breeze conditions. Moreover, the eddy diffusivity coefficient used in the aerodynamic technique is found to be consistent with the coefficient used in the eddy correlation technique. The present result leads us to conclude that the aerodynamic technique may be applicable to underway CO₂ flux measurements over the ocean and may be used in place of the bulk technique. The important point is the need to maintain a measuring accuracy of CO₂ concentration difference of the order of 0.1 ppmv on the research vessels or the buoys.     

Fluid–Sediment Interaction in a Marine Shallow-Water Hydrothermal System in the Wakamiko Submarine Crater, South Kyushu, Japan

The Wakamiko submarine crater is a small depression located in Kagoshima Bay, southwest Japan. Marine shallow‐water hydrothermal activity associated with fumarolic gas emissions at the crater sea floor (water depth 200 m) is considered to be related with magmatic activity of the Aira Caldera. During the NT05‐13 dive expedition conducted in August 2005 using remotely operated vehicle Hyper‐Dolphine (Japan Agency for Marine‐Earth Science and Technology), an active shimmering site was discovered (tentatively named the North site) at approximately 1 km from the previously known site (tentatively named the South site). Surface sediment (up to 30 cm) was cored from six localities including these active sites, and the alteration minerals and pore fluid chemistry were studied. The pore fluids of these sites showed a drastic change in chemical profile from that of seawater, even at 30 cm below the surface, which is attributed to mixing of the ascending hydrothermal component and seawater. The hydrothermal component of the North site is estimated to be derived from a hydrothermal aquifer at 230°C based on the hydrothermal end‐member composition. Occurrence of illite/smectite interstratified minerals in the North site sediment is attributed to in situ fluid–sediment interaction at a temperature around 150°C, which is in accordance with the pore fluid chemistry. In contrast, montmorillonite was identified as the dominant alteration mineral in the South site sediment. Together with the significant low potassium concentration of the hydrothermal end‐member, the abundant occurrence of low‐temperature alteration mineral suggests that the hydrothermal aquifer in the South site is not as high as 200°C. Moreover, the montmorillonite is likely to be unstable with the present pore fluid chemistry at the measured temperature (117°C). This disagreement implies unstable hydrothermal activity at the South site, in contrast to the equilibrium between the pore fluid and alteration minerals in the North site sediment. This difference may reflect the thermal and/or hydrological structure of the Wakamiko Crater hydrothermal system.     

Decarbonation reaction of magnesite in subducting slabs at the lower mantle

High-pressure and temperature experiments (28–62 GPa, and 1,490–2,000 K, corresponding to approximately 770–1,500 km depth in the mantle) have been conducted on a MgCO₃ + SiO₂ mixture using a laser-heated diamond anvil cell combined with analytical transmission electron microscope observation of the product phases to constrain the fate of carbonates carried on the subducting basalt into the lower mantle. At these conditions, the decarbonation reaction MgCO₃ (magnesite) + SiO₂ (stishovite) → MgSiO₃ (perovskite) + CO₂ (solid) has been recognized. This indicates that above reaction takes place as a candidate for decarbonation of the carbonated subducting mid ocean ridge basalts in the Earth’s lower mantle.     

Strain field measurements of rubber by image analysis and design criteria for laminated rubber bearings (LRB)

Although seismic isolation rubber bearings in bridges and buildings have proven to be a very effective passive method for reducing earthquake‐induced forces, a detailed mechanical modeling of the rubber that is used in bearings under large strains has not been established. Therefore, a 3D model of failure behavior and the design criteria for the safety evaluation of seismic isolation bearings have not yet been developed. This paper presents: (1) correlation‐based template‐matching algorithms to measure large strain fields of continua; (2) a failure criterion for rubber; and (3) the design criteria for the safety evaluation of laminated algorithms, data‐validation algorithms were developed and implemented to eliminate possible unrealistic displacement vectors present in the measured displacement field. The algorithms were successfully employed in the strain field measurement of LRB and rubber materials that are subjected to failure. The measured local strains for rubber material at failure were used to develop a failure criterion for rubber. The validity of the proposed criterion was evaluated by applying it to the LRB; the criterion was introduced into a 3D finite element model of LRB, compared with the experimental results of bearings failure, and verified. Finally, design criteria are proposed for LRB for the safety evaluation. Copyright © 2003 John Wiley & Sons, Ltd.     

In situ characterization of forearc serpentinized peridotite from the Sulu ultrahigh-pressure terrane:Behavior of fluid-mobile elements in continental subduction zone

Serpentinized peridotites in the Yangkou(YK),Suoluoshu(SLS) and Hujialin(HJL) areas in the Sulu ultrahighpressure terrane represent the relic of ancient subcontinental lithospheric mantle below the North China Craton.Their protoliths,harzburgite and dunite,were variably hydrated by aqueous fluids released from subducting Yangtze continent.The rocks are enriched in fluid-mobile elements(FME) including Sb(42–333 times the depleted mantle value) and Pb(30–476 times).The degrees of the FME enrichment are comparable to that of the Himalayan forearc serpentinites,and greater than forearc mantle serpentinites from Marianas,suggesting that the degrees of FME enrichment in the forearc serpentinites are greater in continental subduction zones than those in the oceanic subduction zones.Lizardite after olivine in the SLS serpentinite shows higher degrees of enrichment in Sb and As than those for antigorite after both olivine and orthopyroxene in the YK area.The antigorite has highly enriched in Pb,U,Cs,and LREE,but not for the lizardite.The abundance of FME in two different species of serpentine reflects the different temperature of hydration.At temperature lower than 300 ℃,formed lizardite at shallow depths of the mantle wedge incorporates elements that are fluid mobile at low temperatures,such as Sb and As.When the temperature greater than 300 ℃,formed antigorite at a relatively deep mantle wedge incorporate more FME from the subducting continental slab(or fragments),including Pb,U,Cs,LREE as well as Sb and As.The eventual breakdown of antigorite(600–700 ℃) in prograde metamorphism would discharge water as well as FME into the subducting channel and/or the overlying mantle.     

软流圈熔体地幔交代作用过程中的铂族元素行为

南美洲南部的Pali Aike火山岩区第四纪碱性玄武岩中普遍发育含石榴石的斜方辉石岩包体。这种斜方辉石岩既作为独立的捕掳体存在又以细脉的形式穿插于橄榄岩捕掳体中。斜方辉石岩普遍含富Ti矿物,并且次生斜方辉石含橄榄石和单斜辉石残晶。与含石榴石橄榄岩中的斜方辉石相比,这种次生的斜方辉石以高TiO2、中等含量的Al2O3以及低Mg#为特征,表明它是在一种高度分异演化的富Ti熔体交代作用下通过消耗橄榄石和单斜辉石方式形成的。斜方辉石岩全岩的Co、Ni略低,Cr和铂族元素(PGE)含量与地幔橄榄岩相当,表明这些元素在交代作用过程中相对稳定,而交代介质带入的组分以碱质(K2O+Na2O)、Ti、Si、Al和S为主。交代的斜方辉石在现代活动岛弧和古克拉通的地幔橄榄岩捕掳体中多有报道。与这些环境中地幔样品的斜方辉石相比,PaliAike地区的次生斜方辉石含有相对高的Ti和Al,以及相对低的Mg。高Ti低Mg属性反映了交代介质可能来源于下伏的软流圈地幔并且经历了高度的分异和演化过程。Pali Aike地区所见到的这种交代斜方辉石和斜方辉石岩在其他被上涌软流圈影响的陆下岩石圈地幔中可能普遍存在。这些研究对了解中国华北-东北中生代以来的岩石圈地幔减薄机制有着重要的借鉴意义。     

Electron microscopy studies of akermanites (Ca1−xSrx)2CoSi2O7 with modulated structure

Single crystals of akermanite (Ca_1–x Sr _x )₂Co-Si₂O₇ solid solution were grown in nitrogen by the floating zone method using a lamp-image furnace. The grown crystals were 6 mm in diameter by 50 mm in length. Microprobe analyses indicate uniform strontium content x except in the initially crystallized part. Synthetic crystals with x from 0.0 to 0.3 give, at room temperature, satellite reflections and circular diffuse scatterings in the electron diffraction pattern, which are related to an incommensurate phase and microdomains, respectively. With increasing Sr content the wavelength of a modulation increases and the intensity of satellites decreases, but the intensity of circular diffuse scattering increases up to x=0.15 and then decreases until eventually the satellites and the circular diffuse scatterings disappear at x = 0.3. The circular diffuse scattering is explained by the cluster model for the transition state, proposed by De Ridder et al. (1976).     

Impact of intra-daily SST variability on ENSO characteristics in a coupled model

This paper explores the impact of intra-daily Sea Surface Temperature (SST) variability on the tropical large-scale climate variability and differentiates it from the response of the system to the forcing of the solar diurnal cycle. Our methodology is based on a set of numerical experiments based on a fully global coupled ocean–atmosphere general circulation in which we alter (1) the frequency at which the atmosphere sees the SST variations and (2) the amplitude of the SST diurnal cycle. Our results highlight the complexity of the scale interactions existing between the intra-daily and inter-annual variability of the tropical climate system. Neglecting the SST intra-daily variability results, in our CGCM, to a systematic decrease of 15% of El Ni?o—Southern Oscillation (ENSO) amplitude. Furthermore, ENSO frequency and skewness are also significantly modified and are in better agreement with observations when SST intra-daily variability is directly taken into account in the coupling interface of our CGCM. These significant modifications of the SST interannual variability are not associated with any remarkable changes in the mean state or the seasonal variability. They can therefore not be explained by a rectification of the mean state as usually advocated in recent studies focusing on the diurnal cycle and its impact. Furthermore, we demonstrate that SST high frequency coupling is systematically associated with a strengthening of the air-sea feedbacks involved in ENSO physics: SST/sea level pressure (or Bjerknes) feedback, zonal wind/heat content (or Wyrtki) feedback, but also negative surface heat flux feedbacks. In our model, nearly all these results (excepted for SST skewness) are independent of the amplitude of the SST diurnal cycle suggesting that the systematic deterioration of the air-sea coupling by a daily exchange of SST information is cascading toward the major mode of tropical variability, i.e. ENSO.     

Preferred orientation of antiphase boundaries in pigeonite as a cooling ratemeter

Antiphase domains (APD's) of pigeonite lamellae in natural and heated augite crystals from the Hakonetoge andesite have been examined by a transmission electron microscope (TEM). Antiphase boundaries (APB's) of the pigeonite lamellae in natural specimens have a sigmoidal shape cutting the c axis in (010) sections. APB's in specimens heated at temperatures above the high-low inversion and then quenched are nearly parallel to the c axis with almost straight boundaries. These observations indicate that the preferred orientation of APB's in (010) sections depends on cooling rate; at fast colling rates the APB's are nearly parallel to the c axis, whereas at slower cooling rates they are inclined to the c axis. The cooling rate of the natural augite specimen from Hakonetoge is estimated to be about 0.01 °C/h from the experimentally determined time-temperature-transformation (TTT) diagram for the APB orientations. APD sizes are large in specimens quenched from above the inversion temperature; they are at a minimum after cooling rates of around 1–0.1 °C/h, and then become larger with slower cooling rates.