Occurrence and evolution of the Xiaotangshan hot spring in Beijing, China

Thermal groundwater occurs in bedrock aquifers consisting of the dolomite of the Wumishan Group of the Jixianin System and the Cambrian carbonate in the Xiaotangshan geothermal field near the northern margin of the North China Plain, China. The hot water in the geothermal field of basin-type discharges partly in the form of the Xiaotangshan hot spring under natural conditions. The hot water has TDS of less than 600 mg/L and is of Na·Ca-HCO₃ type. The geothermal water receives recharge from precipitation in the mountain area with elevation of about 500 m above sea level to the north of the spring. Thermal groundwater flows slowly south and southeast through a deep circulation with a residence time of 224 years estimated with the Ra–Rn method. The Xiaotangshan hot spring dried up in the middle of the 1980s owing to the increasing withdrawal of the hot water in the geothermal field in the past decades. The water level of the geothermal system still falls continually at an annual average rate of about 2 m, although water temperature changes very little, indicating that the recharge of such a geothermal system of basin-type is limited. Over-exploitation has a dramatic impact on the geothermal system, and reduction in exploitation and reinjection are required for the sustainable usage of the hot water.     

The state of land subsidence and prediction approaches due to groundwater withdrawal in China

This article gives a general introduction to land subsidence with the prediction approaches due to withdrawal of groundwater in three subsided/subsiding regions in China: the deltaic plain of Yangtse River (YRDP), North China Plain (NCP), and Fenwei Plain (FP). On YRDP, Shanghai is the typical subsided/subsiding city; on NCP Tianjin is the typical subsided/subsiding city, and on FP Taiyuan is the typical subsided/subsiding city. The subsided area with subsidence over 200 mm on YRDP is about 10,000 km² and the maximum subsided value reached 2.9 m at Shanghai; on NCP the subsided area reached 60,000 km² with the maximum subsidence of 3.9 m at Tianjing; on FP the subsided area is relatively smaller than that on the other two plains and is about 1,135 km² with maximum subsidence of 3.7 m at Taiyuan city. In order to protect the civil and industrial facilities, it is necessary to predict the future development of land subsidence based on present state. Many researchers proposed several approaches to predict the land subsidence due to groundwater withdrawal according to different geological conditions and groundwater withdrawal practice. This article classifies these approaches into five categories: (i) statistical methods; (ii) 1D numerical method; (iii) quasi-3D seepage model; (iv) 3D seepage model; (v) fully coupled 3D model. In China, the former four categories are presently employed in the prediction practice and their merits and demerits are discussed. According to the prediction practice, 3D seepage model is the best method presently.     

Development of a 3D GIS and its application to karst areas

There is a growing interest in modeling and analyzing karst phenomena in three dimensions. This paper integrates geology, groundwater hydrology, geographic information system (GIS), database management system (DBMS), visualization and data mining to study karst features in Huaibei, China. The 3D geo-objects retrieved from the karst area are analyzed and mapped into different abstract levels. The spatial relationships among the objects are constructed by a dual-linker. The shapes of the 3D objects and the topological models with attributes are stored and maintained in the DBMS. Spatial analysis was then used to integrate the data in the DBMS and the 3D model to form a virtual reality (VR) to provide analytical functions such as distribution analysis, correlation query, and probability assessment. The research successfully implements 3D modeling and analyses in the karst area, and meanwhile provides an efficient tool for government policy-makers to set out restrictions on water resource development in the area.     

A simple mathematical model for soil nail and soil interaction analysis

Soil nails have been widely used to stabilize slopes and earth retaining structures in many countries and regions, especially, in Hong Kong. The analysis of the interaction between a soil nail and the surrounding soil is of great interests to both design engineers and researchers. In this paper, authors present a simple mathematical model for the interaction analysis of a soil nail and the surrounding soil considering a few key factors which are soil dilation, bending of the soil nail, vertical pressure, and non-linear subgrade reaction stiffness. The lateral subgrade reaction between the soil and the soil nail is assumed to obey a hyperbolic relation. Reported test data in the literature are used to verify the present model. The contributions of the soil-nail bending on the pull-out resistance are evaluated in two case studies.     

辽东湾凝析气田超压成因及侧向传递机制初探

位于辽东湾西部低凸起北端的JZ20-2超压凝析气田,离供烃中心较远,压力系数却达到1.56~1.7,这在我国东部裂谷盆地比较少见。经过综合分析,作者认为JZ20-2凝析气田异常高压的形成与其所处的特殊地质背景紧密相关,辽中凹陷沙河街组三段超压凝析油气沿不整合面、砂体输导通道向辽东湾西部低凸起的运移、充注和能量的侧向传递是JZ20-2凝析气田异常高压形成的根本原因,而上覆东营组二段下亚段-东营组三段巨厚的强超压泥岩封盖和辽西3号边界断层侧向遮挡共同构成的优越封闭环境是超压保存的必要条件。本文分析了该气田超压特征及其远距离超压侧向传递的成因机制,不仅有助于揭示辽东湾西部低凸起超压流体运移聚集的规律和成藏作用,而且可能提供了一个超压远距离侧向传递的典型实例。     

http://www.sciencedirect.com/science/article/pii/S1674987113000595

Magmatic oxide deposits in the～260 Ma Emeishan Large Igneous Province(ELIP),SW China and northern Vietnam,are important sources of Fe,Ti and V.Some giant magmatic Fe-Ti-V oxide deposits, such as the Panzhihua,Hongge,and Baima deposits,are well described in the literature and are hosted in layered mafic-ultramafic intrusions in the Panxi region,the central ELIP.The same type of ELIP- related deposits also occur far to the south and include the Anyi deposit,about 130 km south of Panzhihua,and the Mianhuadi deposit in the Red River fault zone.The Anyi deposit is relatively small but is similarly hosted in a layered mafic intrusion.The Mianhuadi deposit has a zircon U-Pb age of～260 Ma and is thus contemporaneous with the ELIP.This deposit was variably metamorphosed during the Indosinian orogeny and Red River faulting.Compositionally,magnetite of the Mianhuadi deposit contains smaller amounts of Ti and V than that of the other deposits,possibly attributable to the later metamorphism.The distribution of the oxide ore deposits is not related to the domal structure of the ELIP.One major feature of all the oxide deposits in the ELIP is the spatial association of oxide-bearing gabbroic intrusions,syenitic plutons and high-Ti flood basalts.Thus,we propose that magmas from a mantle plume were emplaced into a shallow magma chamber where they were evolved into a field of liquid immiscibility to form two silicate liquids,one with an extremely Fe-Ti-rich gabbroic composition and the other syenitic.An immiscible Fe-Ti-(P) oxide melt may then separate from the mafic magmas to form oxide deposits.The parental magmas from which these deposits formed were likely Fe-Ti-rich picritic in composition and were derived from enriched asthenospheric mantle at a greater depth than the magmas that produced sulfide-bearing intrusions of the ELIP.     

New textural and mineralogical constraints on the origin of the Hongge Fe-Ti-V oxide deposit, SW China

The Hongge magmatic Fe-Ti-V oxide deposit in the Panxi region, SW China, is hosted in a layered mafic–ultramafic intrusion. This 2.7-km-thick, lopolith-like intrusion consists of the lower, middle, and upper zones, which are composed of olivine clinopyroxenite, clinopyroxenite, and gabbro, respectively. Abundant Fe-Ti oxide layers mainly occur in the middle zone and the lower part of the upper zone. Fe-Ti oxides include Cr-rich and Cr-poor titanomagnetite and granular ilmenite. Cr-rich titanomagnetite is commonly disseminated in the olivine clinopyroxenite of the lower parts of the lower and middle zones and contains 1.89 to 14.9 wt% Cr₂O₃ and 3.20 to 16.2 wt% TiO₂, whereas Cr-poor titanomagnetite typically occurs as net-textured and massive ores in the upper middle and upper zones and contains much lower Cr₂O₃ (<0.4 wt%) but more variable TiO₂ (0.11 to 18.2 wt%). Disseminated Cr-rich titanomagnetite in the ultramafic rocks is commonly enclosed in either olivine or clinopyroxene, whereas Cr-poor titanomangetite of the net-textured and massive ores is mainly interstitial to clinopyroxene and plagioclase. The lithology of the Hongge intrusion is consistent with multiple injections of magmas, the lower zone being derived from a single pulse of less differentiated ferrobasaltic magma and the middle and upper zones from multiple pulses of more differentiated magmas. Cr-rich titanomagnetite in the disseminated ores of the lower and middle zones is interpreted to represent an early crystallization phase whereas clusters of Cr-poor titanomagnetite, granular ilmenite, and apatite in the net-textured ores of the middle and upper zones are thought to have formed from an Fe-Ti-(P)-rich melt segregated from a differentiated ferrobasaltic magma as a result of liquid immiscibility. The dense Fe-Ti-(P)-rich melt percolated downward through the underlying silicate crystal mush to form net-textured and massive Fe-Ti oxide ores, whereas the coexisting Si-rich melt formed the overlying plagioclase-rich rocks in the intrusion.     

Microseism Induced by Transient Release of In Situ Stress During Deep Rock Mass Excavation by Blasting

During deep rock mass excavation with the method of drill and blast, accompanying the secession of rock fragments and the formation of a new free surface, in situ stress on this boundary is suddenly released within several milliseconds, which is termed the transient release of in situ stress. In this process, enormous strain energy around the excavation face is instantly released in the form of kinetic energy and it inevitably induces microseismic events in surrounding rock masses. Thus, blasting excavation-induced microseismic vibrations in high-stress rock masses are attributed to the combined action of explosion and the transient release of in situ stress. The intensity of stress release-induced microseisms, which depends mainly on the magnitude of the in situ stress and the dimension of the excavation face, is comparable to that of explosion-induced vibrations. With the methods of time–energy density analysis, amplitude spectrum analysis, and finite impulse response (FIR) digital filter, microseismic vibrations induced by the transient release of in situ stress were identified and separated from recorded microseismic signals during a blast of deep rock masses in the Pubugou Hydropower Station. The results show that the low-frequency component in the microseismic records results mainly from the transient release of in situ stress, while the high-frequency component originates primarily from explosion. In addition, a numerical simulation was conducted to demonstrate the occurrence of microseismic events by the transient release of in situ stress, and the results seem to have confirmed fairly well the separated vibrations from microseismic records.     

A new bounding surface model for thermal cyclic behaviour

To accurately predict soil volume changes under thermal cycles is of great importance for analysing the performance of many earth structures such as the energy pile and energy storage system. Most of the existing thermo‐mechanical models focus on soil behaviour under monotonic thermal loading only, and they are not able to capture soil volume changes under thermal cycles. In this study, a constitutive model is proposed to simulate volume changes of saturated soil subjected to cyclic heating and cooling. Two surfaces are defined and used: a bounding surface and a memory surface. The bounding surface and memory surface are mainly controlled by the preconsolidation pressure (a function of plastic volumetric strain) and the maximum stress experienced by the soil, respectively. Under thermal cycles, the distance of the two surfaces and plastic modulus increase with an accumulation of plastic strain. By adopting the double surface concept, a new elastoplastic model is derived from an existing single bounding surface thermo‐mechanical model. Comparisons between model predictions and experimental results reveal that the proposed model is able to capture soil volume changes under thermal cycles well. The plastic strain accumulates under thermal cycles, but at a decreasing rate, until stabilization. Copyright © 2017 John Wiley & Sons, Ltd.     

辽河小洼油田东营组沉积环境条件的研究

陆相盆地沉积作用主要受构造作用及古气候的控制,所以从区域构造背景出发,结合地层、古生物、沉积、地球化学等方面资料.对小洼油田东营组的沉积环境条件进行综合分析.确定了沉积物源来自北东方向的中央凸起,古气候属于半干旱一半潮湿的温带气候条件。水介质是弱还原性的淡水滨浅湖泊沉积环境.此时中央凸起上丰富的风化剥蚀产物经过河流的搬运和分异作用,进入湖盆中形成三角洲沉积体。