Accuracy assessment of lidar-derived digital elevation models

Despite the relatively high cost of airborne lidar-derived digital elevation models (DEMs), such products are usually presented without a satisfactory associated estimate of accuracy. For the most part, DEM accuracy estimates are typically provided by comparing lidar heights against a finite sample of check point coordinates from an independent source of higher accuracy, supposing a normal distribution of the derived height differences or errors. This paper proposes a new methodology to assess the vertical accuracy of lidar DEMs using confidence intervals constructed from a finite sample of errors computed at check points. A non-parametric approach has been tested where no particular error distribution is assumed, making the proposed methodology especially applicable to non-normal error distributions of the type usually found in DEMs derived from lidar. The performance of the proposed model was experimentally validated using Monte Carlo simulation on 18 vertical error data-sets. Fifteen of these data-sets were computed from original lidar data provided by the International Society for Photogrammetry and Remote Sensing Working Group III/3, using their respective filtered reference data as ground truth. The three remaining data-sets were provided by the Natural Environment Research Council's Airborne Research and Survey Facility lidar system, together with check points acquired using high precision kinematic GPS. The results proved promising, the proposed models reproducing the statistical behaviour of vertical errors of lidar using a favourable number of check points, even in the cases of data-sets with non-normally distributed residuals. This research can therefore be considered as a potentially important step towards improving the quality control of lidar-derived DEMs.     

下庄矿田湖子地区铀矿找矿方向探讨

湖子地区位于NNE向诸广-新兴铀成矿带与近EW向大东山-漳州大断裂复合部位,是华南早、晚两期铀成矿热液活动叠加区、放射性高场区,既有"硅化带大脉"型铀矿产出,又有"交点"型铀矿存在,找矿前景良好.文章在论述下庄矿田铀成矿地质环境、铀成矿特征及铀矿定位条件基础上,分析了湖子地区铀成矿条件与找矿前景,指出该区今后铀矿找矿方向是:① 6009号硅化断裂带,在其北段找硅化带大脉型铀矿,在其南段找"交点"型铀矿;②新桥-下庄硅化断裂带和6009号带之间成矿部位,寻找硅化带型和"交点"型铀矿;③NW向、近EW向辉绿岩脉与NNE向、NE向构造交汇部位(交点),寻找"交点"型铀矿.     

From 2D TO 3D Through Modelling Based On A Single Image

Three-dimensional modelling from single images remains an interesting topic of investigation in the research community, even though range sensors are becoming a common alternative for the generation of 3D information. The interest in single-image-based modelling is motivated by a wide spectrum of applications such as cultural heritage, civil engineering, urban planning and even criminology. In this paper a complete new production flowline is presented for modelling based on a single image. The modelling process consists of a series of familiar steps in photogrammetry and computer vision: feature extraction, vanishing point computation, camera self-calibration, 3D reconstruction and dimensional analysis. In particular, the methodology developed for single-image-based modelling takes a scientific approach combining several proven techniques with robust estimators. Finally, in order to demonstrate its capabilities, the reported examples include several real situations applied in different contexts.     

河西走廊疏勒河流域地质灾害危险性现状评估方法的应用——以甘肃省河西走廊(疏勒河)农业灌溉暨移民安置综合开发建设项目8个移民社区及配套工程建设为例

依据“建设用地地质灾害危险性评估技术要求”、利用野外踏勘及相关资料,对“甘肃省河西走廊（疏勒河）农业灌溉暨移民安置综合开发建设项目8个移民社区及配套工程”进行地质灾害危险性现状评估。结果认为：评估区发育和分布的地质灾害类型有土壤盐渍化、风蚀沙埋和洪水冲蚀。现状评估结果：土壤盐渍化和洪水冲蚀危险性均小;风蚀沙埋有1处危险性中等,其它危险性小。     

基于WiMAX的地质灾害应急无线通信系统探索

基于OFDM核心技术的WiMAX(全球微波接入互操作性)具有4G技术的特点。与3G和WiFi无线通讯技术相比具有明显的高速率、大容量数据传输优势。本文就基于WiMAX的地质灾害应急通讯系统的几种技术方案加以详细论述,说明WiMAX在地质灾害应急指挥中具有广阔前景。     

岩石中的渗透率、流体流动及热液成矿作用

热液成因的固体金属矿床形成过程中都曾拥有一段流动的历史。成矿物质以溶液的形式从矿源地穿过孔隙或断裂达到了现在的栖身之所,在此过程中流体通过的路径决定了它们的走向,而溶液本身也改变了路径的特征。因此,对于此类矿床的研究不能仅仅囿于眼之所见,而应将古流体流动的观念融入其中,并考察它们的跋涉之路。文中总结了近年来国内外在岩石孔隙、断裂介质及与其相关渗透率对热液成矿作用的控制等领域的研究成果和最新进展,对岩石渗透率、渗透率的影响因素、岩石中流体流动的特征等问题进行了阐述,讨论了渗透率对于热液成矿作用深度、成矿规模、矿质沉淀机制等方面的重要影响,藉此在固体金属矿床研究中强化流"体运动"的观念,并促进构造地质学和成矿作用地球化学间一个新研究方向的发展。