Natural Hazards - A 2D local inertial equations model coupled with a 1D hydraulic model was established to simulate flood dispatching in river and flood detention areas. A simplified first-order... 相似文献
确定土体动剪切模量的常用方法有规范法、Kumar法和自相关函数法,确定相应阻尼比的方法有规范法、Das and Luo法、Kokusho法、Kumar法和互相关函数法,为了分析不同方法所产生差异,实现定量化对比分析,笔者以福建标准砂(粒径为0.5~1.0 mm)为研究对象,采用不排水的应力控制动三轴试验,探讨不同的确定土体动剪切模量和阻尼比方法的差异性,并给出了不同土体条件建议选用的方法。结果表明:1)3种方法确定动剪切模量的结果有一定的差异,随剪应变的增大结果的差异逐渐增大,有效围压对结果的差异性有所影响,当剪应变为4×10-3,有效围压为100 kPa时,3种方法差异显著,相对误差最大接近20%;2)而5种方法确定阻尼比的结果差异显著,随着剪应变的增大,5种方法确定的阻尼比相对误差大体上均在迅速减小,只有规范法在有效围压为100 kPa时,其相对误差有较小的增大趋势;5种方法中,Kumar法确定的阻尼比最接近平均阻尼比,互相关函数法远高于平均阻尼比,Das and Luo法和Kokusho法确定的阻尼比基本一致但低于平均阻尼比。建议以后的工程应用中,加载方式为应力控制时,可采用自相关函数法确定动剪切模量,采用Kumar法确定阻尼比,二者确定的动剪切模量和阻尼比均最接近平均值。 相似文献
Acta Geotechnica - A basal heave stability analysis in anisotropic and non-homogeneous undrained clay by using the kinematic approach of limit analysis is presented. The proposed failure mechanism... 相似文献
It is universally known that residual soils behave very differently from sedimentary soils. While the latter is widely known as cross-anisotropic, little is known regarding the strength anisotropy of residual soils. This study presents how the inherent anisotropy affects the strength of natural granite residual soils under generalized conditions, where intact specimens were carefully prepared and sheared under triaxial compression, extension, simple shear, and hollow cylinder torsional shear tests. The strength of natural residual soil, in terms of ultimate stress ratio M and undrained shear strength Su, is found to be significantly anisotropic in a different way from normally consolidated clays with the maximum strength obtained under triaxial compression and the minimum under simple shear or at intermediate principal stress direction. As a result, the existing method failed to measure the anisotropy degree of the studied soil. Two parameters were proposed accordingly to quantify the anisotropic strength under general conditions, taking the special strength anisotropy pattern and cohesive-frictional nature of GRS into account. The proposed parameters enable the direct comparison of strength anisotropy among soils. This study serves as a data set to better understand residual soils regarding their anisotropic behaviors under generalized conditions. Although specific to granite residual soils in China, this study is expected to be more widely applicable to other weathered geomaterials.