四川盆地：周缘活动主控下形成的叠合盆地

四川盆地位于扬子板块西缘和青藏高原东缘,地震勘探资料等揭示盆地前寒武纪基底保存完整的古俯冲带和地堑-地垒结构,说明盆地基底后期构造活动非常稳定;显生宙以来经历晚震旦世-石炭纪、二叠纪-中三叠世两幕克拉通边缘强拉张-强挤压,而克拉通内弱拉张-弱挤压的构造演化过程,体现出盆地内部稳定性结构沉积演化特征。克拉通内弱拉张初期以海相碳酸盐岩大面积稳定沉积（即震旦系灯影组和二叠系栖霞-茅口组）和随后的风化壳岩溶作用（即桐湾期、东吴期等不整合面）为特征,弱拉张期以拉张槽（如：绵阳-长宁拉张槽和开江-梁平拉张槽等）的形成为典型特征;弱挤压则以古隆起（如：加里东期乐山-龙女寺古隆起、印支期泸州古隆起等）的发育为典型特征。四川盆地晚三叠世后的前陆盆地演化阶段受控于其周缘造山带逆冲推覆构造活动,是现今地貌和构造盆地的主要建造期,形成了四川盆地周缘突变（线型）和渐变（弥散型）两种盆山结构。盆地西边界（龙门山）和北边界（米仓山-大巴山）即是线型突变边界,也是扬子地块（板块）的边界,边界几何形状和扬子板块刚性特征对盆山系统结构-构造特征等有较大的控制作用;四川盆地的东边界（齐岳山-大娄山）和西南边界（大凉山）即是渐变弥散型边界,同时也是板（陆）块内部的边界,它们受控于邻区（盆外）的构造变形和盆内沉积盖层中滑脱层的分布特征。受控于盆地（克拉通）周缘活动,四川盆地垂向上前寒武纪基底与盖层、盖层内早期和晚期构造具解耦特征。基底与盖层构造的解耦有利于盆地内部前寒武纪基底结构构造的保存和盖层内大型隆-坳结构的形成演化;盖层内早期和晚期构造的解耦有利于早期构造免遭后期破环,对深层油气藏的保存意义重大。总之,四川盆地可能是具独特形成过程和特征的叠合盆地新类型,其突出特征表现为周缘活动、内部稳定及早期和晚期构造解耦。     

Petrophysical characterisation of tight sandstone gas reservoirs using nuclear magnetic resonance: a case study of the upper Paleozoic strata in the Kangning area,eastern margin of the Ordos Basin,China

Residual and movable porosity are significant parameters for characterising petrophysical properties, especially in tight reservoirs. Eight tight sandstone samples from the upper Paleozoic gas-bearing strata in the Kangning area, from the eastern margin of the Ordos Basin, were analysed using nuclear magnetic resonance (NMR), scanning electron microscopy (SEM), petrography, and porosity and permeability tests. The lithology and pore types were identified and classified using petrography and SEM. The residual and movable porosity were obtained with NMR. In addition, NMR was used to visualise pore structure and pore size distribution. The results suggest that the upper Paleozoic sandstones in the study area mainly comprise feldspathic litharenite and litharenite. The sandstone porosity and permeability are low, with means of 5.9% and 0.549 mD, respectively. Four pore types exist in the tight sandstones: residual primary pores, grain dissolution pores, micropores (clay-dominated) and microfractures. The T₂ spectra under water-saturated conditions correlate with pore size and can be used to distinguish small and large pores based on the transverse relaxation time cutoff value of 10 ms, which corresponds to a pore diameter of 0.232 μm. Small pores account for 72% of the pores in the tight sandstones. The continuous bimodal T₂ spectra suggest good connectivity between small and large pores, despite the low porosity and permeability. In this study, the movable porosity of the major tight sandstone gas reservoirs is higher than the residual porosity, which confirms the effective evaluation of movable porosity to tight sandstone reservoirs, based on NMR experiments.     

Study on the Development Laws of Bed-Separation Under the Hard-Thick Magmatic Rock and its Fracture Disaster-Causing Mechanism

Based on the analysis of dynamic phenomena under the condition of high-located hard-thick (HLHT) stratum of one coal mine, along with the similar material simulation and theoretical analysis, the characteristics of bed separation development and cracks distribution under the HLHT stratum are studied. This paper proposes a discriminating method for overlying strata Three Zones considering the influence of HLHT stratum. The development laws of cracks and disaster-causing mechanism of hard-thick magmatic rock in different strata are respectively analyzed. The studies show that in line with the working face advancing direction, the height of bed separation under the magmatic rock increases in the trend of “Increase–Stability–Decrease”, and the width of bed separation increases linearly. The width of bed separation reaches the maximum before the first breaking of magmatic rock, the bed separation completely closes after the breaking. There are no obvious bed separations during the period migration of magmatic rock. Along the direction of the height of roof, the development of bed separation is characterized by bottom-up jump based on the key strata. The analyzed results of “Three zone” height obtained by the discriminate method of overlying strata Three Zones which is based on the key strata theory and the S–R instability theory are in line with the actual facts. When the hard-thick magmatic rock is in the fractured zone, large amounts of gas and water are easy to accumulate in the bed separation space and “O” ring space around the gob. The first breaking of magmatic rock may induce bed separation gas outburst and water inrush. When the hard-thick magmatic rock is in the sagging zone, the long-term stability of magmatic rock will not cause serious disasters. But with the adjacent working face mining, bed separation gas and water often become a safety hazard.     

A model for the representation of emergency cases

The aim of this paper is to propose a location model of earthquake emergency service depot on the basis of hybrid multi-attribute decision-making method. The advantage of the proposed method is that practical mixed uncertainty of location decision information is considered, and the corresponding factors that affect the location of transfer stations are contained. To solve the location problem, a hybrid multi-attribute decision procedure without information transformation is developed. Besides, a novel weighting method and aggregation process is given. Finally, a numerical example is provided to show the feasibility and validity of the proposed method.     

电感耦合等离子体质谱法(7900 ICP-MS)测定土壤中30种痕量元素

本文中土壤样品利用HNO3-HF-HCl O4混酸消解和王水提取后,采用电感耦合等离子体质谱(ICP-MS)法同时测定了国家标准土壤样品中30种痕量元素(Ba、Be、Bi、Cd、Ce、Co、Cr、Cs、Cu、Ga、Hf、In、La、Li、Mn、Mo、Nb、Ni、Pb、Rb、Sb、Sc、Sr、Ta、Th、Tl、U、V、W、Zn)的含量。其测定值与标准值相符,准确度符合国家标准要求。该方法所有元素的相关系数在0.9990~1.0000之间,各元素的方法检出限均满足要求,相对标准偏差(RSD)≤10%,结果表明该方法满足土壤中痕量元素的分析要求,建立的方法样品前处理程序简单快速,线性范围宽,分析重现性好,结果准确,可以运用于大批量地质样品中痕量元素含量的同时测定。最后用已建立的方法测定了北京某地区的土壤样品,测试结果满意。     

X射线荧光光谱法测定土壤中34种主、次痕量元素

采用粉末样品压片制样,水系沉积物及土壤国家一级标准物质作为标准,使用经验系数法和散射线内标法校正元素间的吸收增强效应,用X射线光谱仪对土壤样品中的Fe_2O_3、Cao、Cl、S、As、Ba、Br、Ce、Co、Cr、Ni、Cu、Zn等34种主次痕量元素进行测定,用国家一级标准物质GBW07452(GSS-23),GBW07405(GSS-5)和GBW07404(GSS-4)分析检验准确度和精密度,分析结果与标样标准值吻合,除Cl、S、As、Br、Ce、Co、Ni、Th、Sc、Hf、Nb、Nd的精密度小于10.00%以外,其他各元素精密度均在5.00%以内,各元素检出限均满足化探要求。     

Analysis of estimated satellite clock biases and their effects on precise point positioning

This study provides a systemic analysis to identify the biases in estimated satellite clocks and illustrates their effects in precise point positioning (PPP). First, the precise satellite clock estimation method considering pseudorange and carrier phase hardware delays is derived. Two methods for satellite clock estimation are compared, and their equivalency is discussed. The results show that apart from the well-known constant code hardware biases, the time-variant phase hardware biases are also absorbed by the estimated clocks. Also, the satellite clocks contain biases caused by modeling errors. To analyze the effects of these biases, they are grouped into initial clock biases (ICBs) and time-dependent biases (TDBs). Then, a detailed analysis of the impact of the biases on PPP-based troposphere and coordinate estimates is conducted. The experimental analysis demonstrates that TDBs affect positioning and tropospheric estimates, and their impacts are more significant in the static mode. The ICBs affect coordinate accuracy, zenith total delay mean bias, and its standard deviations only at the millimeter level for kinematic and static PPP, which is negligible. However, the ICBs affect the convergence period for both static and real kinematic PPP, and the magnitude of their impact largely depends on data quality. Note that satellites clocks are generally estimated with the P1/P2 and L1/L2 ionospheric-free combinations, and that hardware-specific parts of ICBs and TDBs cancel if users employ the same type of observables as the clock providers. Otherwise, the effects of biases cannot be ignored, especially for triple-frequency applications. Also, modeling-specific parts of ICBs and TDBs are significant in real-time clocks, which also affect user applications. Our conclusion is applicable for understanding the effects of these biases.     

Improved decentralized multi-sensor navigation system for airborne applications

The integration of Global Navigation Satellite System (GNSS) and Inertial Navigation System (INS) technologies is a very useful navigation option for high-accuracy positioning in many applications. However, its performance is still limited by GNSS satellite availability and satellite geometry. To address such limitations, a non-GNSS-based positioning technology known as “Locata” is used to augment a standard GNSS/INS system. The conventional methods for multi-sensor integration can be classified as being either in the form of centralized Kalman filtering (CKF), or decentralized Kalman filtering. However, these two filtering architectures are not always ideal for real-world applications. To satisfy both accuracy and reliability requirements, these three integration algorithms—CKF, federated Kalman filtering (FKF) and an improved decentralized filtering, known as global optimal filtering (GOF)—are investigated. In principle, the GOF is derived from more information resources than the CKF and FKF algorithms. These three algorithms are implemented in a GPS/Locata/INS integrated navigation system and evaluated using data obtained from a flight test. The experimental results show that the position, velocity and attitude solution derived from the GOF-based system indicate improvements of 30, 18.4 and 20.8% over the CKF- and FKF-based systems, respectively.     

Object- and pixel-based classifications of macroalgae farming area with high spatial resolution imagery

Macroalgae plays an important role in coastal ecosystems. The accurate delineation of macroalgae areas is important for environmental management. This study compared the pixel- and object-based methods using Gaofen satellite no. 2 image to explore an efficient classification approach. Expert system rules and nearest neighbour classifier were adopted for object-based classification, whereas maximum likelihood classifier was implemented in the pixel-based approach. Normalized difference vegetation index, normalized difference water index, mean value of the blue band and geometric characteristics were selected as features to distinguish macroalgae farms by considering the spectral and spatial characteristics. Results show that the object-based method achieved a higher overall accuracy and kappa coefficient than the pixel-based method. Moreover, the object-based approach displayed superiority in identifying Porphyra class. These findings suggest that the object-based method can delineate macroalgae farming areas efficiently and be applied in the future to monitor the macroalgae farms with high spatial resolution imagery.     

Arching effect and displacement on theoretical estimation for lateral force acting on retaining wall

Natural Hazards - A new approach is proposed to evaluate the non-limit active earth pressure in c–φ soil based on the horizontal slices method and limit equilibrium method, which takes...