A mathematical hysteretic model for elastomeric isolation bearings

An analytical model for high damping elastomeric isolation bearings is presented in this paper. The model is used to describe mathematically the damping force and restoring force of the rubber material and bearing. Ten parameters to be identified from cyclic loading tests are included in the model. The sensitivity of the ten parameters in affecting the model is examined. These ten parameters are functions of a number of influence factors on the elastomer such as the rubber compound, Mullins effect, scragging effect, frequency, temperature and axial load. In this study, however, only the Mullins effect, scragging effect, frequency and temperature are investigated. Both material tests and shaking table tests were performed to validate the proposed model. Based on the comparison between the experimental and the analytical results, it is found that the proposed analytical model is capable of predicting the shear force–displacement hysteresis very accurately for both rubber material and bearing under cyclic loading reversals. The seismic response time histories of the bearing can also be captured, using the proposed analytical model, with a practically acceptable precision. Copyright © 2002 John Wiley & Sons, Ltd.     

Tests on low‐ductility RC frames under high‐ and low‐frequency excitations

The response of low‐ductility reinforced concrete (RC) frames, designed typically for a non‐seismic region, subjected to two frequencies of base excitations is studied. Five half‐scaled, two‐bay, two‐storey, RC frames, each approximately 5 m wide by 3.3 m high, were subjected to both horizontal and/or vertical base excitations with a frequency of 40 Hz as well as a lower frequency of about 4 Hz (close to the fundamental frequency) using a shake table. The imposed acceleration amplitude ranged from 0.2 to 1.2g. The test results showed that the response characteristics of the structures differed under high‐ and low‐frequency excitations. The frames were able to sustain high‐frequency excitations without damage but were inadequate for low‐frequency excitations, even though the frames exhibited some ductility. Linear‐elastic time‐history analysis can predict reasonably well the structural response under high‐frequency excitations. As the frames were not designed for seismic loads, the reinforcement detailing may not have been adequate, based on the crack pattern observed. The effect of vertical excitation can cause significant additional forces in the columns and moment reversals in the beams. The ‘strong‐column, weak‐beam’ approach for lateral load RC frame design is supported by experimental observations. Copyright © 2001 John Wiley & Sons, Ltd.     

Optimal design of passive energy dissipation systems based on H∞ and H2 performances

Passive energy dissipation devices (EDDs), such as viscous dampers, viscoelastic dampers, etc., have been used to effectively reduce the dynamic response of civil infrastructures, such as buildings and bridges, subject to earthquakes and strong winds. The design of these passive energy dissipation devices (EDDs) involves the determination of the optimal locations and the corresponding capacities. In this paper, we present two optimal design methodologies for passive EDDs based on active control theories, including H_∞ and H₂ performances, respectively. The optimal design methodologies presented are capable of determining the optimal locations and the corresponding capacities of EDDs. Emphasis is placed on the application of linear matrix inequality (LMI) for the effective design of passive EDDs using the popular MATLAB toolboxes. One important advantage of the proposed approaches is that the computation of the structural response is not needed in the design process. The proposed optimal design methodologies have been applied to: (i) a 10‐storey building and a 24‐storey building both subject to earthquake excitations, and (ii) a 76‐storey wind‐excited benchmark building, to demonstrate the advantages of the proposed design methodologies over the conventional equal capacity design. Copyright © 2002 John Wiley & Sons, Ltd.     

Study on effects of damping in laminated rubber bearings on seismic responses for a ⅛ scale isolated test structure

The effects of damping in various laminated rubber bearings (LRB) on the seismic response of a ?‐scale isolated test structure are investigated by shaking table tests and seismic response analyses. A series of shaking table tests of the structure were performed for a fixed base design and for a base isolation design. Two different types of LRB were used: natural rubber bearings (NRB) and lead rubber bearings (LLRB). Three different designs for the LLRB were tested; each design had a different diameter of lead plug, and thus, different damping values. Artificial time histories of peak ground acceleration 0.4g were used in both the tests and the analyses. In both shaking table tests and analyses, as expected, the acceleration responses of the seismically isolated test structure were considerably reduced. However, the shear displacement at the isolators was increased. To reduce the shear displacement in the isolators, the diameter of the lead plug in the LLRB had to be enlarged to increase isolator damping by more than 24%. This caused the isolator stiffness to increase, and resulted in amplifying the floor acceleration response spectra of the isolated test structure in the higher frequency ranges with a monotonic reduction of isolator shear displacement. Copyright © 2002 John Wiley & Sons, Ltd.     

可持续发展评估指标、方法及应用研究

可持续发展评估指标及方法研究是可持续发展定量评估研究的基础,是实施可持续发展管理的依据,是生态经济学与可持续发展研究的前沿领域和热点问题之一. 在概括介绍可持续发展评估的工具--指标/指数的概念和功能、国际上代表性可持续发展研究机构指标选取的原则的基础上,全面分析归纳了可持续发展指标(体系)的类型及其框架模式. 详细介绍了联合国可持续发展委员会(UNCSD)、经济合作与发展组织(OECD)、世界保护同盟(IUCN)、世界银行等国际上代表性机构的可持续发展系统性指标体系的最新研究进展,并分析了这些系统性指标体系的优缺点. 深入分析了国际上典型的社会发展类、经济发展类、生态环境类可持续发展指标(指数)的研究、开发与实际评估应用的情况. 最后,总结了当前可持续发展指标(体系)研究的特点与趋势.     

古—中生代之交的全球变化与生物效应

古—中生代之交是显生宙以来最大的一次生物绝灭期 ,其形成机制一直是地学界长期探讨的热点课题之一。地史重大转折期是地球内、外各圈层长期作用下 ,各种量变达到阀值 ,加之可能的外因激化 ,在短时间内以连锁反应形式相继质变 ,形成了全球变化 (包括生物绝灭 )的地球突变期。文中从可能的外因 (外星体撞击事件 )及内因 (岩石圈的变化 ,地球表层的变化和生物圈的变化 )两个方面探讨了古—中生代之交的全球变化与生物效应     

论三维等时线叠加反偏移中的有关问题

利用几何射线理论和一种考虑了积分域边缘贡献的二维稳想法，研究了三维等时线叠加反偏移中的反偏移场，反偏移加权函及反偏移孔径。结果证明，在有限孔径条件下，反偏移场的结构比已发表的结果要复杂和多。即使在最简单的条件下，反偏移场也是由反偏移信号的反偏移噪声（孔径效应）叠加而成的。而且，反偏移场的结构强烈地依赖于反偏移孔径边缘的位置。为了消除孔径效应，应采用最佳反偏移孔径和针对有限孔径的加权函数。根据定义，最佳反偏移孔径为稳相点的第一和第二Fresnel区之和。在第一Fresnel区内，有限孔径和加权函数与文献中所给出的加权函数完全一致。而在第二Fresnel区内，有限孔径加权函数为常规的加权函数与一窗函数的乘积。在反偏移孔径的边缘上，有限孔径加权函恒取零值。     

农牧交错带典型区农业与牧业用地互动关系研究

利用1989年和2000年的两期Landsat-TM数据和相关的统计资料以及气候数据，应用转移距阵和多元回归分析等研究方法，对地处典型农牧交错带地区的兴和县土地利用变化进行研究，结果表明：农田和草地是研究区域中最主要的土地利用类型，Landsat-TM卫星影像数据和统计数据比较一致地反映农田和草地面积的变化；农田和草地的相互转换率在各种用地相互转化中非常剧烈；农业与牧业用地的互动特征具有明显的区域差异；农业和牧业用地的互动特点是自然因素和社会经济因素同时影响的结果。     

A multi-scale study on land use and land cover quality change: The case of the Yellow River Delta in China

This paper presents a case study of the Yellow River Delta in China, to trace land use and land cover changes during the past 20 years, with an emphasis on land quality changes. Three sets of data are used in this case study: remote sensing data derived from satellite images; crop yield data from statistics; and soil data collected by the researchers in the field. Our study reveals that at the regional scale, LUCC has taken place in a positive direction: vegetation cover has been expanding and crop yields per hectare have been on rise. However, while the overall eco-environment has improved, the improvement is uneven across the Delta region. At local levels, some areas show signs of increased salinization and declining organic content. Both natural forces and human activities are responsible for the LUCC, but human activities play a more important role. While some impacts of human activities are positive, the damages are often long-lasting and irreversible. We also conclude that it is necessary to use both macro data (such as remote sensing data) and micro data (data collected in the field) to study land quality change. The former are efficient in examining land quality changes at the regional scale, the latter can serve to verify ground patterns revealed from macro data and help to identify local variations, so as to get a comprehensive understanding of LUCC and promote sustainable land use and land management. This revised version was published online in July 2006 with corrections to the Cover Date.     

三牙轮钻头内流场数值研究及损坏原因分析

采用时均N－S方程和标准κ-ε紊流模型，在贴体坐标系中对三牙轮钻头内流场进行了数值研究。通过大量的数值试验，其结果表明：现有三牙轮钻头的内流道结构是不合理的，主要表现在内流道诱发“过流断面突变效应”，严重的导致三牙轮钻头内流道的空蚀破坏。