Structure and oscillations in quiescent filaments from observations in He i λ10830 å

Observations of two quiescent filaments show oscillatory variations in Doppler shift and central intensity of the He i 10830 Å line.The oscillatory periods range from about 5 to 15 min, with dominant periods of 5, 9, and 16 min. The 5-min period is also detected in the intensity variations, after correction for atmospheric effects. Doppler shifts precede intensity variations by about one period. The possibility that the oscillations are Alfvén waves is discussed.The Doppler signals of the filament form fibril-like structures. The fibrils are all inclined at an angle of about 25° to the long axis of the filament. The magnetic field has a similar orientation relative to the major direction of the filament, and the measured Doppler signals are apparently produced by motions along magnetic flux tubes threading the filament.The measured lifetimes of the small-scale fibrils of quiescent disk filaments are very likely a combined effect of intensity modulations and reshuffling of the structures.     

Study on the kinetics of iron oxide leaching by oxalic acid

The presence of iron oxides in clay or silica raw materials is detrimental to the manufacturing of high quality ceramics. Although iron has been traditionally removed by physical mineral processing, acid washing has been tested as it is more effective, especially for extremely low iron (of less than 0.1% w/w). However, inorganic acids such as sulphuric or hydrochloric acids easily contaminate the clay products with SO₄²⁻ and Cl⁻, and therefore should be avoided as much as possible. On the other hand, if oxalic acid is used, any acid left behind will be destroyed during the firing of the ceramic products. The characteristics of dissolution of iron oxides were therefore investigated in this study.The dissolution of iron oxides in oxalic acid was found to be very slow at temperatures within the range 25–60 °C, but its rate increases rapidly above 90 °C. The dissolution rate also increases with increasing oxalate concentration at the constant pH values set within the optimum range of pH2.5–3.0. At this optimum pH, the dissolution of fine pure hematite (Fe₂O₃) (105–140 μm) follows a diffusion-controlled shrinking core model. The rate expression expressed as 1 − (2 / 3)x − (1 − x)^2 / 3 where x is a fraction of iron dissolution was found to be proportional to [oxalate]^1.5.The addition of magnetite to the leach liquor at 10% w/w hematite was found to enhance the dissolution rate dramatically. Such addition of magnetite allows coarser hematite in the range 0.5–1.4 mm to be leached at a reasonable rate.     

Structural similarity and variety at the tips in a wide range of strike–slip faults: a review

Strike–slip faults are often accompanied by a variety of structures, particularly at their tips. The zones of additional fracturing are classified as tip‐damage zones. These zones can be subdivided into several different damage patterns based on the nature and orientation of faults and fractures developed. Damage zones at the ends of small strike–slip faults (mode II tips) develop wing cracks, horsetail splays, antithetic faults, synthetic branch faults and solution surfaces. Similar tip‐damage patterns are also commonly observed at larger (regional) scales, but with a dominance of faulting over tensile cracks and solution surfaces. Wing cracks and horsetail splays developed at small‐scale faults are replaced by normal faults in large‐scale faults. Antithetic faults and synthetic branch faults are observed at small and large scales. Thrust faults are developed at large scales, in a similar pattern to solution surfaces at a small scale. All these structures may show slightly different angular relationships to the master fault at small and large scale, but develop in response similar stress distribution and mechanics around the fault. Thus, mode II tip‐damage zones show similar patterns over a wide range of fault scales.     

Effect of polypropylene fibre and lime admixture on engineering properties of clayey soil

In order to reduce the brittleness of soil stabilized by lime only, a recent study of a newly proposed mixture of polypropylene fibre and lime for ground improvement is described and reported in the paper. To investigate and understand the influence of the mixture of polypropylene fibre and lime on the engineering properties of a clayey soil, nine groups of treated soil specimens were prepared and tested at three different percentages of fibre content (i.e. 0.05%, 0.15%, 0.25% by weight of the parent soil) and three different percentages of lime (i.e. 2%, 5%, 8% by weight of the parent soil). These treated specimens were subjected to unconfined compression, direct shear, swelling and shrinkage tests. Through scanning electron microscopy (SEM) analysis of the specimens after shearing, the improving mechanisms of polypropylene fibre and lime in the soil were discussed and the observed test results were explained. It was found that fibre content, lime content and curing duration had significant influence on the engineering properties of the fibre–lime treated soil. An increase in lime content resulted in an initial increase followed by a slight decrease in unconfined compressive strength, cohesion and angle of internal friction of the clayey soil. On the other hand, an increase in lime content led to a reduction of swelling and shrinkage potential. However, an increase in fibre content caused an increase in strength and shrinkage potential but brought on the reduction of swelling potential. An increase in curing duration improved the unconfined compressive strength and shear strength parameters of the stabilized soil significantly. Based on the SEM analysis, it was found that the presence of fibre contributed to physical interaction between fibre and soil whereas the use of lime produced chemical reaction between lime and soil and changed soil fabric significantly.     

Strain softening of K0-consolidated Changi sand under plane-strain conditions

Experimental results are presented in this paper to study the strain softening behaviour of a marine dredged sand under plane-strain conditions. K₀ consolidated drained and undrained tests were conducted using a new plane-strain apparatus to characterize the strain softening behaviour of the sand under plane-strain conditions. For medium dense specimens, strain softening and shear bands were observed to occur under both drained and undrained conditions. For very loose specimens, no shear bands were observed and critical states were reached within the homogeneous deformation region in both drained and undrained tests. Strain softening was observed to occur at small strain for very loose specimens under undrained conditions. Two types of strain softening, the homogenous softening and banding softening, were identified and the conditions for strain softening were established. The results obtained from this study were compared with the studies by Han and Vardoulakis (Géotechnique 41(1):49–78, 1991), Finno et al. (J Geotech Eng ASCE 122(6):462–473, 1996, Géotechnique 47(1):149–165, 1997) and Mokni and Desrues (Mech Cohes-Frict Mat 4:419–441, 1998).     

Food Deserts in the Prairies? Supermarket Accessibility and Neighborhood Need in Edmonton,Canada*

The U.S. and U.K. literatures have discussed “food deserts,” reflecting populated, typically urban, low‐income areas with limited access to full‐service supermarkets. Less is known about supermarket accessibility within Canadian cities. This article uses the minimum distance and coverage methods to determine supermarket accessibility within the city of Edmonton, Canada, with a focus on high‐need and inner‐city neighborhoods. The results show that for 1999 both of these areas generally had higher accessibility than the remainder of the city, but six high‐need neighborhoods had poor supermarket accessibility. We conclude by examining potential reasons for differences in supermarket accessibility between Canadian, U.S., and U.K. cities.     

柴达木盆地西部尕斯库勒油田E31油藏成藏条件与机制

柴达木盆地西部原油为盐湖相未成熟-低成熟原油,属于典型的原油成因类型。尕斯库勒油田是柴达木盆地西部最大的油田。从油气生成运移、聚集成藏诸方面,较为系统地研究了该油田中E1₃ 油藏的形成条件,动态地探讨了油藏的形成机制,为该油藏的成因认识和进一步勘探开发提供了科学依据。     

基于PGNAA技术在线分析系统的应用

近年来,随着核探测与分析技术的日趋成熟,使复杂γ谱的获取、解析达到了在线测量的要求,从而使在线PGNAA(中子活化瞬发γ射线分析)技术获得了飞速的发展。它可对一些工业生产过程中的全物料进行在线测量,其分析精度、可靠性等皆能满足在线元素含量分析的需要,因而显示出巨大的发展潜力和广阔的市场前景。这里介绍了基于PGNAA技术的在线分析系统的基本原理、组成和发展,并概述了它在水泥、煤炭等行业的应用情况。     

昆明市山地灾害风险分区及防治对策

通过地质灾害调查，认为昆明市地质灾害以泥石流、滑坡、崩塌为主。分析地质灾害时空分布及形成条件，从致灾因子角度，给出昆明市地质灾害风险区划，提出地质灾害防治对策。     

青藏高原北部温泉活动沉积盆地的沉积特征及其地质意义

晚新生代温泉沉积盆地，是青藏高原腹地在南北向挤压、东西向伸展的构造背景下，沿南北向边界走滑断层，经边界正断层和内部张剪断层的进一步发展而形成的近南北向单断单剪楔形半地堑活动沉积盆地。它可能代表了晚新生代青藏高原第三期强烈挤压隆升事件，是侧向向东剪切挤出的结果。笔者以盆地充填序列和TL、ESR测年资料为主要依据，推测唐古拉山在300～250ka前后全面进入冰冻圈；而以温泉活动沉积盆地为代表的中更新世晚期(224．0～150．2ka)的冰碛一冰水堆积则对应于青藏高原第三期隆升的断陷盆地发育阶段；中更新世晚期一晚更新世中期(144．0～56ka)为湖相沉积；晚更新世中期至今(35～0ka)对应于高原缓慢隆升与夷平发育阶段。长江溯源在35ka切割通天河盆地，形成通天河；而在16kat浸蚀切穿雁石坪一温泉兵站峡谷，形成布曲河。