Application of common reflection angle migration for imaging deformation structures in an inner accretionary wedge,Nankai Trough,Japan

To better image deformation structures within the inner accretionary wedge of the Nankai Trough, Japan, we apply common reflection angle migration to a legacy two-dimensional seismic data set acquired with a 6 km streamer cable. In this region, many seismic surveys have been conducted to study the seismogenic zone related to plate subduction. However, the details of the accreted sediments beneath the Kumano forearc basin are still unclear due to the poor quality of seismic images caused by multiple reflections, highly attenuated signals, and possibly complex geological structures. Generating common image gathers in the subsurface local angle domain rather than the surface offset domain is more advantageous for imaging geological structures that involve complex wave paths and poor illumination. By applying this method, previously unseen structures are revealed in the thick accreted sediments. The newly imaged geometric features of reflectors, such as the folds in the shallow part of the section and the deep reflectors with stepwise discontinuities, imply deformation structures with multiple thrust faults. The reflections within the deep accreted sediments (approximately 5 km) are mainly mapped to far angles (30°–50°) in the common reflection angles, which correspond to the recorded offset distances greater than 4.5 km. This result indicates that the far offset/angle information is critical to image the deformation structures at depth. The new depth image from the common reflection angle migration provides seismic evidence of multiple thrust faults and their relationship with the megathrust fault that is essential for understanding the structure and evolution of the Nankai Trough seismogenic zone.     

Simulation analyses of buildings damaged in the 1995 Kobe,Japan, earthquake considering soil–structure interaction

A series of studies was conducted on three buildings of steel reinforced concrete structures with RC shear walls damaged in the 1995 Hyogo-ken Nanbu earthquake. These buildings are located in an area where structural damage centred around. Two of these buildings suffered severe damage, while the third was not structurally damaged. Our studies deal with site inspections, including micro-tremor measurement of buildings, the evaluation of input motions, and the response analyses considering soil–structure interaction. The results of simulation analyses of the two severely damaged buildings correspond to their actual damage state. From the response analyses of the one slender building with no structural damage, it was concluded that uplifting is the main reason it did not suffer any structural damage. Through these studies, the importance of soil–structure interaction and effective input motion is fully understood. Copyright © 1999 John Wiley & Sons, Ltd.     

Lunar photometric properties at wavelengths 0.5-1.6 μm acquired by SELENE Spectral Profiler and their dependency on local albedo and latitudinal zones

The lunar photometric function, which describes the dependency of the observed radiance on the observation geometry, is used for photometric correction of lunar visible/near-infrared data. A precise photometric correction parameter set is crucial for many applications including mineral identification and reflectance map mosaics. We present, for the first time, spectrally continuous photometric correction parameters for both sides of the Moon for wavelengths in the range 0.5-1.6 μm and solar phase angles between 5° and 85°, derived from Kaguya (SELENE) Spectral Profiler (SP) data. Since the measured radiance also depends on the surface albedo, we developed a statistical method for selecting areas with relatively uniform albedos from a nearly 7000-orbit SP data set. Using the selected data set, we obtained empirical photometric correction parameter sets for three albedo groups (high, medium, and low). We did this because the photometric function depends on the albedo, especially at phase angles below about 20° for which the shadow hiding opposition effect is appreciable. We determined the parameters in 160 bands and discovered a small variation in the opposition effect due to the albedo variation of mafic mineral absorption. The consistency of the photometric correction was checked by comparing observations made at different times of the same area on the lunar surface. Variations in the spectra obtained were lower than 2%, except for the large phase angle data in mare. Lastly, we developed a correction method for low solar elevation data, which is required for high latitude regions. By investigating low solar elevation data, we introduced an additional correction method. We used the new photometric correction to generate a 1° mesh global lunar reflectance map cube in a wavelength range of 0.5-1.6 μm. Surprisingly, these maps reveal that high latitude (?75°) regions in both the north and south have much lower spectral continuum slopes (color ratio r_1547.7nm/r_752.8nm ? 1.8) than the low and medium latitude regions, which implies lower degrees of space weathering.     

Influence of shear angle on hangingwall deformation during tectonic inversion

Tectonic inversion is a common phenomenon in island arc settings, especially in back‐arc basins. The reactivation of normal faults as thrusts, triggered by tectonic inversion, produces typical inversion fault‐related folds and thrusts in the hangingwall. These hangingwall inversion geometries are affected by two factors: the geometry of the underlying master fault and the angle of inclined simple shear relative to the regional dip of strata, in the case that the deformation is approximated by simple shear. This study employed numerical simulations to analyse the influence of the antithetic shear angle on the geometry of the hangingwall and displacement along the master fault. The simulation results reveal that a steeply inclined shear vector during extension produces a narrow, steep‐sided half‐graben, whereas a gently inclined shear produces a wide, open basin. After tectonic inversion, a tight anticline is formed under steeply inclined shear, whereas an open anticline is formed under gently inclined shear. Antithetic shear results in reduced total displacement along the master fault, and the greater the angle between the shear direction and the regional dip, the greater the displacement along the master fault. Because the deformation geometry of syn‐extension layers is affected by extension followed by contraction, a change in the shear angle during tectonic inversion produces a wide variety of deformation geometries. Comparison of the simulation results with the results of analogue modelling suggests that the shear angle decreases by 5° during the transition from extension to tectonic inversion and that such a change may be commonly observed in natural geological structures. These results highlight the benefits of numerical simulations, which can be used to readily examine a variety of constraining parameters and thereby lead to a better understanding of the mechanism of hangingwall deformation, avoiding erroneous estimates of the amount of fault displacement.     

Monitoring heat losses using Landsat ETM+ thermal infrared data — a case study at Kuju fumarolic area in Japan

To monitor heat losses using Landsat 7 thermal infrared data from 2002 to 2010 within the active fumarolic region of Kuju volcano in Japan, we used the Stefan-Boltzmann equation for radiative heat flux (RHF) estimation. Heat discharge rate (HDR) was calculated by using the relationship coefficient of RHF and HDR, obtained from two previous studies. The highest total RHF was found to be about 57.7 MW in 2002 and the lowest was about 21.1 MW in 2010. We found the highest HDR, of about 384.5 MW, in 2002 and the lowest, of about 140.8 MW, in 2010. The RHF anomalous areas were showing a declining trend during our study period. The relationship between the land surface temperature (LST) above ambient and RHF was, as expected, in a strong correlation for each result during our study period. Overall, our study was able to delineate the declining trend of heat losses that supports a previous study of similar declining trend of HDR using steam maximum diameter method from the active fumarolic region of Kuju volcano.     

The early Miocene (~25 Ma) volcanism in the northern Kyushu-Palau Ridge,enriched mantle source injection during rifting prior to the Shikoku backarc basin opening

The northern Kyushu-Palau Ridge (KPR), remnant conjugate arc of the Izu-Ogasawara (Bonin)-Mariana (IBM) active arc, is dominated by basalt-andesite except for the Komahashi-Daini Seamount where acidic plutonic rocks of 38 Ma were recovered. These mafic to intermediate volcanics are produced by the rifting volcanism in the proto-IBM arc associated with spreading of the Shikoku Basin. The HFSE and HREE contents and ratios of these volcanics indicate enriched source mantle composition compared to recent volcanic front. The LILE ratios exhibit similar characteristics to reararc volcanism of the recent Izu arc, and some enriched volcanics exhibit high abundance of sediment melt inputs. Based on these observations and compilations of the published data set, the replacement event of the wedge mantle under the IBM arc occurred two times. The first event occurred between 45 and 38 Ma, with Pacific type mantle being replaced by depleted Indian type mantle. The second event occurred between 36 and 25 Ma, enriched mantle flowed from reararc side. The slab component during the proto-IBM arc rifting was a similar characteristic to recent reararc volcanism of the Izu arc, and sediment melt added in a local area.     

Explosive volcanic eruptions triggered by cosmic rays: Volcano as a bubble chamber

Volcanoes with silica-rich and highly viscous magma tend to produce violent explosive eruptions that result in disasters in local communities and that strongly affect the global environment. We examined the timing of 11 eruptive events that produced silica-rich magma from four volcanoes in Japan (Mt. Fuji, Mt. Usu, Myojin-sho, and Satsuma-Iwo-jima) over the past 306 years (from AD 1700 to AD 2005). Nine of the 11 events occurred during inactive phases of solar magnetic activity (solar minimum), which is well indexed by the group sunspot number. This strong association between eruption timing and the solar minimum is statistically significant to a confidence level of 96.7%. This relationship is not observed for eruptions from volcanoes with relatively silica-poor magma, such as Izu-Ohshima. It is well known that the cosmic-ray flux is negatively correlated with solar magnetic activity, as the strong magnetic field in the solar wind repels charged particles such as galactic cosmic rays that originate from outside of the solar system. The strong negative correlation observed between the timing of silica-rich eruptions and solar activity can be explained by variations in cosmic-ray flux arising from solar modulation. Because silica-rich magma has relatively high surface tension (~ 0.1 Nm^?1), the homogeneous nucleation rate is so low that such magma exists in a highly supersaturated state without considerable exsolution, even when located relatively close to the surface, within the penetration range of cosmic-ray muons (1–10 GeV). These muons can contribute to nucleation in supersaturated magma, as documented by many authors studying a bubble chamber, via ionization loss. This radiation-induced nucleation can lead to the pre-eruptive exsolution of H₂O in the silica-rich magma. We note the possibility that the 1991 Mt. Pinatubo eruption was triggered by the same mechanism: an increase in cosmic-ray flux triggered by Typhoon Yunya, as a decrease in atmospheric pressure results in an increase in cosmic-ray flux. We also speculate that the snowball Earth event was triggered by successive large-scale volcanic eruptions triggered by increased cosmic-ray flux due to nearby supernova explosions.     

Phase relations of iron and iron–nickel alloys up to 300 GPa: Implications for composition and structure of the Earth's inner core

We have investigated the phase relations of iron and iron–nickel alloys with 18 to 50 wt.% Ni up to over 300 GPa using a laser-heated diamond-anvil cell. The synchrotron X-ray diffraction measurements show the wide stability of hcp-iron up to 301 GPa and 2000 K and 319 GPa and 300 K without phase transition to dhcp, orthorhombic, or bcc phases. On the other hand, the incorporation of nickel has a remarkable effect on expanding the stability field of fcc phase. The geometry of the temperature–composition phase diagram of iron–nickel alloys suggests that the hcp–fcc–liquid triple point is located at 10 to 20 wt.% Ni at the pressure of the inner core boundary. The fcc phase could crystallize depending on the nickel and silicon contents in the Earth's core, both of which are fcc stabilizer.