Investigation of moment-rotation relation in different joint types and evaluation of their effects on segmental tunnel lining

This paper presents the results of a numerical study that has been performed to investigate the different joint types that affect the moment-rotation relation and ultimate bending moment capacity of a joint. A 3D finite element method was adapted to establish elaborate numerical models of segments. To evaluate the possible differences in moment-rotation behavior between different joint types, 10 different joint types were simulated. Additionally, the effect of different joint types on behavior of a lining ring was investigated. The validity of the peridynamic simulation was tested by comparing results obtained in this paper against the results obtained in a study performed by Hordijk and Gijsbers. Observations of the results demonstrate that in a flat joint, the expanding of joint height increased the rotation stiffness of the joint in the linear branch, and accordingly, the ultimate bending moment of the joint increased. In the ring model, it was observed that the expanding of joint height led to the decreased of ring displacement and stress concentration in the joint. Whenever there were full surface contacts (contact two segment in total cross section) in the joints, the rotation stiffness of the joints in the linear branch became equal, and, as a result, the displacement in the ring model was the same in all joint types. In addition, it was observed that using a convex joint in the ring model increases the displacement of the ring. The ultimate bending moment of bolted joints was higher than that of joints without bolts, especially in the case of a negative moment.     

Characterization of the Tertiary reservoir in Khabbaz Oil Field,Kirkuk area,Northern Iraq

Tertiary reservoir represented by Jeribe, Anah, Azkand, and Azkand/Ibrahim formations has been studied from reservoir characterization point of view in Khabbaz Oil Field/Northern Iraq. Examined thin sections prepared from core rock samples which are selected from the wells Kz-8 and Kz-9 revealed the existence of different microfacies in which are varies types of porosity such as interparticle, intraparticle, moldic, vuggy, and fractures have been noticed. In addition to these different types of diagenetic features are represented mainly by cementation, dolomitization, recrystallization, and dissolution. The available log data for the wells Kz-11, Kz-14, and Kz-16 have been used in characterizing the reservoir properties of the studied formations. The detected lithologies from porosity logs showed domination of limestone, dolomitic limestone, and dolomites in addition to few thin beds of anhydrites in Jeribe Formation and thin beds of sand dominated lithologies in Azkand Formation. Clay content has been calculated from gamma ray log along the studied sections and appeared to be mostly of dispersed clay type as shown from density-neutron porosity crossplot of Thomas-Stieber. Correction from the effect of clay content has been done for all the measured sonic, density, and neutron porosities. The available porosity and permeability values which are measured from core tests in the well Kz-9 for the formations of Jeribe, Anah, and Azkand have been adapted to formalize the best equation for calculating permeability in the other studied wells which have no core test measurements but only log data (Kz-11, Kz-14, and Kz-16 wells). Depending on porosity, permeability, and shale content, the studied sections have been subdivided into seven reservoir units in the wells Kz-11 and Kz-16, and for eight reservoir units in the well Kz-14.     

海洋卡盾藻对青岛大扁藻的化感作用及其对UV-B辐射的响应

本研究以海洋微藻——赤潮藻海洋卡盾藻(Chattonella marina)与饵料藻青岛大扁藻(Platymonas helgolandica var.tsingtaoensis)为研究对象,采用单培养和共培养的方法,研究二者间的竞争关系,并在此基础上研究海洋卡盾藻去藻过滤液和藻细胞裂解液对青岛大扁藻的化感作用,同时进一步探讨两种海洋微藻间的化感作用对UV-B辐射增强的响应。结果显示:共培养条件下,海洋卡盾藻在2个高浓度下对青岛大扁藻的生长产生显著抑制(P0.05);海洋卡盾藻去藻过滤液和藻细胞裂解液对青岛大扁藻的生长也具有显著抑制作用(P0.05),且藻细胞裂解液的抑制作用更强,说明海洋卡盾藻对青岛大扁藻产生化感作用,且通过细胞间直接接触传递的化感物质多于通过介质传递的。不同密度比例的2种藻共培养组用UV-B辐射(2.16J/m2)处理后,海洋卡盾藻对青岛大扁藻生长的化感作用有所减弱。     

琼州海峡潮流能资源的数值模拟评估

近年来,我国能源消耗量不断的增长使我们更加重视可再生能源的开发利用,而我国近海拥有复杂的海岸线和广阔的大陆架,其中许多海域蕴藏着丰富的潮流能资源。潮流能资源评估则是其电站站址选择、发电量预测等工程设计的首要工作。结合两个站位的潮流实测数据,本文利用FVCOM海洋环流数值模式较好的模拟了琼州海峡潮波传播状况,分析了该海域潮流能资源水平分布规律和时间变化特征,初步估算了该水道的潮流能的理论蕴藏量,并采用FLUX方法对该水道的技术可开发量进行了评估。结果表明,琼州海峡中心海域功率密度高,两岸资源低;可能最大流速、大潮年平均最大功率密度、小潮年平均功率密度和年平均功率密度等特征值分布基本相似;其丰富区域出现在海峡东口南部海域以及海峡中部海域,其中东口南部海域可能最大流速可达4.6 m/s,表层流大潮年平均最大功率密度为5996 W/m²,小潮平均最大功率密度仅为467 W/m²,年平均功率密度为819 W/m²,代表点超过0.7 m/s的潮流流速年统计时间约为4717 h;海峡潮流能资源理论蕴藏量为189.55MW,利用FLUX、FARM、GC方法得到该水道的潮流能可开发量分别为249GW/yr、20.2GW/yr和263GW/yr。     

星载SAR对雨团催生海面风场的观测研究

雨团或对流雨是热带与亚热带地区的主要降雨形式,较易被高分辨率星载合成孔径雷达（SAR）探测到。SAR图像上的雨团足印是由大气中雨滴的散射与吸收、下沉气流等共同导致形成的。本文以RADARSAT-2卫星100 m分辨率的SAR图像上雨团引起的海面风场及其结构反演与解译作为实例进行分析。使用CMOD4地球物理模式函数,分别以NCEP再分析数据、欧洲MetOp-A卫星先进散射计（ASCAT）和中国HY-2卫星微波散射计的风向为外部风向,进行了SAR图像的海面风场反演。反演的海面风速相对于NCEP、ASCAT和HY-2的均方根误差（RMSE）分别为1.48 m/s,1.64 m/s和2.14 m/s。SAR图像上一侧明亮另一侧昏暗的圆形信号图斑被解译为雨团携带的下沉气流对海面风场（海面粗糙度）的改变所致。平行于海面背景风场其通过雨团圆形足印中心的剖面上的风速变化可拟合为正弦或余弦曲线,其拟合线性相关系数均不低于0.80。背景风场的风速大小、雨团引起的风速大小以及雨团足印的直径可利用拟合曲线获得,雨团足印的直径大小一般为数千米或数十千米,本文的8例个例解译与分析均验证了该结论。     

Microstructure observations in the upper layer of the South China Sea

A general pattern for turbulent mixing in the upper layer of the South China Sea (SCS) is presented based on TurboMAP measurements in April and May 2010. The turbulence level decreased significantly overall from north to south, and weakened from east to west in the northern SCS. The average dissipation rate north of 18°N reaches 1.69 × 10^?8 W/kg, approximately six times larger than that south of 18°N. The mean mixing efficiency in the SCS is 0.2, with a maximum of 0.31 near the Luzon Strait. At one repeatedly occupied station located in the central deep basin, the dissipation rate varies diurnally in the mixed layer and pycnocline due to diurnal heating and cooling by solar radiation and local barotropic tide, respectively.     

AMSR-E sea surface temperature (SST) charts enhancement

Microwave satellite images used for retrieving sea surface temperatures often have such distortions as noise and blurring of the thermal fronts. An image processing approach based on the Mumford-Shah model of optimal image approximation is considered for the solution to this problem. We divide images into flat areas and frontal zones, and then process these areas separately. Image fragmentation is based on automatic detection of the thermal front lines. SST enhancement in frontal zones is achieved by using image deconvolution methods. It has been shown that SST errors in high gradient areas reach 1–3 °C. The proposed approach can decrease this discrepancy.     

Seasonal variations in the nitrogen isotopic composition of settling particles at station K2 in the western subarctic North Pacific

Intensive observations using hydrographical cruises and moored sediment trap deployments during 2010 and 2012 at station K2 in the North Pacific Western Subarctic Gyre (WSG) revealed seasonal changes in δ ¹⁵N of both suspended and settling particles. Suspended particles (SUS) were collected from depths between the surface and 200 m; settling particles by drifting sediment traps (DST; 100–200 m) and moored sediment traps (MST; 200 and 500 m). All particles showed higher δ ¹⁵N values in winter and lower in summer, contrary to the expected by isotopic fractionation during phytoplankton nitrate consumption. We suggest that these observed isotopic patterns are due to ammonium consumption via light-controlled nitrification, which could induce variations in δ ¹⁵N(SUS) of 0.4–3.1 ‰ in the euphotic zone (EZ). The δ ¹⁵N(SUS) signature was reflected by δ ¹⁵N(DST) despite modifications during biogenic transformation from suspended particles in the EZ. δ ¹⁵N enrichment (average: 3.6 ‰) and the increase in C:N ratio (by 1.6) in settling particles suggests year-round contributions of metabolites from herbivorous zooplankton as well as TEPs produced by diatoms. Accordingly, seasonal δ ¹⁵N(DST) variations of 2.4–7.0 ‰ showed a significant correlation with primary productivity (PP) at K2. By applying the observed δ ¹⁵N(DST) vs. PP regression to δ ¹⁵N(MST) of 1.9–8.0 ‰, we constructed the first annual time-series of PP changes in the WSG. This new approach to estimate productivity can be a powerful tool for further understanding of the biological pump in the WSG, even though its validity needs to be examined carefully.