基于LOD的选取模型应用于电子地图多尺度显示的研究

从电子地图多尺度显示角度出发,提出了基于LOD的选取模型。在选取模型中将显示比例尺和地图比例尺的比值作为LOD算子,总结了LOD算子设置的3个层次,以及分类、分级、要素和空间几何特征等LOD算子的设置规则。     

地壳运动速度场插值方法研究

分析了构建速度场的统计模型和函数模型法,提出利用两种模型逼近原始观测速度的综合逼近法,以减少剩余误差.计算和比较了各种方法,结果显示,综合法优于单独利用统计模型和函数模型法.     

Cross-formational hydrocarbon fluid flows in the Tertiary deltaic system of the Beaufort–Mackenzie Basin

Molecular and isotopic compositions of crude oils in the Beaufort–Mackenzie Basin confirm three genetic end-member oil groups and suggest extensive cross-formational hydrocarbon fluid flows in the Tertiary deltaic system. Inter- and intra-fractional variations in the geochemistry of the Tertiary-reservoired oils indicate that the oil source/maturity signatures were substantially masked by biomarkers that were picked up along migration pathways. Thus, many of the previously recognized “immature non-marine oils” are in fact thermally mature, probably derived from unpenetrated deeper marine source rocks. Although the effective source rock volumes have not been evaluated and their exact stratigraphic levels remain unknown, the relative timing of oil generation versus trap formation, rather than poor source quality, may be the cause of under-filled traps in the offshore area.     

基于数据手套和跟踪器的虚拟手臂建模

文中利用数据手套和跟踪器获取手臂各关节运动数据,根据关节运动限制对所获取数据进行处理,建立了符合人体运动规律的虚拟手臂数学模型,实现了虚拟环境中与试验者的手臂同步运动、效果逼真的虚拟手臂模型.     

纹理映射失真处理中的LOD技术

纹理映射是计算机图形学中广泛应用的一项重要技术,纹理图像可以描述景物表面各点处的反射属性,模拟景物表面丰富的纹理细节,减少建模的工作量,提高计算机生成图形的真实性.但是由于纹理都为栅格图像,放大和缩小会产生一定程度的失真,所以要对纹理进行细节分层处理.文中主要介绍纹理的重采样和建立金字塔技术,提出减少纹理映射失真的方法.     

少量地面控制点的遥感图像精纠正与定位技术探讨

本文主要讨论了利用空间投影一空间斜墨卡托（SOM）投影进行卫星遥感图像精纠正与定位，解决缺少控制点地区卫星遥感图像精纠正与定位问题，并根据正反算公式讨论了卫星遥感图像纠正的空间投影数学基础。     

Tests on low‐ductility RC frames under high‐ and low‐frequency excitations

The response of low‐ductility reinforced concrete (RC) frames, designed typically for a non‐seismic region, subjected to two frequencies of base excitations is studied. Five half‐scaled, two‐bay, two‐storey, RC frames, each approximately 5 m wide by 3.3 m high, were subjected to both horizontal and/or vertical base excitations with a frequency of 40 Hz as well as a lower frequency of about 4 Hz (close to the fundamental frequency) using a shake table. The imposed acceleration amplitude ranged from 0.2 to 1.2g. The test results showed that the response characteristics of the structures differed under high‐ and low‐frequency excitations. The frames were able to sustain high‐frequency excitations without damage but were inadequate for low‐frequency excitations, even though the frames exhibited some ductility. Linear‐elastic time‐history analysis can predict reasonably well the structural response under high‐frequency excitations. As the frames were not designed for seismic loads, the reinforcement detailing may not have been adequate, based on the crack pattern observed. The effect of vertical excitation can cause significant additional forces in the columns and moment reversals in the beams. The ‘strong‐column, weak‐beam’ approach for lateral load RC frame design is supported by experimental observations. Copyright © 2001 John Wiley & Sons, Ltd.     

河南南召水洞岭铜铅锌矿床地质特征及成因分析

通过地质详查和综合研究相结合的手段 ,从水洞岭铜铅锌矿床的地质特征入手 ,分析矿床成因 ,提出矿床属海相火山喷发沉积 -弱改造型的成因观点     

西藏蛇绿岩中二种合金矿物新变种

在西藏雅鲁藏布江蛇绿岩带的东部，距拉萨200km的泽当罗莎蛇绿岩的铬铁矿中，发现有种类繁多的合金矿物，铬铁镍矿和依铁镍矿就是其中二种。铬铁镍矿分子式：Ni0.41Fe0.35Cr0.24，为等轴晶系，空间群为Fm3m，晶胞参数a=0.35622(2)nm。铱铁镍矿分子式：Ni0.66Fe0.18Ir0.16，属等轴晶系，空间群Oh^5-Fm3m，晶胞参数a=0.46486(4)mm。     

Heat flow and thermal modeling of the Yinggehai Basin, South China Sea

Geothermal gradients are estimated to vary from 31 to 43 °C/km in the Yinggehai Basin based on 99 temperature data sets compiled from oil well data. Thirty-seven thermal conductivity measurements on core samples were made and the effects of porosity and water saturation were corrected. Thermal conductivities of mudstone and sandstone range from 1.2 to 2.7 W/m K, with a mean of 2.0±0.5 W/m K after approximate correction. Heat flow at six sites in the Yinggehai Basin range from 69 to 86 mW/m², with a mean value of 79±7 mW/m². Thick sediments and high sedimentation rates resulted in a considerable radiogenic contribution, but also depressed the heat flow. Measurements indicate the radiogenic heat production in the sediment is 1.28 μW/m³, which contributes 20% to the surface heat flow. After subtracting radiogenic heat contribution of the sediment, and sedimentation correction, the average basal heat flow from basement is about 86 mW/m².Three stages of extension are recognized in the subsidence history, and a kinematic model is used to study the thermal evolution of the basin since the Cenozoic era. Model results show that the peak value of basal heat flow was getting higher and higher through the Cenozoic. The maximum basal heat flow increased from 65 mW/m² in the first stage to 75 mW/m² in the second stage, and then 90 mW/m² in the third stage. The present temperature field of the lithosphere of the Yinggehai Basin, which is still transient, is the result of the multistage extension, but was primarily associated with the Pliocene extension.