煤矿井简检查孔施工技术探讨

介绍了煤矿井筒检查孔的特点和技术、质量要求,总结了以往工程中的经验教训,针对工程中的技术难点,如取心、孔斜控制、抽水作业和冲洗液选择与维护等影响质量、工期的关键环节提出了技术措施,为优质、高效施工此类工程提供借鉴.     

煤田勘查超千米深孔快速钻进技术探讨

针对目前国内煤田勘查主要机具及工艺技术方法存在的主要问题,结合煤田勘查地层地质条件和超千米深孔施工要求,研制了液压立轴式HTJ-2000型钻机和新型绳索取心钻具,并就配套设备选型、钻进工艺、钻进参数、泥浆指标及应用效果进行了阐述.该项技术的应用,已明显提高了钻效,使钻孔深度达到1 350m.     

少量地面控制点的遥感图像精纠正与定位技术探讨

本文主要讨论了利用空间投影一空间斜墨卡托（SOM）投影进行卫星遥感图像精纠正与定位，解决缺少控制点地区卫星遥感图像精纠正与定位问题，并根据正反算公式讨论了卫星遥感图像纠正的空间投影数学基础。     

北京夏季城市热岛现状及楔形绿地规划对缓解城市热岛的作用

通过遥感技术与地面测定相结合的方法，对北京城市热岛现状作观测研究，得到北京城市地面的温度分布特点。使用北京大学城市边界层模式从气象观点就“楔形绿地”规划对北京城市气候的影响进行研究和评价，模式通过对城市地表复杂性和多样性的特征进行细致描述，建立了一个细致模拟城市特点的城市边界层能量平衡模式，并用此能量平衡模式得到的地面温度作为下边界条件，中尺度气象模式MM5做初始场和侧边界条件，建立一个最小分辨率为500 m的城市边界层模式系统，来研究城市边界层在中尺度背景场作用下的精细结构。通过个例模拟，模式能够较准确地模拟城市边界层的风温场分布情况，可以用来对楔形绿地规划进行模拟试验。通过对规划后的气象场在特定的气象条件下进行模拟，结果显示，建造大型的楔形绿地后，绿地区域及绿地周围约1 km以内的地区温度有所降低，降低的程度由规划前后的地表类型改变的剧烈程度、风速大小及与绿地的距离决定，但是这种规划方案却会因城市的下风方向的风速减小而导致通风不畅。     

气象资料三维化技术中的插值问题

通过对不同源气象资料及数字地理信息资料的插值，实现了不同气象资料与地理信息资料分辨率的协调；从而将多种信息叠加到一起，实现了多源资料的二维、三维仿真显示。这对于模拟真实的大气空间结构、理解地形及植被对大气运动的影响、辨识各种天气系统及多种信息的融合等有积极意义。     

Tests on low‐ductility RC frames under high‐ and low‐frequency excitations

The response of low‐ductility reinforced concrete (RC) frames, designed typically for a non‐seismic region, subjected to two frequencies of base excitations is studied. Five half‐scaled, two‐bay, two‐storey, RC frames, each approximately 5 m wide by 3.3 m high, were subjected to both horizontal and/or vertical base excitations with a frequency of 40 Hz as well as a lower frequency of about 4 Hz (close to the fundamental frequency) using a shake table. The imposed acceleration amplitude ranged from 0.2 to 1.2g. The test results showed that the response characteristics of the structures differed under high‐ and low‐frequency excitations. The frames were able to sustain high‐frequency excitations without damage but were inadequate for low‐frequency excitations, even though the frames exhibited some ductility. Linear‐elastic time‐history analysis can predict reasonably well the structural response under high‐frequency excitations. As the frames were not designed for seismic loads, the reinforcement detailing may not have been adequate, based on the crack pattern observed. The effect of vertical excitation can cause significant additional forces in the columns and moment reversals in the beams. The ‘strong‐column, weak‐beam’ approach for lateral load RC frame design is supported by experimental observations. Copyright © 2001 John Wiley & Sons, Ltd.     

河南南召水洞岭铜铅锌矿床地质特征及成因分析

通过地质详查和综合研究相结合的手段 ,从水洞岭铜铅锌矿床的地质特征入手 ,分析矿床成因 ,提出矿床属海相火山喷发沉积 -弱改造型的成因观点     

西藏蛇绿岩中二种合金矿物新变种

在西藏雅鲁藏布江蛇绿岩带的东部，距拉萨200km的泽当罗莎蛇绿岩的铬铁矿中，发现有种类繁多的合金矿物，铬铁镍矿和依铁镍矿就是其中二种。铬铁镍矿分子式：Ni0.41Fe0.35Cr0.24，为等轴晶系，空间群为Fm3m，晶胞参数a=0.35622(2)nm。铱铁镍矿分子式：Ni0.66Fe0.18Ir0.16，属等轴晶系，空间群Oh^5-Fm3m，晶胞参数a=0.46486(4)mm。     

Heat flow and thermal modeling of the Yinggehai Basin, South China Sea

Geothermal gradients are estimated to vary from 31 to 43 °C/km in the Yinggehai Basin based on 99 temperature data sets compiled from oil well data. Thirty-seven thermal conductivity measurements on core samples were made and the effects of porosity and water saturation were corrected. Thermal conductivities of mudstone and sandstone range from 1.2 to 2.7 W/m K, with a mean of 2.0±0.5 W/m K after approximate correction. Heat flow at six sites in the Yinggehai Basin range from 69 to 86 mW/m², with a mean value of 79±7 mW/m². Thick sediments and high sedimentation rates resulted in a considerable radiogenic contribution, but also depressed the heat flow. Measurements indicate the radiogenic heat production in the sediment is 1.28 μW/m³, which contributes 20% to the surface heat flow. After subtracting radiogenic heat contribution of the sediment, and sedimentation correction, the average basal heat flow from basement is about 86 mW/m².Three stages of extension are recognized in the subsidence history, and a kinematic model is used to study the thermal evolution of the basin since the Cenozoic era. Model results show that the peak value of basal heat flow was getting higher and higher through the Cenozoic. The maximum basal heat flow increased from 65 mW/m² in the first stage to 75 mW/m² in the second stage, and then 90 mW/m² in the third stage. The present temperature field of the lithosphere of the Yinggehai Basin, which is still transient, is the result of the multistage extension, but was primarily associated with the Pliocene extension.     

一种计算固体潮观测数据改正值的新方法

从标定前一天和标定当天的地形变前兆数据变化趋势入手，在分析当天数据结构的基础上采用最小二乘法原理，提出了一种计算数采改正值的新方法。经典型实例计算表明，该方法精度较高，效果明显。并对误差的来源作了进一步的分析。