Horizontal and vertical components of earthquake ground motions at liquefiable sites

Field observations on ground motions from recent earthquakes imply that current knowledge is limited with regard to relating vertical and horizontal motions at liquefiable sites. This paper describes a study with the purpose of clarifying this emerging issue to some extent. A series of numerical analyses is carried out on a liquefiable soil deposit with a verified, fully coupled, nonlinear procedure. It is shown that the transformation of vertical motions in the deposit differs considerably from the transformation of horizontal motions. Both the amplitude and frequency content of the horizontal motions are strongly dependent on the shaking level or the associated nonlinear soil behavior. The transfer function for vertical motions is however likely to be independent of the intensity of input motions; no reduction in the amplitude occurs even in the case of strong shaking. The results are shown to be in consistence with the laboratory observations on shaking table tests and recent field observations that less nonlinearity exists for vertical motions. It is also shown that the possibility exists for using information on spectral ratios between the horizontal and vertical surface motions to quickly identify in situ soil behavior and liquefaction that are not readily covered by conventional field or laboratory experimentation procedures.     

Transient foundation solution of saturated soil to impulsive concentrated loading

The transient dynamic response of saturated soil under suddenly applied normal and horizontal concentrated loading is studied in this paper. The behavior of saturated soil is governed by Biot's consolidation theory. The general solutions for Biot equations of equilibrium are derived in terms of displacements and variations of fluid volume, using Laplace–Hankel integral transforms. The solutions in the time domain can be evaluated by numerical inverse Laplace–Hankel transforms. Selected numerical results for displacements, stresses, and pore pressures are presented. Comparisons with existing closed-form solutions for the elastic half-space are made to confirm the accuracy of the present solutions. The solutions can be used to study a variety of transient wave propagation problems and dynamical interactions between saturated soil and structures.     

Modelling of meteorological conditions at an urban scale for the PUMA winter campaign

For the winter 2000 campaign of the Pollution of Urban Midlands Atmosphere project, observation and numerical modelling of meteorological conditions over the West Midlands conurbation, UK, was undertaken. Modelling was performed using the regional atmospheric meteorological system (RAMS). This paper presents a comparison of modelled and observed wind and temperature for 25 and 26 January 2000. The RAMS model uses two nested grids with a mesh size of 2 km for the inner grid which is embedded in the outer grid with a mesh size of 8 km. Statistical evaluation of the model results against the observational data of wind speed, direction and temperature at 10 m was conducted. In general, the modelling results are in a reasonable agreement with observation. The statistical evaluation suggests that model performance is poorer for the inner grid than the outer grid as the model uncertainties (mainly mean bias) transfer from the outer to inner one. The low indices of agreement of temperature and wind are mainly associated with the systematic root-mean-square-difference values. For temperature, the systematic bias may also be affected by representation of cloud amount by the model. For wind, the model tends to have a poor performance for calm conditions, as under a stable anti-cyclonic situation local wind patterns associated with topography may develop, although the topography of the region is relatively flat. The results for the inner grid reveal some subtle spatial patterns at a scale smaller than 10 km near hills and valleys with differences in elevation of a few hundred metres.     

Identification of Mining Blasts at Mid- to Far-regional Distances Using Low Frequency Seismic Signals

—?This paper reports results from two recent monitoring experiments in Wyoming. Broadband seismic recordings of kiloton class delay-fired cast blasts and instantaneous calibration shots in the Black Thunder coal mine were made at four azimuths at ranges from 1° to 2°. The primary focus of this experiment was to observe and to explain low-frequency signals that can be seen at all azimuths and should routinely propagate above noise to mid-regional distances where most events will be recorded by International Monitoring System (IMS) stations.¶The recordings clearly demonstrate that large millisecond delay-fired cast blasts routinely produce seismic signals that have significant spectral modulations below 10?Hz. These modulations are independent of time, the azimuth from the source and the orientation of the sensor. Low-frequency modulations below 5?Hz are seen beyond 9°. The modulations are not due to resonance as they are not produced by the calibration shots. Linear elastic modeling of the blasts that is guided by mine-blast reports fails to reproduce the fine detail of these modulations but clearly indicates that the enhanced “spectral roughness” is due to long interrow delays and source finiteness. The mismatch between the data and the synthetics is likely due to source processes, such as nonlinear interactions between shots, that are poorly understood and to other effects, such as variations of shot time and yield from planned values, that are known to be omnipresent but cannot be described accurately. A variant of the Automated Time-Frequency Discriminant (Hedlin, 1998b), which uses low-frequency spectral modulations, effectively separates these events from the calibration shots.¶The experiment also provided evidence that kiloton class cast blasts consistently yield energetic 2–10 second surface waves. The surface waves are strongly dependent on azimuth but are seen beyond 9°. Physical modeling of these events indicates that the surface waves are due mainly to the extended source duration and to a lesser extent to the slap-down of spalled material. The directionality is largely a path effect. A discriminant that is based on the partitioning of energy between surface and body waves routinely separates these events from the calibration shots.¶The Powder River Basin has essentially no natural seismic activity. How these mining events compare to earthquake observations remains to be determined.     

新时期我国区域经济地理学发展问题初探

我国新时期的区域经济地理学在取得全面发展的同时，在理论体系，研究方法和实践领域等方面还需要进一步的发展，文章根据学习和实践区域经济地理学的体会，初步提出基础理论和应用理论，思维方法和技术方法等方面发展见解，并指出区域创新系统和国际经济技术合作等学科应注意拓展的重要实践领域，最后提出我国区域经济地理学科发展的建议。     

华南地区凉果加工业与凉果资源的匹配关系分析——以广东省新兴县为例

文章以广东省新兴县为例，从凉果资源分布与加工能力的匹配关系角度对华南地区凉果资源的分布，凉果加工业的分布与布局，凉果市场分布与竞争力，凉果加工业与资源的匹配关系等进行了分析，并针对华南地区凉果加工业面临的主要问题提供了一些建议。     

成都市民消费结构与休闲活动关系研究

城市居民消费水平，消费结构会影响其休闲消费能力，消费意愿，消费方式，消费态度和休闲时空结构，文章以成都市7个城区歌舞，茶棋牌，电影及城市公园休闲活动调查为基础，探讨了城市居民消费结构及其变化与休闲活动特征的关系。研究结果表明，城市居民消费结构的改变对歌舞，茶棋牌娱乐活动影响最大。     

南水北调中线工程建设与河南水资源可持续利用

文章通过对河南省水资源开发利用现状，存在的主要问题，水资源供需平衡以及南水北调工程对河南省水资源利用的影响论述，提出了在拟定南水北调工程供水方案中，应通过强化节水，加强水资源保护，严格控制地下水开采，将水资源作为商品等措施，促进河南省水资源的可持续开发利用。     

区域视觉形象识别系统设计的理论与实践

目前，全国各地正在兴起区域形象设计与建设的浪潮，但如何把区域形象信息系统地传递出去，这方面的理论研究大大落后于实践。文章就区域形象信息传递的有效工具－区域视觉识别系统设计的主要内容，设计的原则，设计的基本流程等在理论与实践上作了较为详细的探讨，并就区域视觉识别系统设计方案的经济学论证作了一些有益探讨。     

河南经济技术开发区发展前景与对策

文章阐述了经济技术开发区在区域经济发展过程中的作用。根据河南省经济技术开发区的发展现状和存在的问题，分析了加入WTO后开发区所面临的机遇和挑战，并在此基础上从开发区环境营造，运行机制，筹资方式，产业发展，城市建设等方面提出了加快河南省经济技术开发区发展的对策。