Cement Deep Soil Mixing (CDSM) for Solidification of Soft Estuarine Sediments

A preliminary study was conducted to determine the potential for cement deep soil mixing (CDSM) technology as a method for in-situ solidification of contaminated river and estuarine sediments. The study was conducted in Newark Bay, near the mouth of the Passaic River, New Jersey. The primary objective of the study was to evaluate the viability of CDSM for the in-situ S/S with a focus on: 1) determining the correct mix of the cement slurry, which provides rapid stabilization of the sediment matrix, 2) potential resuspension of solids during CSDM operations, 3) the effects of high organic content on the solidification process, and 4) the feasibility of using conventional dredging/extraction methods once the sediments have been stabilized and allowed to cure. The results of the study show CDSM slurry mixtures, as low as 7% in cement content, result in significant solidification and strength gain of in-situ sediments under ambient conditions. In sediments with very high organic contents (> 20%), the slurry mix would need to be adjusted to account for retardation effects of organics on cement hydration. Sediment resuspension during application was shown to be minimal at a distance of as little as 75 feet from the mixing head. Strength gains were considerable, effectively consolidating the sediment particles in a secure matrix, but not so high as to preclude extraction of solidified sediments with conventional dredging equipment. Dredged solidified sediment exhibited characteristics of a stiff glacial clay, and as such was easier to handle and transport than untreated dredged sediments. This technique has high potential to be used as an interim remedial measure prior to either extraction and decontamination/disposal or proper capping.     

Rare Earth and Metal Geochemistry of Land and Submarine Phosphorites in the Baja California Peninsula,Mexico

The geochemical composition of phosphorites and phosphatic sediments in the Baja California peninsula is studied and used to assess the environment in which phosphogenesis took place. The deposits are classified in three groups: (1) stratified phosphorites, (2) phosphatic sandy sediments from beaches and dunes, and (3) submarine sediments. Some of the elements that might have substituted Ca and PO₄ during francolite mineralization were studied by means of ICP-AES. Significant differences are seen in the concentration of these metals (e.g., Cr = 72-406 μg g^?1 and V = 17-198 μg g^?1), indicating that their concentration is not only controlled by the P₂O₅ concentration, but also by paleo-environmental conditions existing during francolite precipitation. Shale normalized REE patterns suggest two main environments of formation: (1) a strong negative Ce anomaly (< ? 0.3) and La enrichment (La/Nd ≥ 1) enrichment, suggesting well oxygenated shelf environments and probably lower light REE weathering, and (2) a weak negative Ce anomaly (> ? 0.3) and La depletion (La/Nd ≤ 1) suggesting shallower waters or restricted circulation and probably LREE weathering.     

Assessment of relative slope stability of Kodiak shelf,Alaska, using high‐resolution acoustic profiling data

Abstract

The use of marine high‐resolution geophysical profiling data, seafloor soil samples, and accepted land‐based methods of analysis have provided a means of assessing the regional geotechnical conditions and relative slope stability of the portion of the Gulf of Alaska Continental Margin known as the Kodiak Shelf. Eight distinct types of soils were recognized in the study; the seafloor distribution of these indicates a complex geotechnical setting. Each soil unit was interpreted as having a distinct suite of geotechnical properties and potential foundation engineering problems. Seven categories of relative slope stability were defined and mapped. These categories range from “highest stability”; to “lowest stability,”; and are based on the degree of slope of the seafloor, type of soil underlying the slope, and evidence of mass movement. The results of the analysis indicate that the highest potential for soil failure exists on (1) the slopes forming boundaries between the submarine banks and the broad sea valleys, and (2) the upper portion of the continental slope, where evidence of past slope failure is common. Also of concern are gently sloping areas near the edges of submarine banks where evidence of possible tension cracks and slow downhill creep was found.     

Comparison of vane shear and fall cone strengths of soft marine clay

A total of 1,014 measures of sediment shear strengths were measured by means of miniature vane shear and fall cone tests on five gravity cores collected in Eckernfo‐erde Bay, Baltic Sea. Paired t test was used to compare the shear strengths measured by the two methods. It was found that fall cone strength calculated with Wood's K₆₀value (0.29) overestimates the vane shear strength by 0.15 kPa (a = 0.001) and the sample mean of the fall cone strength is 4.1% higher than the mean of the vane shear strength. However, fall cone strength calculated with Hansbo's K₆₀ value (0.24) underestimates the vane shear strength by 0.88 kPa (a = 0.001), and the sample mean of the fall cone strength is 13.8% less than the mean of the vane shear strength. Both calculated fall cone strengths are significantly different from the vane shear strength, with a p value of less than 0.001. Regression analysis of the Echernfoerde Bay data indicates that a new K₆₀ value is 0.275 with a confidence interval (a = 0.01) from 0.2704 to 0.2786. Paired t test shows that there is no significant difference between miniature vane shear and fall cone tests for these samples if the fall cone strength is calculated with K₆₀ = 0.275.     

Computerized detection of seamounts from Seasat type geodetic data

Abstract

Geoid heights and vertical deflections derived from satellite radar altimetry contain characteristic signals that may be reproduced and explained by simple models for seamount gravitation acting on the sea surface. Computer algorithms capable of automatic operation and able to detect, approximately locate, and estimate parameters constraining the shape of actual sea‐mounts were written and tested. The computer program which utilized a digital high‐pass filter combined with a roughness sensor was effective in separating the seamount produced geoid undulation/vertical deflection pattern from the remaining data track features, simultaneously detecting and locating along the track such signals. Tests of the algorithm on several SEASAT passes over known bathymetry produced mixed results. Meaningful shape constraints were obtained by matching the geoid anomaly calculated from the seamount model to the actual mean sea level pattern for some seamounts. Results for other seamounts were poor and possible reasons for the failure are discussed. It is concluded that a computerized seamount detection program for radar altimetry data is feasible, but it will have to be more complex than the present one for fully successful operation.     

Accurate GPS measurement of the location and orientation of a floating platform

Abstract

This article describes the design and initial tests of the GPS portion of a system for making seafloor geodesy measurements. In the planned system, GPS antennas on a floating platform will be used to measure the location of an acoustic transducer, attached below the platform, which interrogates an array of transponders on the seafloor. Since the GPS antennas are necessarily some distance above the transducer, a short‐baseline GPS interferometer consisting of three antennas is used to measure the platform's orientation.

A preliminary test of several crucial elements of the system was performed at the Scripps Institution of Oceanography (SIO) in December 1989. The test involved a fixed antenna on the pier and a second antenna floating on a buoy about 80 m away. GPS measurements of the vertical component of this baseline, analyzed independently by two groups using different software, agree with each other and with an independent measurement within a centimeter.

The first test of an integrated GPS/acoustic system took place in the Santa Cruz Basin off the coast of southern California in May 1990. In this test a much larger buoy, designed and built at SIO, was equipped with three GPS antennas and an acoustic transducer that interrogated a transponder on the ocean floor. Preliminary analysis indicates that the horizontal position of the transponder can be determined with a precision of about a centimeter. Further analysis will be required to investigate the magnitude of systematic errors.     

The coast between Cabo de Santa Maria (Portugal) and Rabat (Morocco): a mega-size headland-bay shoreline under control of the North Atlantic swell?

Equilibrium headland-bay beach systems have been mathematically described by logarithmic, parabolic and hyperbolic curve functions. The largest system of this type reported to date has a shoreline length of about 62 km. In the present study, an apparent headland-bay system is presented which has a shoreline length of about 500 km. It was discovered on satellite images, and is located between Cabo de Santa Maria in Portugal and the coastal city of Rabat in Morocco. It appears to be controlled by long-period North Atlantic swells diffracting around Cabo São Vicente at the south-western tip of Portugal, in combination with SW–SE wind wave climates impinging on the northern shoreline of Cádiz Bay. The coast shows two marked departures from the equilibrium shoreline along its central section north and south of the Strait of Gibraltar, which are easily explained. Thus, the promontories to the north of the strait still exist because there has not been sufficient time to erode these back to the equilibrium shoreline since postglacial sea-level recovery. The coastal indentation to the south is explained by an insufficient sediment supply from terrestrial sources to facilitate the required beach accretion. Perfectly adjusted planimetric headland-bay shoreline shapes represent situations where wave orthogonals approach the coast at right angles everywhere, i.e. there is no longer any alongshore sediment transport. Equilibrium shorelines form independently of the grain size of the beach sediment, whereas morphodynamic beach states are indirectly affected by the shoreline shapes because the latter are modulated by wave period and breaker height which also control the morphodynamic response of the beach in combination with the local grain size.     

Is there a link between deep‐sea biodiversity and ecosystem function?

Studying the diversity‐ecosystem function relationship in the deep sea is of primary importance in the face of biodiversity loss and for our understanding of how the deep sea functions. Results from the first study of diversity‐ecosystem function relationships in the deep sea (Danovaro et al. 2008; Current Biology, 18, 1–8) are unexpected and show an exponential relationship between deep‐sea nematode diversity and ecosystem function and efficiency, although this relationship appears largely restricted to relatively low diversities [ES(51) <25]. Here, we investigate the relationship between nematode diversity and several independent measures/proxies of ecosystem function (sediment community oxygen consumption, bacterial biomass, bacterial extracellular enzyme activity) and efficiency (ratio of bacterial/nematode carbon to organic C content of the sediment) on the New Zealand continental slope. Nematode diversity at our study sites was relatively high [ES(51) = 30–42], and there was no relationship between species/functional diversity and ecosystem function/efficiency after accounting for the effects of water depth and food availability. Our results are consistent with a breakdown of the exponential diversity‐function relationship at high levels of diversity, which may be due to increased competition or greater functional redundancy. Future studies need to take into account as many environmental factors and as wide a range of diversities as possible to provide further insights into the diversity‐ecosystem function relationship in the largest ecosystem on Earth.     

Distribution and ecology of Nectocarcinus antarcticus and N. bennetti (Brachyura: Portunidae) in the New Zealand region

The distributions of two swimming crabs endemic to the New Zealand region are described, mostly from material obtained at 118 of 2544 New Zealand Oceanographic Institute benthic stations sampled.

Nectocarcinus antarcticus (Jacquinot) was found within the geographic limits 34°S‐51°S and 166° E‐176° W, with concentrations around Cook Strait, the Chatham Rise, Foveaux Strait, and the Auckland Is. N. bennetti (Takeda & Miyake) occurred between 44° S and 53° S, and 165° E and 180°, most frequently in the south and west, on the ‘highs’ of the Campbell Plateau. Although the distributions overlap between 44° S and 51° S, and this overlap zone produced most of the available material, only one joint occurrence of the two species was noted. This apparent separation was not satisfactorily explained by any of the ecological factors recorded. The depth ranges of both species were broadly similar (0–550 m for TV. antarcticus, 20–474 m for JV. bennetti); both were most frequently obtained at depths less than 200 m. Both occurred primarily on the coarser sediment grades, though N. antarcticus occupied a broader range of grades than N. bennetti.

The size ranges of the two species were similar; carapace lengths were 8.0–62.0 mm for N. antarcticus and 5.8–68.0 mm for N. bennetti. The larger specimens of both species were found towards the southern limits of distribution. Larger specimens of N. antarcticus were absent from depths greater than 120 m; smaller N. antarcticus and all N. bennetti occurred throughout their respective depth ranges. Ovigerous N. antarcticus (smallest, 8.8 mm carapace length) were obtained at depths of 17–263 m from May to October; ovigerous N. bennetti (smallest 36.1 mm) were from depths of 150–183 m in May only.     

Chlorophyll production,in response to nutrient additions,by the algae in Lake Taupo water

In batch cultures of Lake Taupo water, phosphorus was the nutrient limiting plant growth from January to June, and nitrogen took over this role from July to December. Chlorophyll production by algae was often stimulated by trace element additions, but it was uncertain whether total cytoplasmic production was also involved.