下扬子地区幕府山组陆缘海-台地黑色细粒沉积岩系沉积学和孔隙结构特征

黑色细粒沉积岩系沉积学和孔隙结构研究对于沉积环境恢复、页岩气储层评价和有利储层预测具有重要意义.利用下扬子地区最新完钻的XYZ-1钻井资料,综合钻井岩心、岩石薄片、XRD分析、氩离子-场扫描电镜等手段,开展幕府山组细粒沉积岩系的沉积学和孔隙结构研究.结果表明,幕府山组岩性组成以块状、纹层状深色(碳质)泥岩、浅灰色纹层状...     

银川平原植被生长与地下水关系研究

干旱区植被生长与地下水的关系是生态水文地质学研究的热点之一。西北内陆干旱地区降水稀少,植被的生长发育与地下水的关系极为密切,从大尺度上研究地下水变化的生态效应问题对生态环境的保护和恢复具有重要的意义。借助遥感方法,结合地下水观测数据,在区域尺度上定量地研究了中国银川平原地区地下水埋深及矿化度与植被生长的关系。结果表明:适宜植被生长的地下水埋深范围约为1~6m,当地下水位埋深为3.5m左右时,植被长势最好。而在水位埋深为3.5m左右的地区,植被生长的相对好坏又受地下水矿化度的影响。当地下水矿化度为0.9g/L时对该地区植被的生长最为有利。     

固体潮汐理论值算法在VB 6.0中的应用与实现

太阳和月球对地球的力学影响在地球科学研究中占有重要地位,但目前对该物理量的计算还没有人机交互很好的计算软件。本文在前人引潮位计算基础上,使用了面向对象的程序设计方法,编制了界面友好的固体潮汐理论值计算软件。介绍了该软件的设计思路和基本功能。该软件采用窗口界面进行输入和输出,数据显示以波形图为主。软件的友好界面增强了数据分析的直观性,为固体潮理论的推广应用和教学奠定了一定的基础。     

土-桩-钢结构相互作用体系的振动台模型试验

本项试验是研究土-结构相互作用对结构TLD减震控制影响的系列振动台模型试验的组成部分,主要目的是提供相应的对比试验数据。在这组试验中,突出的问题是TLD、上部被控结构和土层三个子系统模型基频间的协调。为了尽可能降低土层模型基频,文中采用了一种具有低剪切波速特性的土层模拟介质。最后,通过土-桩-钢结构系统的振动台模型试验,研究了土-结构相互作用对钢结构动力特性和地震反应的影响。     

土-桩-钢结构-TLD系统振动台模型试验研究

通过系列振动台模型试验,研究土-结构相互作用对结构TLD减震控制影响。文中首先提出试验模型设计中应考虑的几个主要问题及解决方法,然后介绍土-桩基础-钢结构-TLD相互作用体系的试验成果,分析TLD的减震效果,最后与刚性地基上钢结构TLD减震试验结果相比较,揭示土-结构相互作用对TLD减震效率的影响特点。试验结果表明:土-结构相互作用使得TLD减震效率降低,这一削减作用受到输入地震动的频谱特性和强度的影响。因此,对于建在土层场地上的结构进行TLD减震设计时,应充分重视工程场地条件和地震动特性等实际情况。     

基于遗传Elman神经网络进行矿区GPS高程拟合

目前,城市、平原地区的似大地水准面建立精度已经达到厘米级,但在矿区进行高程拟合时,由于地面高低起伏没有规则,其似大地水准面的拟合精度并不理想。针对此问题,本文提出利用遗传算法优化Elman神经网络的方法精化似大地水准面,采用移去-恢复法对残差进行建模,使用EGM 2008地球重力场模型和地形起伏信息来精化求解似大地水准面和参考椭球面之间的高程异常,同时着重分析了地球重力场模型以及地形变化信息对高程异常求解的重要性,并使用某矿区实测数据(GPS、水准)对所提方法进行验证,实验结果表明:文中所提方法的精度要优于二次曲面拟合模型和单一Elman模型,其外符合精度达到了1.14 cm,可以代替四等水准测量。     

SMAP卫星海表盐度产品的检验与校正

In this study, sea surface salinity(SSS) Level 3(L3) daily product derived from soil moisture active passive(SMAP)during the year 2016, was validated and compared with SSS daily products derived from soil Moisture and ocean salinity(SMOS) and in-situ measurements. Generally, the root mean square error(RMSE) of the daily SSS products is larger along the coastal areas and at high latitudes and is smaller in the tropical regions and open oceans. Comparisons between the two types of daily satellite SSS product revealed that the RMSE was higher in the daily SMOS product than in the SMAP, whereas the bias of the daily SMOS was observed to be less than that of the SMAP when compared with Argo floats data. In addition, the latitude-dependent bias and RMSE of the SMAP SSS were found to be primarily influenced by the precipitation and the sea surface temperature(SST). Then, a regression analysis method which has adopted the precipitation and SST data was used to correct the larger bias of the daily SMAP product. It was confirmed that the corrected daily SMAP product could be used for assimilation in high-resolution forecast models, due to the fact that it was demonstrated to be unbiased and much closer to the in-situ measurements than the original uncorrected SMAP product.     

Effect of different registration methods on precision of orientation based on RTK registration/georeferencing mode

Abstract

Compared with traditional methods, the three-dimensional laser-scanning (3D-LS) technique can efficiently acquire many high-quality geometric properties of rock discontinuities. In practice, engineers usually prefer to simplify the processing by using single-station point data and roughly orienting owing to the complexity of registration/georeferencing multi-station point data. However, prior published studies have paid little attention to the accuracy and reliability when determining discontinuity orientations using 3D-LS. We propose a reliable and accurate method with robust on-site applicability. As part of an ongoing effort, we are evaluating the precision of the commonly used coarse registration method and the fine registration method, and promoted the optimized coarse- and fine-registration methods and evaluated their precision. It is found that: (1) the common and the optimized registration method can meet our project’s engineering requirements, and the optimized registration method improved accuracy in the dip direction by approximately 1°; (2) fine registration using an iterative closest point (ICP) algorithm can correct both dip direction and dip angle; and (3) the orientation is of high precision with commonly used coarse and fine registration, whereas the optimization effect to correct the orientation is slightly limited.     

Prediction of Flyrock in Mine Blasting: A New Computational Intelligence Approach

Natural Resources Research - Blasting is the predominant rock fragmentation technique in civil constructions, underground and surface mines. Flyrock is the unwanted throw of rock fragments during...     

不同插值方法在海域气象参数估算中的可靠性评价

海域条件下的气象观测具有数据稀少、变化大且观测站点分布不均的特点,其插值精度受插值方法影响较大。首先对常规插值方法进行理论分析,进而选取了反距离加权法、克里金法和样条函数法三种插值方法进行了插值实验和精度分析。根据渤海湾某区域的气象历史数据,采用不同方法绘制了温度、压强和湿度的插值平面图,并基于交叉验证的方式对各插值方法进行了对比,给出了不同方法的插值估算可靠性评价。结果表明:温度、压强和湿度的插值精度均是基于反距离加权法的插值结果最优(MAE_(温度)=2.42,RMSE_(温度)=1.92,MAE_(压强)=2.05,RMSE_(压强)=1.30,MAE_(湿度)=11.394, RMSE_(压强)=6.43),同时基于反距离加权法的图形绘制可视化效果也要优于其他两种方法。研究结果可为海域气象参数估算提供理论和实践依据。