Sedimentary facies during early stages of flooding in an extensional basin: the Brèche Rouge de Carboneras (Late Miocene, Almería/SE Spain)

The intramontane basins of the Betic Cordilleras (SE Spain) formed subsequent to the main phase of orogenic deformation during the middle Miocene in a close genetic relation to the Trans-Alboran Shear zone. Left lateral movements along a local branch (Carboneras fault zone, CF; strike NE–SW) of this zone played a major role in controlling the formation and dynamics of the Nijar-Carboneras Basin. To the south of the fault, a major phase of strike-slip faulting is recorded during the late Tortonian. The expression of this event is the Brèche Rouge de Carboneras (BRC), which seals a deep denudational surface on top of dislocated fault blocks formed by volcanics of the Cabo de Gata complex and early Tortonian shallow marine calcarenite. The sedimentary facies of this widely distributed unit in the Carboneras-Subbasin mirror the submarine topography and the distribution of the fault zones. Along strike-slip fault zones, autoclastic breccias and neptunian dikes preferentially oriented NW–SE and NE–SW occur, which are interpreted to represent the near-surface expression of the faults. Red limestone forms the groundmass of the autoclastic breccia and infills of neptunian dikes, which exhibit multiple phases of opening of fissures, gravitational sedimentary infill, lithification, and renewed creation of cracks. Steep relief, probably along fault scarps, was mantled by epiclastic volcanic conglomerate with a red carbonate matrix. Well-lithified coarse skeletal limestone rich in planktonic foraminifera formed pavements along sediment starved rocky surfaces in deep water. Laterally, within topographic depressions, the pavement limestone grades into thick accumulations of skeletal rudstone composed of fragmented azooxanthellate corals and stylasterid hydrozoans, which were concentrated by powerful bottom currents and gravitiy flows. Within the shallow water zone of dip slope ramps, cross-bedded calcarenite and calcirudite formed. Based on textures, fabrics and biota, rocks of the BRC were grouped into nine genetic lithofacies which document cryptic, deep-aphotic and shallow-photic environments typical of a sediment starved extensional basin.     

Quaternary minettes and associated volcanic rocks of Mascota,western Mexico: a consequence of plate extension above a subduction modified mantle wedge

 Pleistocene-Holocene volcanism in the Jalisco block of western Mexico is confined to two conspicuous grabens, where potassic eruptives range from absarokites (48–52% SiO₂) and minettes (49–54% SiO₂) through basaltic andesites (53–57% SiO₂), the most voluminous type, to andesites and their lamprophyric equivalent spessartite (58–62% SiO₂); there are no contemporary rhyolitic rocks. This suite has high concentrations of Mg, Cr (<550 ppm) and Ni (<450 ppm) accompanied by large concentrations of K, P, Ba (<4000 ppm) and Sr (<5000 ppm) and elements such as LREE and Zr (<600 ppm). No combination of crystal fractionation and/or crustal contamination can reproduce the compositional range of these magmas, which nevertheless are believed to be genetically related because of their proximity in time and space. Hydrous minerals in the lamprophyres and the typical absence of plagioclase phenocrysts in both basaltic andesites and andesites reflect the relatively high concentrations of water in the magmas, which suppressed the crystallisation of feldspar. Experimental verification of the minimal amounts of water required to reproduce the phenocryst assemblages in selected rocks range from 3.5 to 6%. During ascent in a volcanic conduit, andesitic magma may lose water and consequently precipitate plagioclase, or it may ascend more rapidly, retaining more of its initial water, which stabilises phenocrysts of hornblende at the expense of plagioclase. Our estimates of water concentrations, which are consistent with the various low pressure phenocryst assemblages, will be minimal for the magmas in their source regions, and the process of magmatic dewatering on ascent may be typical in well established volcanic conduits. In accord with the compositions of phenocrystic olivine in the basaltic andesites and the minettes, the values of FeO and Fe₂O₃ of the bulk lavas and scoriae are demonstrably pristine. As a consequence, there are two characteristic features of the Mascota suite: the high range of relative oxygen fugacities (ΔNNO=1–5) and the high Mg# (MgO/MgO+FeO) that ranges from 0.70 to 0.91 (with only one andesite as low as 0.66). From the evidence of phlogopite phenocrysts, a partial melt involving phlogopite would have a higher Mg# than one from olivine (Fo₉₀) and pyroxene alone. As the Mascota series shows a correlation between K₂O and Mg#, we conclude that it was generated by partial fusion of the mantle wedge, with a variable contribution of phlogopite and apatite from veins throughout the lherzolitic assemblage. In conformity with an origin by varying increments of partial fusion of a phlogopite-bearing mantle, all incompatible elements vary linearly with Ti (or K) as if phlogopite (+apatite) in the source dominated their contribution to the partial melts. Fluids from dehydration of the subducting slab presumably deposit hydrous and other minerals in veins in the mantle wedge and also increase its redox state. As the Mascota volcanism occurs in grabens closer to the trench than the main andesite arc, it is concluded that the eruption of these small volumes of hydrous magmas require the tectonically favored ascent paths offered by the extensional grabens to reach the surface from their mantle sources. Received: 24 January 1995 / Accepted: 21 February 1996     

Self-sedimentation of phytoplankton blooms in the geologic record

Understanding the formation of laminated, organic-rich sediments is an essential topic for researchers interested in fossil fuels, biogeochemical cycles, Earth's environmental history and global change. Biologists have very recently demonstrated that some marine phytoplankton blooms actively govern their own sedimentation by the formation of sticky transparent gels that facilitate rapid aggregation, accelerated sinking and efficient export flux. Here we present fossil evidence of unfragmented, low-diversity phytoplankton assemblages preserved as sedimentary laminae and irregular flocs that are attributable to a similar phytoplankton-driven sedimentary mechanism we term ‘self-sedimentation’. The geological evidence suggests that self-sedimentation precludes significant heterotrophic grazing, propels the formation of some conspicuous hemipelagic sedimentary laminae and results in efficient carbon and opal flux to the sediments. We suggest that the self-sedimentation phenomenon may have broad implications for the geological history of biogeochemical cycling, oceanic ecological dynamics, and abrupt atmospheric/environmental change. Broader recognition of the self-sedimentation phenomenon as explicitly defined here is a prerequisite to testing these unconventional hypotheses.     

An Eocene/Oligocene blueschist‐/greenschist facies P–T loop from the Cycladic Blueschist Unit on Naxos Island,Greece: Deformation‐related re‐equilibration vs. thermal relaxation

Geothermobarometric and geochronological work indicates a complete Eocene/early Oligocene blueschist/greenschist facies metamorphic cycle of the Cycladic Blueschist Unit on Naxos Island in the Aegean Sea region. Using the average pressure–temperature (P–T) method of thermocalc coupled with detailed textural work, we separate an early blueschist facies event at 576 ± 16 to 619 ± 32°C and 15.5 ± 0.5 to 16.3 ± 0.9 kbar from a subsequent greenschist facies overprint at 384 ± 30°C and 3.8 ± 1.1 kbar. Multi‐mineral Rb–Sr isochron dating yields crystallization ages for near peak‐pressure blueschist facies assemblages between 40.5 ± 1.0 and 38.3 ± 0.5 Ma. The greenschist facies overprint commonly did not result in complete resetting of age signatures. Maximum ages for the end of greenschist facies reworking, obtained from disequilibrium patterns, cluster near c. 32 Ma, with one sample showing rejuvenation at c. 27 Ma. We conclude that the high‐P rocks from south Naxos were exhumed to upper mid‐crustal levels in the late Eocene and early Oligocene at rates of 7.4 ± 4.6 km/Ma, completing a full blueschist‐/greenschist facies metamorphic cycle soon after subduction within c. 8 Ma. The greenschist facies overprint of the blueschist facies rocks from south Naxos resulted from rapid exhumation and associated deformation/fluid‐controlled metamorphic re‐equilibration, and is unrelated to the strong high‐T metamorphism associated with the Miocene formation of the Naxos migmatite dome. It follows that the Miocene thermal overprint had no impact on rock textures or Sr isotopic signatures, and that the rocks of south Naxos underwent three metamorphic events, one more than hitherto envisaged.     

A GLUE‐based uncertainty assessment framework for tritium‐inferred transit time estimations under baseflow conditions

The last decade has seen major technical and scientific improvements in the study of water transfer time through catchments. Nevertheless, it has been argued that most of these developments used conservative tracers that may disregard the oldest component of water transfer, which often has transit times greater than 5 years. Indeed, although the analytical reproducibility of tracers limits the detection of the older flow components associated with the most dampened seasonal fluctuations, this is very rarely taken into account in modelling applications. Tritium is the only environmental tracer at hand to investigate transfer times in the 5‐ to 50‐year range in surface waters, as dissolved gases are not suitable due to the degassing process. Water dating with tritium has often been difficult because of the complex history of its atmospheric concentration, but its current stabilization together with recent analytical improvements open promising perspectives. In this context, the innovative contribution of this study lies in the development of a generalized likelihood uncertainty estimation‐based approach for analysing the uncertainties associated with the modelling of transit time due to both parameter identification and tracer analytical precision issues. A coupled resampling procedure allows assessment of the statistical significance of the transfer time differences found in diverse waters. This approach was developed for tritium and the exponential‐piston model but can be implemented for virtually any tracer and model. Stream baseflow, spring and shallow aquifer waters from the Vallcebre research catchments, analysed for tritium in different years with different analytical precisions, were investigated by using this approach and taking into account other sources of uncertainty. The results showed three groups of waters of different mean transit times, with all the stream baseflow and spring waters older than the 5‐year threshold needing tritium. Low sensitivity of the results to the model structure was also demonstrated. Dual solutions were found for the waters sampled in 2013, but these results may be disambiguated when additional analyses will be made in a few years. Copyright © 2016 John Wiley & Sons, Ltd.     

Latitudinal patterns of export production recorded in surface sediments of the Chilean Patagonian fjords (41–55°S) as a response to water column productivity

The Chilean Patagonian fjords region (41–56°S) is characterized by highly complex geomorphology and hydrographic conditions, and strong seasonal and latitudinal patterns in precipitation, freshwater discharge, glacier coverage, and light regime; all of these directly affect biological production in the water column. In this study, we compiled published and new information on water column properties (primary production, nutrients) and surface sediment characteristics (biogenic opal, organic carbon, molar C/N, bulk sedimentary δ¹³C_org) from the Chilean Patagonian fjords between 41°S and 55°S, describing herein the latitudinal pattern of water column productivity and its imprint in the underlying sediments. Based on information collected at 188 water column and 118 sediment sampling sites, we grouped the Chilean fjords into four main zones: Inner Sea of Chiloé (41° to ～44°S), Northern Patagonia (44° to ～47°S), Central Patagonia (48–51°S), and Southern Patagonia (Magellan Strait region between 52° and 55°S). Primary production in the Chilean Patagonian fjords was the highest in spring–summer, reflecting the seasonal pattern of water column productivity. A clear north–south latitudinal pattern in primary production was observed, with the highest average spring and summer estimates in the Inner Sea of Chiloé (2427 and 5860 mg C m^?2 d^?1) and Northern Patagonia (1667 and 2616 mg C m^?2 d^?1). This pattern was closely related to the higher availability of nutrients, greater solar radiation, and extended photoperiod during the productive season in these two zones. The lowest spring value was found in Caleta Tortel, Central Patagonia (91 mg C m^?2 d^?1), a site heavily influenced by glacier meltwater and river discharge loaded with glacial sediments. Biogenic opal, an important constituent of the Chilean fjord surface sediments (Si_OPAL ～1–13%), reproduced the general north–south pattern of primary production and was directly related to water column silicic acid concentrations. Surface sediments were also rich in organic carbon content and the highest values corresponded to locations far away from glacier influence, sites within fjords, and/or semi-enclosed and protected basins, reflecting both autochthonous (water column productivity) and allochthonous sources (contribution of terrestrial organic matter from fluvial input to the fjords). A gradient was observed from the more oceanic sites to the fjord heads (west–east) in terms of bulk sedimentary δ¹³C_org and C/N ratios; the more depleted (δ¹³C_org ?26‰) and higher C/N (23) values corresponded to areas close to rivers and glaciers. A comparison of the Chilean Patagonian fjords with other fjord systems in the world revealed high variability in primary production for all fjord systems as well as similar surface sediment geochemistry due to the mixing of marine and terrestrial organic carbon.     

Hydrographic Vertical Separation Surfaces (HyVSEPs) for the Tidal Waters of Canada

Since the advent of Global Navigation Satellite Systems, it has been possible to perform hydrographic survey reductions through the ellipsoid, which has the potential to simplify operations and improve bathymetric products. This technique requires a spatially continuous separation surface connecting chart datum (CD) to a geodetic ellipsoid. The Canadian Hydrographic Service (CHS), with support from the Canadian Geodetic Survey, has developed a new suite of such surfaces, termed Hydrographic Vertical Separations Surfaces, or HyVSEPs, for CD and seven tidal levels. They capture the spatial variability of the tidal datum and levels between tide gauges and offshore using semiempirical models coupling observations at tide stations with relative sea-level rise estimates, dynamic ocean model solutions, satellite altimetry, and a geoid model. HyVSEPs are available for all tidal waters of Canada, covering over seven million square kilometers of ocean and more than 200,000 kilometers of shoreline. This document provides an overview of the CHS's modeling approach, tools, methods, and procedures.

The HyVSEP for CD defines the new hydrographic datum for the tidal waters of Canada. HyVSEPs for other tidal levels are fundamental for coastal studies, climate change adaptation and the definition of the Canadian shoreline and offshore boundaries. HyVSEPs for inland waters are not discussed.