Application of a Simulation Model for the Formation of Methane Hydrate to the Nankai Trough and the Blake Ridge: Natural Examples of Two End-member Cases

Abstract. Simulation experiments with a one-dimensional static model for formation of methane hydrate are used to demonstrate models of hydrate occurrence and its generation mechanism for two end-member cases. The simulation results compare well with experimental data for two natural examples (the Nankai Trough and the Blake Ridge).
At the MITI Nankai Trough wells, the hydrate occurrence is characterized by strongly hydrated sediments developing just above the BGHS. Such occurrence can be reproduced well by simulation in which the end-member case of upward advective fluid flow from below the BGHS is set. The strongly hydrated sediments is formed by oversaturated solution with free gas which directly enters the BGHS by the upward advective fluid flow. The recycling of dissociated methane of preexisting hydrate also contributes to the increase of hydrate saturation.
At the Site 997 in the Blake Ridge area, the hydrate occurrence is characterized by thick zone with poorly hydrated sediments and no hydrate zone developing above the hydrate zone. Such occurrence can be reproduced well by simulation in which the end-member case of in-situ biogenic production of methane in the sediment of methane hydrate zone is set. The distribution pattern of hydrate saturation is basically controlled by that of TOC. However, the hydrate concentration near the bottom of the hydrate zone is increased by the effect of recycling of dissociated methane of pre-existing hydrate. No hydrate zone expresses the geologic time needed until the local concentration of methane exceeds the solubility by gradual accumulation of in-situ biogenic methane with burial.     

Metamorphic P-T conditions and variation of REE between two garnet generations from granulites in the Sør-Rondane mountains,East Antarctica

Mineralogy and Petrology - In this paper, we describe the metamorphic conditions of Fe-rich granulite and variations in rare earth elements (REE) between peak garnet porphyroblasts and secondary...     

On the initiation and movement mechanisms of a catastrophic landslide triggered by the 2008 Wenchuan (M<Subscript>s</Subscript> 8.0) earthquake in the epicenter area

The Niumiangou landslide (~7.5 × 10⁶ m³) was the largest that occurred in the town of Yingxiu (the epicentral area) during the 2008 Wenchuan earthquake. This landslide originated on a steep slope (~30°) that was located directly above the rupture surface of the responsible fault and then traveled ~2 km after flowing down the axes of two gently sloping (<12°) valleys. Evidence at the site indicates that the landslide materials were highly fluidized and underwent rapid movement. To examine the initiation and movement mechanisms of this landslide, we performed a detailed field survey, conducted laboratory tests on samples taken from the field, and analyzed the seismic motion. We conclude that the landside materials were displaced due to seismic loading during the earthquake and that liquefaction may have been triggered in saturated layers above the sliding surface with progressive downslope sliding, which resulted in the high mobility of the displaced materials. The liquefaction of colluvial deposits along the travel path due to loading by the sliding mass enhanced the mobility of the displaced mass originating in the source area. Using an energy-based approach, we estimated the dissipated energy in our cyclic loading test and the possible energy dissipated to the soil layer on the slope by the earthquake. We infer that the seismic energy available for the initiation of the slope failure in the source area may have greatly exceeded the amount required for the initiation of the liquefaction failure. The slope instability might have been triggered several seconds after the arrival of seismic motion.     

Validation and Joint Inversion of Teleseismic Waveforms for Earthquake Source Models Using Deep Ocean Bottom Pressure Records: A Case Study of the 2006 Kuril Megathrust Earthquake

The importance of accurate tsunami simulation has increased since the 2004 Sumatra-Andaman earthquake and the Indian Ocean tsunami that followed it, because it is an important tool for inundation mapping and, potentially, tsunami warning. An important source of uncertainty in tsunami simulations is the source model, which is often estimated from some combination of seismic, geodetic or geological data. A magnitude 8.3 earthquake that occurred in the Kuril subduction zone on 15 November, 2006 resulted in the first teletsunami to be widely recorded by bottom pressure recorders deployed in the northern Pacific Ocean. Because these recordings were unaffected by shallow complicated bathymetry near the coast, this provides a unique opportunity to investigate whether seismic rupture models can be inferred from teleseismic waves with sufficient accuracy to be used to forecast teletsunami. In this study, we estimated the rupture model of the 2006 Kuril earthquake by inverting the teleseimic waves and used that to model the tsunami source. The tsunami propagation was then calculated by solving the linear long-wave equations. We found that the simulated 2006 Kuril tsunami compared very well to the ocean bottom recordings when simultaneously using P and long-period surface waves in the earthquake source process inversion.     

Earthquake-induced displacements of gravity retaining walls and anchor-reinforced slopes

This paper examines in terms of seismic performance, the effectiveness of anchor reinforcement against gravity retaining walls used to stabilize a dry homogenous fill slope in earthquake-prone environment. Both analyzed stabilizing measures have the same design yield acceleration estimated from a limit equilibrium approach. The earthquake-induced displacements are calculated using a sliding block formulation of the equation of motion. Sliding failure along the base of the gravity retaining wall and rotational failure of the soil active wedge behind the wall, as well as rotational failure of the slide mass of the anchor-reinforced slope were considered in the present formulation. For the specific characteristics of the analyzed fill slope and input horizontal ground motion, the slope reinforced with anchors appears to experience vertical and horizontal seismic displacements at slope crest smaller by 12% and respectively, 32% than the vertical and horizontal earthquake-induced deformations estimated at the top of the active wedge behind the gravity retaining wall.     

Shift-and-add reconstruction of solar granulation images

To restore an atmospherically degraded image of solar granulation the shift-and-add (SAA) method is applied to its specklegrams. It is the first time, to the best of our knowledge, that such a technique has been used for image reconstruction of solar granulation, a largely extended target. SAA, therefore, enables us to monitor restored images of solar granulation in a simple and fast way.     

Roles of atmospheric variabilities in the formation of the Indian Ocean Dipole

Ocean Dynamics - Roles of atmospheric variabilities in the formation of Indian Ocean Dipole (IOD) were investigated using an ocean general circulation model and different atmospheric forcing...     

Enrichment of adsorbed methane in authigenic carbonate concretions of the Japan Trench

Substantial amounts of adsorbed methane were detected in authigenic carbonate concretions recovered from sedimentary layers from depths between 245 and 1,108 m below seafloor during Ocean Drilling Program Leg 186 to ODP sites 1150 and 1151 on the deep-sea terrace of the Japan Trench. Methane contents were almost two orders of magnitude higher in the concretions (291–4,528 nmol/g wet wt) than in the surrounding bulk sediments (5–93 nmol/g wet wt), whereas methane/ethane ratios and stable carbon isotopic compositions were very similar. Carbonate content of surrounding bulk sediments (0.02–3.2 wet wt%) and methane content of the surrounding bulk sediments correlated positively. Extrapolation of the carbonate contents of bulk sediments suggests that 100 wt% carbonate would correspond to 1,886±732 nmol methane per g bulk sediment, which is similar to the average value observed in the carbonate concretions (1,321±1,067 nmol/g wet wt, n = 13). These data support the hypothesis that, in sediments, adsorbed hydrocarbon gases are strongly associated with authigenic carbonates.     

Stability Behavior and Thermodynamic States of Iron and Manganese in Sandy Soil Aquifer,Manukan Island,Malaysia

A total of 20 soil samples were collected from 10 boreholes constructed in the low lying area, which included ancillary samples taken from the high elevation area. Redox processes were investigated in the soil as well as groundwater in the shallow groundwater aquifer of Manukan Island, Sabah, Malaysia. Groundwater samples (n = 10) from each boreholes were also collected in the low lying area to understand the concentrations and behaviors of Fe and Mn in the dissolved state. This study strives to obtain a general understanding of the stability behaviors on Fe and Mn at the upper unsaturated and the lower-saturated soil horizons in the low lying area of Manukan Island as these elements usually play a major role in the redox chemistry of the shallow groundwater. Thermodynamic calculations using PHREEQC showed that the groundwater samples in the study area are oversaturated with respect to goethite, hematite, Fe(OH)₃ and undersaturated with respect to manganite and pyrochroite. Low concentrations of Fe and Mn in the groundwater might be probably due to the lack of minerals of iron and manganese oxides, which exist in the sandy aquifer. In fact, high organic matters that present in the unsaturated horizon are believed to be responsible for the high Mn content in the soil. It was observed that the soil samples collected from high elevation area (BK) comprises considerable amount of Fe in both unsaturated (6675.87 mg/kg) and saturated horizons (31440.49 mg/kg) compared to the low Fe content in the low lying area. Based on the stability diagram, the groundwater composition lies within the stability field for Mn²⁺ and Fe²⁺ under suboxic condition and very close to the FeS/Fe²⁺ stability boundary. This study also shows that both pH and Eh values comprise a strong negative value thus suggesting that the redox potential is inversely dependent on the changes of pH.     

Inferred ultrahigh-temperature metamorphism of amphibolitized olivine granulite from the Sør Rondane Mountains, East Antarctica

This paper reports the first evidence of ultrahigh-temperature (UHT) metamorphism from the Sør Rondane Mountains, eastern Dronning Maud Land, East Antarctica, which is evident as orthopyroxene + spinel symplectite in an amphibolitized mafic granulite. The granulite consists of olivine, orthopyroxene, clinopyroxene, pargasitic amphibole, plagioclase, and ilmenite, and it possesses a within-plate alkali basalt signature. The local bulk chemical composition of symplectite, major and trace element compositions, and thermodynamic calculations for the symplectite, suggest the presence of garnet at the high-pressure stage and that the symplectite formed from garnet, olivine, and primary orthopyroxene by decompression from more than 12 kbar at 1000 °C. The granulite records a subsequent amphibolite-facies overprint (<700 °C at <6 kbar) that involved the chemical re-equilibration of several phases. The obtained pressure–temperature (P–T) conditions and P–T path are different from the UHT metamorphism from the Schirmacher Hills, central Dronning Maud Land, which is considered to have occurred in a back-arc tectonic setting. The relatively high-P conditions and the decompression path reconstructed in the present study are similar to those reported for southern India, Sri Lanka, and part of northeastern Mozambique, possibly reflecting continental thickening and exhumation during the main collision event between East and West Gondwana.