Deformation measurements on Kilauea volcano,Hawaii

Repeated electronic distance measurements across Kilauea Caldera with Tellurometers and Geodimeter show definite horizontal expansion related to the vertical uplift and outward tilting of the summit prior to an eruption, and contraction during and after a flank eruption. Measurements started in October 1964, along a 3098 meter line between Uwekahuna and Keanakakoi, indicate a relatively uniform lengthening of 12 centimeters during the interval October 22, 1964 to March 1, 1965. Rapid shortening of the line by 28 centimeters was measured 4 days after the beginning of a flank eruption which involved emission of approximately 29 million cubic meters of lava during the period March 5 to March 15, 1965. During the expansion, the standard deviation of 10 Tellurometer measurements from a least-squares srtaight line solution is ± 2.0 centimeters (6.5 ppm) whereas 9 Geodimeter measurements have a standard deviation of ± 1.1 (3.6 ppm) centimeters. Absolute distance readings between the two instruments differ by 4 centimeters (13 ppm), but relative changes in distance were the same on both instruments. Changes in distance across Kilauea Caldera can, therefore, be easily measured to accuracies of 4 to 7 parts per million with standard electronic distance measuring systems. On active volcanoes where ground surface deformation exceeds 10–100 parts per million with changes in subsurface magma pressure or volume, repeated horizontal distance measurements can be a most useful technique.     

Detection of ocean waves by microwave radar; The modulation of short gravity-capillary waves

Short gravity-capillary waves, the predominant radar scatterers under many oceanic and radar-viewing conditions, are modulated in amplitude, velocity and orientation by the larger-scale motions of the ocean surface. These modulations render the larger scales observable to microwave radar. The high data rate and advanced technology of modern radar systems make it possible to measure these modulations and, in some cases, to display them as images of the ocean surface. While the modulation of orientation and velocity are straightforward to understand, the amplitude modulation is a dynamic response of the equilibrium short gravity-capillary waves to larger scale driving forces including straining by orbital velocities of large waves. Microwave studies of the growth and equilibrium of short wind-generated waves are reviewed. It is shown that the response of these waves to straining can produce modulations in radar cross-section greater than those due to tilting but which are wind-speed dependent. The net modulation depends strongly on the direction as well as the magnitude of the wind speed. Quantitative determination of ocean wave-height spectra from measured modulations will therefore be a complicated procedure. Measurements of ocean waves with CW Doppler and Synthetic Aperture radars are discussed in the light of these findings.     

A deep seismic profile of 800 km length recorded in southern Queensland, Australia

Summary. In 1984, the Australian Bureau of Mineral Resources and the Geological Survey of Queensland recorded a regional seismic reflection profile of over 800 km length from the eastern part of the Eromanga Basin to the Beenleigh Block east of the Clarence Moreton Basin. A relatively transparent upper crustal basement with an underlying, more reflective lower crust is characteristic of much of the region. Prominent westerly dipping reflectors occur well below the sediments of the eastern margin of the Clarence Moreton Basin and the adjacent Beenleigh Block, and provide some of the most interesting features of the entire survey. A wide angle reflection/refraction survey of 192 km length and an expanding reflection spread of 25 km length were recorded across the Nebine Ridge. The only clear deep reflectors are interpreted as P-to-SV or SV-to-P converted reflections from a mid-crustal boundary at a depth of about 17 km. The combined Nebine Ridge data provide well-constrained P and S wave velocity models of the upper crust, and suggest a crustal structure quite different from that beneath the adjacent Mesozoic basins.     

Pleistocene climatic change in Southern Australia and its effect on speleothem deposition in some Nullarbor caves

Activity ratios of ²³⁴U/²³⁸U, ²³⁰Th/²³⁴U, and ²³⁰Th/²³²Th have been determined for calcite, gypsum and halite speleothems from caves of the Nullarbor Plain, mostly in the area N and NW of Mundrabilla Station, for the purpose of U-series dating. All calcite speleothems contain adequate amounts of uranium for dating, but some show an excess of ²³⁰Th. Stratigraphic relationships indicate that there were at least three phases of calcium carbonate deposition in the Nullarbor caves. The calcite samples, with one possible exception, have ages in excess of ca. 400000 yrs BP. This suggests that no significant amounts of calcium carbonate deposition have taken place during the last 400ka. At present, active deposition of speleothems is restricted almost entirely to gypsum and halite. The only gypsum speleothem dated was found to have a finite age of ca. 185 ka. Six dates on a small halite speleothem containing insect and arachnid remains indicate that it formed rapidly during Holocene time.     

Catastrophic landslides,glacier behaviour and moraine formation – A view from an active plate margin

The influence of large bedrock landslides (“rock avalanches”) on the behaviour of glaciers is incompletely recognised. Here we present an example from an active tectonic margin in South Island, New Zealand where large earthquakes leave a significant imprint on glacial records. We demonstrate that terminal moraines on the western side of the Southern Alps record both ‘ordinary’ (i.e. climate-driven) and landslide-initiated glacial advances. Following consideration of the processes involved in rock avalanche-initiated moraine construction we suggest ways of determining the nature of the advance that built the terminal moraine. The implications of these observations are important in breaking the conventional linkage of individual terminal moraines with climate forcing.     

The effects of rock fragments on hydrologic and hydraulic responses along a slope

A model describing the three‐dimensional matrix flow along a slope with rock fragments or impermeable blocks was developed. The model was combined with modified Picard's iteration to ensure mass conservation in the unsaturated flow. We found that rock fragments obstruct water flow along the slope. The groundwater table must be raised to provide a sufficient pore water pressure gradient to facilitate water flow, but higher pore water pressure may induce slope failure. We also conducted a bench‐scale laboratory flume experiment to examine the effects of impermeable blocks on downstream seepage flow. In addition, a numerical experiment was conducted to examine how different arrangements of impermeable blocks affect downstream seepage flow and pore water pressure. This research demonstrated that the hydraulic phenomena were affected when impermeable blocks were present, and pore water pressure increased as the position of impermeable blocks was lowered. Copyright © 2006 John Wiley & Sons, Ltd.     

Crustal and upper mantle structure of the northwestern North Island, New Zealand, from seismic refraction data

The crustal and upper mantle structure of the northwestern North Island of New Zealand is derived from the results of a seismic refraction experiment; shots were fired at the ends and middle of a 575 km-long line extending from Lake Taupo to Cape Reinga. The principal finding from the experiment is that the crust is 25 ± 2 km thick, and is underlain by what is interpreted to be an upper mantle of seismic velocity 7.6 ± 0.1 km s⁻¹, that increases to 7.9 km s⁻¹ at a depth of about 45 km. Crustal seismic velocities vary between 5.3 and 6.36 km s⁻¹ with an average value of 6.04 km s⁻¹. There are close geophysical and geological similarities between the north-western North Island of New Zealand and the Basin and Range province of the western United States. In particular, the conditions of low upper-mantle seismic velocities, thin crust with respect to surface elevation, and high heat-flow (70–100 mW m⁻²) observed in these two areas can be ascribed to their respective positions behind an active convergent margin for about the past 20 Myr.     

Genetic structure of the tall sea pen Funiculina quadrangularis in NW Scottish sea lochs

The tall sea pen Funiculina quadrangularis has a patchy distribution around the UK, being found in sheltered waters below 20 m depth on the northwest coast of Scotland and Ireland. The limited distribution and sensitivity to bottom fishing activities make F. quadrangularis vulnerable to reduction in population numbers that may lead to genetic isolation and reduced diversity. Because of this vulnerability and low resilience to physical disturbance, the tall sea pen is recognised as a Species of Principle Importance under the Natural Environment and Rural Communities Act, 2006, UK. ( http://www.legislation.gov.uk/ukpga/2006/16/contents ) and is also on the Biodiversity Action Plan list of Priority Species for the UK. In the Mediterranean it is recognised as a sensitive and essential fish habitat because it forms habitat for several commercially important crustaceans. The aim of this study was to understand the current state of the genetic structure and gene flow of F. quadrangularis in areas of NW Scotland. We developed 10 microsatellite markers and used them to genotype 176 samples from four populations. Overall, our results suggest that there is high genetic diversity and high gene flow between colonies of F. quadrangularis in and among locations in Loch Linnhe and Loch Duich. As a result of the high rates of gene flow, genetic differentiation between sites was low. This may provide resilience to human impacts if distant populations have a high connectivity. However, care must be taken, as small but significant isolation by distance was found between the most geographically distant sites and only a small part of the species range was examined in this study. The genetic tools developed here will provide a foundation for wider studies of this vulnerable species.     

A Geoarchaeological Study of the Middle and Upper Pleistocene Levels at Canteen Kopje,Northern Cape Province,South Africa

Canteen Kopje, situated in the Northern Cape Province of South Africa, has two main archaeological deposits: alluvial gravels and a mantle of overlying fine sediments known locally as the “Hutton Sands.” This paper focuses on the fine sediments, the three industries contained within them, and the interface with the underlying gravels in an attempt to clarify their formation and transformation. A Fauresmith assemblage is found at this interface; it is thus crucial to understand the processes of deposition and modification at this poorly understood boundary. The methods used in this study involved the analysis of artifact depositional (dip and orientation) and spatial data, artifact condition, raw materials, and assemblage size profiles. Data presented document the mixing between the lowest levels of the fine sediments and the underlying alluvial gravels. This study thus provides important contextual information for the Fauresmith industry at Canteen Kopje.     

The Kabanga Ni sulfide deposit, Tanzania: I. Geology, petrography, silicate rock geochemistry, and sulfur and oxygen isotopes

The Kabanga Ni sulfide deposit represents one of the most significant Ni sulfide discoveries of the last two decades, with current indicated mineral resources of 23.23 Mt at 2.64% Ni and inferred mineral resources of 28.5 Mt at 2.7% Ni (Nov. 2008). The sulfides are hosted by a suite of ∼1.4 Ga ultramafic–mafic, sill-like, and chonolithic intrusions that form part of the approximately 500 km long Kabanga–Musongati–Kapalagulu igneous belt in Tanzania and Burundi. The igneous bodies are up to about 1 km thick and 4 km long. They crystallized from several compositionally distinct magma pulses emplaced into sulfide-bearing pelitic schists. The first magma was a siliceous high-magnesium basalt (approximately 13.3% MgO) that formed a network of fine-grained acicular-textured gabbronoritic and orthopyroxenitic sills (Mg# opx 78–88, An plag 45–88). The magma was highly enriched in incompatible trace elements (LILE, LREE) and had pronounced negative Nb and Ta anomalies and heavy O isotopic signatures (δ¹⁸O +6 to +8). These compositional features are consistent with about 20% contamination of primitive picrite with the sulfidic pelitic schists. Subsequent magma pulses were more magnesian (approximately 14–15% MgO) and less contaminated (e.g., δ¹⁸O +5.1 to +6.6). They injected into the earlier sills, resulting in the formation of medium-grained harzburgites, olivine orthopyroxenites and orthopyroxenites (Fo 83–89, Mg# _opx 86–89), and magmatic breccias consisting of gabbronorite–orthopyroxenite fragments within an olivine-rich matrix. All intrusions in the Kabanga area contain abundant sulfides (pyrrhotite, pentlandite, and minor chalcopyrite and pyrite). In the lower portions and the immediate footwall of two of the intrusions, namely Kabanga North and Kabanga Main, there occur numerous layers, lenses, and veins of massive Ni sulfides reaching a thickness of several meters. The largest amount of high grade, massive sulfide occurs in the smallest intrusion (Kabanga North). The sulfides have heavy S isotopic signatures (δ³⁴S wr = +10 to +24) that broadly overlap with those of the country rock sulfides, consistent with significant assimilation of external sulfur from the Karagwe–Ankolean sedimentary sequence. However, based partly on the relatively homogenous distribution of disseminated sulfides in many of the intrusive rocks, we propose that the Kabanga magmas reached sulfide saturation prior to final emplacement, in staging chambers or feeder conduits, followed by entrainment of the sulfides during continued magma ascent. Oxygen isotope data indicate that the mode of sulfide assimilation changed with time. The heavy δ¹⁸O ratios of the early magmas are consistent with ingestion of the sedimentary country rocks in bulk. The relatively light δ¹⁸O ratios of the later magmas indicate less bulk assimilation of the country rocks, but in addition the magmas selectively assimilated additional S, possibly through devolatization of the country rocks or through cannibalization of magmatic sulfides deposited in the conduits by preceding magma surges. The intrusions were tilted at ca. 1.37 Ga, during the Kibaran orogeny and associated synkinematic granite plutonism. This caused solid-state mobilization of ductile sulfides into shear zones, notably along the base of the intrusions where sulfide-hornfels breccias and lenses and layers of massive sulfides may reach a thickness of >10 m and can extend for several 10 s to >100 m away from the intrusions. These horizons represent an important exploration target for additional nickel sulfide deposits.