Suspended barite as a tracer of biological activity in the Southern Ocean

During two cruises in the Southern Ocean (INDIGO 3, Indian sector and EPOS 2, Scotia-Weddell Confluence) suspended matter samples were collected for analysis of several biogenic elements including Ba, Si and particulate organic carbon (POC).The good agreement between particulate barium in subsurface water with oxygen minimum concentrations as well as with nitrate depletions suggests that it reflects the intensity of new production over the past season. As a consequence of new production in the Southern Ocean being performed mainly by diatoms, the occurrences of barite and diatoms are related in the water column. In areas characterized by diatom-poor phytoplankton, barite does occur, but in lower concentrations.     

Sublethal effects of oiled sediment on the sand worm, Nereis (neanthes) virens: Induced changes in burrowing and emergence

The burrowing and emergence behavior of sand worms, Nereis (Neanthes) virens Sars, in sediment contaminated with sublethal concentrations of Prudhoe Bay crude oil ranging from 74 to 5222 ppm, was studied in the laboratory. Initial burrowing in oiled sediment did not differ from that observed in unoiled sediment. Emergence of exposed worms was related to the oil concentration and the extent of weathering of oiled sediment. Sand worms buried in unoiled sediment did not emerge. Worms dug from oiled sediment after 12 hours' exposure and placed on unoiled sediment were impaired, resulting in a significant increase in time to burrow. However, after 12h, they recovered and burrowed at normal rates. Worms held in oiled sediment for 96 h also recovered. Possible causes for recovery are discussed. Results suggest that oil-induced aberrations may increase vulnerability to predation.     

Theoretical aspects of cap-rock and fault seals for single- and two-phase hydrocarbon columns

Cap-rock seals can be divided genetically into those that fail by capillary leakage (membrane seals) and those whose capillary entry pressures are so high that seal failure preferentially occurs by fracturing and/or wedging open of faults (hydraulic seals). A given membrane seal can trap a larger oil column than gas column at shallow depths, but below a critical depth (interval), gas is more easily sealed than oil. This critical depth increases with lower API gravity, lower oil GOR and overpressured conditions (for the gas phase). These observations arise from a series of modelling studies of membrane sealing and can be conveniently represented using pressure/ depth (P/D) profiles through sealed hydrocarbon columns. P/D diagrams have been applied to the more complex situation of the membrane sealing of a gas cap underlain by an oil rim; at seal capacity, such a two-phase column will be always greater than if only oil or gas occurs below the seal.These conclusions contrast with those for hydraulic seals where the seal capacity to oil always exceeds that for gas. Moreover, a trapped two-phase column, at hydraulic seal capacity will be less than the maximum-allowed oil-only column, but more than the maximum gas-only column. Unlike membrane seals, hydraulic seal capacity should be directly related to cap-rock thickness, in addition to the magnitude of the minimum effective stress in the sealing layer and the degree of overpressure development in the sequence as a whole.Fault-related seals are effectively analogous to membrane cap-rocks which have been tilted to the angle of the fault plane. Consequently, all of the above conclusions derived for membrane cap-rocks apply to both sealing faults sensu stricto (fault plane itself seals) and juxtaposition faults (hydrocarbon trapped laterally against a juxtaposed sealing unit). The maximum-allowed two-phase column trapped by a sealing fault is greater than for equivalent oil-only and gas-only columns, but less than that predicted for a horizontal membrane cap-rock under similar conditions. Where a two-phase column is present on both sides of a sealing fault (which is at two-phase seal capacity), a deeper oil/water contact (OWC) in one fault block is associated with a deeper gas/oil contact (GOC) compared with the adjacent fault block. If the fault seal is discontinuous in the gas leg, however, the deeper OWC is accompanied by a shallower GOC, whereas a break in the fault seal in the oil leg results in a common OWC in both fault blocks, even though separate GOC's exist. Schematic P/D profiles are provided for each of the above situations from which a series of fundamental equations governing single- and two-phase cap-rock and fault seal capacities can be derived. These relationships may have significant implications for exploration prospect appraisal exercises where more meaningful estimates of differential seal capacities can be made.The membrane sealing theory developed herein assumes that all reservoirs and seals are water-wet and no hydrodynamic flow exists. The conclusions on membrane seal capacity place constraints on the migration efficiency of gas along low-permeabiligy paths at depth where fracturing, wedging open of faults and/or diffusion process may be more important. Contrary to previous assertions, it is speculated that leakage of hydrocarbons through membrane seals occurs in distinct pulses such that the seal is at or near the theoretically calculated seal capacity, once this has been initially attained.Finally, the developed seal theory and P/D profile concepts are applied to a series of development geological problems including the effects of differential depletion, and degree of aquifer support, on sealing fault leakage, and the evaluation of barriers to vertical cross-flow using RFT profiles through depleted reservoirs. It is shown that imbibition processes and dynamic effects related to active cross-flow across such barriers often preclude quantitative analysis and solution of these problems for which simulation studies are usually required.     

The behaviour of a Cu(II) ion selective electrode in seawater; copper consumption capacity and copper determinations

Determinations of copper consumption capacity (CuCs.C) and labile copper concentrations in surface coastal seawater, using a copper ion selective electrode (Cu-ISE) potentiometric method under predominantly diffusive conditions, are reported. For evaluation of the copper concentrations, the points of the endpoint contiguity zone of the CuCs.C titration curve were treated by an ISE multiple standard addition technique. The results were compared with those obtained by means of a Chelex-100 (calcic form) ‘batch’ procedure-potentiometric stripping analysis.The labile copper of the sample was determined at concentrations down to 10.70 nM with an average RSD of 12%, independent of the Cu-ISE employed. For adjacent subsamples, the mean CuCs.C values obtained for El Way seawater were equivalent to 81.05 and 48.00 nM copper, with an RSD of 4 and 7%, and for Isla Santa Maria seawater the value was equivalent to 70.27 nM copper, with an RSD of 7%. The theoretical approach of the electrode diffusive mechanism proposed, which would depend, fundamentally, on the adsorptive, complexing and reducing properties of the dissolved organic matter in the seawater sample, allows simultaneous analytical determination of CuCs.C and labile copper concentration in seawater.     

The effect of currents on the generation of internal waves by a barotropic tide near an underwater ridge

In the frame of the linear theory for long waves, the paper studies long waves generated by a barotropic tide running at an arbitrary angle over a bottom ridge. The ocean is assumed to be two-layered. In the area of a ridge with a rectangular cross section, geostrophic flows are considered, coupled with the inclinations of the free surface and interface. Wave amplitudes are shown to depend on the angle of an onrunning tide and this allows us to reach a conclusion about the influence of a geostrophic current on the generation of internal waves. Translated by Vladimir A. Puchkin.