Seasonal variations in prey selection by estuarine black-headed gulls (Larus ridibundus)

The number of black-headed gulls (Larus ridibundus) in the Clyde Estuary is large. In summer the average density has reached 1350 gulls km^?2 and in winter 180 gulls km^?2. This paper compares prey selection and feeding efficiency in gulls during summer and winter on tidal flats, and considers how seasonal differences may be adaptations to cope with seasonal changes in prey availability.Gross and net rates of energy intake were highest in summer because gulls captured more of the polychaete N. diversicolor than the amphipod C. volutator. In winter, gulls selected for C. volutator and therefore an energetically less profitable diet. Throughout the year gulls selected more C. volutator relative to N. diversicolor than expected on energetic grounds and so apparently did not maximize potential net rate of energy intake.Gulls used three techniques to capture prey and made most intensive use of the ‘crouch’ technique. Crouching gulls attained a much higher net rate of energy intake than ‘upright’ or ‘paddling’ gulls.A log-linear model showed that (a) season, water depth and gull density determined feeding technique and (b) feeding technique and season independently determined foraging success and prey selection. Thus gull density and water depth acted on prey selection through imposed variations in feeding technique.Reasons for gulls selecting energetically unprofitable C. volutator and for the use of several distinct feeding techniques are discussed.     

Deep-ocean piezometer probe technology for geotechnical investigations

Two single-sensor piezometer probes, 8 mm in diameter, were developed for deep-ocean geotechnical investigations. These probes were tested in a hyperbaric chamber pressurized to 55 MPa (8000 psi). Testing was performed for a period of five weeks under high hydrostatic pressure with the probes inserted in reconstituted illitic marine sediment. Small differential pore-water pressures were generated in response to both mechanically and thermally generated forcing functions. During deep-ocean simulated pressure tests, the sensors exhibited excellent sensitivity and stability. These developments in piezometer-probe technology provide a quantitative means of assessing important geotechnical parameters of fine-grained seabed deposits.     

Generalized strain probing of constitutive models

Advanced material constitutive models are used to describe complex soil behaviour. These models are often used in the solution of boundary value problems under general loading conditions. Users and developers of constitutive models need to methodically investigate the represented soil response under a wide range of loading conditions. This paper presents a systematic procedure for probing constitutive models. A general incremental strain probe, 6D hyperspherical strain probe (HSP), is introduced to examine rate‐independent model response under all possible strain loading conditions. Two special cases of HSP, the true triaxial strain probe (TTSP) and the plane‐strain strain probe (PSSP), are used to generate 3‐D objects that represent model stress response to probing. The TTSP, PSSP and general HSP procedures are demonstrated using elasto‐plastic models. The objects resulting from the probing procedure readily highlight important model characteristics including anisotropy, yielding, hardening, softening and failure. The PSSP procedure is applied to a Neural Network (NN) based constitutive model. It shows that this probing is especially useful in understanding NN constitutive models, which do not contain explicit functions for yield surface, hardening, or anisotropy. Copyright © 2004 John Wiley & Sons, Ltd.     

Methods of array element localization for a towed underwateracoustic array

The location of the hydrophones on a towed underwater acoustic array as a function of time (array element localization) is needed for signal processing. Methods to perform this localization using least squares polynomial fitting to data from depth sensors, heading sensors, and sensors detecting a ping from a single source are discussed. Arc distance along the array is used as the independent parameter so that all solutions are constrained to be space curves. Examples of application to real data are presented, and techniques to discriminate against bad sensor data are discussed     

Theoretical accuracy of synthetic aperture sonar micronavigation using a displaced phase-center antenna

The Cramer-Rao lower bounds on the cross-track translation and rotation of a displaced phase-center antenna (DPCA) in the slant range plane between two successive pings (known as DPCA sway and yaw in what follows) are computed, assuming statistically homogeneous backscatter. These bounds are validated using experimental data from a 118-182-kHz sonar, showing an accuracy of the order of 20 microns on the ping-to-ping cross-track displacements. Next, the accuracy required on the DPCA sway and yaw in order to achieve a given synthetic aperture sonar (SAS) beampattern specification, specified by the expected SAS array gain, is computed as a function of the number P of pings in the SAS. Higher accuracy is required when P increases to counter the accumulation of errors during the integration of the elementary ping-to-ping estimates: the standard deviation must decrease as P/sup -1/2/ for the DPCA sway and P/sup -3/2/ for the yaw. Finally, by combining the above results, the lower bounds on DPCA micronavigation accuracy are established. These bounds set an upper limit to the SAS length achievable in practice. The maximum gain Q in cross-range resolution achievable by a DPCA micronavigated SAS is computed as a function of the key SAS parameters. These theoretical predictions are compared with simulations and experimental results.     

Vertical stress distribution due to an arbitrarily shaped foundation using triangulation and an analytical expression for a triangular loaded region

Using the basic Boussinesq's equation, the expression for the vertical stress distribution (σ_z) underneath any point on the ground surface due to a general triangular loaded region in a preferred orientation with a linearly varied loading has been successfully derived. When the triangle is not in a preferred orientation, a simple axis transformation is required and the expression will be equally applicable. Based on this expression, σ_z due to an arbitrarily shaped loaded foundation can simply be determined by first triangulating the loaded area and summing up the contributions from each generated triangular region. The procedures for triangulating and calculating the stress distribution can be simply automated through computer programs.     

Metamorphism in Archaean greenstone belts: calculated fluid compositions and implications for gold mineralization

An inescapable consequence of the metamorphism of greenstone belt sequences is the release of a large volume of metamorphic fluid of low salinity with chemical characteristics controlled by the mineral assemblages involved in the devolatilization reactions. For mafic and ultramafic sequences, the composition of fluids released at upper greenschist to lower amphibolite facies conditions for the necessary relatively hot geotherm corresponds to those inferred for greenstone gold deposits (X_CO2= 0.2–0.3). This result follows from the calculation of mineral equilibria in the model system CaO–MgO–FeO–Al₂O₃–SiO₂–H₂O–CO₂, using a new, expanded, internally consistent dataset. Greenstone metamorphism cannot have involved much crustal over-thickening, because very shallow levels of greenstone belts are preserved. Such orogeny can be accounted for if compressive deformation of the crust is accompanied by thinning of the mantle lithosphere. In this case, the observed metamorphism, which was contemporaneous with deformation, is of the low-P high-T type. For this type of metamorphism, the metamorphic peak should have occurred earlier at deeper levels in the crust; i.e. the piezothermal array should be of the ‘deeper-earlier’type. However, at shallow crustal levels, the piezothermal array is likely to have been of ‘deeper-later’type, as a consequence of erosion. Thus, while the lower crust reached maximum temperatures, and partially melted to produce the observed granites, mid-crustal levels were releasing fluids prograde into shallow crustal levels that were already retrograde. We propose that these fluids are responsible for the gold mineralization. Thus, the contemporaneity of igneous activity and gold mineralization is a natural consequence of the thermal evolution, and does not mean that the mineralization has to be a consequence of igneous processes. Upward migration of metamorphic fluid, via appropriate structurally controlled pathways, will bring the fluid into contact with mineral assemblages that have equilibrated with a fluid with significantly lower X_CO2. These assemblages are therefore grossly out of equilibrium with the fluid. In the case of infiltrated metabasic rocks, intense carbonation and sulphidation is predicted. If, as seems reasonable, gold is mobilized by the fluid generated by devolatilization, then the combination of processes proposed, most of which are an inevitable consequence of the metamorphism, leads to the formation of greenstone gold deposits predominantly from metamorphic fluids.     

A high resolution,multiproxy Late‐glacial record of climate change and intrasystem responses in northwest England

A lacustrine carbonate sequence from Hawes Water, Lancashire, UK, has been studied using stable isotopic, lithological, pollen and mineral magnetic analysis. The data reveal four abrupt climatic oscillations in the Late‐glacial Interstadial leading up to the onset of the Loch Lomond Stadial. The data also point to climatic warming relatively early within the stadial, ca. 12 500 GRIP yr, prior to the onset of the Holocene. The oxygen isotope record is taken as a signature of climate forcing against which the response of the lake‐system can be monitored. By adopting this approach it is revealed that the response of the biological system to the rapid climatic oscillations is non‐linear and primarily a function of the antecedent conditions. A significant end‐Devensian isotopic excursion (A) is matched by only minor changes in the cold‐adapted floras and faunas. During the warmer interstadial, the response of the biological ecosystem (events B–D) is clearly influenced by thresholds: major changes in the catchment vegetation associated with relatively minor oscillations in the isotopic signature. The stratigraphical patterns reveal significant lag effects between the onset of climate deterioration and resulting changes in vegetation. Copyright © 2002 John Wiley & Sons, Ltd.     

A chum scale pattern analyzer and stock identification based onscale patterns by discriminant function and power spectrum analysis

An optoelectronic instrument has been developed to analyze the scales and scale patterns of chum salmon. This device, with specially developed software, has been used to study populations of salmon. Fish from two different rivers approximately 200 km apart from each other were grouped with an accuracy of 82% or more. Machine-measured ages coincided with those derived from visual estimation in approximately 80% of the fish sampled. These results suggest the proposed system could be of practical use for measuring and analyzing the scale patterns that allow one to accurately measure both natural and farmed populations of salmon