Opacitization conditions of hornblende in Bezymyannyi volcano andesites (March 30, 1956 eruption)

The paper is devoted to the conditions under which opacite rims developed around hornblende grains in andesite of the catastrophic eruption (March 30, 1956) of Bezymyannyi volcano, Kamchatka. The opacite rims were produced by a bimetasomatic reaction between hornblende and melt with the development of the following zoning: hornblende → Px + Pl + Ti-Mag → Px + Pl → Px → melt. Biometasomatic reaction was accompanied by the active removal of CaO from the rim, addition of SiO₂, and more complicated behavior of other components. The hornblende also shows reactions of its volumetric decomposition under near-isochemical conditions. The opacite rims developed under isobaric conditions, at a pressure of approximately 6 kbar. The main reason for the instability of the hornblende was the heating of the magma chamber from 890 to 1005°C due to new hot magma portion injection. The time interval between the injection and the start of eruption was estimated from the thickness of the opacite rims and did not exceed 37 days. Hence, the March 30, 1956, eruption was not related to the volcanic activity in November of 1955 but to the injection of a fresh magma portion in February–March of 1956.     

Weibull statistical analysis of granite bending strength

Summary  This paper describes and discusses the adequacy of Weibull statistical analysis to analyse the bending strength of granite. The experimental results show that strength variability is related with a specific origin of failure. This conclusion is based on analysing the influence of the surface condition (extrinsic defects) on the bending strength results treated by the Weibull statistics. The conclusions drawn from this study have been validated by analysing the results of the critical flaw dimension estimated by applying the linear elastic fracture mechanics (LEFM) formulae. Results obtained from fractographic examination also have been used to describe the location of the origin of the fracture and understand the distribution of defects; i.e., there is a unimodal distribution of defects (intrinsic defects), despite the fact that some outlier values are normally observed in the fractured surfaces. Correspndence: P. M. Amaral, Department of Materials Engineering, Instituto Superior Técnico, Technical University of Lisbon, Av. Rovisco Pais, 1049-001 Lisboa, Portugal     

Chemical composition,volatile components,and trace elements in melts of the Karymskii volcanic center,Kamchatka, and Golovnina volcano,Kunashir Island: Evidence from inclusions in minerals

Melt inclusions were examined in phenocrysts in basalt, andesite, dacite, and rhyodacite from the Karymskii volcanic center in Kamchatka and dacite form Golovnina volcano in Kunashir Island, Kuriles. The inclusions were examined by homogenization and by analyzing glasses in more than 80 inclusions on an electron microscope and ion microprobe. The SiO₂ concentrations in the melt inclusions in plagioclase phenocrysts from basalts from the Karymskii volcanic center vary from 47.4 to 57.1 wt %, these values for inclusions in plagioclase phenocrysts from andesites are 55.7–67.1 wt %, in plagioclase phenocrysts from the dacites and rhyodacites are 65.9–73.1 wt %, and those in quartz in the rhyodacites are 72.2–75.7 wt %. The SiO₂ concentrations in melt inclusions in quartz from dacites from Golovnina volcano range from 70.2 to 77.0 wt %. The basaltic melts are characterized by usual concentrations of major components (wt %): TiO₂ = 0.7–1.3, FeO = 6.8–11.4, MgO = 2.3–6.1, CaO = 6.7–10.8, and K₂O = 0.4–1.7; but these rocks are notably enriched in Na₂O (2.9–7.4 wt % at an average of 5.1 wt %, with the highest Na₂O concentration detected in the most basic melts: SiO₂ = 47.4–52.0 wt %. The concentrations of volatiles in the basic melts are 1.6 wt % for H₂O, 0.14 wt % for S, 0.09 wt % for Cl, and 50 ppm for F. The andesite melts are characterized by high concentrations (wt %) of FeO (6.5 on average), CaO (5.2), and Cl (0.26) at usual concentrations of Na₂O (4.5), K₂O (2.1), and S (0.07). High water concentrations were determined in the dacite and rhyodacite melts: from 0.9 to 7.3 wt % (average of 15 analyses equals 4.5 wt %). The Cl concentration in these melts is 0.15 wt %, and those of F and S are 0.06 and 0.01 wt %, respectively. Melt inclusions in quartz from the dacites of Golovnina volcano are also rich in water: they contain from 5.0 to 6.7 wt % (average 5.6 wt %). The comparison of melt compositions from the Karymskii volcanic center and previously studied melts from Bezymyannyi and Shiveluch volcanoes revealed their significant differences. The former are more basic, are enriched in Ti, Fe, Mg, Ca, Na, and P but significantly depleted in K. The melts of the Karymskii volcanic center are most probably less differentiated than the melts of Bezymyannyi and Shiveluch volcanoes. The concentrations of water and 20 trace elements were measured in the glasses of 22 melt inclusions in plagioclase and quartz from our samples. Unusually high values were obtained for Li concentrations (along with high Na concentrations) in the basaltic melts from the Karymskii volcanic center: from 118 to 1750 ppm, whereas the dacite and rhyolite melts contain 25 ppm Li on average. The rhyolite melts of Golovnina volcano are much poorer in Li: 1.4 ppm on average. The melts of the Karymskii volcanic center are characterized by relative minima at Nb and Ti and maxima at B and K, as is typical of arc magmas.     

An Attempt to Predict the Failure Time of Abandoned Mine Pillars

Summary  Left in place pillars of abandoned mines are subject to weathering (e.g action of water, bacteria) that degrades their mechanical strength and eventually leads to collapse. A simple weathering model is proposed, that is governed by two parameters: the rate of progression of weathered front and the rate of degradation of the compressive strength with time. Both plane strain and axisymmetric analyses are performed and closed form solutions of the variation with time of the bearing capacity of the pillar are given. Experimental data of the tests conducted on gypsum and anhydrite specimens attacked by water are presented. It is shown that in order to fit the experimental data a third parameter must be introduced. New closed form solutions are given and the data are used for estimating the time to failure of abandoned gypsum mines in Northern Italy. Authors’ address: Dr. Riccardo Castellanza, Research Assistant, Department of Structural Engineering, Milan University of Technology (Politecnico), Piazza Leonardo da Vinci 32, 20133 Milan, Italy     

Dissolved metals and associated constituents in abandoned coal-mine discharges,Pennsylvania, USA. Part 1: Constituent quantities and correlations

Complete hydrochemical data are rarely reported for coal-mine discharges (CMD). This report summarizes major and trace-element concentrations and loadings for CMD at 140 abandoned mines in the Anthracite and Bituminous Coalfields of Pennsylvania. Clean-sampling and low-level analytical methods were used in 1999 to collect data that could be useful to determine potential environmental effects, remediation strategies, and quantities of valuable constituents. A subset of 10 sites was resampled in 2003 to analyze both the CMD and associated ochreous precipitates; the hydrochemical data were similar in 2003 and 1999. In 1999, the flow at the 140 CMD sites ranged from 0.028 to 2210 L s⁻¹, with a median of 18.4 L s⁻¹. The pH ranged from 2.7 to 7.3; concentrations (range in mg/L) of dissolved (0.45-μm pore-size filter) SO₄ (34–2000), Fe (0.046–512), Mn (0.019–74), and Al (0.007–108) varied widely. Predominant metalloid elements were Si (2.7–31.3 mg L⁻¹), B (<1–260 μg L⁻¹), Ge (<0.01–0.57 μg L⁻¹), and As (<0.03–64 μg L⁻¹). The most abundant trace metals, in order of median concentrations (range in μg/L), were Zn (0.6–10,000), Ni (2.6–3200), Co (0.27–3100), Ti (0.65–28), Cu (0.4–190), Cr (<0.5–72), Pb (<0.05–11) and Cd (<0.01–16). Gold was detected at concentrations greater than 0.0005 μg L⁻¹ in 97% of the samples, with a maximum of 0.0175 μg L⁻¹. No samples had detectable concentrations of Hg, Os or Pt, and less than half of the samples had detectable Pd, Ag, Ru, Ta, Nb, Re or Sn. Predominant rare-earth elements, in order of median concentrations (range in μg/L), were Y (0.11–530), Ce (0.01–370), Sc (1.0–36), Nd (0.006–260), La (0.005–140), Gd (0.005–110), Dy (0.002–99) and Sm (<0.005–79). Although dissolved Fe was not correlated with pH, concentrations of Al, Mn, most trace metals, and rare earths were negatively correlated with pH, consistent with solubility or sorption controls. In contrast, As was positively correlated with pH.     

The presence of anomalous trace element levels in present day Jamaican soils and the geochemistry of Late-Miocene or Pliocene phosphorites

High levels of Cd and Zn in Jamaican soils observed in geochemical surveys are related to the presence of phosphorites of possible Late-Miocene or Pliocene age. The trace element and REE geochemistry of the phosphorites, together with SEM studies, indicate a guano origin for the phosphorites. No specific host minerals for Cd could be identified in the fossiliferous phosphorite which is characterized by uniquely high levels of Cd, Zn, Ag, Be, U and Y. However, in the soil Cd is present in lithiophorite and a complex history of pedological development is preserved in the aluminous–goethite present in the soil. The unique guano signature is preserved in the soil despite the fact that guanos themselves have either not been observed or have been destroyed by continuing karst and soil development. The phosphorite geochemical signature can be traced in the data of a 1988 island-wide soil geochemical survey, identifying areas where the Palaeo-environment that supported bird ‘rookeries’ existed in the Late-Miocene or Pliocene.     

Paleogeographic regionalization of Triassic seas based on conodontophorids

Geographic differentiation of conodontophorids between northern and southern latitudes commenced in the Triassic since the early Induan. Cosmopolitan long-lived genera of predominantly smooth morphotypes without sculpturing were characteristic of high-latitude basins of the Panboreal Superrealm. Since the early Olenekian until the Carnian inclusive, this superrealm consisted of the Siberian Realm that extended over Northeast Asia and the Canada-Svalbard Realm that included the Svalbard Archipelago and northern regions of Canada. Throughout the Triassic period, conodontophorids characteristic of the Tethys-Panthalassa Superrealm spanning the Tethys and low-latitude zones of the Pacific were highly endemic, very diverse in taxonomic aspect, having well-developed sculpturing and tempos of morphological transformations. Distinctions between the Early-Middle Triassic conodontophorids from northern and southern zones were not as great as afterward, and their impoverished assemblages from southern Tethyan basins were close in some respects to the Boreal ones. Their habitat basins of that time can be grouped into the Mediterranean-Pacific and India-Pakistan realms. Hence, the extent of geographic differentiation of conodontophorids was not constant and gradually grew, as their taxonomic diversity was reducing in northern basins but relatively increasing in southern ones. The Panboreal e Tethys-Panthalassa superrealms of conodontophorids, which are most clearly recognizable, are close to first-rank paleobiochores (superrealms) established earlier for ammonoids and bivalve mollusks. Main factor that controlled geographic differentiation of Triassic conodontophorids was climatic zoning. Initially lower diversity of southern Tethyan assemblages points probably to relatively cooler water regime in the peri-Gondwanan part of the Tethys. The established patterns in geographic distribution of conodontophorids characterize most likely the real trend of their differentiation and evolution, i.e., the distribution area contraction prior to complete extinction at the end of the Triassic     

Geochemical characterization of surface waters and groundwater resources in the Managua area (Nicaragua,Central America)

This paper reports new geochemical data on dissolved major and minor constituents in surface waters and ground waters collected in the Managua region (Nicaragua), and provides a preliminary characterization of the hydrogeochemical processes governing the natural water evolution in this area. The peculiar geological features of the study site, an active tectonic region (Nicaragua Depression) characterized by active volcanism and thermalism, combined with significant anthropogenic pressure, contribute to a complex evolution of water chemistry, which results from the simultaneous action of several geochemical processes such as evaporation, rock leaching, mixing with saline brines of natural or anthropogenic origin. The effect of active thermalism on both surface waters (e.g., saline volcanic lakes) and groundwaters, as a result of mixing with variable proportions of hyper-saline geothermal Na–Cl brines (e.g., Momotombo geothermal plant), accounts for the high salinities and high concentrations of many environmentally-relevant trace elements (As, B, Fe and Mn) in the waters. At the same time the active extensional tectonics of the Managua area favour the interaction with acidic, reduced thermal fluids, followed by extensive leaching of the host rock and the groundwater release of toxic metals (e.g., Ni, Cu). The significant pollution in the area, deriving principally from urban and industrial waste-water, probably also contributes to the aquatic cycling of many trace elements, which attain concentrations above the WHO recommended limits for the elements Ni (∼40 μg/l) and Cu (∼10 μg/l) limiting the potential utilisation of Lake Xolotlan for nearby Managua.