DISASTER ANALYSIS AND COUNTERMEASURES OF LAND SUBSIDENCE CAUSED BY COAL CUTTING IN CHINA

In recent years, many coal-producing countries have paid great attention to the land subsidence causedby coal cutting. In China, because of the dense population in coalfield areas, the land subsidence hazard is more seri-ous. After a brief analysis on the mechanism of land subsidence, this paper gives a comprehensive and systematical ac-count on all kinds of hazards caused by the land subsidence in China. The study shows that land subsidence has endan-gered land, buildings, traffic and communication lines, dykes and dams. It also causes damage to ecological and socialenvironment. In order to lessen the hazard of land subsidence, preventive measures should be taken to reduce the col-lapse amount, such as extraction with stowing, banded mining system, succession and coordination mining system, orhigh-pressure mudflow between rock strata. Measures of reinforcing or moving certain buildings should also be taken toreduce the destructive degree. In order to harness the subsidence land and bring them under control for fanning, mea-sures should be taken such as filling with spoil or fine breeze, excavating the deeper and covering the shallower land.     

The shape of the rotation curves of edge-on galaxies

We consider the effects of projection, internal absorption, and gas-or stellar-velocity dispersion on the measured rotation curves of galaxies with edge-on disks. Axisymmetric disk models clearly show that the rotational velocity in the inner galaxy is highly underestimated. As a result, an extended portion that imitates nearly rigid rotation appears. At galactocentric distances where the absorption is low (i.e., it does not exceed 0.3–0.5^m kpc^?1), the line profiles can have two peaks, and a rotation curve with minimum distortions can be obtained by estimating the position of the peak that corresponds to a higher rotational velocity. However, the high-velocity peak disappears in high-absorption regions and the actual shape of the rotation curve cannot be reproduced from line-of-sight velocity estimates. In general, the optical rotation curves for edge-on galaxies are of little use in reconstructing the mass distribution in the inner regions, particularly for galaxies with a steep velocity gradient in the central region. In this case, estimating the rotation velocities for outer (transparent) disk regions yields correct results.     

The petrogenesis of type B1 Ca‐Al‐rich inclusions: The spinel perspective

Abstract— Minor element variations in MgAl₂O₄ spinel from the type B1 calcium‐aluminum‐rich inclusion (CAI) Allende TS‐34 confirm earlier studies in showing correlations between the minor element chemistry of spinels with their location within the inclusion and with the chemistry of host silicate phases. These correlations result from a combination of crystallization of a liquid produced by re‐melting event(s) and local re‐equilibration during subsolidus reheating. The correlation of the Ti and V in spinel inclusions with the Ti and V in the adjacent host clinopyroxene can be qualitatively explained by spinel and clinopyroxene crystallization prior to melilite, following a partial melting event. There are, however, difficulties in quantitative modeling of the observed trends, and it is easier to explain the Ti correlation in terms of complete re‐equilibration. The correlation of V in spinel inclusions with that in the adjacent host clinopyroxene also cannot be quantitatively modeled by fractional crystallization of the liquid produced by re‐melting, but it can be explained by partial re‐equilibration. The distinct V and Ti concentrations in spinel inclusions in melilite from the edge regions of the CAI are best explained as being affected by only a minor degree of re‐equilibration. The center melilites and included spinels formed during crystallization of the liquid produced by re‐melting, while the edge melilites and included spinels are primary. The oxygen isotope compositions of TS‐34 spinels are uniformly ¹⁶O‐rich, regardless of the host silicate phase or its location within the inclusion. Similar to other type B1 CAIs, clinopyroxene is ¹⁶O‐rich, but melilite is relatively ¹⁶O‐poor. These data require that the oxygen isotope exchange in TS‐34 melilite occurred subsequent to the last re‐melting event.     

In-Orbit Vignetting Calibrations of XMM-Newton Telescopes

We describe measurements of the mirror vignetting in the XMM-Newton Observatory made in-orbit, using observations of SNR G21.5-09 and SNR 3C58 with the EPIC imaging cameras. The instrument features that complicate these measurements are briefly described. We show the spatial and energy dependences of measured vignetting, outlining assumptions made in deriving the eventual agreement between simulation and measurement. Alternate methods to confirm these are described, including an assessment of source elongation with off-axis angle, the surface brightness distribution of the diffuse X-ray background, and the consistency of Coma cluster emission at different position angles. A synthesis of these measurements leads to a change in the XMM calibration data base, for the optical axis of two of the three telescopes, by in excess of 1 arcmin. This has a small but measureable effect on the assumed spectral responses of the cameras for on-axis targets. This revised version was published online in July 2006 with corrections to the Cover Date.     

Investigation of ion beam techniques for the analysis and exposure of particles encapsulated by silica aerogel: Applicability for Stardust

Abstract— In 2006, the Stardust spacecraft will return to Earth with cometary and perhaps interstellar dust particles embedded in silica aerogel collectors for analysis in terrestrial laboratories. These particles will be the first sample return from a solid planetary body since the Apollo missions. In preparation for the return, analogue particles were implanted into a keystone of silica aerogel that had been extracted from bulk silica aerogel using the optical technique described in Westphal et al. (2004). These particles were subsequently analyzed using analytical techniques associated with the use of a nuclear microprobe. The particles have been analyzed using: a) scanning transmission ion microscopy (STIM) that enables quantitative density imaging; b) proton elastic scattering analysis (PESA) and proton backscattering (PBS) for the detection of light elements including hydrogen; and c) proton‐induced X‐ray emission (PIXE) for elements with Z > 11. These analytical techniques have enabled us to quantify the composition of the encapsulated particles. A significant observation from the study is the variable column density of the silica aerogel. We also observed organic contamination within the silica aerogel. The implanted particles were then subjected to focused ion beam (FIB) milling using a 30 keV gallium ion beam to ablate silica aerogel in site‐specific areas to expose embedded particles. An ion polished flat surface of one of the particles was also prepared using the FIB. Here, we show that ion beam techniques have great potential in assisting with the analysis and exposure of Stardust particles.     

Ocean-floor hydrothermal metamorphism in the Limousin ophiolites (western French Massif Central): evidence of a rare preserved Variscan oceanic marker

The Limousin ophiolite is located at the suture zone between two major thrust sheets in the western French Massif Central. This ophiolitic section comprises mantle‐harzburgite, mantle‐dunite, wehrlites, troctolites and layered gabbros. It has recorded a static metamorphic event transforming the gabbros into undeformed amphibolites and the magmatic ultramafites into serpentinites and/or pargasite‐bearing chloritites. With various thermobarometric methods, it is possible to show that the different varieties of amphibole have registered low‐P (c. 0.2 GPa) conditions with temperature ranging from high‐T, late‐magmatic conditions to greenschist–zeolite metamorphic facies. The abundance of undeformed metamorphic rocks (which is typical of the lower oceanic crust), the occurrence of Ca–Al (–Mg) metasomatism illustrated by the growth of Ca–Al silicates in veins or replacing the primary magmatic minerals, the P–T conditions of the metamorphism and the numerous similarities with oceanic crustal rocks from Ocean Drilling Program and worldwide ophiolites are the main arguments for an ocean‐floor hydrothermal metamorphism in the vicinity of a palaeo‐ridge. Among the West‐European Variscan ophiolites, the Limousin ophiolites constitute an extremely rare occurrence that has not been involved in any HP (subduction‐related) or MP (orogenic) metamorphism as observed in other ophiolite occurrences (i.e. France, Spain and Germany).     

SORPTION AND DESORPTION CHARACTERISTICS OF CADMIUM BY FOUR DIFFERENT SOILS IN NORTHEAST CHINA

1IN TR O D U C TIO NA s a persistentand toxic pollutant, cadm ium (C d) canresultin m any adverse health effects in a variety oftis-suesand organssuch asthe lung,kidney,urinary,blad-der,pancreas,breast and prostate (SA TA R U G etal.,2003).C adm ium in so…     

Estimation of dispersion in estuaries by a self-consistent method

Longitudinal and transverse dispersion in estuaries may be determined in principle by measuring the change in time of the concentration field of a water soluble dye. In practice, measurements may take the form of several sampling runs crossing the dye patch. The coefficients of dispersion are usually estimated from the second moments of the concentration field; the use of second moments, in particular, introduces errors because measurements at long times or distance are unduly emphasized.A self-consistent method, free of the disadvantages inherent in the use of higher moments, is described in which the distribution of concentration in space is related to the zeroth spatial moment of concentration. In this formulation, based upon sampling runs across the dye patch, the concentration field in the estuary may be directly and simply related to the dispersion coefficients in both the intercept and gradient of a linear graph.The methods are illustrated by the characterization of a series of experiments in the Inner Estuary of Milford Haven.     

Seasonal variations in prey selection by estuarine black-headed gulls (Larus ridibundus)

The number of black-headed gulls (Larus ridibundus) in the Clyde Estuary is large. In summer the average density has reached 1350 gulls km^?2 and in winter 180 gulls km^?2. This paper compares prey selection and feeding efficiency in gulls during summer and winter on tidal flats, and considers how seasonal differences may be adaptations to cope with seasonal changes in prey availability.Gross and net rates of energy intake were highest in summer because gulls captured more of the polychaete N. diversicolor than the amphipod C. volutator. In winter, gulls selected for C. volutator and therefore an energetically less profitable diet. Throughout the year gulls selected more C. volutator relative to N. diversicolor than expected on energetic grounds and so apparently did not maximize potential net rate of energy intake.Gulls used three techniques to capture prey and made most intensive use of the ‘crouch’ technique. Crouching gulls attained a much higher net rate of energy intake than ‘upright’ or ‘paddling’ gulls.A log-linear model showed that (a) season, water depth and gull density determined feeding technique and (b) feeding technique and season independently determined foraging success and prey selection. Thus gull density and water depth acted on prey selection through imposed variations in feeding technique.Reasons for gulls selecting energetically unprofitable C. volutator and for the use of several distinct feeding techniques are discussed.     

Robertson-Walker type model with conformally invariant scalar field with trace-free energy momentum tensor

A non-static exact solution of the Einstein equations corresponding to a conformally invariant scalar field with trace-free energy momentum tensor is obtained for the Robertson-Walker type metric. Some physical properties of the solution are discussed.