Geomorphology of Lake Lisan terraces along the eastern coast of the Dead Sea, Jordan

Lake Lisan, the lake that filled the Jordan graben during the Last Glacial, left behind a well developed sequence of erosional and depositional shore terraces in the south east of the current Dead Sea. These terraces record a series of stillstands that were caused by small transgressions within an overall trend of falling lake levels. The terraces were observed in places where they had not been identified previously. The morphology of the terraces was investigated in six cross-sections using differential GPS altimetry. The levels of the terraces range between − 370 and − 148 m a.s.l. The high stand of Lake Lisan at − 148 m correlates well with the high level of − 150 m reported by Bowman and Gross [Bowman, D., Gross, T., 1992. The highest stand of Lake Lisan: ~ 150 meters below MSL. Israel Journal of Earth-Science 41, 233–237.] along the western coast of Lake Lisan. The lake terraces are horizontal, elongated and tectonically undisturbed, and have a sub-horizontal foreshore (tread) with an average slope of 8.2° and steep backshore cliff (riser) with an average slope of 17.7°. The six cross-sections show a good altitudinal correlation between their terraces. Moreover, the terraces appear in undisturbed continuity on the aerial photos. These morphological characteristics demonstrate that the retreat of the lake was a result of substantial climatic changes, not of tectonic subsidence.In-situ stromatolites were found on most of the terraces, reflecting a shallow water environment and emphasizing that these terraces are recessional. Well-developed desert varnish and Tafoni observed on blocks sitting on the terrace surfaces imply a long period of exposure and a low rate of post lacustrine erosion. The formation of Lisan terraces is constrained mainly by coastal slope, water depth and underlying lithology. The morphological analysis of these terraces allows identification of two kinds of pseudo-terraces, which were formed as a result of tread or riser destruction.U/Th and OSL dating allowed the dating of three events within the lake level curve more precisely. The high level of − 148 m occurred at 30.5 ± 0.22 ka BP, consistent with the Heinrich Event 3 and Dansgaard–Oeschger stadial 5, the coldest period in the NGRIP Greenland Ice Core record. The next lower terrace at − 154 m was formed at 22.9 ka BP ± 0.29 and corresponds to the stadial 2C, the final phase of the Last High Glacial. The correlation between the Lisan high stands and climatic stadials suggests that Northern-Hemispheric cold periods led to periods with a more positive water balance in the Near East. At ~ 10 ± 0.8 ka BP Lake Lisan experienced a sharp drop to − 200 m followed by a transgression between 9.5 to 7 ka BP.     

Mineralogical and chemical composition and cosmic‐ray exposure history of two mesosiderites and two iron meteorites

Abstract— We performed a comprehensive study of the noble gas isotopic abundances, radionuclide activities, and mineralogical and chemical composition of two mesosiderites and two iron meteorites. For the mesosiderites Dong Ujimqin Qi and Weiyuan, the silicate and the metal phases were studied. The anomalous ataxite Rafrüti is not chemically related to any other meteorite class, whereas Ningbo is a type IVA octahedrite. The mineralogy and major and trace element abundances of the silicate phases of Dong Ujimqin Qi and Weiyuan are similar to those of other mesosiderites and distinct from those of the howardites. The cosmic‐ray exposure history was studied based on the concentrations of the cosmogenic noble gas nuclei and radionuclide activities. For the iron meteorites, cosmic‐ray exposure ages were calculated from the pairs ¹⁰Be‐²¹Ne, ²⁶Al‐²¹Ne, and ³⁶Cl‐³⁶Ar. Rafrüti yields the youngest exposure age of all ataxites (6.8 ± 1.7 Ma), whereas that of Ningbo with 107 ± 15 Ma falls within the range observed for the other octahedrites. The parent body break‐up times of the mesosiderites Dong Ujimqin Qi and Weiyuan are 252 ± 50 and 25.9 ± 5.0 Ma, respectively. We find no evidence for a common break‐up event for the mesosiderites and the howardites.     

The role of biogeochemical cycling for the formation and preservation of varved sediments in Soppensee (Switzerland)

We analyzed seasonally aggregated observations of temperature, conductivity, dissolved oxygen and dissolved inorganic carbon from Soppensee (District of Lucerne, Switzerland) for the yrs 1980 to 1993. Holomictic Soppensee is characterized by a strong summer stratification with a thin epilimnion separated from an anoxic hypolimnion by a strong pycnocline formed by thermal and chemical gradients. A vertical one-dimensional model was developed to simulate the observed seasonal cycles of carbon and oxygen. The processes of net community production, mineralization of organic matter, precipitation and dissolution of calcite, gas exchange, in- and outflow, sedimentation and vertical eddy diffusion are included. According to the model, the annual net community production is estimated to about 110 g C m^-2 yr^-1 and the annual net primary production to about 330 to 440 g C m^-2 yr^-1, which is a typical value for eutrophic lakes. A mass balance of the carbon cycle indicates that most of the inflow comes from groundwater which is super-saturated with respect to atmospheric CO₂. Therefore the surface waters exhibit a large capacity for calcite precipitation. The results of the model are used to constrain the conditions that favor the formation of varved sediments in Soppensee during thousands of yrs. Model calculations show that the deep waters would still turn anoxic even if the sedimentation rate of organic matter were decreased to 25%. Several physical factors such as biogenic stabilization of the deep waters due to calcite dissolution and low input of wind energy are responsible for the long term anoxia in Soppensee.     

A unique aspect of ballast water management requirements - The same location concept

Under certain circumstances vessels do not need to meet ballast water management requirements as stated in the International Convention for the Management and Control of Ballast Water and Sediments (BWM Convention). Besides exceptions to ensure e.g., (a) the safety of a ship, (b) discharge of ballast water for the purpose of avoiding or minimizing pollution incidents, (c) uptake and discharge on high seas of the same ballast water, the same location concept comes into play as ballast water discharges from a ship at the same location where it was taken up is also excepted from BWM requirements. The term same location was not defined in this instrument, hence it is exposed to different interpretations (e.g., a terminal, a port, a larger area where two or more ports may be located). As the BWM Convention is an instrument with biological meaning, the authors recommend a biologically meaningful definition of the same location in this contribution.     

Analysis of Wellbore Skin Samples—Typology,Composition, and Hydraulic Properties

The presence of a wellbore skin layer, formed during the drilling process, is a major impediment for the energy‐efficient use of water wells. Many models exist that predict its potential impacts on well hydraulics, but so far its relevant hydraulic parameters were only estimates or, at best, model results. Here, we present data on the typology, thickness, composition, and hydraulic properties obtained from the sampling of excavated dewatering wells in lignite surface mines and from inclined core drilling into the annulus of an abandoned water well. Despite the limited number of samples, several types of skin were identified. Both surface cake filtration and particle straining in the aquifer occur. The presence of microcracks may be a determining feature for the hydraulic conductivity of skin layers. In the case of the well‐developed water supply well, no skin layer was detected. The observed types and properties of wellbore skin samples can be used to test the many mathematical skin models.     

Exsolution and coarsening in iron-free clinopyroxene during isothermal annealing

Exsolution and coarsening in Fe-free clinopyroxene of composition En_45.1Di_54.9 was studied at temperatures of 1300, 1200, and 1100°C, and annealing times between 10 min and 4320 h. Based on the wavelength of the exsolution lamellae, the exsolution process can be divided into exsolution sensu stricto and coarsening. During exsolution sensu stricto, the average wavelength of the “001” and “100” lamellae remains constant in contrast to the subsequent coarsening process. A progressive development of the microstructure is observed before coarsening which includes formation of island-like regions of dark contrast without phase separation, occurrence of pigeonite and diopside domains predominantly elongated along (100), formation of “100” exsolution lamellae, dissolution of the “100” lamellae, and predominant occurrence of “001” exsolution lamellae. All observations are in accordance with the exsolution mechanism of spinodal decomposition. After termination of the exsolution process, coarsening of the exsolution lamellae is observed. The “001” lamellae coarsen according to the rate law

     

Tropical Deforestation and the Kyoto Protocol

The current annual rates of tropical deforestation from Brazil and Indonesia alone would equal four-fifths of the emissions reductions gained by implementing the Kyoto Protocol in its first commitment period, jeopardizing the goal of Protocol to avoid “dangerous anthropogenic interference” with the climate system. We propose the novel concept of “compensated reduction”, whereby countries that elect to reduce national level deforestation to below a previously determined historical level would receive post facto compensation, and commit to stabilize or further reduce deforestation in the future. Such a program could create large-scale incentives to reduce tropical deforestation, as well as for broader developing country participation in the Kyoto Protocol, and leverage support for the continuity of the Protocol beyond the 2008–2012 first commitment period.