Oil-weathering behavior in Arctic environments

Oil-weathering processes in ice-free subarctic and Arctic waters include spreading, evaporation, dissolution, dispersion of whole-oil droplets into the water column, photochemical oxidation, water-in-oil emulsification, microbial degradation, adsorption onto suspended particulate material, ingestion by organisms, sinking, and sedimentation. While many of these processes also are important factors in ice-covered waters, the various forms of sea ice (depending on the active state of ice growth, extent of coverage and/or decay) impart drastic, if not controlling, changes to the rates and relative importance of different oil-weathering mechanisms. Flow-through seawater wave-tank experiments in a cold room at −35°C and studies in the Chukchi Sea in late winter provide data on oil fate and effects for a variety of potential oil spill scenarios in the Arctic. Time-series chemical weathering data are presented for Prudhoe Bay crude oil released under and encapsulated in growing first-year columnar ice through spring breakup.     

Nutrient (P, N) dynamics in the southwestern Kattegat, Scandinavia: sedimentation and resuspension effects

 The yearly nutrient supply from land and atmosphere to the study area in SW Kattegat is 10 900 tons of N and 365 tons of P. This is only few percent of the supply from adjacent marine areas, as the yearly transport through the study area is 218 000 tons of N and 18 250 tons of P. Yearly net deposition makes up 1340 tons of N (on average 2.5 g m^–2 yr^–1) and 477 ton of P (on average 0.9 g m^–2 yr^–1). Shallow-water parts of the study area have no net deposition because of frequent (>35% of the year) resuspension. Resuspension frequency in deep water is <1% of the year. Resuspension rates, as averages for the study area, are 10–17 times higher than net deposition rates. Because of resuspension, shallow-water sediments are coarse lag deposits with small amounts of organic matter (1.1%) and nutrients (0.04% N and 0.02% P). Deep-water sediments, in contrast, are fine grained with high levels of organic matter (11.7%) and nutrients (0.43% N and 0.15% P). Laboratory studies showed that resuspension changes the diffusive sediment water fluxes of nutrients, oxygen consumption, and penetration into the sediment. Fluxes of dissolved reactive phosphate from sediment to water after resuspension were negative in organic-rich sediments (13.2% organic matter) with low porosity (56) and close to zero in coarse sediments with a low organic matter content (2.3%) and high porosity (73). Fluxes of inorganic N after resuspension were reduced to 70% and 0–20% in relation to the rates before resuspension, respectively. Received: 10 July 1995 · Accepted: 19 January 1996     

A simulation tool for high data-rate acoustic communication in ashallow-water, time-varying channel

The paper discusses the development of a simulation tool to model high data-rate acoustic communication in shallow water. The simulation tool is able to generate synthetic time series of signals received at a transducer array after transmission across a shallow-water communication channel. The simulation tool is suitable for testing advanced signal processing techniques for message recovery. A channel model has been developed based on the physical aspects of the acoustic channel. Special emphasis has been given to fluctuations of the signal transmission caused by time-varying multipath effects. At shorter ranges, the temporal variations are dominated by acoustic scattering from the moving sea surface. Therefore, the channel model produces a coherence function which may be interpreted as a time-varying reflection coefficient for the surface scattered acoustical path. A static, range-independent ray model identifies the significant multipaths, and the surface path is modulated with the time-varying reflection coefficient. The advantages and limitations of the channel model are discussed and assumptions necessary to overcome the limitations are emphasised. Based on the assumptions, an algorithm has been developed and implemented to model how a binary message will be modulated when transmitted by a transducer, is distorted in the channel and finally is received by a transducer array     

OSCR wave measurements-some preliminary results

OSCR is an HF radar system that has been developed for high spatial resolution coastal surface current measurement. This paper describes preliminary results that demonstrate that wave measurement can be successfully obtained from suitably processed OSCR data. Comparisons with data from a WAVEC directional buoy are presented and show encouraging agreement. Some of the limitations to the measurement process are discussed and indicate a maximum range of about 20 km. Surface current variability on short time scales presents the most serious obstacle to wave measurement. This appears to be more of a problem when the mean currents are large, in that in these circumstances the data fail initial quality control criteria. However, in lower mean currents, the effect is often still present and leads to errors in long wave measurement     

Infiltration at the Tai rain forest (Ivory Coast): Measurements and modelling

Infiltration experiments have been performed at three sites along a well-known catena under virgin tropical rain forest using a portable sprinkling infiltrometer. Experimentally determined infiltration curves are presented. Infiltration curves are also simulated on the basis of the Mein-Larson equation. The parameters for this model have been obtained from the infiltration curves (saturated conductivity) and simple soil moisture determinations (fillable porosity). The agreement between experimentally determined and modelled infiltration is reasonable, provided (a) saturated conductivity as derived from the experimental data is corrected, (b) a storage parameter, also derived from the experimental data, is added to the Mein-Larson model, and (c) the decline in soil porosity with depth is either small or occurs abruptly at shallow depth. Comparison of observed infiltration rates with rainfall intensity shows that Horton Overland Flow has to occur naturally at least on the middle and lower section of the catena. Despite the fact that most parameters can be estimated in principle from basic soil data, it remains advisable to obtain sprinkling infiltrometer field measurements, because of soil variability due to dynamic surface conditions, macroporosity, air entrapment, and irregularity of the wetting front.     

Swimming with…Devonian fish

Armoured jawless fish, or 'ostracoderms', lived 450–360 million years ago, and display unusual morphologies, unlike any modern fish group. Since they left no living descendants, their mode of swimming has, until recently, remained speculative, although this is a crucial question as the first true pectoral fins evolved within the 'ostracoderms'. The discovery of the oldest-known fish trails, from the Early Devonian (400 million year old) 'Lower Old Red Sandstone' of south-east Wales offers new insights into the swimming behaviour of these early fish, notably the osteostracan 'ostracoderms' (or cephalaspids), whose horseshoe-shaped head and paddle-shaped pectoral fins have remained a functional riddle.     

SANICLAY: simple anisotropic clay plasticity model

SANICLAY is a new simple anisotropic clay plasticity model that builds on a modification of an earlier model with an associated flow rule, in order to include simulations of softening response under undrained compression following K_o consolidation. Non‐associativity is introduced by adopting a yield surface different than the plastic potential surface. Besides, the isotropic hardening of the yield surface both surfaces evolve according to a combined distortional and rotational hardening rule, simulating the evolving anisotropy. Although built on the general premises of critical state soil mechanics, the model induces a critical state line in the void ratio–mean effective stress space, which is a function of anisotropy. To ease interpretation, the model formulation is presented firstly in the triaxial stress space and subsequently, its multiaxial generalization is developed systematically, in a form appropriate for implementation in numerical codes. The SANICLAY is shown to provide successful simulation of both undrained and drained rate‐independent behaviour of normally consolidated sensitive clays, and to a satisfactory degree of accuracy of overconsolidated clays. The new model requires merely three constants more than those of the modified Cam clay model, all of which are easily calibrated from well‐established laboratory tests following a meticulously presented procedure. Copyright © 2006 John Wiley & Sons, Ltd.