McCreary和Fickian湍扩散形式差异的分析

用矩阵方法,求解McCreary和Fickian铅垂向湍扩散形式下,无界海洋条件时在风应力和深层浮力作用下的线性解。得出不同的湍扩散系数A情况下McCreary与Fickian湍扩散形式的流场结构。指出随湍扩散系数的增加,McCreary和Fickian湍扩散形式下u分量结构及其量值差异增大。在Fickian湍扩散形式下,能量穿越密度跃层的传递能力较强。当A=0.1cm~2s~(-3)时,在风应力和深层浮力作用下两种湍扩散形式造成流场的差异很小。提出在小湍扩散系数下,用McCreary湍扩散形式研究热带海洋环流,其结果和Fickian形式应相当一致。     

中国对虾镰刀菌病的细胞病理研究

本文报导中国对虾养成期病原体茄类镰刀菌Fusarium solani(Mart)的细微结构及其引起宿主的细胞病理变化,以便为该病的正确诊断和有效防治提供依据。     

西沙群岛龙介虫科两新种

龙介虫科Serpulidae的盘管虫Hydroides栖于石灰质管内,又名石灰虫,营附着生活，是有害附着生物之一。它们大量附着在船底,影响航行速度;附着在软体动物的重要养殖种类(珍珠贝、鲍、牡蛎等)的贝売上面,影响贝类生长,危害贝类养殖事业。因此,进行龙介虫科分类,生态的研究,可为有害生物的防除工作提供基本资料。 1956年和1975年,中国科学院海洋研究所在我国西沙群岛考察时,在永兴岛和珊瑚岛采到龙介虫科,盘管虫属两个新种,描述如下：     

Optimum design of filament-wound multilayer-sandwich submersible pressure hulls

Submersible pressure hulls with fiber-reinforced multilayer-sandwich constructions have been developed in recent years as substitutes for classical metallic ring-stiffened pressure hulls. This study aims to optimize the design of filament-wound multilayer-sandwich submersible pressure hulls, taking into consideration the shell buckling strength constraint, the angle-ply laminated facing failure strength constraint and the low-density isotropic core yielding strength constraint under hydrostatic pressure using the hybrid genetic algorithm (HGA). The thickness of the facing, the thickness of the core layer, the orientation angle of the fibers in the facings and the shear modulus of the core material are taken as design variables. A sensitivity analysis is performed to study the effects of the operational depths and the hull shell geometry parameter, the length-to-diameter ratio (L/D), on the optimal design of filament-wound multilayer-sandwich submersible pressure hulls with graphite/epoxy, glass/epoxy and boron/epoxy composite facings. The results reveal that the optimal weight of various sandwich pressure hulls increases linearly with the operational depth, but it is almost unchanged as the geometry paramter. Furthermore, Graphite/Epoxy is the best choice for the material of the facings in a light-weight design. With reference to wall design, Boron/Epoxy is the best choice for the material of the facing at shallow depths, but Graphite/Epoxy is the best choice at extreme depths. Results of this study provide a valuable reference for designers of underwater vehicles.     

中国南极长城湾及附近海区1993/1994年夏季表层水样无机氮、磷酸盐的浓度及其分布状况

1993／1994年南极夏季对中国南极长城湾及附近海区表层海水四种营养盐浓度及其分布状况作了调查。结果表明，NH4－N、NO3－N、NO2－N及PO4－P的大致浓度分别是2．13、7．07、0．74和1．12μg·dm-3。一般来说，湾内高于湾外氮盐于12月份常出现高值。四种形态的无机盐类之最高、最低浓度出现的时间和站位不尽一致。∑N／P递减次序大致是12月，2月，1月。水温变化与NH4－N、PO4－P浓度和∑N／P的变化常较一致，而与NO2－N则常不一，一些站位上营养盐浓度偏低可能与浮游植物摄取有关。结果显示了调研海区的浅水内湾特征。浮游植物所需营养充分。该湾仍维持正常状态。     

Regression Formulations for the Stress at Hot Spot of Multiplanar Tubular DT Joints

- Stress concentration analysis of multiplanar tubular DT joints plays an important role in the fatigue design of offshore platforms. A semi-analytic method for stress analysis under the condition of any loads is briefly introduced in the paper. Nineteen multiplanar tubular DT joints with one of two braces of the same dimension subjected to axial loads and out- of- plane bending moments are computed for parametric stress analysis by using the present method. The influence of geometrical parameters on the stresses of multiplanar tubular DT joints is discussed and compared with corresponding uniplanar T joints. The regression formulae for the stress at hot spot of multiplanar DT joints are found by modification of SCF of corresponding uniplanar T joints. The parametric formulae for the maximum stress by superposition. Finally, the influences of stiffening effect and load-interaction effect on the maximum stress of DT joints are discussed.     

Distribution of chlorophyll a and diatom in the sea ice of the Weddell Sea, Antarctica

Diatoms are major primary producers of microbial biomass in the Antarctica. They are found in the water and sea ice. The distribution, abundance of the ice diatoms and their relation to the environmental factors inside and outside the ice have been studied for its special role in the Antarctic Ocean ecology. In this paper we describe the abundance, distribution and composition of diatom assemblages in     

对虾暴发性流行病及其预防研究

１９９３～１９９４年我国沿海养殖对虾发生了特大的暴发性流行病，损失惨重。本文报道该病的特点、症状及危害，并在患病的中国对虾、日本对虾、长毛对虾的中肠、肝胰腺的上皮细胞核和细胞质及腹肌纤维间质中发现大量具有囊膜的杆状病毒。通过病毒引起宿主靶组织细胞的病理变化、无包涵体等特性分析，认为该病毒属于有囊膜杆状病毒科Ｃ亚群，不同于已知的对虾所有杆状病毒，为对虾的一类新致病病毒。文中还分析了主要致病原因，通过调查和试验提出８条有针对性的预防措施。     

华贵栉孔扇贝三倍体的研究

本文报道了用细胞松驰素B、高温和低温休克等方法诱导华贵栉孔扇贝（Chlamys nobilis）三倍体的实验结果。在26.0～28.0℃条件下，选用不同浓度的细胞松驰素B0.1、0.3、0.5、0.7和1.0mg/dm^3，在受精后15min，处理受精卵15min，三倍体诱导率分别为12.5%、37.5%、68.0%、66.6%和81.0%，其中0.5～1.0mg/dm^3浓度的细胞松驰素B对改变倍性最有效。高温休克选用31.0、33.0、35.0和37.0℃处理受精卵，最高三倍体诱导率达46.7%（33.0℃,处理15min）。低温休克选用6.0、8.0、10.0和12.0℃处理受精卵，最高三倍体诱导率为40.7%（10.0℃，处理20min）。实验结果表明，随着处理强度的增大和处理时间的延长，三倍体诱导率增高、但孵化率下降，畸型率上升。用高温休克处理的实验组幼虫生长速度较对照组快。作者认为，在商业性生产中，温度休克是诱导扇贝三倍体的一种简便、有效的方法。文中还就细胞松驰素B与温度休克诱导三倍体的机制进行了讨论。     

海面对风应力的非定常响应

针对常垂直湍流系数和变垂直湍流系数两种情况，给出了开阔静止海面对风应力的非定常响应的解析表达式，并讨论了水深，风应力强弱对响应过程的影响，尽管没有考虑风场的非定常性，但本文的结果对理解海洋对风应力的非定常响应过程具有一定的帮助，对分析海面停风后的消衰过程也具有实际意义。通过与实测资料比较，认为垂直湍流系数模式要比常垂直湍流系数模式更为合理。