Remote estimation of surficial seafloor properties through the application Angular Range Analysis to multibeam sonar data

The variation of the backscatter strength with the angle of incidence is an intrinsic property of the seafloor, which can be used in methods for acoustic seafloor characterization. Although multibeam sonars acquire backscatter over a wide range of incidence angles, the angular information is normally neglected during standard backscatter processing and mosaicking. An approach called Angular Range Analysis has been developed to preserve the backscatter angular information, and use it for remote estimation of seafloor properties. Angular Range Analysis starts with the beam-by-beam time-series of acoustic backscatter provided by the multibeam sonar and then corrects the backscatter for seafloor slope, beam pattern, time varying and angle varying gains, and area of insonification. Subsequently a series of parameters are calculated from the stacking of consecutive time series over a spatial scale that approximates half of the swath width. Based on these calculated parameters and the inversion of an acoustic backscatter model, we estimate the acoustic impedance and the roughness of the insonified area on the seafloor. In the process of this inversion, the behavior of the model parameters is constrained by established inter-property relationships. The approach has been tested using a 300 kHz Simrad EM3000 multibeam sonar in Little Bay, NH. Impedance estimates are compared to in situ measurements of sound speed. The comparison shows a very good correlation, indicating the potential of this approach for robust seafloor characterization.     

4D seismic time-lapse monitoring of an active cold vent,northern Cascadia margin

Two single-channel seismic (SCS) data sets collected in 2000 and 2005 were used for a four-dimensional (4D) time-lapse analysis of an active cold vent (Bullseye Vent). The data set acquired in 2000 serves as a reference in the applied processing sequence. The 4D processing sequence utilizes time- and phase-matching, gain adjustments and shaping filters to transform the 2005 data set so that it is most comparable to the conditions under which the 2000 data were acquired. The cold vent is characterized by seismic blanking, which is a result of the presence of gas hydrate in the subsurface either within coarser-grained turbidite sands or in fractures, as well as free gas trapped in these fracture systems. The area of blanking was defined using the seismic attributes instantaneous amplitude and similarity. Several areas were identified where blanking was reduced in 2005 relative to 2000. But most of the centre of Bullseye Vent and the area around it were seen to be characterized by intensified blanking in 2005. Tracing these areas of intensified blanking through the three-dimensional (3D) seismic volume defined several apparent new flow pathways that were not seen in the 2000 data, which are interpreted as newly generated fractures/faults for upward fluid migration. Intensified blanking is interpreted as a result of new formation of gas hydrate in the subsurface along new fracture pathways. Areas with reduced blanking may be zones where formerly plugged fractures that had trapped some free gas may have been opened and free gas was liberated.     

Wave runup on a concentric twin perforated circular cylinder

The regular wave interaction with a twin concentric porous circular cylinder system consisting of an inner impermeable cylinder and an outer perforated cylinder was studied through physical model and numerical model studies. The experiments were carried out on the twin concentric cylinder model in a wave flume to study the wave runup and rundown at the leading and trailing edges of the perforated cylinder. It was found that the maximum wave runup on the perforated cylinder is almost same as the incident wave height. The experimental results were used to develop the predictive formulae for the wave runup and rundown on the perforated cylinder, which can be easily used for design applications. The wave runup profiles around the perforated cylinder for different values of ka and porosities were studied numerically using Green's Identity Method. The results of the numerical study are presented and compared with the experimental measurements.     

Phytoplankton biomass and size fractions in surface waters of the Australian sector of the southern ocean

We collected surface water along the 142nd E meridian from Tasmania to Antarctica in December 1999. We measured temperature, salinity and total chlorophyll a; additionally, we collected suspended particle size fractions and used fluorometric analysis to determine the quantity of chlorophyll a in each of four cell size classes: picoplankton (<3 μm), two nanoplankton fractions (3–10 μm and 10–20 μm) and microplankton (> 20 μm). Changes in temperature and salinity show that we crossed 6 water masses separated by 5 fronts. We found low abundance (<0.2 mg m⁻³) of chlorophyll in all size classes, with the exception of higher values near the continent (0.2 to 0.4 mg m⁻³). Lowest chlorophyll values (<0.1 mg m⁻³) were found in the Polar Frontal Zone (51° to 54°S). Microplankton made up the largest portion of total chlorophyll throughout most of the region. We conclude that biomass of all phytoplankton fractions, especially pico-and nanoplankton, was constrained by limiting factors, most probably iron, throughout the region and that ecosystem dynamics within a zone are not circumpolar but are regionalized within sectors.     

Chemical processes and interactions involving marine organic matter

The concepts which have guided our thinking about chemical processes and interactions of organic matter in seawater are identified and their utility assessed. Some recommendations for the future are made.     

Estimation of the oxygen and CO2 mean exchange between the ocean and the atmosphere in key areas of the ocean

Current estimations of gas exchange between the ocean and the atmosphere are based on the concepts about diffusive gas transfer across the interface and about a stationary character of the processes; however, under a strong wind, these concepts are invalid. Transfer equations for gas constitutents of the air are incorporated into a numerical model of a nonstationary upper layer of the ocean. These equations contain the source function—gas transfer by bubbles, which becomes noticeable even at a wind speed of 8–10 m/s. The fluxes of oxygen and CO₂ are calculated at a specified wind speed, dependences of these fluxes on the wind speed are constructed, and estimates for the average annual fluxes are obtained for several areas of the Gulf Stream and Kuroshio. A substantial change in the difference of the air-water gas contents under a strong wind, caused by the turbulent exchange growth and appreciably affecting the gas exchange, is noted. The influence of the carbonate system of seawater on the CO₂ transfer during a storm is estimated. The results obtained are compared to the estimates based on the traditional approach.     

Effects of an Artificial Breakwater on the Distributions of Planktonic Microbial Communities

The summer distributions of planktonic microbial communities (heterotrophic and phtosynthetic bacteria, phtosynthetic and heterotrophic nanoflagellates, ciliate plankton, and microphytoplankton) were compared between inner and outer areas of Lake Sihwa, divided by an artificial breakwater, located on the western coast of Korea, in September 2003. The semienclosed, inner area was characterized by hyposaline surface water (<17 psu), and by low concentrations of dissolved oxygen (avg. 0.4 mg L¹) and high concentrations of inorganic nutrients (nitrogenous nutrients >36 μM, phosphate <4 μM) in the bottom layer. Higher densities of heterotrophic bacteria and nanoflagellates also occurred in the inner area than did in the outer area, while microphytoplankton (mainly diatoms) occurred abundantly in the outer area. A tiny tintinnid ciliate, Tintinnopsis nana, bloomed into more than 10⁶ cells L¹ at the surface layer of the inner area, while its abundance was much lower (10³-10⁴ cells L¹) in the outer area of the breakwater. Ciliate abundance was highly correlated with heterotrophic bacteria (r = 0.886, p < 0.001) and heterotrophic flagellates (r = 0.962, p < 0.001), indicating that rich food availability may have led to theT. nana bloom. These results suggest that the breakwater causes the eutrophic environment in artificial lakes with limited flushing of enriched water and develops into abundant bacteria, nanoflagellates, and ciliates.     

A low level supplementary heating system for free divers

A simple and effective method of heating divers in extreme cold water has been developed. The local heating concept utilizes a uniformly distributed granular mixture of magnesium and iron particles packed in small sachets. Upon activation by sea water, the two metal mixture behaves as a multitude of short-circuited electrolytic cells, producing thermal energy rather than electrical energy. The 45 mm-square sachets may be placed where heating is required on the diver's body, thus giving rise to the term “local heating”, obviously, the heating system requires no pumping device, or distribution network. Heating rate and duration of output of the sachets are controlled by particle size, and mixture ratio of the constituent Mg and Fe particles.This paper described the development, testing and performance of the heating sachets. Results of live tests in different dive situations are also presented and discussed.