The Effect of Sunspot Weighting

Although W. Brunner began to weight sunspot counts (from 1926), using a method whereby larger spots were counted more than once, he compensated for the weighting by not counting enough smaller spots in order to maintain the same reduction factor (0.6) as was used by his predecessor A. Wolfer to reduce the count to R. Wolf’s original scale, so that the weighting did not have any effect on the scale of the sunspot number. In 1947, M. Waldmeier formalized the weighting (on a scale from 1 to 5) of the sunspot count made at Zurich and its auxiliary station Locarno. This explicit counting method, when followed, inflates the relative sunspot number over that which corresponds to the scale set by Wolfer (and matched by Brunner). Recounting some 60,000 sunspots on drawings from the reference station Locarno shows that the number of sunspots reported was “over counted” by \({\approx}\,44~\%\) on average, leading to an inflation (measured by an effective weight factor) in excess of 1.2 for high solar activity. In a double-blind parallel counting by the Locarno observer M. Cagnotti, we determined that Svalgaard’s count closely matches that of Cagnotti, allowing us to determine from direct observation the daily weight factor for spots since 2003 (and sporadically before). The effective total inflation turns out to have two sources: a major one (15?–?18 %) caused by weighting of spots, and a minor source (4?–?5 %) caused by the introduction of the Zürich classification of sunspot groups which increases the group count by 7?–?8 % and the relative sunspot number by about half that. We find that a simple empirical equation (depending on the activity level) fits the observed factors well, and use that fit to estimate the weighting inflation factor for each month back to the introduction of effective inflation in 1947 and thus to be able to correct for the over-counts and to reduce sunspot counting to the Wolfer method in use from 1894 onwards.     

Effects of parasitism and environment on shell size of the South American intertidal mud snail Heleobia australis (Gastropoda)

The aim of this work was to evaluate the effects of parasitism and certain environmental factors on the shell size of Heleobia australis (Hydrobiidae, Cochliopinae). We report sporocysts and metacercariae of Microphallus simillimus (Microphallidae, Trematoda) parasitizing the gonad and digestive gland of H. australis specimens from two sites of Bahía Blanca estuary, Argentina. The prevalence of infection was significantly higher (34.17% in winter and 68.14% in late spring) in snails from the outer estuary at Site 2 than in those from the inner estuary at Site 1 (5.88% and 4.71% respectively). The only known definitive host for this digenean is the white-backed stilt Himantopus melanurus (Recurvirostridae, Aves), most abundant in the estuary during winter. Parasitism by M. simillimus causes variations in the shell dimensions of H. australis, the shells of infected snails being narrower than those of uninfected snails. Snails from Site 2 were found in general to be significantly smaller than those at Site 1, possibly as a result of differences in environmental factors such as the degree of exposure to wave energy, the allocation of energy to reproduction rather than growth (induced by predation and/or parasitic castrators) and anthropogenic stressors.     

Impoverishment of recent floodplain forest mollusc fauna in the lower Ohře River (Czech Republic) as a result of prehistoric human impact

Analyses of fossil mollusc successions have rarely been used to study the development of floodplain forests during the Holocene. The Oh?e River, located in a prehistorically settled chernozem area in the Czech Republic, is partly situated in Cretaceous marlstones, yielding sediments suitable for fossilization directly in floodplain deposits. We analysed five fossil mollusc successions situated in the lower stretch of the Oh?e River and compared the results with recent mollusc assemblages studied along the entire 256 km of the river. Fossil samples were composed mostly of open‐country species throughout the Holocene or the whole preserved succession. Only some samples also contained woodland assemblages, but these were always greatly impoverished, with a very low frequency of strictly woodland species. Although the natural‐looking appearance of the present‐day floodplain forests of the lower river stretch has resulted in its being declared a nature reserve, modern floodplain forest mollusc assemblages there are also impoverished. This reduction in the distribution of strictly woodland species compared with modern assemblages in the upper stretch of the river seems to be the result of an ancient human settlement and continuous disturbances of the floodplain forest development since the Neolithic. Thus, fully developed floodplain forest assemblages occur recently only in the upper non‐impacted stretch of the river. Based on the studied fossil successions we can conclude that the lower Oh?e River floodplain was probably a mosaic of open and disturbed forest habitats throughout the Holocene. This area is part of a central European landscape island, where forests probably never fully developed and open patches from the early Holocene continually developed into an agricultural landscape.     

Constitutive approach for rate‐sensitive anisotropic structured clays

This paper describes a constitutive approach to model the behavior of rate‐dependent anisotropic structured clay. Rate‐sensitivity is modeled using overstress viscoplasticity. Clay structure is treated as a viscous phenomenon whereby the viscosity of the undisturbed structured clay is initially very high and the viscosity degrades or decreases with plastic straining until the intrinsic or residual viscosity is reached. A microstructure tensor approach is used to make the structured viscosity anisotropic; whereas, the intrinsic viscosity is assumed to be isotropic. The behavior of the constitutive model is compared with the measured response of two clays (Gloucester and St. Vallier clay) from Eastern Canada during triaxial compression tests on specimens trimmed at different orientations to the vertical. The comparisons show that the constitutive framework is able to describe the anisotropic and rate‐sensitive response of both clays. The response of the model is also examined for the more general case of anisotropic consolidated triaxial compression and extension. Copyright © 2010 John Wiley & Sons, Ltd.     

Contact oxidation process followed by activated carbon adsorption for textile wastewater treatment

A pilot plant study and a full scale plant study were conducted to determine the feasibility of using contact oxidation followed by activated carbon adsorption process in textile wastewater treatment, and to determine the effects of types of packing media in the contact oxidation tank and types of aeration process on the treatment performance. Results indicated that contact oxidation followed by activated carbon adsorption process was effective in removing organics and color from textile wastewaters. Types of packing media and types of aeration processes had little effect on the treatment performance. The pilot plant performance was found to perform slightly better than the performance of the full scale plant.     

Low Energy Transfer to the Moon

In 1991, the Japanese Hiten mission used a low energy transfer with a ballistic capture at the Moon which required less Vthan a standard Hohmann transfer. In this paper, we apply the dynamical systems techniques developed in our earlier work to reproduce systematically a Hiten-like mission. We approximate the Sun–Earth–Moon-spacecraft 4-body system as two 3-body systems. Using the invariant manifold structures of the Lagrange points of the 3-body systems, we are able to construct low energy transfer trajectories from the Earth which execute ballistic capture at the Moon. The techniques used in the design and construction of this trajectory may be applied in many situations.     

Morphology of the Itapeva to Tramandai transgressive dunefield barrier system and mid‐ to late Holocene sea level change

The surface morphology of the transgressive dunefield barrier extending from Itapeva to Tramandai along the northern littoral of Rio Grande do Sul, is examined and an attempt is presented to link morphological changes across the barrier to Holocene sea level changes. The 4·5 km wide Holocene barrier displays two typical morphologies: an inner part dominated by large‐scale, continuous alongshore, overlapping dunefield phases comprising sand sheets, dunes, deflation plains and precipitation ridges; and an outer part dominated by discontinuous, medium‐ to small‐scale, triangular to lobate transgressive dunefield phases, cut by both active and relict (palaeo‐) creeks or washouts. Holocene sea level in the region rose to c. +1 to +3 m above present reaching a maximum around 5100 years bp and then progressively fell to the present level. We argue that the effect on barrier development was to suppress the development of a drainage system during the rising and maximum stages, and encourage the development of an organized drainage system in the form of regularly spaced washouts during the falling period, and that this change in sea level from rising to falling therefore produced the large‐scale differences in barrier morphology. Copyright © 2006 John Wiley & Sons, Ltd.     

Considerations on tilt observations at the Vesuvius Observatory

Tilt observations carried out at the Vesuvian Observatory by spirit levels and vertical pendulum till 1961, have allowed to point out motions of the volcanic edifice related to the volcanic activity.