中国东部地区耕地土壤肥力变化趋势研究

随着人口、资源和环境之间的矛盾日趋尖锐,中国耕地土壤肥力及其变化日益为世人所关注。本文利用最近20年东北地区的吉林和黑龙江省,华北地区的北京市和河北省以及长江下游地区的江苏和浙江省的15个县市180个样本点的土壤数据资料,分析了20世纪80年代以来东部地区农业土壤肥力的演变趋势。结果表明,从总体上看,东部地区除土壤速效钾下降和酸碱性有所退化外,农业土壤的有机质、全氮和速效磷平均含量都增加了。在空间分布上,土壤肥力的变化趋势存在明显差异。长江下游和华北地区的平均肥力提高,东北地区下降。另外,除华北地区的土壤酸碱性有改善外,长江下游和东北地区土壤都存在酸化倾向。     

Dublin days: the 2003 NAM

Mark E Bailey and Tom Ray give an overview of the National Astronomy Meeting in Dublin, where record numbers of astronomers went to talk, listen and network.     

Structural, chemical, and isotopic microanalytical investigations of graphite from supernovae

We report the results of coordinated ion microprobe and transmission electron microscope (TEM) studies of presolar graphites from the KE3 separate (1.65-1.72 g/cm³) of the Murchison CM2 meteorite. Isotopic analysis of individual graphites (1-12 μm) with the ion microprobe shows many to have large ¹⁸O excesses combined with large silicon isotopic anomalies, indicative of a supernova (SN) origin. Transmission electron microscopy (TEM) of ultramicrotome slices of these SN graphites revealed a high abundance (25-2400 ppm) of internal titanium carbides (TiCs), with a single graphite in some cases containing hundreds of TiCs. Isotopic compositions of individual TiCs by nanoscale resolution secondary ion mass spectrometry (NanoSIMS) confirmed their presolar origin. In addition to TiCs, composite TiC/Fe grains (TiCs with attached iron-nickel subgrains) and solitary kamacite internal grains were found. In the composite grains, the attached iron phase (kamacite [0-24 at. % Ni] or taenite [up to 60 at. % Ni]) was epitaxially grown onto one or more TiC faces. In contrast to the denser Murchison KFC1 graphites, no Zr-Ti-Mo carbides were observed. The average TiC diameters were quite variable among the SN graphites, from 30 to 232 nm, and were generally independent of the host graphite size. TiC grain morphologies ranged from euhedral to anhedral, with the grain surfaces exhibiting variable degrees of corrosion, and sometimes partially amorphous rims (3 to 15 nm thick). Partially amorphous rims of similar thickness were also observed on some solitary kamacite grains. We speculate that the rims on the internal grains are most plausibly the result of atom bombardment caused by drift of grains with respect to the ambient gas, requiring relative outflow speeds ∼100 km/s (i.e., a few percent of the SN mass outflow speed).Energy dispersive X-ray spectrometry (EDXS) of TiCs revealed significant V in solid solution, with an average V/Ti ratio over all TiCs of ∼83% of the solar value of 0.122. Significant variations about the mean V/Ti ratio were also seen among TiCs in the same graphite, likely indicating chemical equilibration with the surrounding gas over a range of temperatures. In general, the diversity in internal TiC properties suggests that TiCs formed first and had substantially diverse histories before incorporation into the graphite, implying some degree of turbulent mixing in the SN outflows.In most graphites, there is a decrease in the number density of TiCs as a function of increasing radial dis- tance, caused by either preferential depletion of TiCs from the gas or an acceleration of graphite growth with decreasing ambient temperature. In several graphites, TiCs showed a trend of larger V/Ti ratios with increasing distance from the graphite center, an indication of progressive equilibration with the surrounding gas before they were sequestered in the graphites. In all but one graphite, no trend was seen in the TiC size vs. distance from the graphite center, implying that appreciable TiC growth had effectively stopped before the graphites formed, or else that graphite growth was rapid compared to TiC growth. Taken together, the chemical variations among internal grains as well as the presence of partially amorphous rims and epitaxial Fe phases on some TiCs clearly indicate that the phase condensation sequence was TiC, followed by the iron phases (only found in some graphites) and finally graphite. Since graphite typically condenses at a higher temperature than iron at low pressures (<10⁻³ bars) in a gas with C > O and otherwise solar composition, the observed condensation sequence implies a relative iron enrichment in the gas or greater supersaturation of graphite relative to iron.The TEM observations allow inferences to be made about the physical conditions in the gas from which the grains condensed. Given the TiC sizes and abundances, the gas was evidently quite dusty. From the observed TiC size range of ∼20 nm to ∼500 nm (assuming ∼1 yr growth time and T ∼ 1800°K), we infer minimum Ti number densities in the gas to be ∼7 × 10⁴ to ∼2 × 10⁶ atoms/cc, respectively. Although the gas composition is clearly not solar, for scale, these number densities would correspond to a pressure range of ∼0.2 μbar to ∼5.0 μbar in a gas of solar composition. They also correspond to minimum TiC grain number densities of ∼3 × 10⁻⁴ to ∼0.2 grains/cc, assuming complete condensation of Ti in TiC. We estimate the maximum ratio of mean TiC grain separation distance in the gas to grain diameter from the Ti number densities as ∼3 × 10⁵ to ∼1 × 10⁶.     

The mutual climatic range method of palaeoclimate reconstruction based on insect fossils: New applications and interhemispheric comparisons

The Mutual Climatic Range (MCR) method of palaeoclimate reconstruction has been employed in Europe for the last decade. A quantitative, calibrated method, MCR has many advantages over qualitative methods. More recent applications deal with eastern and central North America, and the method is also being developed for desert and arctic faunas. The climate envelopes for North American beetles have been compiled using a 25-km gridded North American climate database that pairs climate parameters with modern collection sites. Modern tests of the reliability of the MCR method for North American species yielded similar results to prior European tests. Linear regressions of predicted on observed values yielded equations used to calibrate the MCR estimates. Work is under way to develop MCR estimates of mean annual precipitation for fossil assemblages from the desert southwest, where moisture conditions may play a more important role in determining beetle species' ranges.An examination of British and North American mean July temperature reconstructions during the Late Wisconsinan glacial interval compares and contrasts three sets of records. The North American records show no indication of the Younger Dryas cooling that is clearly marked in records from northwest Europe. The MCR method adds vigour to our reconstructions, and allows us to compare between regions and with other palaeoenvironmental methods.     

Fluvial process and the establishment of bottomland trees

The effects of river regulation on bottomland tree communities in western North America have generated substantial concern because of the important habitat and aesthetic values of these communities. Consideration of such effects in water management decisions has been hampered by the apparent variability of responses of bottomland tree communities to flow alteration. When the relation between streamflow and tree establishment is placed in a geomorphic context, however, much of that variability is explained, and prediction of changes in the tree community is improved.The relation between streamflow and establishment of bottomland trees is conditioned by the dominant fluvial process or processes acting along a stream. For successful establishment, cottonwoods, poplars, and willows require bare, moist surfaces protected from disturbance. Channel narrowing, channel meandering, and flood deposition promote different spatial and temporal patterns of establishment. During channel narrowing, the site requirements are met on portions of the bed abandoned by the stream, and establishment is associated with a period of low flow lasting one to several years. During channel meandering, the requirements are met on point bars following moderate or higher peak flows. Following flood deposition, the requirements are met on flood deposits ;high above the channel bed. Flood deposition can occur along most streams, but where a channel is constrained by a narrow valley, this process may be the only mechanism that can produce a bare, moist surface high enough to be safe from future disturbance. Because of differences in local bedrock, tributary influence, or geologic history, two nearby reaches of the same stream may be dominated by different fluvial processes and have different spatial and temporal patterns of trees. We illustrate this phenomenon with examples from forests of plains cottonwood (Populus deltoides ssp. monilifera) along meandering and constrained reaches of the Missouri River in Montana.     

An accurate and robust multigrid algorithm for 2D forward resistivity modelling

We present an adaptation of the full multigrid algorithm in DC resistivity modelling in an effort to increase its accuracy. There is a great difficulty with conventional multigrid solvers in representing the physics of an arbitrary distribution of electrical conductivity on a very coarse grid. In general, conventional rectangular finite‐difference or 5‐point approximations of Poisson's equation cannot represent, at a coarse grid level, the effective anisotropy on a coarse scale which results from fine structure in the model. An exception to this generalization occurs when the principal axes of structural anisotropy are aligned with the coordinate axis. Additional and similarly generated problems arise when a coarse cell is obliged to represent fine structure containing very high conductivity contrasts. We have developed an adaptation of the usual resistive‐network representation of the continuum, which avoids some of these problems, and have compared it with the traditional resistive network currently used. The network adaptation consists of replacing the usual 5‐point Laplacian operator stencil used on the finite‐difference grid with a 9‐point stencil, and the conductivity scalar with a 6‐parameter conductivity parametrization. This parametrization permits representation of arbitrarily orientated anisotropy as well as more complex behaviour related to high conductivity contrasts. The importance of multigrid solvers does not lie in their speed at forward modelling (which is comparable with other methods), but rather in their potential for inverse modelling. Inverse solvers which proceed by refinement of an initially very coarse solution can, in principle, take time only linearly proportional to the number of gridpoints in the final desired model.     

Blast Induced Damage and Dynamic Behaviour of Hangingwalls in Bench Stoping

This paper presents the results of a comprehensive monitoring program designed to investigate the extent of blast induced damage experienced by rock masses extracted by bench stoping methods. An array of triaxial geophones and extensometers were used to monitor blast vibration attenuation and measure hangingwall deformations during stope extraction. In addition, pre and post surveys of the hangingwall rock mass were conducted using a TV borehole camera and cavity survey instrumentation. These surveys were later used to calibrate damage profiles into the stope hangingwalls.

Peak particle velocity, hangingwall deformation measurements and stope surveys were used to develop a site specific damage model that allowed engineers to asses drilling and blasting configurations to minimise the extent of pre-conditioning and damage. In addition the study included the analysis of the frequency response, displacements and accelerations experienced by the excavation as extraction and mine filling progressed. This work aimed at improving our understanding of the influence of blasting on the dynamic behaviour of stope hangingwalls.

The study demonstrated that estimates of the maximum extent of rock mass pre-conditioning and/or damage made through the application of the Holmberg-Persson approach compared well with measured results. In addition, the study found that dynamic loading imparted on an exposed hangingwall from subsequent stope blasting was also expected to contribute to rock mass weakening and that mine filling was crucial to arrest further deterioration. Hangingwall accelerations were used to demonstrate that larger openings may be more susceptible to dynamic loading.     

The Elusive AD 1826 Tsunami, South Westland, New Zealand

In AD 1826 sealers reported earthquake and tsunami activity in Fiordland, although, contemporary or near‐contemporary accounts of tsunami inundation at the time are elusive. A detailed analysis of recent sediments from Okarito Lagoon builds on contextual evidence provided by earlier research concerning past tsunami inundation. Sedimentological, geochemical, micropalaeontological and geochronological data are used to determine palaeoenvironments before, during and after what was most probably tsunami inundation in AD 1826. The most compelling chronological control is provided fry a young cohort of trees growing on a raised shoreline bench stranded fry a drop in the lagoon water level following tsunami inundation.     

The International Laser Ranging Service and its support for IGGOS

The International Laser Ranging Service (ILRS) was established in September 1998 as a service within the IAG to support programs in geodetic, geophysical, and lunar research activities and to provide data products to the International Earth Rotation Service (IERS) in support of its prime objectives. Now in operation for 5 years, the ILRS develops: (1) the standards and specifications necessary for product consistency and (2) the priorities and tracking strategies required to maximize network efficiency. The service collects, merges, analyzes, archives and distributes satellite and lunar laser ranging data to satisfy a variety of scientific, engineering, and operational needs and encourages the application of new technologies to enhance the quality, quantity, and cost effectiveness of its data products. The ILRS works with: (1) the global network to improve station performance; (2) new satellite missions in the design and building of retroreflector targets to maximize data quality and quantity and (3) science programs to optimize scientific data yield. The ILRS Central Bureau maintains a comprehensive web site as the primary vehicle for the distribution of information within the ILRS community. The site, which can be accessed at: http://ilrs.gsfc.nasa.gov is also available at mirrored sites at the Communications Research Laboratory (CRL) in Tokyo and the European Data Center (EDC) in Munich.During the last 2 years, the ILRS has addressed very important challenges: (1) data from the field stations are now submitted hourly and made available immediately through the data centers for access by the user community; (2) tracking on low satellites has been significantly improved through the sub-daily issue of predictions, drag functions, and the real-time exchange of time biases; (3) analysis products are now submitted in SINEX format for compatibility with the other space geodesy techniques; (4) the Analysis Working Group is heavily engaged in Pilot Projects as it works toward an ILRS “standard” global solution and (5) SLR has significantly increased its participation in the International Terrestrial Reference Frame (ITRF) activity, which is important to the success of IGGOS.