Site effect on vulnerability of high-rise shear wall buildings under near and far field earthquakes

Worldwide experience repeatedly shows that damages in structures caused by earthquakes are highly dependent on site condition and epicentral distance. In this paper, a 21-storey shear wall-structure built in the 1960s in Hong Kong is selected as an example to investigate these two effects. Under various design earthquake intensities and for various site conditions, the fragility curves or damage probability matrix of such building is quantified in terms of the ductility factor, which is estimated from the ratio of storey yield shear to the inter-storey seismic shear. For high-rise buildings, a higher probability of damage is obtained for a softer site condition, and damage is more severe for far field earthquakes than for near field earthquakes. For earthquake intensity of VIII, the probability of complete collapse (P) increases from 1 to 24% for near field earthquakes and from 1 to 41% for far field earthquakes if the building is moved form a rock site to a site consisting a 80 m thick soft clay. For intensity IX, P increases from 6 to 69% for near field earthquake and from 14 to 79% for far field earthquake if the building is again moved form rock site to soft soil site. Therefore, site effect is very important and not to be neglected. Similar site and epicentral effects should also be expected for other types of high-rise structures.     

TEM study of a special grain boundary in a synthetic K-feldspar bicrystal: Manebach Twin

 A monoclinic KAlSi₃O₈ feldspar Manebach twin boundary was synthesized by diffusion bonding and examined using high-resolution transmission electron microscopy. The sharp (001) twin boundary is straight and free of strain. The boundary width is smaller than d₀₀₁. There is no rigid body shift observed at the twin boundary, and the feldspar structure is arranged symmetrically across (001). The twin boundary structure consists of bridged tetrahedral crankshafts, which are characteristic of the feldspar lattice. The grain boundary structure is in good agreement with the geometrical model of Taylor et al. (1934). The grain boundary composition of K_1/2H_1/2AlSi₃O₈ differs from their model. Received: 13 February 2002 / Accepted: 24 December 2002 Acknowledgements We thank M. Rühle, S. Hutt, J. Mayer, A. Strecker and U. Salzberger at MPI, Stuttgart, for their support and valuable advice in preparing TEM sections of bicrystals.     

Inverse Analysis of Deep Excavation Using Differential Evolution Algorithm

This paper presents the applications of the differential evolution (DE) algorithm in back analysis of soil parameters for deep excavation problems. A computer code, named Python‐based DE, is developed and incorporated into the commercial finite element software ABAQUS, with a parallel computing technique to run an FE analysis for all trail vectors of one generation in DE in multiple cores of a cluster, which dramatically reduces the computational time. A synthetic case and a well‐instrumented real case, that is, the Taipei National Enterprise Center (TNEC) project, are used to demonstrate the capability of the proposed back‐analysis procedure. Results show that multiple soil parameters are well identified by back analysis using a DE optimization algorithm for highly nonlinear problems. For the synthetic excavation case, the back‐analyzed parameters are basically identical to the input parameters that are used to generate synthetic response of wall deflection. For the TNEC case with a total of nine parameters to be back analyzed, the relative errors of wall deflection for the last three stages are 2.2, 1.1, and 1.0%, respectively. Robustness of the back‐estimated parameters is further illustrated by a forward prediction. The wall deflection in the subsequent stages can be satisfactorily predicted using the back‐analyzed soil parameters at early stages. Copyright © 2014 John Wiley & Sons, Ltd.     

The biogeochemical sulfur cycle in the marine boundary layer over the Northeast Pacific Ocean

The major components of the marine boundary layer biogeochemical sulfur cycle were measured simultaneously onshore and off the coast of Washington State, U.S.A. during May 1987. Seawater dimethylsulfide (DMS) concentrations on the continental shelf were strongly influenced by coastal upwelling. Concentration further offshore were typical of summer values (2.2 nmol/L) at this latitude. Although seawater DMS concentrations were high on the biologically productive continental shelf (2–12 nmol/L), this region had no measurable effect on atmospheric DMS concentrations. Atmospheric DMS concentrations (0.1–12 nmol/m³), however, were extremely dependent upon wind speed and boundary layer height. Although there appeared to be an appreciable input of non-sea-salt sulfate to the marine boundary layer from the free troposphere, the local flux of DMS from the ocean to the atmosphere was sufficient to balance the remainder of the sulfur budget.     

Slump debris flows in the Akovolwo Mountains area of Benue State,Nigeria

In September 1979, rain-induced complex landslides occurred in two separate localities along the slopes of the Akovolwo Mountains near Jato-Aka in the Kwande Local Government area of Benue State, Nigeria.The two movements developed on bedrock slopes covered by a veneer of colluvium and (or) residuum no more than 1.5 to 2m deep. Each started as a slump and graduated into a debris flow. The slump, extending downhill a short distance away from the head scarp, had been reconstituted into a debris flow as the initial movement (sliding movement) of the soil mass caused remoulding of the saturated moving mass into viscous debris-laden mud. The resulting mass moved partly along a pre-existing mountain stream channel and partly along a fresh channel it cleared in the savanna forest. At the break of slope, the mass of boulders was dumped and a trail of smaller fragments littered the channels towards the Katsina-Ala River.     

Measurement of stress effects (scope for growth) and contaminant levels in mussels (Mytilus edulis) collected from the Irish Sea

The objective of this research was to quantify the impact of pollution along the coastlines of the Irish Sea. Pollution assessment was based on the combined measurement of scope for growth (SFG), and chemical contaminants in the tissues of mussels (Mytilus edulis) collected from 38 coastal sites around the Irish Sea during June-July in 1996 and 1997. On the UK mainland coast, the SFG showed a general trend with a significant decline in water quality in the Liverpool and Morecambe Bay region. High water quality was recorded along the west coast of Wales, as well as southwest England and northwest Scotland (clean reference sites outside the Irish Sea). Along the coast of Ireland there was a similar trend with reduced SFG within the Irish Sea region. SFG was generally low north of Duncannon and then improved north of Belfast. The poor water quality on both sides of the Irish Sea is consistent with the prevailing hydrodynamics and the spatial distribution of contaminants associated with urban/ industrial development. The decline in SFG of mussels on both sides of the Irish Sea was associated with a general increase in contaminant levels in the mussels. Certain contaminants, including PAHs, TBT, sigmaDDT, Dieldrin, gamma-HCH, PCBs, and a few of the metals (Cd, Se, Ag, Pb), showed elevated concentrations. Many of these contaminants were particularly elevated in the coastal margins of Liverpool Bay, Morecambe Bay and Dublin Bay. A quantitative toxicological interpretation (QTI) of the combined tissue residue chemistry and SFG measurements indicated that at the majority of coastal sites, c. 50 to > 80% of the observed decline in SFG was due to PAHs as a result of fossil fuel combustion and oil spills. TBT levels were highest at major ports and harbours, but these concentrations only made a minor contribution to the overall reduction in SFG. At no sites were individual metals accumulated to concentrations that could cause a significant effect on SFG. The study identified many sites where the observed reduction in SFG was far greater than predicted from the limited number of chemical contaminants analysed, thus indicating the presence of additional 'unknown toxicants'. Sewage (containing domestic, agricultural and industrial components) appears to be an important contributor to reduced SFG and linear alkylbenzenes (LABs) and As may provide suitable 'sewage markers'. There was a highly significant positive correlation between SFG and As (P < 0.001). This relationship may be due to reduced As uptake by algal food material and mussels at sites with elevated P04 concentrations (e.g. at sites with sewage inputs). Phosphate is a known competitive inhibitor of As accumulation, at least in algae. The results highlight that further research is required on 'sewage markers' in mussels. The SFG approach therefore provides a rapid, cost-effective and quantitative measure of pollution impact, as well as a means of identifying the causes through a QTI of tissue contaminants levels. It also serves to identify the presence of unidentified toxicants and areas that require further study.     

Intraplate deformation and 3D rheological structure of the Rhine Rift System and adjacent areas of the northern Alpine foreland

The lithosphere of the Northern Alpine foreland has undergone a polyphase evolution during which interacting stress-induced intraplate deformation and upper mantle thermal perturbations controlled folding of the thermally weakened lithosphere. In this paper we address relationships among deeper lithospheric processes, neotectonics and surface processes in the Northern Alpine foreland with special emphasis on tectonically induced topography. We focus on lithosphere memory and neotectonics, paying special attention to the thermo-mechanical structure of the Rhine Graben System and adjacent areas of the northern Alpine foreland lithosphere. We discuss implications for mechanisms of large-scale intraplate deformation and links with surface processes and topography evolution.     

Gamma-ray bursts: optical afterglows in the deep Newtonian phase

Gamma-ray burst remnants become trans-relativistic typically in days to tens of days, and they enter the deep Newtonian phase in tens of days to months, during which the majority of shock-accelerated electrons will no longer be highly relativistic. However, a small portion of electrons are still accelerated to ultra-relativistic speeds and are capable of emitting synchrotron radiation. The distribution function for electrons is re-derived here so that synchrotron emission from these relativistic electrons can be calculated. Based on the revised model, optical afterglows from both isotropic fireballs and highly collimated jets are studied numerically, and compared to analytical results. In the beamed cases, it is found that, in addition to the steepening due to the edge effect and the lateral expansion effect, the light curves are universally characterized by a flattening during the deep Newtonian phase.