Expression of heat shock protein 70 in a permanent cell line (EPC) exposed to sediment extracts from the North Sea and the Baltic Sea

Heat shock proteins 70 (hsp70) are known to be induced by a great variety of chemical stressors. The effects of different environmental contaminants, which were identified in sediments of the North Sea and the Baltic Sea as main contaminants or as contaminants of special toxicological interest, on the extent of expression of hsp70 in a permanent cell line Epithelioma papulosum cyprini (EPC) were investigated. Concentrations of the single contaminants leading to elevated hsp70 levels were compared to the respective concentrations of these contaminants encountered in the sediment extracts thus allowing an assessment of their contribution to the toxicity of these sediments. Analysis of hsp70 was performed using western blotting techniques with subsequent comparative quantification by densitometry. Eleven of thirteen contaminants have shown a dose-dependent increase in hsp70 levels. An expression of hsp70 was observed in most cases between 0.1 and 10 microg/mL test solution. Some of the investigated stressors led to extremely high hsp70 contents even at low concentrations. However, in most cases contaminant concentrations in sediments were too low to cause an effect. For this reason, effects of the tested sediments are attributed to other contaminants or rather to mixtures of stressors.     

Inter-basin movements of Mediterranean sperm whales provide insight into their population structure and conservation

The sperm whale is one of the very few deep diving mammal species in the Mediterranean Sea. Following a rare mass stranding of male sperm whales in the Adriatic Sea in December 2009, photo-identification methods were used in order to investigate previous sightings of the stranded whales in the region. Fluke photos of the stranded whales were compared with those of 153 and 128 free-ranging individuals photographed in the western and eastern Mediterranean basins, respectively. Three out of the seven stranded whales had been previously photo-identified and some of them more than once. To reach the stranding place, two of these re-identified whales performed long-range inter-basin movements of about 1600-2100 km (in a straight line) either through the Strait of Sicily or the Strait of Messina. In addition, comparisons among all whales photographed in the two Mediterranean basins revealed that one more individual first photographed in the western basin (1991) was re-identified 13 years later in the eastern basin (2004). These three cases provide the first conclusive evidence of inter-basin movement of sperm whales in the Mediterranean Sea. Inter-basin gene flow is important for the survival of the small and endangered Mediterranean sperm whale population. Mitigating the disturbance created by human activities in the straits area is crucial for its conservation.     

Petroleum-related hydrocarbons in deep and subsurface sediments from South-Western Barents Sea

Subsurface sediments from a pockmark area in South-Western Barents Sea have been earlier found to contain elevated levels of petroleum-related polycyclic aromatic hydrocarbons. This work describes a comprehensive analysis of various biomarkers, including the highly source-specific hopanes, in a 4.5?m long gravity core from the same area, together with subsurface sediment samples from other areas in the region without pockmarks present ("background samples"). A clear difference between the pockmark gravity core and the background sediment cores was found, both with regard to genesis and the level of transformation of organic matter. A number of indicator parameters, such as methylphenanthrene index (MPI-1), point towards a significantly higher maturity of hydrocarbons in the pockmark core throughout its length as compared to the other sampled locations. Higher contents of microbial hopanoids (hopenes) may indicate the former presence of petroleum. These findings confirm the hypothesis of a natural hydrocarbon source in the deeper strata present in the studied location with pockmarks.     

Physical and biological response of the Arabian Sea to tropical cyclone Phyan and its implications

The response to the tropical cyclone Phyan, which developed in the eastern Arabian Sea during 9-11 November 2009, was rapid cooling of sea surface temperature (SST), enhancement of chlorophyll a and two-fold increase in net primary productivity (NPP). Cooling of SST was immediate in response to the strong wind-mixing, and the subsequent upward Ekman pumping sustained the cooling even after the dissipation of Phyan. The biological response mediated by the upward Ekman pumping driven vertical transport of subsurface nutrient showed a time lag of 3-4 days. The CO? flux to the atmosphere associated with Phyan was 0.123 Tg C, which accounted for ~85% of the total out-gassing from the eastern Arabian Sea during November. Thus, an increased occurrence of cyclones in a warming environment will lead to an enhanced biomass production and also increase in CO? out-gassing.     

Composition and secondary alterations of microfossils in sediments of the Ashadze-1 hydrothermal field (tropical Mid-Atlantic Ridge)

The first thorough analysis of microfossils from ore-bearing sediments of the Ashadze-1 hydrothermal field in the Mid-Atlantic Ridge sampled during cruise 26 of the R/V Professor Logachev in 2005 revealed the substantial influence of hydrothermal processes on the preservation of planktonic calcareous organisms, as well as on the preservation and composition of the benthic foraminifers. From the lateral and vertical distribution patterns and the secondary alterations of the microfossils, it is inferred that the main phase of the hydrothermal mineralization occurred in the Holocene. Heavy metals (Cu, Co, Cr, and Ag) were accumulated by foraminiferal tests and in their enveloping Fe-Mn crusts. The distribution of authigenic minerals replacing foraminiferal tests demonstrates local zoning related to the hydrothermal activity. There are three mineral-geochemical zones defined: the sulfide zone, the zone with an elevated Mg content, and zone of Fe-Mn crusts.     

A review of the equations used to predict the velocity distribution within a ship’s propeller jet

Predicting the velocity within the ship’s propeller jet is the initial step to investigate the scouring made by the propeller jet. Albertson et al. (1950) suggested the investigation of a submerged jet can be undertaken through observation of the plain water jet from an orifice. The plain water jet investigation of Albertson et al. (1950) was based on the axial momentum theory. This has been the basis of all subsequent work with propeller jets. In reality, the velocity characteristic of a ship’s propeller jet is more complicated than a plain water jet. Fuehrer and Römisch (1977), Blaauw and van de Kaa (1978), Berger et al. (1981), Verhey (1983) and Hamill (1987) have carried out investigations using physical model. Current paper reviews the state-of-art of the equations used to predict the time-averaged axial, tangential and radial components of velocity within the zone of flow establishment and the zone of established flow of a ship’s propeller jet.     

A simplified approach to design fuzzy logic controller for an underwater vehicle

Fuzzy logic controller (FLC) performance is greatly dependent on its inference rules. In most cases, the more rules being applied to an FLC, the accuracy of the control action is enhanced. Nevertheless, a large set of rules requires more computation time. As a result, an FLC implementation requires fast and high performance processors. This paper describes a simplified control scheme to design a fuzzy logic controller (FLC) for an underwater vehicle namely, deep submergence rescue vehicle (DSRV). The proposed method, known as the single input fuzzy logic controller (SIFLC), reduces the conventional two-input FLC (CFLC) to a single input FLC. The SIFLC offers significant reduction in rule inferences and simplifies the tuning process of control parameters. The performance of the proposed controller is validated via simulation by using the marine systems simulator (MSS) on the Matlab/Simulink^® platform. During simulation, the DSRV is subjected to ocean wave disturbances. The results indicate that the SIFLC, Mamdani and Sugeno type CFLC give identical response to the same input sets. However, an SIFLC requires very minimum tuning effort and its execution time is in the orders of two magnitudes less than CFLC.     

Fracture mechanics analysis of multiple cracks in anisotropic media

This paper presents a single‐domain boundary element method (BEM) for linear elastic fracture mechanics analysis in the two‐dimensional anisotropic material. In this formulation, the displacement integral equation is collocated on the un‐cracked boundary only, and the traction integral equation is collocated on one side of the crack surface only. A special crack‐tip element was introduced to capture exactly the crack‐tip behavior. A computer program with the FORTRAN language has been developed to effectively calculate the stress intensity factors of an anisotropic material. This BEM program has been verified having a good accuracy with the previous researches. Furthermore, by analyzing the different anisotropic degree cracks in a finite plate, we found that the stress intensity factors of crack tips had apparent influence by the geometry forms of cracks and media with different anisotropic degrees. Copyright © 2010 John Wiley & Sons, Ltd.