Erodibility of soft freshwater sediments in Markermeer: the role of bioturbation by meiobenthic fauna

The Markermeer is a large and shallow man-made freshwater lake in the Netherlands, characterized by its high turbidity. As part of a study aiming to mitigate this high turbidity, we studied the water–bed exchange processes of the lake’s muddy bed. The upper centimeter’s–decimeter’s of the lake bed sediments mainly consists of soft anoxic mud. Recent measurements have proved the existence of a thin oxic layer on top of this soft anoxic mud. This oxic layer, which is much easier to be eroded than the anoxic mud, is believed to be related with Markermeer’s high-turbidity levels. Our hypothesis is that the thin oxic layer develops from the anoxic mud, enhanced by bioturbation. Actually, we will demonstrate that it is the bioturbated state of the bed that increases its erodability, and not the oxidation state of the sediments. In particular, we will refer to bioturbation caused by meiobenthic fauna. The objective of this study is therefore to determine the influence of the development of the thin oxic layer on the water–bed exchange processes, as well as to establish the role of bioturbation on those processes. This is done by quantifying the erosion rate as a function of bed shear stresses, and at different stages of the development of the oxic layer. Our experiments show that bioturbation increases the rate at which Markermeer sediments are eroded by almost an order of magnitude. The short-term fine sediment dynamics in Markermeer are found to be driven by the complex and highly dynamic interactions between physics, chemistry, and biology. Finally, the long-term fine sediment dynamics are driven by the erosion of the historical deposits in the lake’s bed, which is only possible after bioturbation, and which leads to an increase of the stock of sediments in the lake’s muddy bed.     

Siltation by sediment-induced density currents

This paper describes the results of numerical experiments with a three-dimensional hydrodynamic and mud transport model in which sediment–fluid interaction is taken into account through the effects of hindered settling, buoyancy destruction in the turbulence k– model and sediment-induced barocline pressure gradients in the momentum equations. The model was applied to a schematic case representing a coastal area with a tidal river, navigation channel and harbour basin, and a real-world case, viz. Rotterdam harbour area in The Netherlands. The results show that the sediment transport into the harbour area, and subsequent siltation rates, increase by a factor 3 to 5 due to the sediment–fluid interaction. It is shown that the larger contribution stems from an increase in vertical gradients in suspended sediment.Responsible Editor: Jens Kappenberg     

Correlating fracture trends and hydraulic head using semivariogram cloud analysis

Fracture trends (defined as kilometer-scale linear features interpolated between field observations of fractures along their strikes) often have a dominant orientation. Finding a correlation between this orientation and hydraulic data could shed light on their hydraulic influence. A significant correlation between head residuals from first-order regional drift and the orientation of 2- to 4-km-long fracture trends was found in a study site in the Negev, Israel, using the semivariogram cloud analysis. Correlation of head residuals rather than the head itself implies that the orientation of the fracture trends controls the anisotropy and heterogeneity at this scale, mainly because the fracture trends define the orientation of blocks, which differ in their hydraulic properties. Preferential transmissive pathways are probably shorter than the full extent of the fracture trends, causing a relatively high head difference along the trends on the 2- to 4-km scale. Fracture trend density and additional data from short-range hydraulic tests helped characterize two blocks separated by a fault zone. The identification of hydraulic features on a kilometer scale is necessary for better modeling of regional ground water flow and transport. Hydraulic tests at this scale are not feasible, thereby rendering combined analyses of head and structural data, such as the one presented here, essential.     

The activity of chromite in multicomponent spinels: Implications for T‐fO2 conditions of equilibrated H chondrites

Abstract— Activities of chromite in multicomponent spinels with compositions similar to those of H chondrites were experimentally determined by equilibrating Pt‐alloys with spinel at known temperature and fO₂. Our results are consistent with predictions based on the spinel solid solution model incorporated into the MELTS program. Therefore, we combined literature formulations for the activities of components in spinel, the ferromagnesian silicates, and alloys with measured and literature (bulk alloy) compositions of the meteoritic phases to constrain T‐fO₂ conditions for the H‐group chondrites Avanhandava (H4), Allegan (H5), and Guareña (H6). Log₁₀fO₂ values based on the assemblage of olivine + orthopyroxene + metal are 2.19–2.56 log units below the iron‐wüstite (IW) buffer for any equilibration temperature between 740 and 990 °C, regardless of petrographic type. Only lower limits on fO₂ could be determined from spinel + metal equilibria because of the extremely low concentrations of Cr in the alloys of equilibrated H chondrites (≤3 ppb). Log₁₀fO₂ values required by spinel + metal equilibria are inconsistent with those for olivine + orthopyroxene + metal if equilibration temperatures were at or above those inferred from olivine‐spinel thermometry. This probably indicates that the closure for spinel + metal equilibria occurred under retrograde conditions at temperatures below ～625 °C for Allegan and Guareña and below ～660 °C for Avanhandava.     

Moveout approximation for horizontal transversely isotropic and vertical transversely isotropic layered medium. Part II: effective model‡

We use residual moveouts measured along continuous full azimuth reflection angle gathers, in order to obtain effective horizontal transversely isotropic model parameters. The angle gathers are generated through a special angle domain imaging system, for a wide range of reflection angles and full range of phase velocity azimuths. The estimation of the effective model parameters is performed in two stages. First, the background horizontal transversely isotropic (HTI)/vertical transversely isotropic (VTI) layered model is used, along with the values of reflection angles, for converting the measured residual moveouts (or traveltime errors) into azimuthally dependent normal moveout (NMO) velocities. Then we apply a digital Fourier transform to convert the NMO velocities into azimuthal wavenumber domain, in order to obtain the effective HTI model parameters: vertical time, vertical compression velocity, Thomsen parameter delta and the azimuth of the medium axis of symmetry. The method also provides a reliability criterion of the HTI assumption. The criterion shows whether the medium possesses the HTI type of symmetry, or whether the azimuthal dependence of the residual traveltime indicates to a more complex azimuthal anisotropy. The effective model used in this approach is defined for a 1D structure with a set of HTI, VTI and isotropic layers (with at least one HTI layer). We describe and analyse the reduction of a multi‐layer structure into an equivalent effective HTI model. The equivalent model yields the same NMO velocity and the same offset azimuth on the Earth's surface as the original layered structure, for any azimuth of the phase velocity. The effective model approximates the kinematics of an HTI/VTI layered structure using only a few parameters. Under the hyperbolic approximation, the proposed effective model is exact.     

Can the desert bloom? Lessons learned from the Israeli case

Despite the central management of Israel's water resources and the highly planned strategy for a sustainable water supply, Israel has twice faced an acute water crisis during the past decade. Although the visible problem is related to a lack of additional quantities of water, the deterioration of water quality appears to be endangering the future use of available water quantities as well. A long-term policy of ground water mining (translated to salt water encroachments), and irrigation with relatively saline water and recycled waste water, among other damage, account for this deterioration. Enhanced flushing of the salt and contaminant load from the aquifers (using various techniques) is proposed as a solution to the problem.     

Understanding the peak growing season ecosystem water-use efficiency at four boreal fens in the Athabasca oil sands region

Ecosystem water-use efficiency (WUE), a ratio between gross ecosystem production (GEP) and water loss through evapotranspiration (ET) can be helpful for the assessment of coupled peatland carbon and water cycles under anthropogenic changes in the Athabasca oil sands region (AOSR) where extensive oil sands development has been occurring since the 1960's. As such, this study assessed multiyear peak growing season variability of WUE at four fens (poor treed, poor open, treed moderate-rich, open saline) near Fort McMurray using the eddy covariance technique combined with a set of environmental variables. Freshwater fens were characterized by WUE values within the range reported from other boreal wetlands while a saline fen had significantly lower values of WUE. Negative correlation (R_s < −0.55, p < 0.05) between WUE and net radiation was observed. Moisture conditions were responsible for interannual differences in WUE, whereby increasing WUE under wetter conditions was observed. However, such a pattern was offset by decreased air temperature (T_air) resulting in moisture oversupply. This study also revealed a negative effect of wildfire on WUE due to a prominent decline in GEP and a moderate decrease in ET. WUE can be useful for monitoring the functioning of natural and constructed fens, but a better understanding of WUE variability under a wide range of climatic conditions with respect to differences in vegetation is required.