Monitoring volcanic hazard using eddy covariance at Solfatara volcano, Naples, Italy

An eddy covariance (EC) station was deployed at Solfatara crater, Italy, June 8–25, 2001 to assess if EC could reliably monitor CO₂ fluxes continuously at this site. Deployment at six different locations within the crater allowed areas of focused gas venting to be variably included in the measured flux. Turbulent (EC) fluxes calculated in 30-min averages varied between 950 and 4460 g CO₂ m⁻² d⁻¹; the highest measurements were made downwind of degassing pools. Comparing turbulent fluxes with chamber measurements of surface fluxes using footprint models in diffuse degassing regions yielded an average difference of 0% (±4%), indicating that EC measurements are representative of surface fluxes at this volcanic site. Similar comparisons made downwind of degassing pools yielded emission rates from 12 to 27 t CO₂ d⁻¹ for these features. Reliable EC measurements (i.e. measurements with sufficient and stationary turbulence) were obtained primarily during daytime hours (08:00 and 20:00 local time) when the wind speed exceeded 2 m s⁻¹. Daily average EC fluxes varied by ±50% and variations were likely correlated to changes in atmospheric pressure. Variations in CO₂ emissions due to volcanic processes at depth would have to be on the same order of magnitude as the measured diurnal variability in order to be useful in predicting volcanic hazard. First-order models of magma emplacement suggest that emissions could exceed this rate for reasonable assumptions of magma movement. EC therefore provides a useful method of monitoring volcanic hazard at Solfatara. Further, EC can monitor significantly larger areas than can be monitored by previous methods.     

Barometric pumping effects on soil gas studies for geological and environmental characterization

Data from two free soil gas sampling programs are evaluated for the effects of barometric pumping over time on measured soil gas volumes. One program collected data from the trapped atmosphere immediately above two hazardous waste landfill areas. Of these areas, one had extremely high soil gas emanations, whereas the other had a more modest soil gas release. The second experimental program involved the collection of free soil gas samples on a rough grid with an approximate spacing of 1.6 km over a 720-sq-km area. This reconnaissance effort was designed to establish regional soil gas background values and to establish the utility of this method as a geological mapping tool in the Atlantic Coastal Plain. Methane, ethane, propane, and hydrogen data are used for this study. The data suggest that there is a predictable change in soil gas volume with a given change in barometric pressure. The rate of change is greater with large soil gas volumes in permeable soils versus lower soil gas volumes in impermeable soils; however, a simple linear relationship seems to generate a predictable curve with a margin of error of approximately 50%. Furthermore, the results of this study indicate that barometric pumping effects should be strongly considered during soil gas screening efforts at hazardous waste sites as well as in regional studies for hydrocarbon source potential mapping.     

CM-like interplanetary dust particles in lower stratosphere during 1989 October and 1991 June/July

Abstract— The stratospheric interplanetary dust particles L2005T12 and L2011O3 are linked to CM chondrite matrix. Particle L2005T12 is dominated by tabular grains of partially dehydrated greenalite-rich serpentine. Its amorphous matrix contains abundant smectite nanocrystals and annular Fe, Ni, S units. A uniquely stratified (partial) maghémite rim occurs only on S-rich parts of the matrix. Formation of this rim and Mg depletions in the matrix occurred during atmospheric entry heating of this particle. Particle L2011O3 has large iron sulfide and magnesiowüstite grains in an amorphous low-Al, ferromagnesiosilica matrix. Hydrous crystallisation of this matrix produced ultrafine-grained smectites and disseminated iron sulfides. Atmospheric entry heating of both particles is indicated by the partial iron oxide rim, vesicular sulfides, and the scatter of matrix compositions due to loss of Mg. While many uncertainties remain, the high incidence of chondritic rough particles, which include an unknown amount of CM-like particles, in the lower stratosphere during 1984, 1989, and 1991 suggests annual variations in their abundances. The timing of lower stratospheric dust samplings is critical to collect these particles.     

Bubble-induced porewater mixing: A 3-D model for deep porewater irrigation

Porewater data from vent sites of the northeastern shelf off Sakhalin Island, Sea of Okhotsk, exhibit bottom-water concentrations down to a sediment depth of up to 300 cm. Below this depth, solute concentrations rapidly change due to methanogenesis and anaerobic methane oxidation (AMO). The profile shapes suggest an irrigation-like process that mixes on a meter scale. At these sites active gas emanation into the overlying water column and near-surface gas hydrates are commonly observed. We propose that methane gas bubbles rise through the soft surface sediments and cause mixing of the porewater.Mathematically, the bubble-induced irrigation can be described by eddy diffusion enhancing the diffusive transport of solutes by several orders of magnitude. A 3-D numerical transport-reaction model was developed to investigate the parameters defining the mixing process, such as bubble rise velocity, tube size, tube distribution in the sediment, and ebullition frequency.Model consistency with the field data requires eddy diffusivities ?1 × 10⁵ cm²/a, tube densities of >4 tubes/m² (equivalent to a tube spacing of <40 cm), active gas seepage for more than a few weeks or months, and moderate to low diagenetic reaction rates of solutes. The corresponding methane gas fluxes that are predicted from the results of the model realizations range from 1 × 10³-5 × 10⁵ L/(m² a). Due to bubble mixing, solute fluxes in these sediments are increased by a factor of 3 and the maximum AMO rate by a factor of 7.     

The evolution of massive close binaries

The results of evolutionary computations for massive binary systems (initial masses of the primary 10M ) with mass ratios between 0.3 and 0.8 are summarized and compared with observations in order to verify how far one can go with the conservative assumption of mass exchange. It is found that conservative mass exchange leads to acceptable first-order models of W-R and massive X-ray binaries. However, the comparison between this theory and observation reveals that for the observed systems (W-R and X-ray binaries) a preference exists for low intial mass ratios; moreover, the X-ray luminosities of the theoretical models are systematically too low, though this may be due to the adopted wind model. In addition, the influences of several parameters (distance between the components, chemical composition, primary mass, mass ratio and atmosphere) are examined. These parameters influence the remnant mass and any further evolution only marginally. Attention is also given to the effect on the system parameters of a supernova explosion of the remnant of the mass-losing component. For a large range of systems a disruption probability smaller than 25% is found.     

Discrete element modelling of fragmentable geomaterials with size dependent strength

This paper presents the application of a discrete element technique to the analysis of the dynamic indentation of either a purely brittle or a brittle viscoplastic geomaterial which can experience fragmentation resulting in fragments with size dependent strength characteristics.     

Changes in the internal spatial structure of post-communist Prague*

The article overviews the most important changes in the internal urban structure of Prague since 1989. Post-communist urban development has been influenced by government-directed reforms of political and economic system, internationalisation and globalisation, public policies favouring unregulated market development, economic restructuring in terms of deindustrialisation and growth of producer services, and increasing social differentiation. The three most transparent processes of urban change in Prague have been (1) commercialisation of the historical core; (2) revitalisation of some inner city neighbourhoods; and (3) residential and commercial suburbanisation in the outer city. This revised version was published online in July 2006 with corrections to the Cover Date.     

Prime controls on Archaean–Palaeoproterozoic sedimentation: Change over time

Although the principle of uniformitarianism may be applied to the Precambrian sedimentary record as a whole, certain periods of the Archaean and Palaeoproterozoic witnessed a changing pattern of prime influences controlling the depositional systems. This paper examines the major controls on sedimentation systems and environments during the Archaean and Palaeoproterozoic within the broader perspective of Earth evolution. Earth's earliest sedimentary system (4.4?-3.7 Ga) was presumably comprised of deep oceanic realms and probably influenced primarily by bolide impacts, major tsunamis, localized traction and global contour current patterns, and bathymetry. As continental crust began to form, the impact-dominated, tsunami type sedimentation gave way to wider varieties of sedimentary environments, known from the oldest sedimentary records. During early continental crustal evolution (c. 3.7–2.7 Ga), sedimentation was essentially of greenstone-type. Volcanic and volcaniclastic rocks were the major components of the greenstone belts, associated with thin carbonates, stromatolitic evaporites, BIF, pelites and quartzites and lesser synorogenic turbidites, conglomerates and sandstones. Volcanism and active tectonism (reflecting dynamic depositional settings during island arc and proto-continental nucleus formation) were the predominant factors influencing sedimentation during this phase of Earth evolution. Transgressions and regressions under the combined influence of tectonics and eustasy are reflected in fining- and coarsening-upwards successions from the proto-cratonic settings; low freeboard enabled the transgression to affect large areas of the proto-cratons. As the earliest, relatively stable craton formed, through a combination of plate tectonic and mantle-thermal processes, continents and supercontinents with the potential for supercontinental cycles started to influence sedimentation strongly. Major controls on Neoarchaean–Palaeoproterozoic sedimentation systems (2.7–1.6 Ga) were provided by a combination of superplume events and plate tectonics. Two global-scale ‘superevents’ at c. 2.7 Ga and c. 2.2–1.8 Ga were accompanied by eustatic rise concomitant with peaks in crustal growth rates, and large epeiric seas developed. The operation of first-order controls leading to development of vast chemical sedimentary platforms in these epeiric seas and concomitant palaeo-atmospheric and palaeo-oceanic evolution combined to provide a second-order control on global sedimentary systems in the Neoarchaean–Palaeoproterozoic period. The supercontinental cycle had become well established by the end of the Palaeoproterozoic, with the existence of large cratons across broad spectrums of palaeolatitude enabling erg development. The entire spectrum of sedimentary systems and environments came into existence by c. 1.8 Ga, prime influences on sedimentation and depositional system possibly remaining essentially uniform thereafter.     

Generation of correlated properties in heterogeneous porous media

The spatial distribution of rock properties in porous media, such as permeability and porosity, often is strongly variable. Therefore, these properties usefully may be considered as a random field. However, this variability is correlated frequently on length scales comparable to geological lengths (for example, scales of sand bodies or facies). To solve various engineering problems (for example, in the oil recovery process) numerical models of a porous medium often are used. A need exists then to understand correlated random fields and to generate them over discretized numerical grids. The paper describes the general mathematical methods required to do this, with one particular method (the nearest neighbor model) described in detail. How parameters of the mathematical model may be related to rock property statistics for the nearest neighbor model is shown. The method is described in detail in one, two, and three dimensions. Examples are given of how model parameters may be determined from real data.