Multiple longshore sand bars in the upper Chesapeake Bay

In the upper Chesapeake Bay (Maryland, U.S.A.) field surveys were conducted at 18 multiple longshore sand bar sites. The multiple bar systems were found in water depths less than approximately 2 m (mean sea level), and exhibited mild bottom slopes of 0·0052 or less. The number of bars composing each system ranged from four to 17 and the spacing between the crests typically increased in the offshore direction, ranging from 12 to 70 m. Bar height also typically increased with distance offshore and ranged from 0·03 to 0·61 m. A grain size analysis of crest and trough sediment did not reveal any significant differences and the sediment was categorized as ‘fine sand’. A review of the literature data indicated that the Chesapeake Bay multiple bars possessed similar characteristics to those found in Gelding Bay (Baltic Sea); similarities in fetch, wave height and tidal range between the two bays may account for this finding. The surf-scaling parameter indicated that the multiple bar systems were extremely dissipative with regard to wave energy, and wave height appeared to be an important factor in controlling bar spacing and bar height. A multiple wave break point hypothesis was discussed as a possible mechanism for the formation of Chesapeake Bay multiple longshore bars, and limited observational evidence appeared to support such a mechanism.     

利用自回归模型检测地球极移重力效应

同时采用4个台站的国际超导重力仪长期连续重力观测资料和国际地球自转服务中心提供的同步地球自转参数，研究了极移引起的地球重力场变化特征。利用自回归模型估计了各序列的功率谱密度和积谱密度，结果表明极移导致的重力效应的主要能量集中在Chandler摆动和周年项附近，叠积后实际重力观测与极移重力信号理论值之间的差异分别为0．4％和3．9％，说明超导重力仪可有效监测极移导致的重力变化。     

Microstructures of co-axially folded vein segments and crenulation cleavage： Evidence for dissolution phenomena in the Chamba Thrust Sheet, western Himalayas

The metasediments in the Chamba region experienced three phases of deformation: DF1, DF2 and DF3.Folded quartz veins are co-folded with the F2 crenulation folds. Their geometric and tectonic significance is studied by microstructures and shortening adjacent to the discrete crenulation cleavage, S2. Microstructures of folded vein segments, their geometric changes and truncation to cleavage (S2) are mainly due to pressure-solution phenomena and the estimated volume loss from reconstructed vein segments range from 16 to 25.5%,which is closely related to volume decrease (26%) calculated from the polydeformed slates of North Wales areas.     

Ultraviolet reflectance properties of asteroids

An analysis of the UV spectra of 28 asteroids obtained with the Internal Ultraviolet Explorer (IUE) satellite is presented. The spectra lie within the range 2100–3200 Å. Our results are examined in terms of both asteroid classification and of current ideas concerning the surface mineralogy of asteroids. For all the asteroids examined, UV reflectivity declines approximately linearly toward shorter wavelengths. In general, the same taxonomic groups are seen in the UV as in the visible and IR, although there is some evidence for asteroids with anomalous UV properties and for UV subclasses within the S class. No mineral absorption features are reported of strength similar to the strongest features in the visible and IR regions, but a number of shallow absorptions do occur and may provide valuable information on the surface composition of many asteroids.     

Comparison of marine gas hydrates in sediments of an active and passive continental margin

Two sites of the Deep Sea Drilling Project in contrasting geologic settings provide a basis for comparison of the geochemical conditions associated with marine gas hydrates in continental margin sediments. Site 533 is located at 3191 m water depth on a spit-like extension of the continental rise on a passive margin in the Atlantic Ocean. Site 568, at 2031 m water depth, is in upper slope sediment of an active accretionary margin in the Pacific Ocean. Both sites are characterized by high rates of sedimentation, and the organic carbon contents of these sediments generally exceed 0.5%. Anomalous seismic reflections that transgress sedimentary structures and parallel the seafloor, suggested the presence of gas hydrates at both sites, and, during coring, small samples of gas hydrate were recovered at subbottom depths of 238m (Site 533) and 404 m (Site 568). The principal gaseous components of the gas hydrates wer methane, ethane, and CO₂. Residual methane in sediments at both sites usually exceeded 10 mll^?1 of wet sediment. Carbon isotopic compositions of methane, CO₂, and ΣCO₂ followed parallel trends with depth, suggesting that methane formed mainly as a result of biological reduction of oxidized carbon. Salinity of pore waters decreased with depth, a likely result of gas hydrate formation. These geochemical characteristics define some of the conditions associated with the occurrence of gas hydrates formed by in situ processes in continental margin sediments.     

Organotemplate silica deposition in Neoproterozoic deep-marine environments: evidence from the Penganga Group, Adilabad, India

Silica in bedded cherts interstratified with manganese carbonates in a deep‐water carbonate ramp succession of the Neoproterozoic Penganga Group, India, displays film‐like, spherical to rod‐shaped, and tubular branching microstructures. The microstructures resemble mineralized extracellular polysaccharides, biofilms and bacterial morphologies. The microstructures suggest silicification by nucleation of silica on organic‐templates or indirectly as sorbed species accumulating on organic templates. Given that similar microstructures have also been documented in Archean cherts it is proposed that organotemplates might have been an important sink for the deposition of silica in Precambrian deep‐water marine environments.     

Slowness—time mapping of near offset seismic reflection data

Summary. The transformation of a set of seismograms to the delay time-slowness, τ—p, domain is presented as a sequence of Fourier and Bessel transforms, For a horizontally layered medium, this sequence gives an exact cylindrical wave decomposition of the response to a point source; correctly compensating for the phase shifting and geometrical spreading associated with transmission through the Earth. The resultant τ—p map or 'slant stack' contains true amplitude and phase information. The spatial aliasing properties of the transformation, when applied to a dataset, are greatly improved by the use of only outgoing waves in the Bessel transform. This is equivalent to using Hankel functions rather than Bessel functions, and is justified by the absence of incoming waves from most datasets. The WKBJ approximation to the medium response enables predictions to be made about the shape and amplitude variation with slowness of truncation effects. Theoretically the τ—p transformation is reversible, thus the τ—p domain is a suitable one in which to perform filtering operations before seismogram reconstruction.     

A critical state model for sands dependent on stress and density

An elastoplastic model for sands is presented in this paper, which can describe stress–strain behaviour dependent on mean effective stress level and void ratio. The main features of the proposed model are: (a) a new state parameter, which is dependent on the initial void ratio and initial mean stress, is proposed and applied to the yield function in order to predict the plastic deformation for very loose sands; and (b) another new state parameter, which is used to determine the peak strength and describe the critical state behaviour of sands during shearing, is proposed in order to predict simply negative/positive dilatancy and the hardening/softening behaviour of medium or dense sands. In addition, the proposed model can also predict the stress–strain behaviour of sands under three-dimensional stress conditions by using a transformed stress tensor instead of ordinary stress tensor. Copyright © 2004 John Wiley & Sons, Ltd.     

Plane of elastic non-resisting tension material under foundation structures

In the frame of 2D-static problems one approaches the problem of elastic-NRT (not-resisting tension) semi-plane loaded on its limit line. This problem is intended to model the stress situation induced in the soil by a foundation structure. The solution, in terms of activated stress field, is searched for in the class of stress fields satisfying equilibrium and admissibility conditions, by applying an energy approach. Copyright © 2004 John Wiley & Sons, Ltd.