Abundance, distribution and patch formation of zooplankton

The goal of studies described here was to determine the responses of zooplankton taxa to phytoplankton patches which develop in and near intrusions of cold, nutrient-rich Gulf Stream water. To achieve this goal we determined the horizontal and vertical distributions of abundant mesozooplankton taxa on the south-eastern continental shelf of the USA between 29°30′ and 31°N. The study period was from June 23 to August 16, 1981. Highest concentrations of zooplankton usually occurred in and near patches of phytoplankton. Increased phytoplankton appeared to trigger the formation of patches of the calanoid copepod Temora turbinata and the cyclopoid copepods Oithona spp. and Oncaea spp. The patches of zooplankton had greater alongshore than cross-shelf dimensions. T. turbinata responded rapidly to increased concentrations of phytoplankton by reproducing and aggregating in and above intruded waters. Oithonidae which were often, but not always, abundant in phytoplankton patches eventually attained high concentrations over most of the middle and part of the inner shelf. Their concentration and that of Oncaeidae increased steadily. Oncaeidae were not abundant in recently upwelled waters, as was T. turbinata but reached high concentrations in older intrusions when the abundance of T. turbinata remained level or decreased slowly. Both cyclopoid taxa are thought to reproduce slowly (egg sacs) compared to T. turbinata. Another taxon, the doliolids, became abundant far more rapidly in intruded waters (by asexual reproduction) than did the other three taxa. Doliolids were the most opportunistic intrusion zooplankton form. They do not regularly occur in low abundance on the shelf, as do the three copepod taxa, but develop in pulses in regions where T. turbinata and Oncaea are not abundant. Of the four taxa studied the abundance of doliolids increased and decreased most rapidly, whereas Oithona and Oncaea increased slowly and did not decrease during the study period. T. turbinata and Oncaea were most abundant at 60% of all stations in the intruding water. Doliolids and Oithona on the other hand, were mostly in the thermocline and intrusion. Whereas phytoplankton patches, which developed in intrusions, were physically induced (PAFFENHÖFER and LEE, 1988), patches of zooplankton were biologically induced.     

Joint Soviet-Turkish expedition in the Black Sea

The hydrological and hydrochemical structures of the upper 300 m water column of the Black Sea in autumn 1988 have been studied. Regularities in the distribution of the physico-chemical characteristics in the zone of interaction between aerobic and anaerobic waters as well as the topography of the H₂S zone boundary and its connection with a certain density gradient have been found.Translated by Mikhail M. Trufanov.     

Blockage correction

The velocity distribution and resistance for a body moving in a channel differs from that of in unrestricted water. A simple method has been developed to determine these velocity and resistance differences. An ellipsoid of revolution has been taken as the equivalent body from the blockage effect point of view. The motion of the equivalent ellipsoid in a rectangular channel has been studied by slender body approximation. The velocity increases have been computed numerically for different channels and velocities. Curve fitting has been applied to these velocity increases and velocity increase formulae have been obtained for different channel width-depth ratios. The resistance variation in unrestricted water can be easily obtained from values in a rectangular channel or vice versa by applying the method presented here.     

The distributions of particulate atmospheric trace metals and mineral aerosols over the Indian Ocean

Data are presented for the concentrations of Al, Fe, Mn, Ni, Co, Cr, V, Cu, Zn, Pb and Cd in aerosols collected over two contrasting regions of the Indian Ocean. These are: (1) the northern Arabian Sea (AS), from which samples were collected in the northeast monsoon, during which the region receives an input of crustal material from the surrounding arid land masses; and (2) the Tropical Southern Indian Ocean (TSIO), a remote region from which samples were collected from air masses for which there were no large-scale up-wind continental aerosol sources. The TSIO samples can be divided into two populations: Population I aerosols, collected from air masses which have probably impinged on Madagascar, and Population II aerosols, which have been confined to open-ocean regions to the south of the area.The data indicate that there are strong latitudinal variations in the chemical signatures of aerosols over the Indian Ocean. The input of crustal material to the Arabian Sea gives rise to an average Al concentration of about 1000 ng m⁻³ of air in the northeast monsoon regime. As a result, the concentrations of all trace metals are relatively high, and the values of crustal enrichment factors are less than 10 for most metals, in the AS aerosols. In contrast, TSIO Population II ‘open-ocean southern air’ sampled during the southwest monsoon season, has an average Al concentration of only about 10 ng m⁻³ of air. Trace metal concentrations in the TSIO ‘open-ocean southern air’ during the southwest monsoon season are representative of ‘clean’ remote marine air and are generally similar to those reported over the central North Pacific.Mineral dust concentrations over the Indian Ocean decrease in a north to south direction, from about 15–20 μg m⁻³ of air in the extreme north to about 0.01–0.25 μg m⁻³ of air in the far south. The deposition of mineral dust over the northern Arabian Sea can account for approximately 75% of the non-carbonate material incorporated into the underlying sediments.In the Arabian Sea the dissolved atmospheric inputs of all the trace metals, with the exception of Cu and Co, exceed those from fluvial run-off by factors which range from 9.6 for Pb to 1.6 for Cr.     

Particulate flux in the water column overlying Santa Monica Basin

Fluxes of particulate carbon, nitrogen, phytoplankton pigments, biogenic silica and dry mass were measured using free-floating and moored sediment trap arrays in the Santa Monica Basin during the period from October 1985 to August 1990 as part of the California Basin Study (CaBS) Program. In field testing for potential sources of sediment trap biases, we found little significant or consistent difference in rate estimates between short-term drifting traps and long-term moored traps, between preserved and unpreserved traps in short-term experiments, between different preservatives (mercury or formalin) in long-term experiments, between different designs of small cylindrical traps, and between deep-moored cylindrical traps and large conical traps. We did, however, find that sediment trap samples collected and analyzed on 0.45 μm silver filters gave estimates of carbon and nitrogen fluxes about 25% higher than samples collected on GF/F glass-fiber filters. Concurrent trap deployments at two stations 18km apart revealed low mesoscale variability in flux estimates. Seasonal patterns in carbon and nitrogen flux were not evident in our data, but strong seasonality, with spring maxima and summer minima, were observed for fluxes of phaeopigments and biogenic silica out of the euphotic zone.Time-averaged rates of particulate flux for long-term trap deployments from January to August 1990, were 121, 18.8, 1.5, 67 and 633mg m⁻²d⁻¹ at 110–135m for carbon, nitrogen, phaeopigment, biogenic silica and mass, respectively. Flux estimates to the basin floor (835–860m) were 50, 6.5, 0.64, 41.6 and 575mg m⁻²d⁻¹ for the same parameters. The former estimates are constrained by and in good agreement with independent assessments of new production from nitrate uptake in the euphotic zone. The latter agree with rates previously inferred from the sedimentary record using ²¹⁰Pb as a tracer. In addition, the difference in carbon estimates in the water column between the euphotic zone and the basin floor is consistent with the requirements for bacterial growth and metabolism at intermediate depths as measured by the thymidine method.     

Impact of Satellite Altimetry on Simulations of Sea Level Variability by an Indian Ocean Model

This article describes the impact of satellite altimeter data on the simulations of sea level variability (SLV) by a nonlinear reduced gravity model of the entire Indian Ocean. The model has been forced by 6-hourly analyzed wind stress data containing SSM/I observations and has been able to produce realistic circulation features. However, SLV values observed by Topex/Poseidon altimeter do not fit these simulations because of imperfect initial data. Hence an attempt has been made to initialize the model using altimeter data. The initialized model-generated SLVvalues have been compared with SLV derived by altimeter for monsoon as well as nonmonsoon months of 1996. Experimental runs have been performed for 10 days, 20 days, and one month. It has been found that the initialized model results on the final day of these experiments are in very good agreement with altimeter data of the same day. It is thus possible, in principle, to hindcast and forecast sea level variations in the time scale of 10 days to one month with the availability of good quality wind data for forcing the model and altimeter observations of sea level for initializing it.     

Acoustic imaging,visualization, and quantification of buoyant hydrothermal plumes in the Ocean

We develop and apply visualization and quantification methods to reconstruct hydrothermal plumes in 3D from acoustic images and to make the first direct measurements from the reconstructions of scalar properties that describe the behavior of two buoyant plumes discharging from adjacent black smoker chimneys. The actual behavior is then compared to that predicted by a classic simple buoyant plume model. The images are reconstructed as isointensity surfaces of backscatter from particulate matter suspended in the plumes. The measurements pertinent to the role of the plumes as agents of dispersal of heat and mass into the ocean include change with height of diameter, particle distribution, dilution, centerline attitude, surface protrusions, and connectivity. The protrusions are the surface expression of eddies and appear to follow a bifurcating helical flow pattern that resemble simulation of the naturally forced flow of coherent vortex rings as the eddies rise with the buoyant plume. These direct measurements and the derived entrainment coefficient are generally consistent with behavior predicted by the simple buoyant plume model and support engulfment by vortex shedding as a primary mechanism for entrainment of surrounding seawater. Deviations from predicted buoyant plume behavior are diagnostic of particle dynamics.     

Parameter identification of a compliant nonlinear SDOF system in random ocean waves by reverse MISO method

The determination of the drag and inertia coefficients, which enter into the wave force model given by Morison's equation, is particularly uncertain and difficult when a linear spectral model is used for ocean waves, and the structure is compliant and has nonlinear dynamic response. In this paper, a nonlinear System Identification method, called Reverse Multiple Inputs–Single Output (R–MISO) is applied to identify the hydrodynamic coefficients as well as the nonlinear stiffness parameter for a compliant single-degree-of-freedom system. Four different types of problems have been identified for use in various situations and the R–MISO has been applied to all of them. One of the problems requires iterative solution strategy to identify the parameters. The method has been found to be efficient in predicting the parameters with reasonable accuracy and has the potential for use in the laboratory experiments on compliant nonlinear offshore systems.