Acoustic reflectors in the surface layers of deep sea sediments

Using ultrasonic scanning it is possible to display the position of an acoustic discontinuity within a sediment core and the amplitude of the reflected signal which results from it. From these results it has been possible to examine the effect of variations in the geotechnical properties on the reflection of compressional waves at normal incidence within the core at a frequency of 100 kHz. The occurrence of acoustic reflectors in the surface layers of North Atlantic sediments has also been examined.Two ultrasonic scanning systems for the non-destructive testing of marine sediment cores have been developed. The performance of the two systems has been evaluated using the results from measurements made on a suite of marine sediment cores from the North Atlantic in conjunction with X-ray scanning and geological analysis of the same cores.     

Experimental study on loss factor for corrugated plates by bandwidth method

The material loss factor for technically orthotropic plates was measured by half-power bandwidth method. Rectangular and trapezoidal corrugated plates of steel were considered. A simple isotropic steel plate was also considered for comparison of the results. The concept of single degree of freedom system was adopted. The tests were undertaken at very low frequency range (0–100) Hz. The plate models were suspended freely with two wires to minimize or prevent excessive extraneous energy dissipation. Out of plane point force, random in nature was applied to the top middle of the plates and the responses were measured from the middle point of the plates by FFT analyzer using miniature small mass accelerometer as sensor. The aim of these tests is to investigate the effects of bending rigidity and mode orders over material loss factor. The values of estimated modal damping loss factors are compared and tabulated for the plates models considered. Natural frequencies of some of the initial modes of the plates are also presented.It is observed that the higher the value of bending rigidity of the plates, the larger the values of loss factor of it. There was a significant increase in value of loss factor in corrugated plates to that of the isotropic plate.     

The evolution of isolated vortices interacted with steep slope

Numerical solutions are examined for isolated, intense vortices as influenced by western bounding bottom topography through the use of a rigid-lid, two-layer primitive -plane numerical model. Systematic studies are made of the sense of rotation (cyclonic/anticyclonic), the consequence of varying the gradient of bottom slope, and the different vertical shear in a two layer ocean. In the basin with a bottom slope, the nearly barotropic anticyclonic vortex forms a modon-like vortex for S with fixedRo ₂<O(1) (where is the ratio between the variation of the Coriolis parameter across the eddy to the Coriolis parameter in the center, S the topographic effect and,Ro ₂ the Rossby number in the lower layer) and its generation is due to a compound effect of the planetary beta, topographic beta, avvection, and mirror image. The formation of the modon-like vortex and the propagation of the original vortex onto the bottom slope depends on the strength of slope gradient and the baroclinicity of the vortex. The nearly barotropic anticyclonic vortex evolves into the stronger upper ocean one with increasing S: the gradient of the bottom slope becomes steeper. Then the original vortex lives longer because the barotropic component of the energy is converted to the baroclinic one and it moves toward southeast in forming a modon-like vortex in the lower layer. The evolution of a vortex in the model results are compared to observational results of a Kuroshio warm core ring (KWCR) obtained from hydrographic data (June, 1985) and from NOAA satellite infrared images (April, 1985 to July, 1985). It is shown that a KWCR (June, 1985) is influenced by the western continental slope/shelf of the East Japan.     

Histopathological biomarkers in estuarine fish species for the assessment of biological effects of contaminants

The increasing emphasis on the assessment and monitoring of estuarine ecosystems has highlighted the need to deploy appropriate biological indices for these locations. Fish diseases and histopathology, with a broad range of causes, are increasingly being used as indicators of environmental stress since they provide a definite biological end-point of historical exposure. This study reports on the histopathological alterations observed in selected organs and tissues of three species of estuarine fish (Platichthys flesus, Pomatoschistus minutus and Zoarces viviparus), captured from four British estuaries (the Tyne, Tees, Mersey and Alde), differently impacted by contaminants, including PAHs. A biannual sampling regime was used to identify the important seasonal variations that occur in terms of the observed biological effects. Inflammatory lesions and hepatocellular fibrillar inclusions attained their highest prevalence in P. flesus captured from the Tyne, Tees and Mersey. The presence of pre-neoplastic and neoplastic toxicopathic lesions was highest in P. flesus captured from these sites, when compared to fish from the Aide reference site. In particular, the prevalence of hepatic foci of cellular alteration (up to 43.3%) and hepatocellular adenoma (up to 10%) were highest in P. flesus captured from the Mersey estuary. Intersex (ovotestis) was only recorded in male P.flesus captured from the Mersey estuary (up to 8.3%) and from male Z. viviparous captured from the Tyne estuary (25%). Pathologies associated with the gill and the kidney were also most prevalent in fish captured from the Tyne, Tees and Mersey estuaries. This study has successfully applied histopathology to an estuarine monitoring program, both for the recording of toxicopathic lesions in the liver and other organs, and for the detection of the endpoint of endocrine disruption, intersex. As such, it provides a powerful integrative tool for the assessment of biological effects of contaminants in these environments.     

Comparative tolerance of two estuarine annelids to fluoranthene under normoxic and moderately hypoxic conditions

The tolerance of the oligochaete Monopylephorus rubroniveus and the polychaete Streblospio benedicti to sediment-associated fluoranthene was characterized under normoxic (>80% dissolved oxygen saturation) and moderately hypoxic ( approximately 50% dissolved oxygen saturation) conditions. Under both conditions, M. rubroniveus was highly tolerant of fluoranthene. Streblospio benedicti was considerably less tolerant of fluoranthene compared with M. rubroniveus. In addition, S. benedicti was less tolerant to fluoranthene under moderately hypoxic conditions, although no differences in sensitivity between the two oxygen conditions were observed based upon median lethal tissue residues. Bioaccumulation factors were higher for S. benedicti exposed to moderate hypoxia, suggesting that behavioral adaptations to compensate for the lower dissolved oxygen increased its bioaccumulation of fluoranthene. The results of the present laboratory study demonstrate that (1). changes in annelid tolerance to fluoranthene under varying oxygen conditions is a species-dependent phenomenon and (2). the differential tolerance of these two annelids to these combined stressors is consistent with their relative abundances in the field.     

Fully nonlinear numerical wave tank (NWT) simulations and wave run-up prediction around 3-D structures

A finite-difference scheme and a modified marker-and-cell (MAC) algorithm have been developed to investigate the interactions of fully nonlinear waves with two- or three-dimensional structures of arbitrary shape. The Navier–Stokes (NS) and continuity equations are solved in the computational domain and the boundary values are updated at each time step by the finite-difference time-marching scheme in the framework of a rectangular coordinate system. The fully nonlinear kinematic free-surface condition is implemented by the marker-density function (MDF) technique developed for two fluid layers.To demonstrate the capability and accuracy of the present method, the numerical simulation of backstep flows with free-surface, and the numerical tests of the MDF technique with limit functions are conducted. The 3D program was then applied to nonlinear wave interactions with conical gravity platforms of circular and octagonal cross-sections. The numerical prediction of maximum wave run-up on arctic structures is compared with the prediction of the Shore Protection Manual (SPM) method and those of linear and second-order diffraction analyses based on potential theory and boundary element method (BEM). Through this comparison, the effects of non-linearity and viscosity on wave loading and run-up are discussed.