Fracture energy release and size effect in borehole breakout

The paper presents a simple approximate analytical solution of the remote stresses that cause the collapse of a borehole or other circular cylindrical cavity in an infinite elastic space. Regions of parallel equidistant splitting cracks are assumed to form on the sides of the cavity. Their boundary is assumed to be an ellipse of a growing horizontal axis, the other axis remaining equal to the borehole diameter. The slabs of rock between the splitting cracks are assumed to buckle as slender columns, and their post-critical stress is considered as the residual stress in the cracked rock. The buckling of these slab columns is assumed to be resisted not only by their elastic bending stiffness but also shear stresses produced on rough crack faces by relative shear displacements. The energy release from the infinite medium caused by the growth of the elliptical cracking region is evaluated according to Eschelby's theorem. This release is set equal to the energy dissipated by the formation of all the splitting cracks, which is calculated under the assumption of constant fracture energy. This yields the collapse stress as a function of the elastic moduli, fracture energy, ratio of the remote principal stresses, crack shear resistance characteristic and borehole diameter. The collapse stress as a function of crack spacing is found to have a minimum, and the correct crack spacing is determined from this minimum. For small enough diameters, the crack spacing increases as the (4/5)-power of the borehole diameter, while for large enough diameters a constant spacing is approached. In contrast to plastic solutions, the breakout stress exhibits a size effect, such that for small enough diameters the breakout stress decreases as the (? 2/5)-power of the borehole diameter, while for large enough diameters a constant limiting value is approached. Finally, some numerical estimates are given and the validity of various simplifying assumptions made is discussed.     

Speciation of trace metals in sediments of a tropical estuary

Axial surveys were performed in the two river tributaries of the Cochin estuary, SW India during November 1988. Surficial sediments were subjected to sequential chemical extractions to delineate five metal fractions, namely, exchangeable, carbonate bound, easily reducible, organic/sulfide bound, and residual. The results indicated selective accumulation of Mn and Ni in carbonate bound and organic/sulfide forms, along with marginal amounts of Co in the exchangeable fraction. Large portions of Fe and Cr occurred in the residual fraction, whereas composite fractionation of Zn species was noticed. The exchangeable fractions of Fe and Cr as well as of easily reducible cobalt were below detection limits. The levels of Cr and Zn indicate anthropogenic inputs in this estuary, whereas Co and Ni show regional contamination exceeding natural levels. The analytical speciation procedure helps to deduce the sedimental diagenetic processes in the estuarine environment.     

The estimation of the shape of an array using a hidden Markov model

A hidden Markov model (HMM) technique for the estimation of the shape of a towed array is presented. It is assumed that there is a far-field source radiating sound containing possibly weak spectral lines. The technique uses either the Fourier coefficients at a given frequency computed from a single time block or the maximal eigenvector of a sample spectral covariance matrix. The technique is illustrated using several simulations. The results of these simulations indicate that the HMM technique yields shape and bearing estimates more accurate than those provided by a maximum-likelihood array shape estimation technique     

Transient response of a circular cavity in a poroelastic medium

This paper considers the transient response of a pressurized long cylindrical cavity in an infinite poroelastic medium. To obtain transient solutions, Biot's equations for poroelastodynamics are specialized for this problem. A set of exact general solutions for radial displacement, stresses, pore pressure and discharge are derived in the Laplace transform space by using analytical techniques. Solutions are presented for three different types of prescribed transient radial pressures acting on the surface of a permeable as well as an impermeable cavity surface. Time domain solutions are obtained by inverting Laplace domain solutions using a reliable numerical scheme. A detailed parametric study is presented to illustrate the influence of poroelastic material parameters and hydraulic boundary conditions on the response of the medium. Comparisons are also presented with the corresponding ideal elastic solutions to portray the poroelastic effects. It is noted that the maximum radial displacement and hoop stress at the cavity surface are substantially higher than the classical static solutions and differ considerably from the transient elastic solutions. Time histories and radial variations of displacement, hoop stress, pore pressure and fluid discharge corresponding to a cavity in two representative poroelastic materials are also presented.     

Shakedown in layered pavements under moving surface loads

Elastic–plastic deformations in pavements consisting of layers of different frictional materials are investigated. The upper bound, kinematic shakedown theorem is used to obtain estimates of the critical shakedown loads. Fully general three-dimensional deformations are considered. The influence of the loading distribution, interactions between loads, and the effect of varying the thickness, stiffness and strength of the layers are explored. Consequences of this investigation for particular existing designs of flexible pavements are investigated. In particular, it is found that the strength of the subgrade has no effect on the magnitude of the critical shakedown load.     

Upscaling of elastic properties for large scale geomechanical simulations

Large scale geomechanical simulations are being increasingly used to model the compaction of stress dependent reservoirs, predict the long term integrity of under‐ground radioactive waste disposals, and analyse the viability of hot‐dry rock geothermal sites. These large scale simulations require the definition of homogenous mechanical properties for each geomechanical cell whereas the rock properties are expected to vary at a smaller scale. Therefore, this paper proposes a new methodology that makes possible to define the equivalent mechanical properties of the geomechanical cells using the fine scale information given in the geological model. This methodology is implemented on a synthetic reservoir case and two upscaling procedures providing the effective elastic properties of the Hooke's law are tested. The first upscaling procedure is an analytical method for perfectly stratified rock mass, whereas the second procedure computes lower and upper bounds of the equivalent properties with no assumption on the small scale heterogeneity distribution. Both procedures are applied to one geomechanical cell extracted from the reservoir structure. The results show that the analytical and numerical upscaling procedures provide accurate estimations of the effective parameters. Furthermore, a large scale simulation using the homogenized properties of each geomechanical cell calculated with the analytical method demonstrates that the overall behaviour of the reservoir structure is well reproduced for two different loading cases. Copyright © 2004 John Wiley & Sons, Ltd.     

Preliminary organic petrography of Palaeozoic rocks from the Grand Banks,Newfoundland

Samples of lower Palaeozoic bedrock from the Grand Banks of Newfoundland were examined using reflected light microscopy and Rock-Eval pyrolysis. These samples contained organic material which included bitumen (structureless organic material), acritarchs, chitinozoa, scolecodonts and graptolites. The reflectance of the organic material increased from acritarchs towards graptolites with bitumen showing a wide range of reflectance. Multiple phases of oil migration through one sample were inferred by examination of the bitumens: the lowest reflecting being more recent than the highest reflecting bitumen. Combined reflectance and Rock-Eval analysis indicate that these samples are mature to overmature. The two oldest samples (Arenig-Llanvirn, Ordovician) are assessed as mature and as having potential for generation of liquid hydrocarbons, but must be considered as mainly gas prone.     

Long-term seismicity of Istanbul and of the Marmara Sea region

We examine the long-term seismicity of the Marmara Sea region in Turkey over a period of twenty centuries to attempt to answer two questions: (1) how well recorded in history is the earthquake activity of this region? and (2) does seismicity over this long period of time differ from that over the present century? We study this densely-populated and fast-developing region because it is one of the most tectonically active regions on the continents that appears today to be relatively quiescent.     

The stable isotope signature of kilometre-scale fracturedominated metamorphic fluid pathways, Mary Kathleen, Australia

Abstract Large calcite veins and pods in the Proterozoic Corella Formation of the Mount Isa Inlier provide evidence for kilometre-scale fluid transport during amphibolite facies metamorphism. These 10- to 100-m-scale podiform veins and their surrounding alteration zones have similar oxygen and carbon isotopic ratios throughout the 200 × 10-km Mary Kathleen Fold Belt, despite the isotopic heterogeneity of the surrounding wallrocks. The fluids that formed the pods and veins were not in isotopic equilibrium with the immediately adjacent rocks. The pods have δ¹³C_calcite values of –2 to –7% and δ¹⁸O_calcite values of 10.5 to 12.5%. Away from the pods, metadolerite wallrocks have δ¹⁸O_whole-rock values of 3.5 to 7%. and unaltered banded calc-silicate and marble wallrocks have δ¹³C_calcite of –1.6 to –0.6%, and δ¹⁸O_calcite of 18 to 21%. In the alteration zones adjacent to the pods, the δ¹⁸O values of both metadolerite and calc-silicate rocks approach those of the pods. Large calcite pods hosted entirely in calc-silicates show little difference in isotopic composition from pods hosted entirely in metadolerite. Thus, 100- to 500-m-scale isotopic exchange with the surrounding metadolerites and calc-silicates does not explain the observation that the δ¹⁸O values of the pods are intermediate between these two rock types. Pods hosted in felsic metavolcanics and metasiltstones are also isotopically indistinguishable from those hosted in the dominant metadolerites and calc-silicates. These data suggest the veins are the product of infiltration of isotopically homogeneous fluids that were not derived from within the Corella Formation at the presently exposed crustal level, although some of the spread in the data may be due to a relatively small contribution from devolatilization reactions in the calc-silicates, or thermal fluctuations attending deformation and metamorphism. The overall L-shaped trend of the data on plots of δ¹³C vs. δ¹⁸O is most consistent with mixing of large volumes of externally derived fluids with small volumes of locally derived fluid produced by devolatilization of calc-silicate rocks. Localization of the vein systems in dilatant sites around metadolerite/calc-silicate boundaries indicates a strong structural control on fluid flow, and the stable isotope data suggest fluid migration must have occurred at scales greater than at least 1 km. The ultimate source for the external fluid is uncertain, but is probably fluid released from crystallizing melts derived from the lower crust or upper mantle. Intrusion of magmas below the exposed crustal level would also explain the high geothermal gradient calculated for the regional metamorphism.