Simulation of pebble abrasion on coastal benches by transgressive waves

Tumbler simulations of abrasion processes affecting rocks on basaltic marine benches have clarified the effects of mass and volume of rock fragments on their rate of wear. Several experiments indicate that rate of basalt wear increases with mass in the interval 1 g to 8 g, but is not related to volume of fragments abraded in seawater. Relatively small quantities of rock flour suspended in the immersant seawater substantially reduced the rate of basalt wear. Basalt and calcareous beachrock responded differently in systems with both rock types tumbling together. Examination of the cuttings from these low-energy encounters suggests that abrasion on elevated benches along exposed seacoasts reduces virtually all clastic material to particles of silt size or smaller, producing essentially no sand.     

A statistical study of pressure changes in the troposphere and lower stratosphere after strong solar flares

Summary The average change in height of several constant pressure levels in the troposphere and lower stratosphere after a strong solar flare is described. The analysis covers the northern hemisphere north of 10°N and is based on a sample of 81 carefully selected flares from the period July 1957 through December 1959.The statistical significance of the results is tested by drawing a comparison with the results obtained when one applies exactly the same analysis to three samples of 81 random key-dates selected from the same period.Properties of the reaction pattern are (1) it is pronounced at high as well as low latitudes, (2) it consists of alternating cells of positive and negative height change, (3) it is established within six hours after the flare, and (4) the maximum response occurs near the tropopause.It appears more likely that the atmospheric reaction pattern can be attributed to very energetic solar particles rather than to enhanced ultraviolet radiation.     

The Application of Petroleum Hydrocarbon Fingerprint Characterization in Site Investigation and Remediation

Tremendous resources have been and continue to be spent investigating and remediating petroleum hydrocarbon compounds (PHCs) in soil and ground water. Investigating and planning a remedial strategy for sites affected by PHCs is often a challenging task because of the complex chemical nature of the PHCs. the complex regulatory environment related to PHC cleanup, and the use of analytical methods that provide quantitation but not identification of PHCs. From a technical standpoint, the PHC impacting soil and/or ground water is frequently inadequately characterised, both in identification as well as in is general properties (solubility, toxicity). From a regulatory standpoint, promulgated or recommended total petroleum hydrocarbon (TPH) cleanup levels generally relate to assumed properties of specific unweathered products and are inconsistent among different agencies and regions. This produces a prime situation for unwillingly spending more resources on investigation or remediation than may be necessary, especially when the PHC in the subsurface has different properties from unweathered products such as gasoline or diesel.
Accurately identifying the PHC and its nature, a process known as fingerprint characterization, is critical to the determination of appropriate regulatory goals and design of cost-effective remedial approaches. This paper presents several case studies in which fingerprint characterization made a significant difference in the project outcome. In each instance the nature of the organic material was better understood, the regulatory cleanup levels were negotiated based on the nature of the material, and a remedial approach was implemented that differed significantly from and was generally less costly than what would have been required without fingerprint characterization data.     

Observations of vertical ground accelerations exceeding gravity during the 1997 Umbria-Marche (central Italy) earthquakes

We found extensive evidence that the vertical ground accelerations produced during the largest shock (M = 6.0) of the 1997 Umbria-Marche earthquake sequence exceeded 1g in two areas close to the heavily-damaged villages of Annifo and Colle Croce. This evidence comes from the striking observation of thousands of freshly fractured and broken rocks and stones in these areas. Some of the broken stones lie isolated on soft detritic soil while others had been previously piled up, probably a long time agoto clear the fields for farming. The freshness of the cuts and fractures and the consistency of the observations for thousands of rocks and stones in these areas indicate that these rocks were thrown upwards during the earthquake, with breakage occurring at the time of impact. Ground motion calculations consistent with the static deformation inferred from GPS and interferometry data, show that the broken stones and rocks are found in the zone where the strongest shaking took place during the earthquake and that most of the shaking there was vertical.     

Secular changes,polarity epochs and tectonic movements as indicated by palaeomagnetic studies of Hungarian rock samples

Summary The paper contains an outline of the palaeomagnetic investigations in Hungary including some of their geophysical and geological applications. More than 500 samples of volcanic rocks were studied by usual palaeomagnetic techniques. The rocks investigated belong to three different geological periods — the Quaternary — upper Tertiary, the middle Miocene and the lower Cretaceous. The palaeomagnetic data obtained for the individual localities are summarized in the Appendix.Paper presented at the IAGA Symposium Madrid, September 1969.     

Adsorption und Hydrolyse von Methylparathion an Aktivkohle und Adsorberharz Adsorption and Hydrolysis of Methyl Parathion (MPT) on Activated Carbon and Adsorption Resin

Investigating adsorption of methyl parathion on the activated carbons Filtrasorb 400 and F 44 and on the adsorption polymer Wofatit Y 77 we found a stronger adsorption on the carbons at smaller concentration whereas the resin has the larger capacity at higher concentration. Adsorbents were regenerated through hydrolysis of the pesticide at pH = 11.7. The velocity of hydrolysis in the adsorbed state is reduced to a tenth of that in solution. However, a transport resistance in the pores of adsorbents seems to be negligible as may be concluded from the very small measured particle diameter dependence of the velocity constants. In adsorption-regeneration measurements the capacity of the adsorbents stabilized at about 70% of that of the fresh adsorbents.     

No evidence for a 0.8–0.9 m.y. old micro-australite layer in deep-sea cores

Fission-track and⁴⁰Ar—³⁹Ar dating of Australasian tektites indicates that the australites are older than the rest of the Australasian tektites. Some authors have suggested, therefore, that there should be two microtektite layers in the Australasian region: a younger layer approximately synchronous with the Brunhes/Matuyama geomagnetic reversal boundary (previously described in the literature) and an older layer of Australian microtektites (micro-australites) below the Brunhes/Matuyama reversal boundary and perhaps associated with the end of the Jaramillo event. Fifteen cores already known to contain a layer of Australasian microtektites at or slightly above the Brunhes/Matuyama reversal boundary were searched for an 0.8 to 0.9 m.y. old micro-australite layer. No evidence for this layer was found. Thus, the data do not support the conclusion that the Australasian tektites were produced by two impact events at different times.