Microwave brightness of Saturn's rings

It is shown that a lower limit exists on the microwave brightness of the rings of Saturn, if they are assumed to be composed of Mie scatterers of geological composition. The lower limit (about 15°K) is due to scattering of planetary microwave emission. Significant variation of brightness with azimuth along the rings is expected if the particles are typically of 2–3cm radius. Implications for the multiple-scattering hypothesis of the radar cross section of the rings are noted.     

Edge-to-Stem Variability in Wet-Canopy Evaporation From an Urban Tree Row

Evaporation from wet-canopy (\(E_\mathrm{C}\)) and stem (\(E_\mathrm{S}\)) surfaces during rainfall represents a significant portion of municipal-to-global scale hydrologic cycles. For urban ecosystems, \(E_\mathrm{C}\) and \(E_\mathrm{S}\) dynamics play valuable roles in stormwater management. Despite this, canopy-interception loss studies typically ignore crown-scale variability in \(E_\mathrm{C}\) and assume (with few indirect data) that \(E_\mathrm{S}\) is generally \({<}2\%\) of total wet-canopy evaporation. We test these common assumptions for the first time with a spatially-distributed network of in-canopy meteorological monitoring and 45 surface temperature sensors in an urban Pinus elliottii tree row to estimate \(E_\mathrm{C}\) and \(E_\mathrm{S}\) under the assumption that crown surfaces behave as “wet bulbs”. From December 2015 through July 2016, 33 saturated crown periods (195 h of 5-min observations) were isolated from storms for determination of 5-min evaporation rates ranging from negligible to 0.67 \(\hbox {mm h}^{-1}\). Mean \(E_\mathrm{S}\) (0.10 \(\hbox {mm h}^{-1}\)) was significantly lower (\(p < 0.01\)) than mean \(E_\mathrm{C}\) (0.16 \(\hbox {mm h}^{-1}\)). But, \(E_\mathrm{S}\) values often equalled \(E_\mathrm{C}\) and, when scaled to trunk area using terrestrial lidar, accounted for 8–13% (inter-quartile range) of total wet-crown evaporation (\(E_\mathrm{S}+E_\mathrm{C}\) scaled to surface area). \(E_\mathrm{S}\) contributions to total wet-crown evaporation maximized at 33%, showing a general underestimate (by 2–17 times) of this quantity in the literature. Moreover, results suggest wet-crown evaporation from urban tree rows can be adequately estimated by simply assuming saturated tree surfaces behave as wet bulbs, avoiding problematic assumptions associated with other physically-based methods.     

Statistical analysis of short-term water stress conditions at Riggs Creek OzFlux tower site

Theoretical and Applied Climatology - A large range of indices and proxies are available to describe the water stress conditions of an area subject to different applications, which have varying...     

Is there diversity in the New Urbanism? Analyzing the demographic characteristics of New Urbanist neighborhoods in the United States

The New Urbanism (NU) planning movement aspires to create socially diverse neighborhoods. It is unclear, however, whether this movement lives up to its aspirations in practice. In an effort to systematically examine this aspect of the movement, this paper analyzes age, family type, income, and race data of 70 NU neighborhoods in the United States. The paper uses a diversity index to compare the NU neighborhoods with control sites. Findings show that NU neighborhoods have lower racial diversity, but may have higher income diversity. Consideration of variations within the way NU is implemented reveals that the low racial diversity is associated with a single approach, but higher income diversity is associated with all variants. This paper argues that NU generates places that are more socially diverse than what is described in the literature and uses two case studies to explore the ways in which diversity is produced and its relation to gentrification.     

Deep crustal structure and rheology of the Gascoyne volcanic margin,western Australia

Interpretation of deep seismic reflection data across the Gascoyne Margin reveals six distinct seismic facies units related to the tectono-magmatic breakup history. On the outer Exmouth Plateau four large scale units are identified: (1) an extensively block-faulted upper crust; (2) a middle-crustal unit of discontinuous, undulatory reflectors; (3) a reflection-free deep crustal unit; and (4) a lower-crustal band of low-frequency, high-amplitude reflectors. Two additional units are found near the continent-ocean boundary (COB); (5) seaward-dipping reflectors (SDR); and (6) landward-dipping reflectors in the lower crust below the SDR. The lower-crustal high-reflectivity band, located near the top of a high-velocity unit (V_p > 7 kms^–1), is interpreted as magmatic underplating. There is a spatial correlation between the underplated area and the presence of extensive upper-crustal block-faulting and intrusive rocks in the shallow crust. The undulatory middle-crustal reflector unit is also only identified in the outer plateau area, and is interpreted as a zone in which the upper-crustal faults terminate. The inner parts of the margin consist of a deep basin showing little upper-crustal faulting and no evidence of middle crustal deformation or underplating. Theoretical modeling of the effect of rifting and magmatic underplating on crustal strength profiles suggests that the brittle-ductile transition may migrate at least 5 km upwards during several million years after the underplating event. Based on the seismic interpretation and crustal strength modeling we propose that the seismic structure of the outer Exmouth Plateau is severely modified by a transient change in the crustal rheological structure associated with magmatic underplating.     

Laboratory Study of Air Sparging of TCE-Contaminated Saturated Soils and Ground Water

Air sparging has proven to be an effective remediation technique for treating saturated soils and ground water contaminated by volatile organic compounds (VOCs). Since little is known about the system variables and mass transfer mechanisms important to air sparging, several researchers have recently performed laboratory investigations to study such issues. This paper presents the results of column experiments performed to investigate the behavior of dense nonaqueous phase liquids (DNAPFs). specifically trichloroethylene (TCE), during air sparging. The specific objectives of the study were (1) to compare the removal of dissolved TCE with the removal of dissolved light nonaqueous phase liquids (LNAPLs). such as benzene or toluene; (2) to determine the effect of injected air-flow rate on dissolved TCE removal; (3) to determine the effect of initial dissolved TCE concentration on removal efficiency; and (4) to determine the differences in removal between dissolved and pure-phase TCE. The test results showed that (1) the removal of dissolved TCE was similar to that of dissolved LNAPL: (2) increased air-injection rates led to increased TCE removal at lower ranges of air injection, but further increases at higher ranges of air injection did not increase the rate of removal, indicating a threshold removal rate had been reached; (3) increased initial concentration of dissolved TCE resulted in similar rates of removal: and (4) the removal of pure-phase TCE was difficult using a low air-injection rate, but higher air-injection rates led to easier removal.     

Stable isotope paleohydrology and chemostratigraphy of the Albian Wayan Formation from the wedge-top depozone,North American Western Interior Basin

Understanding of the role of atmospheric moisture and heat transport in the climate system of the Cretaceous greenhouse world represents a major challenge in Earth system science.Stable isotopic paleohydrologic data from mid-Cretaceous paleosols in North America,from paleoequatorial to paleoArctic latitudes,have been used to constrain the oxygen isotope mass balance of the Albian hydrologic cycle.Over the range from 40°-50°N paleolatitude,sideritic paleosols predominate,indicating paleoenvironments with positive precipitation-evaporation(P-E)balances.Local exceptions occur on leeward side of the Sevier Orogen,where calcic paleosols in the wedge-top depozone record paleoenvironments with negative P-E balances in the orographic rain shadow.Stratigraphic sections in the Wayan Formation of Idaho(WF)were sampled from the wedge-top depozone.The units consist of stacked m-scale mudstone paleosols separated by m-scale sandstone-siltstone beds.Sections were sampled for organic carbon isotope profiles,and B-horizons from 6 well-developed paleosols were sampled for detrital zircons to determine maximum depositional ages.The first of these from the WF has produced a U-Pb concordia age of 101.0±1.1 Ma.This same WF section has produced a stratigraphic trend of upwardly decreasingδ~(13)C values ranging from-24‰upwards to-27‰VPDB,suggesting correlation to the late Albian C15 C-isotope segment.Pedogenic carbonates from the WF principally consist of micritic calcite,with carbon-oxygen isotope values that array along meteoric calcite lines(MCLs)withδ~(18)O values that range from-9.47‰up to-8.39‰VPDB.At approximately 42°N paleolatitude,these MCL values produce calculated paleoprecipitation values of-8.12‰to-7.04‰VSMOW,a range that is consistent with the estimates produced from other proxies at the same paleolatitudes across North America.These results indicate that despite the orographic rain shadow effect,the processes of meridional atmospheric moisture transport in this locale were similar to those in more humid mid-latitude paleoenvironments elsewhere in the continent.     

Using Diurnal Temperature Signals to Infer Vertical Groundwater‐Surface Water Exchange

Heat is a powerful tracer to quantify fluid exchange between surface water and groundwater. Temperature time series can be used to estimate pore water fluid flux, and techniques can be employed to extend these estimates to produce detailed plan‐view flux maps. Key advantages of heat tracing include cost‐effective sensors and ease of data collection and interpretation, without the need for expensive and time‐consuming laboratory analyses or induced tracers. While the collection of temperature data in saturated sediments is relatively straightforward, several factors influence the reliability of flux estimates that are based on time series analysis (diurnal signals) of recorded temperatures. Sensor resolution and deployment are particularly important in obtaining robust flux estimates in upwelling conditions. Also, processing temperature time series data involves a sequence of complex steps, including filtering temperature signals, selection of appropriate thermal parameters, and selection of the optimal analytical solution for modeling. This review provides a synthesis of heat tracing using diurnal temperature oscillations, including details on optimal sensor selection and deployment, data processing, model parameterization, and an overview of computing tools available. Recent advances in diurnal temperature methods also provide the opportunity to determine local saturated thermal diffusivity, which can improve the accuracy of fluid flux modeling and sensor spacing, which is related to streambed scour and deposition. These parameters can also be used to determine the reliability of flux estimates from the use of heat as a tracer.     

Determination of the seismic performance factors for post‐tensioned rocking timber wall systems

Post‐tensioned technologies for concrete seismic resistant buildings were first developed in the 1990s during the PREcast Seismic Structural Systems program. Among different solutions, the hybrid system proved to be the most resilient solution providing a combination of re‐centering and energy dissipative contributions respectively by using post‐tensioned tendons and mild steel reinforcement. The system, while providing significant strength and energy dissipation, reduces structural element damage and limits post‐earthquake residual displacements. More recently, the technology was extended to laminated veneer lumber (LVL) structural members, and extensive experimental and numerical work was carried out and allowed the development of reliable analytical and numerical models as well as design guidelines. On the basis of the experimental and numerical outcomes, this paper presents the evaluation of the seismic performance factors for post‐tensioned rocking LVL walls using the FEMA P‐695 procedure. Several archetype buildings were designed considering different parameters such as the building and story height, the type of seismic resistant system, the magnitude of gravity loads and the seismic design category. Lumped plasticity models were developed for each index archetype to simulate the behavioral aspects and collapse mechanisms. Non‐linear quasi‐static analyses were carried out to evaluate the system over‐strength factor; moreover, non‐linear time history analyses were performed using the incremental dynamic analysis concept to assess the collapse of each building. From the results of quasi‐static and dynamic analyses the response modification factor, R, system over‐strength factor, Ω₀, and deflection amplification factor, C_d, values of, respectively, 7, 3.5 and 7.5 are recommended. Copyright © 2016 John Wiley & Sons, Ltd.     

On the importance of soil moisture in calibration of rainfall–runoff models: two case studies

Streamflow modelling results from the GR4H and PDM hydrological models were evaluated in two Australian sub-catchments, using (1) calibration to streamflow and (2) joint-calibration to streamflow and soil moisture. Soil moisture storage in the models was evaluated against soil moisture observations from field measurements. The PDM had the best performance in terms of both streamflow and soil moisture estimations during the calibration period, but was outperformed by GR4H during validation. It was also shown that the soil moisture estimation was improved significantly by joint-calibration for the case where streamflow and soil moisture estimations were poor. In other cases, addition of the soil moisture constraint did not degrade the results. Consequently, it is recommended that GR4H be used, in preference to the PDM, in the foothills of the Murrumbidgee catchment or other Australian catchments with semi-arid to sub-humid climate, and that soil moisture data be used in the calibration process.