Formation mechanism of pigeonite lamellae in skaergaard augite

Fine textures of exsolution lamellae and interface boundaries between augite and pigeonite in augite crystals from Skaergaard ferrogabbro 4430 have been studied by high resolution electron microscopy and X-ray methods. Thick pigeonite lamellae have higher densities of (100) stacking faults than thin lamellae. The displacement vector of the faults has been determined as 5/6c from the measured density of faults and the relative rotation of the augite and pigeonite lattices. The augite and pigeonite lattices are apparently coherent, and no growth ledges were observed at the interfaces. The stacking faults are often combined with the antiphase boundary of pigeonite resulting in a total displacement vector of 1/2(a+b)+5/6c. The observation of thick and thin pigeonite lamellae indicated that the thickening of (001) pigeonite lamellae was controlled by coherency strains accumulated at the interfaces between augite and pigeonite.     

Cooling flows induced by Compton cooling resulting from luminous quasars in clusters of galaxies

We have studied the effects of Compton cooling on cooling flow by performing numerical hydrodynamic calculations of the time evolution of hot gas in clusters of galaxies with luminous quasars. We assumed various temperatures for the hot intracluster gas. We have shown that the Compton cooling resulting from very luminous quasars is effective in inducing cooling flow, before radiative cooling flow is realized. The mass flux resulting from the cooling flow increases with time, as the Compton-cooled region expands. However, the mass flux of the Compton cooling flow is not large, less than 1 M⊙ yr⁻¹ in our model, because the Compton-cooled region is limited to an inner galactic region around a quasar. Even after the quasar active phase has ceased, the cooling flow will continue for at least 10⁹ yr. The accreted mass is enough to explain X-ray absorption lines in high-redshift quasars, if the Compton-cooled gas is compressed by high-pressure intracluster gas.     

Fine-grained aggregates in L3 chondrites

The textures and chemical compositions of the constituent minerals of the fine-grained aggregates (FGA's) of L3 chondrites were studied by the backscattered electron image technique, electron probe microanalysis, and transmission electron microscopy. Plagioclase and glass in the interstices between fine grains of olivine and pyroxene indicate that the FGA's once partly melted. Compositional zoning and decomposition texture of pyroxenes are similar to those observed in chondrules, indicating a common cooling history of the FGA's and chondrules. Therefore, the mechanism that caused melting of the FGA's is considered to be the same as for chondrules. Bulk compositions of the FGA's are within the range of those of chondrules, so some chondrules probably were produced by complete melting of the same precursor materials as those of the FGA's. The precursor materials must have included fine olivine and other grains that probably are condensates.     

Petrographic features of a high-temperature granite just newly solidified magma at the Kakkonda geothermal field, Japan

A 3729-m-deep geothermal research well, WD-1a, provides us with a unique opportunity to study initial petrographic features of a high-temperature granite just after solidification of magma. The well succeeded in collecting three spot-cores of the Kakkonda Granite that is a pluton emplaced at a shallow depth and regarded as a heat source of the active Kakkonda geothermal system. The core samples were collected at the present formation temperatures of 370, 410 and over 500°C. These samples are granodiorite to tonalite consisting mainly of plagioclase, quartz, hornblende, biotite and K-feldspar. A sample collected at a formation temperature of over 500°C possesses the following remarkable petrographic features compared to the other two samples. Interstitial spaces are not completely sealed. K-feldspar exhibits no perthite by the exsolution of albite lamella. Quartz includes glassy melt inclusions without devitrification. Hornblende is less intensively altered to actinolite, and biotite is not altered. This study directly confirmed that perthite in K-feldspar is a recrystallization texture formed at 410–500°C based on a comparison of the in situ temperatures of the samples. Chemical compositions of minerals were analyzed to compare temperatures determined from geothermometers in several publications to the in situ temperatures of the samples.     

Tsunami Assessment for Risk Management at Nuclear Power Facilities in Japan

The present study focuses on evaluation of the maximum and minimum water levels caused by tsunamis as risk factors for operation and management at nuclear power facilities along the coastal area of Japan. Tsunamis generated by submarine earthquakes are examined, basing literature reviews and databases of information on historical tsunami events and run-up heights. For simulation of water level along the coast, a numerical calculation system should be designed with computational regions covering a particular site. Also the calculation system should be verified by comparison of historical and calculated tsunami heights. At the beginning of the tsunami assessment, the standard faults, their locations, mechanisms and maximum magnitudes should be carefully estimated by considering historical earthquake-induced tsunamis and seismo-tectonics at each area. Secondly, the range of errors in the model parameters should be considered since earthquakes and tsunamis are natural phenomena that involve natural variability as well as errors in estimating parameters. For these reasons, uncertainty-induced errors should be taken into account in the process of tsunami assessment with parametric study of the tsunami source model. The element tsunamis calculated by the standard fault models with the errors would be given for the design. Then, the design tsunami can be selected among the element tsunamis with the most significant impact, maximum and minimum water levels, on the site, bearing in mind the possible errors in the numerical calculation system. Finally, the design tsunami is verified by comparison with the run-up heights of historical tsunamis, ensuring that the design tsunami is selected as the highest of all historical and possible future tsunamis at the site.     

Studying air pollution with kitt peak solar flux atlas — analysis method and results of observation

For the measurement of atmospheric NO2 vertical column density (VCD), Kitt Peak Solar Flux Atlas can be substituted as an extraterrestrial solar radiation. Compared with differential analysis method, the Taylor expansion of integrated transfer equation underestimates the VCD. This underestimation is as large as 35% when the amount of NO2 is 1 × 1017 cm－2 and observation is conducted with an air mass factor of 10. Even when the VCD is 2 × 1016 cm－2 and the air mass factor is 4, the relative error of the retrieved VCD is still no less than 3%. If the observation is restricted under the small air mass factor condition (≤4), with Kitt Peak Solar spectrum as an extraterrestrial solar radiation, only an atmospheric layer of 2 km thick from ground can be studied, which will make the absorption too weak to be detected by normal instruments.The VCD in winter Tokyo area was observed and analyzed by differential method, which shows a good precision even when the absorption is as low as 3%. The largest average VCD was about 1.3 × 1017 cm－2, and the lowest was about 1.3 × 1016 cm－2. The trend of its variation was almost the same as the ground level observation by Saltzman reagent method.     

Studying Air Pollution with Kitt Peak Solar Flux Atlas—Analysis Method and Results of Observation

l.Introducti0nTwoflightsoftheSAGEIIIinstrumentwereplanedbeinglaunchedinJune2O00byRussianMeteor-3Mandin2002byInternationalSpaceStation(ISS).Itisexpectedthattheywouldofferinformationofalmostglobalcoverage.Theseinstrumentswillutilizetheselfcal-ibratingsolaroccultationtechniquetomeasureprofilesofaerosoIextinctionfrom0to4Okm,ozonefrom6to85km,nitrogendioxidefroml0to5Okm,andwatervaporfrom0to5Okm,andutilizelunaroccultationobservati0nstomonitorthekeynighttimesPecies,nitrogentrioxidefrom22to55k…     

Lessons Learned from the 2011 Great East Japan Tsunami: Performance of Tsunami Countermeasures, Coastal Buildings, and Tsunami Evacuation in Japan

In 2011, Japan was hit by a tsunami that was generated by the greatest earthquake in its history. The first tsunami warning was announced 3 min after the earthquake, as is normal, but failed to estimate the actual tsunami height. Most of the structural countermeasures were not designed for the huge tsunami that was generated by the magnitude M = 9.0 earthquake; as a result, many were destroyed and did not stop the tsunami. These structures included breakwaters, seawalls, water gates, and control forests. In this paper we discuss the performance of these countermeasures, and the mechanisms by which they were damaged; we also discuss damage to residential houses, commercial and public buildings, and evacuation buildings. Some topics regarding tsunami awareness and mitigation are discussed. The failures of structural defenses are a reminder that structural (hard) measures alone were not sufficient to protect people and buildings from a major disaster such as this. These defenses might be able to reduce the impact but should be designed so that they can survive even if the tsunami flows over them. Coastal residents should also understand the function and limit of the hard measures. For this purpose, non-structural (soft) measures, for example experience and awareness, are very important for promoting rapid evacuation in the event of a tsunami. An adequate communication system for tsunami warning messages and more evacuation shelters with evacuation routes in good condition might support a safe evacuation process. The combination of both hard and soft measures is very important for reducing the loss caused by a major tsunami. This tsunami has taught us that natural disasters can occur repeatedly and that their scale is sometimes larger than expected.