Effect of Atmosphere and Temperature Treatment on Leoanardite for Increasing Humic Acid Yield

In this review, the shifts in organic matter (OM) accumulation and C:N ratios in lake sediments to reconstruct paleoclimate and paleo-environmental changes since the early Holocene period are presented. The C:N proxy data of total OM reflect wet climatic conditions during early Holocene (10 to 8.2 kyrs BP) due to enhanced southwest monsoon. This was followed by intermittent arid conditions during the mid and late Holocene period (8.2 to 2.8 kyr BP). Enhanced values of C:N ratio during middle to late Holocene (7.8–2.3 kyrs B.P) indicate periods with lower lake levels and minimum precipitation, while decreased C:N ratio point to stronger SW monsoon and expansion of the lakes. Further, C:N and δ¹³C results from the lake sediments reveal a detailed and continuous paleo-environmental changes in the relative sources of OM (allochthonous vs autochthonous). Proxy records using such natural archives have also been utilized to reconstruct past extreme events and environmental changes around the lake systems, such as causes for lake desiccation, hydrographic changes, alternations between C₃ and C₄ vegetation and historical disturbances in the catchment area since the early-late Holocene period coupled with the Indian summer monsoon.     

A new approach to minimize the loss of life after natural hazards by using Android operating system

Nowadays, the usage rates of smartphones are increasing rapidly. With the versatility of its features, smartphones have succeeded in attracting users. Performing this study has also affected the usage rate of smartphones every day. It is possible to determine the position with GPS (Global Positioning System) technology which is located in smartphones. In this study, smartphone location notification was used to detect the locations of the people who were under debris after the earthquake by means of the phones on them. People who cannot be reached for any reason will be immediately identified, and emergency interventions will be possible. Thus, the survival rate of the injured will be high with early intervention. In this study, it was aimed to minimize the loss of life after the earthquake and all the negativities that would be experienced in society due to this loss. The developed application has been tested in the external world, and the obtained data are given in results section.

     

Constraints on unconsolidated pyroclastic flow sediments related REE enrichments originated from potassic-alkaline Gölcük stratovolcano: Darıdere-Direkli-Yakaören (DDY) table 4deposits,southwestern Anatolia of Turkey

Acta Geochimica - In the last five decades, Rare Earth Elements (REE) are mostly produced from carbonatite complexes and alkaline magmatic environments. In this respect, pyroclastic flows produced...     

Impact of different sampling rates on precise point positioning performance using online processing service

In this study, the effect of different sampling rates (i.e. observation recording interval) on the Precise Point Positioning (PPP) solutions in terms of accurac...     

Bending of orthotropic super-elliptical plates on intermediate point supports

Bending analysis of orthotropic super-elliptical plates of uniform thickness was investigated. Optimum location of the point supports was searched by minimizing the maximum absolute deflection. The support location which minimizes the bending moments at the supports was reported. The Ritz method was used and the total potential energy functional was modified by introducing the Lagrange multipliers to improve the accuracy of the stress resultants. The deflection and the bending moments computed at various points for a large variety of plate shapes ranging from an ellipse to a rectangle were checked with those of rectangular and elliptical plates. Good agreement was obtained for both cases. The structural response was found to be sensitive to support position.     

Parametric analysis of liquid storage tanks base isolated by curved surface sliding bearings

Curved surface sliding bearings, which are usually called as friction pendulum system (FPS) are commonly used for base isolation of liquid storage tanks since the period of the isolation system is independent of the storage level. However the restoring force and the damping at the isolation system are functions of axial load which changes during an earthquake excitation. This change might be in appreciable amounts especially for the tanks with high aspect ratios. The present paper focuses on earthquake performances of both broad and slender tanks base isolated by FPS bearings. The effects of overturning moment and vertical acceleration on axial load variation at the bearings are considered. The efficiency of the isolation system is investigated by analyzing the effects of various parameters such as; (i) isolation period, (ii) tank aspect ratio and (iii) coefficient of friction. The Haroun and Housner's three-degrees-of-freedom lumped mass model was used to solve the governing equations of motion in which convective, impulsive and rigid masses were included. A number of selected ground motions were considered and the results were compared to those of non-isolated cases.As a result, base isolation was found to be effective in reducing the base shear values for both broad and slender tanks without significantly affecting the sloshing displacements of the broad ones. The efficiency was even more pronounced for slender tanks subjected to near fault ground motions for isolation periods above 3 s. This specific value of isolation period also eliminated possible design problems arising from under-estimation of base shear values (up to 40%) due to ignoring the effects of axial load variation in lower isolation periods. Overturning effects should not be ignored especially for tanks with high aspect ratios (S) and being subjected to near fault ground motion.     

An energy approach to sliding of single-span simply supported slab-on-girder steel highway bridges with damaged bearings

This paper investigates the non-linear inelastic seismic response of existing single-span simply supported bridges having bearings which can remain stable and slide after their anchor bolts are ruptured. A simplified equivalent model is developed for the inelastic analysis of these single-span simply supported bridges. Non-linear inelastic time-history analyses are conducted for various acceleration inputs. It is found that narrower bridges with longer spans may have considerable sliding displacements and fall off their supports if adequate seat width is not provided. It is also found that for the same ratio of friction coefficient to peak ground acceleration, the sliding displacement of a structural system is linearly proportional to the amplitude of the peak ground acceleration beyond a certain threshold value. This is also demonstrated analytically from an energy approach point of view. The distribution of the energy content of an earthquake, which is related to its velocity time history, can be an indication of the propensity of an earthquake to cause high sliding displacements. Ground motions with high frequency content or high A_p/V_p ratio may produce smaller sliding displacements than ground motions with relatively lower A_p/V_p ratios.     

The effect of interpolation methods in surface definition: an experimental study

Mappings of the earth surface and their representation in 3D (three‐dimensional) models are commonly used in most recent research. Modeling research, which starts with classical surveying methods, acquires new dimensions matching the modern technologies. 3D models of any object or earth surface can be used in much visual and scientific research. A digital model of the landscape is an important part within creation of geo‐information systems used in the public administration and in the commercial sphere. It is an important tool in applications such as geomorphology, hydrology, geology, cartography, ecology, mining etc. Values of volume in terrains that do not have regular geometric structure can be obtained more accurately by using 3D models of surfaces with respect to developing technology. Basic data of 3D models must indicate 3D coordinates of the surveyed object in the reference frame. Distribution and intensity of points are important factors in modeling earth surfaces. A minimum number of points is desired in defining an object in 3D. Interpolation methods employing different mathematical models are used to obtain 3D models of terrain surfaces. In this study, the effect of interpolation methods in defining a terrain surface is investigated. For this purpose, a uniform surface, hill‐shaped artificial object with a known volume is employed. The 3D surface and volume are calculated by using 12 different interpolation methods. Point distribution, point intensity and accuracy of point measurements are not considered. The same data set was used for all the interpolation methods. The interpolation methods are compared and evaluated based on the results. Copyright © 2007 John Wiley & Sons, Ltd.     

Animal burrowing and associated formation of large desiccation cracks as factors of a rapid restoration of soil cover in flooded farmlands

The burrowing activity of annelids controls the spatial pattern and rapid formation of large desiccation cracks in the river flood-derived mud cover in recently inundated farmland areas in northwestern Anatolia, Turkey. The phenomenon is confirmed by laboratory experiments imitating the natural floodplain conditions.