Bringing GPS into harsh environments for fully automated deformation monitoring

Engineering projects that require deformation monitoring frequently utilize geodetic sensors to measure displacements of target points located in the deformation zone. In situations where control stations and targets are separated by a kilometer or more, GPS can offer higher precision position updates at more frequent intervals than can normally be achieved using total station technology. For large-scale deformation projects requiring the highest precision, it is therefore advisable to use a combination of the two sensors. In response to the need for high precision, continuous GPS position updates in harsh deformation monitoring environments, a software has been developed that employs triple-differenced carrier-phase measurements in a delayed-state Kalman filter. Two data sets were analyzed to test the capabilities of the software. In the first test, a GPS antenna was displaced using a translation stage to mimic slow deformation. In the second test, data collected at a large open pit mine were processed. It was shown that the delayed-state Kalman filter developed could detect millimeter-level displacements of a GPS antenna. The actual precision attained depends upon the amount of process noise infused at each epoch to accommodate the antenna displacements. Higher process noise values result in quicker detection times, but at the same time increase the noise in the solutions. A slow, 25 mm displacement was detected within 30 min of the full displacement with sigma values in E, N and U of ±10 mm or better. The same displacement could also be detected in less than 5 h with sigma values in E, N and U of ±5 mm or better. The software works best for detecting long period deformations (e.g., 20 mm per day or less) for which sigma values of 1–2 mm are attained in all three solution components. It was also shown that the triple-differenced carrier-phase observation can be used to significantly reduce the effects of residual tropospheric delay that would normally plague double-differenced observations in harsh GPS environments.

Spin rate estimation of sounding rockets using GPS wind-up

Carrier phase wind-up is a well-known effect that arises from the relative rotation between a transmitting and receiving antenna. In GPS measurements at L1 frequency, this effect translates into an error of 19.029 cm per full relative rotation of antennas. Since this effect is independent of the satellite elevation for pure rotation about the antenna boresight axis, it is usually absorbed by the clock estimation in navigation algorithms. Therefore, the impact of wind-up is usually neglected for applications that do not require accuracies to the cm level like RTK. However, in receiving platforms with high rotation rate, the accumulated wind-up value can be important and actually be larger than receiver noise or even ionospheric variations. Therefore, in such scenarios, the wind-up contribution can be isolated and used as a source of information to compute the spin rate of such platforms using an appropriate combination of GPS observables. This work shows some results of a coarse, yet simple, approach to monitor the rotation angle and spin-rate of spin stabilized sounding rockets flown by DLR.     

Geodetic intersection on the ellipsoid

Through each of two known points on the ellipsoid a geodesic is passing in a known azimuth. We solve the problem of intersection of the two geodesics. The solution for the latitude is obtained as a closed formula for the sphere plus a small correction, of the order of the eccentricity of the ellipsoid, which is determined by numerical integration. The solution is iterative. Once the latitude is obtained, the longitude is determined without iteration.     

Population growth and the development of a central place system

This paper describes the spatial and functional evolution of a central place system as market conditions change with population growth. Utilizing a partial equilibrium optimization model, we examine the spatial response of two economic sectors to increases in market populations resulting from natural increase and migration. Response in both sectors is conditioned by threshold demand, with factor prices also affecting one of the sectors. As the central place system evolves it exhibits spatial and functional characteristics that are initially consistent with a Löschian landscape, then a Christallerian landscape at higher populations, while at even larger populations Krugman’s landscape emerges.     

Using GPS multipath to measure soil moisture fluctuations: initial results

Measurements of soil moisture are important for studies of climate and weather forecasting, flood prediction, and aquifer recharge studies. Although soil moisture measurement networks exist, most are sparsely distributed and lack standardized instrumentation. Measurements of soil moisture from satellites have extremely large spatial footprints (40–60 km). A methodology is described here that uses existing networks of continuously-operating GPS receivers to measure soil moisture fluctuations. In this technique, incoming signals are reflected off and attenuated by the ground before reception by the GPS receiver. These multipath reflections directly affect signal-to-noise ratio (SNR) data routinely collected by GPS receivers, creating amplitude variations that are a function of ground reflectivity and therefore soil moisture content. After describing this technique, multipath reflection amplitudes at a GPS site in Tashkent, Uzbekistan are compared to estimates of soil moisture from the Noah land surface model. Although the GPS multipath amplitudes and the land surface model are uncalibrated, over the 70-day period studied, they both rise sharply following each rainfall event and slowly decrease over a period of ∼10 days.     

Cross-scale analysis of cluster correspondence using different operational neighborhoods

Cluster correspondence analysis examines the spatial autocorrelation of multi-location events at the local scale. This paper argues that patterns of cluster correspondence are highly sensitive to the definition of operational neighborhoods that form the spatial units of analysis. A subset of multi-location events is examined for cluster correspondence if they are associated with the same operational neighborhood. This paper discusses the construction of operational neighborhoods for cluster correspondence analysis based on the spatial properties of the underlying zoning system and the scales at which the zones are aggregated into neighborhoods. Impacts of this construction on the degree of cluster correspondence are also analyzed. Empirical analyses of cluster correspondence between paired vehicle theft and recovery locations are conducted on different zoning methods and across a series of geographic scales and the dynamics of cluster correspondence patterns are discussed.      

Income distribution dynamics and cross-region convergence in Europe

This paper presents a continuous version of the model of distribution dynamics to analyse the transition dynamics and implied long-run behaviour of the EU-27 NUTS-2 regions over the period 1995–2003. It departs from previous research in two respects: first, by introducing kernel estimation and three-dimensional stacked conditional density plots as well as highest density regions plots for the visualisation of the transition function, based on Hyndman et al. (J Comput Graph Stat 5(4):315–336, 1996), and second, by combining Getis’ spatial filtering view with kernel estimation to explicitly account for the spatial dimension of the growth process. The results of the analysis indicate a very slow catching-up of the poorest regions with the richer ones, a process of shifting away of a small group of very rich regions, and highlight the importance of geography in understanding regional income distribution dynamics.

Low multipath antennas for GNSS-based attitude determination systems applied to high-altitude platforms

High-altitude platforms (HAPs) are a flexible and attractive technology for providing innovative wireless services. These aerial platforms can be successfully employed for mobile or broadband communications and for disaster monitoring or response. However, one of the open issues is whether HAP stations can provide reliable services without temporal outages owing to stratospheric winds that can cause positional and attitude instabilities thus affecting the communication system operation. To counteract this issue, one possible solution is to use reconfigurable antennas whose pointing direction can be adjusted depending on the platform spatial orientation. However, this would require real-time three-axial attitude data. As a possible solution, this paper will review the potential of GNSS-based attitude determination systems with reference to HAP stations. In particular, it will be shown how the use of a particular class of low multipath and lightweight antennas can provide a high degree of accuracy without altering the avionic ballast.     

Inter sensor comparison between RESOURCESAT LISS III, LISS IV and AWiFS with reference to coastal landuse/landcover studies

Coastal zone assumes importance due to high productivity of ecosystems, man-made developmental activities, natural hazards and dynamic nature of the coast. As costal ecosystems are unique and fragile, understanding the impact of developmental activities on the sustainability of the coastal zone is very important. Remote sensing, because of repetitive and synoptic nature is an ideal tool for studying this. Time series data analyses for monitoring coastal zone require different type of sensors. Present study deals with atmospheric correction of satellite data, reflectance, selection of coastal features like, mudflat, mangroves, vegetated dune, coastal water, etc. and their inter-comparison using different sensor data of RESOURCESAT sensors. Reflectance values give better separateability for various coastal features in comparison to DN values. LISS IV can be used in place of LISS III or merged (LISS III + PAN) for long-term coastal zone studies.